倒置A2/O污水处理工艺的特点及应用实例

传统A²/O工艺在保证脱氮效果的同时除磷效果往往不佳。在充分分析传统A²/O工艺的基础上，提出了将缺氧池置于厌氧池前面，厌氧池后设置好氧池的分点进水倒置A²/O工艺。某污水厂的现场试验表明，在COD去除能力与常规A²/O工艺相当的情况下，倒置A²/O工艺的脱氮除磷功能明显优于常规A²/O工艺。     

填埋垃圾腐殖质组成在填埋场稳定度表征中的应用

通过对上海老港生活垃圾填埋场1991-2004年封场单元填埋垃圾腐殖质组成的分析,考察了填埋垃圾中腐殖质组成随填埋龄的变化规律.研究结果表明,填埋垃圾腐殖质的总可提取率和胡敏酸(HA)与富里酸(FA)比值(HA/FA)分别随填埋龄呈线性下降和上升趋势.因此,填埋垃圾总可提取率和HA/FA可用来有效表征填埋场和填埋垃圾稳定度.     

A/O工艺处理城市生活工业综合污水的耐受性研究

针对目前城市污水处理厂进水水质以生活污水为主转向以难生物处理的工业废水为主的现状,进行了A/O工艺的耐受性试验.结果表明:随着工业废水比例的增加,厌氧、好氧污泥活性都显著下降,厌氧污泥的耐受性较高;随着运行时间的延长,两类污泥的活性逐步得到不同程度的恢复;工业废水比例越高,活性恢复所需时间越长;两类污泥的协同代谢作用保证了出水效果.A/O工艺所能耐受的进水中制药废水、印染废水和生活污水的分配比(体积比)为3∶3∶4.     

气-水联合反冲洗膜污染防治技术研究

采用气水联合反冲洗技术,考察了气水比(Qg/Ql)、反冲洗周期及其对膜污染的防治效果。结果表明,气水联合反冲洗较单独气或水反冲洗效果好;在过滤周期20min,反冲洗时间1min,气水比1.5时,气水联合反冲洗能够恢复膜通量到膜清水通量的80%以上。此法可大幅度清除沉积在膜表面的泥饼层,恢复膜通量,维持膜过滤性能的稳定,是一种较为有效的膜污染防治技术。     

Emissions from RDF/coal blended fuel combustion

The significant volume and weight reduction along with the energy potential of MSW, in the form of refuse derived fuel (RDF), has made its incineration an attractive alternative. However, the gaseous emissions such as, CO₂, CO, NO_x and SO₂, which are the byproduct of the combustion process pose serious environmental problems. These problems are compounded by the presence of certain highly regulated hazardous wastes such as, dioxins and furans in the exhaust stream. In the present investigation, different compositions of RDF/Coal blends were examined and the gaseous emissions from the combustion of the briquetted fuel were measured. Also, a direct comparison of emissions from RDF/coal blend incineration with coal combustion is presented in this paper. The potential for recovery of ferrous and non- ferrous metals provides an additional economic motivation for the use of RDF/Coal blended briquettes.     

H2O2 formation from photocatalytic processes at the ZnO/water interface

The paper focuses on the production of H2O2 by photocatalysis over ZnO in an aerated aqueous phase. The presence of different reductants that increase the H2O2 production in the aqueous phase is analysed; particular attention is paid to nitrite, which has been shown to be the reductant that produces the most significant increments in the H2O2 production. The photocatalytic anodic decomposition of ZnO in the presence of the different reductants is also investigated. From the results obtained, the relevance of the ZnO photocatalysis in the formation of environmental hydrogen peroxide is estimated.     

Ti/Cu交联累托石光催化氧化处理硝基苯废水研究

以钛酸丁酯为钛源,掺杂铜(CuCl2)制备交联剂.制得柱状Ti/Cu交联累托石,结合其吸附特性并通过其在光催化氧化条件下处理含硝基苯有机废水.在pH=9,交联累托石用量为30 g/L,一根20 W紫外灯光辐照2 h的处理条件下,硝基苯由73.81 mg/L降至3.17 mg/L,去除率达到95.71%,优于GB-8978-1996三级标准,用其处理含硝基苯工业废水,COD去除率为83.73%,由4800 mg/L降至530.4 mg/L,硝基苯去除率达92.3l%,由10.32 mg/L降至0.79 mg/L,小于GB-8978-1996-级标准.     

MBBR与A/O法对污水中有机物及氮处理效果的研究

实验在不同水力停留时间（HRT）、进水COD浓度和不同COD容积负荷条件下考察了移动床生物膜反应器（MBBR）和活性污泥A/O工艺对污水中有机物及氮的处理效果。结果表明,MBBR工艺去除有机物和脱氮效果均优于A/O工艺。在进水COD和NH₃－N浓度分别为1000和25 mg/L，HRT为8 h时，MBBR的COD和TN去除率分别为92％和94％，而A/O工艺分别为78％和82％。造成这种结果的原因是MBBR的生物活性高，并且在生物膜内发生了同时硝化反硝化。MBBR脱氮能力受COD冲击明显小于A/O，但在较低进水COD浓度下，两者TN去除率均较低。     

A/O脱氮工艺的控制策略和应用性研究

根据A/O脱氮工艺的运行状况和影响因素 ,提出了应用在线传感器连续测定曝气池中DO浓度、氨氮浓度和硝酸氮浓度 ,并据此调节供氧强度、内循环回流量、有机碳源的投加以及硝化区和反硝化区的大小 ,这是保证A/O脱氮工艺良好处理效果的重要控制策略和思想。同时对近年来国外A/O脱氮工艺自动控制的应用及研究进行了简单的回顾。