Simulation of atmospheric PAH emissions from diesel engines

Simulation of atmospheric PAH emissions in a typical European passenger car diesel engine at steady conditions or under a certification cycle is made using in-house software. It is based on neural fitting of experimental data from eight different fuels tested under five operating steady conditions (reproducing modes of the European transient urban/extraurban certification cycle). The software allows the determination of PAH emissions as a function of the fuel composition parameters (aromatic content, cetane index, gross heat power, nitrogen and sulphur content) and operation conditions (torque and engine speed). The mathematical model reproduces experimental data with a maximum error of 20%. This tool is very useful, since changes in parameters can be made without experimental cost and the trend in modifications in PAH emissions is immediately obvious.     

Isolation and identification of intermediates from biodegradation of low chlorinated biphenyls (Delor-103)

Microorganism Pseudomonas species P2 metabolizes polychlorinated biphenyls (PCBs) and biphenyl, producing the whole spectrum of intermediates, among them coloured intermediates, which are suitable for the monitoring of PCBs degradation by optical sensors. Knowledge of chemical structures and conditions of development of colour metabolites is necessary for application of optical analytical methods. The main goal of this work was the isolation and identification of intermediates from the biodegradation of the mixture of low chlorinated biphenyls (Delor-103), which is based on the solid phase extraction (SPE) of the whole mixture using LiChrolut EN cartridges, then silylation of the extract as one way to the identification of one part of intermediates by GC-MS, and acetylation of the extract as a way for the further concentration and analysis of more polar chlorobiphenylols and chlorobiphenyldiols. The combination of SPE and following acetylation allows to obtain chlorobiphenylols and chlorobiphenyldiols as an almost pure fraction. The acetylation method could be also used instead SPE procedure with the same final concentration effect. Using the simulation mass spectrometry program, two new compounds, dihydrodihydroxytrichloro- and tetrahydrodihydroxytrichlorobiphenyl, as silylderivatives, were identified.     

Adsorption of atrazine from aqueous solution on heat treated kerolites

The adsorption of 6-chloro-N(2)-ethyl-N(4)-isopropyl-1,3,5-triazine-2,4-diamine (atrazine) on heat treated kerolite samples at 110 degrees C (K-110), 200 degrees C (K-200), 400 degrees C (K-400) and 600 degrees C (K-600) from aqueous solution at 25 degrees C has been studied. The evolution of surface properties of kerolite samples such as specific surface area and porosity after heat treatment was analysed. The clays were characterised by using usual techniques: FTIR spectroscopy, XRD diffraction, TG and DTG analysis, surface analysis and Hg porosimetry. The adsorption experimental data points have been fitted to the Freundlich equation in order to calculate the adsorption capacities (K(f)) of the samples; K(f) values range from 468 mgkg(-1) for the K-110 sample up to 2291 mgkg(-1) for the K-600 sample. The values obtained for the removal efficiency (R), (percentage of pesticide removed), ranged from 48% for K-110 up to 78% for K-600. The adsorption experiments showed that the stronger heat treatment, the most effective adsorption of atrazine, so, as this type of clay is relatively plentiful, these activated samples might be used in order to remove this pesticide from water.     

The three-year monitoring of 18 elements in five edible mushroom species collected from an old orchard

Abstract

The content of Al, As, Be, Cd, Ca, Cr, Co, Cu, Fe, Pb, Li, Mg, Mn, Ni, Rb, Se, Sr, and Zn in fruiting bodies of edible mushrooms Calocybe gambosa, Entoloma clypeatum, Entoloma saepium, Xerocomellus chrysenteron, and Amanita rubescens growing in an orchard planted with fruit trees and situated close to a high-grown forest was studied during years 2016–2018. A. rubescens showed the highest potential of the element accumulation with bioconcentration factors of 48.5, 16.2, 7.80, 6.53, 1.75, and 1.68 obtained for Rb, Cd, Cu, Zn, Sr, and Mg, respectively. Both Entoloma species accumulated the elements similarly with bioconcentration factors >1.0 obtained for Rb, Cu, Cd, and Mg. Bioconcentration factors <0.05 were obtained for Al, Cr, Fe, and Pb in all studied species. The contents of beryllium (<0.1?mg/kg dry matter) were always the lowest among the studied elements. The contents of some elements of studied mushroom species significantly fluctuated over the years. Despite the fact that some studied elements (As, Be, Cd, Pb, Ni) are considerably toxic for humans, the pronounced effect on health is not expected if the studied mushroom species are consumed occasionally and do not represent the main component of the diet.     

Photocatalytic degradation of formaldehyde containing wastewater from veterinarian laboratories

The photocatalytic destruction of methanol, formaline (mixture of formaldehyde, methanol and water) and formaline wastes from the preservation of vertinarian physiologic samples has been attempted by two different processes, at high concentrations of reagents and by dossification of reagents, varying pH in both. Experiment evolution has been monitored by measuring the organic matter such as TOC and formaldehyde concentrations [H2CO]. Also, methanol and methanol-formaldehyde interactions with the TiO2 surface have been analysed by FTIR spectroscopy. Results indicate that at high concentrations the catalyst surfacial alterations given by methoxy, formates or carbonates, according to the pH of the sample can profoundly affect catalyst behaviour. It has been established that reagent dossification is advantageous for enhancing photonic efficiency as it minimizes the adsorbate presence that hampers the photocatalytic process.     

Vegetation of the selected forest stands and land use in the Carpathian Mountains

Within the framework of the project "Effects of forest health on biodiversity with emphasis on air pollution in the Carpathian Mountains" 26 permanent study sites were established in the vicinity of the ozone monitoring sites. The study sites were located on the NW-SE transect through the Western (12 sites), Eastern (11 sites) and Southern (3 sites) Carpathians in forest ecosystems typical of each area. Some of the forest monitoring sites were located in national parks, biosphere reserves and areas of protected landscape. Each permanent site of 0.7 ha area consisted of 5 small 500m(2) circular plots, arranged in the form of a cross, i.e. four placed on the cardinal points (N, E, S, W) and one in the center. Phytosociological records were done twice during the 1998 growing season using the Braun-Blanquet's method. The study sites represented various types of forest: Picea abies stands (8), beech (Fagus sylvatica) stands (10), fir (Abies alba) stands (2) and mixed beech-fir, spruce-fir and beech-spruce stands (6). Age of most stands was 80-100 years. Degree of crown damage varied greatly between sites, a percentage of damaged trees decrease in Carpathians from West to East. It corresponds well with the O(3) level in these areas. Typical damage by O(3) in herb layer species in several Carpathian sites were found. Land-use map for the entire Carpathian Mountains and two detailed land use maps for Tatras (Western Carpathians) and Retezat (Southern Carpathians) are presented. A little more than half of the Carpathian territory is forested. The most densely forested are Eastern Carpathians, while the most sparsely Western Carpathians. Arable lands occupy 22.6% of the Carpathians, pastures and meadows 6.2%, water bodies 1.9%, and build up areas several percent. In the highest elevation of the Carpathians alpine meadows (11.3%) and rocks (3.5%) are distributed.     

Influence of water hardening of the chorion on cadmium accumulation in medaka (Oryzias latipes) eggs

This report describes a study in which in vitro fertilization methods were used to expose medaka (Oryzias latipes) eggs to cadmium (Cd(2+)). This approach was applied to address the differential sensitivity and cumulative potential of Cd(2+) when exposure was initiated early (before fertilization and water hardening of the chorion) versus later during embryo development (i.e., well after the chorion has undergone water hardening). Following range finding exposures (2.5, 10, 20, 40 or 80 mg/l) under artificially controlled experimental procedures, results from hatching success and embryo malformations showed the earlier exposure interval more sensitive than the assay involving only the embryonated egg. Subsequent accumulation studies have shown that the exposure initiated before fertilization apparently led to more Cd(2+) deposition in the chorion compared to the exposure during embryonated stages of the eggs. Similarly, values for total Cd(2+) indicated higher concentrations in those eggs exposed prior to--and during--water hardening. Results suggest an alteration of the properties of the zona radiata in the early-stage eggs, making it more permeable to the potential exit or entrance of waterborne agents even after water hardening. Ongoing studies must now address the development of more realistic exposure conditions of the gametes by using incubation media with osmolarities similar to surface waters, and by shortening duration for gamete exposure. Also, sensitive methods to localize Cd(2+) and to delineate the transfer from the chorion to the embryo are needed.     

Large-scale spatial variation in mercury concentrations in cattle in NW Spain

Mercury (Hg) is a highly toxic environmental contaminant and man-made emissions account for between a quarter and a third of total atmospheric levels. Point discharges, particularly coal-burning power stations, are major sources of atmospheric Hg and can result in marked spatial variation in mercury deposition and subsequent uptake by biota. The aims of this study were to quantify the extent to which major point and diffuse sources of atmospheric Hg emissions affected accumulation of Hg by biota throughout Galicia and Asturias, two of the major regions in northwest Spain. We did this by relating renal Hg concentrations in locally reared cattle (n=284) to the proximity of animals to point and diffuse sources of Hg emissions. Mercury residues in calf kidneys ranged between non-detected and 89.4 g/kg wet weight. Point discharges from coal-fired power plants in Galicia had the most dominant impact on Hg accumulation by calves in Galicia, affecting animals throughout the region and explaining some two-thirds of the variation in renal residues between animals located directly downwind from the plants. The effects of more diffuse emission sources on Hg accumulation in calves were not distinguishable in Galicia but were detected in cattle from neighbouring Asturias. The impact of both point and diffuse sources in elevating environmental levels of bioavailable Hg and subsequent accumulation by cattle extended to approximately 140-200 km downwind from source.     

Greening of arid cities by residual water reuse: a multidisciplinary project in northern Chile

This paper describes a project in northern Chile aimed to promote the development of appropriate green areas and gardens for arid regions under prevalent conditions of shortage of water and high salt content in soil and water. Field studies were conducted to test the suitability of selected salt-tolerant native and introduced plants for ornamental use. Plant growth, water and soil quality, marine spray, climate, wastewater treatment and irrigation operating problems were the subject of specific studies and discussion.     

Impact of wildfires on the air quality of Mexico City, 1992-1999

Wildfires in Mexico increased in 1998, compared to information for the last 6 years. The average number of wildfires in the Mexico City Metropolitan Area (MCMA) for this year (1998) were 58% (1916 events) more events than the 1992-1997 (average cases 1217 events). Mexico City affected area corresponds to 1.3% of the national affected area. The purpose of this paper is to evaluate the impact on the particles air quality due to the wildfire emissions at the MCMA and surrounding areas. Using the corresponding US EPA emission factors for wildfires, the tons of particulate matter, nitrogen oxides, carbon monoxide, and total hydrocarbons emitted by this source for the MCMA case were obtained. The calculated emissions during wildfires were correlated with the levels of particles present in the atmosphere. A comparison of the concentration levels of particles, both as PM10 as well as TSP, were made for the years 1992-1998, during wet and dry season, being March, April, and May the critical months due to the presence of wildfires. A good correlation is observed between particulate wildfire emissions and particulate air quality, being stronger for TSP. A clear impact on the particles air quality due to the increase of wildfires in 1998, is observed when this year is compared with 1997, presenting an increment of 200-300% for some monitoring stations.