武汉市秋季PM2.5中硫酸盐、硝酸盐理化特征及影响因素

为了解武汉市秋季PM_(2.5)中硫酸盐、硝酸盐理化特征,2016年9—11月利用热还原法在线连续监测分析系统对此进行了采样分析,并同步收集气象因子和离子色谱方法监测结果。结果表明,硫酸盐、硝酸盐的热还原分析方法与离子色谱法的相关系数分别为0.88、0.94;PM_(2.5)中硫酸盐、硝酸盐的水溶性部分占比达92.5%,难溶性部分为7.5%;空气质量为优、良和轻度污染时,硫酸盐、硝酸盐与PM_(2.5)的占比分别为45%、42%、45%;硫酸盐、硝酸盐在降水日和非降水日平均质量浓度分别为(19.6±18.5)μg/m~3和(31.0±9.1)μg/m~3;硝酸盐与硫酸盐的质量比为1.1,高于国内其他城市,与武汉市机动车保有量大幅增加有关。     

300MW燃煤锅炉机组超细颗粒聚并器的实验研究

为了解决燃煤锅炉烟气中超细颗粒难以脱除的问题,基于流体动力学原理设计了一种超细颗粒聚并器,并在300 MW燃煤锅炉机组电除尘器的前置烟道中进行了实验研究。结果表明,聚并器内部存在超细颗粒之间以及超细颗粒与大颗粒之间的相互聚集行为,从而使超细颗粒数量显著减少。例如,对于粒径在2.65和10.48μm以下的颗粒,其体积比例在聚并器出口分别减少了56.7%和62.3%,在电除尘器出口的粉尘浓度减少了26.34 mg/Nm3,这表明,基于流体动力学原理的聚并器对超细颗粒的聚并作用明显,具有良好的应用前景。     

210m钢筋混凝土烟囱控制爆破拆除数值模拟研究

通过采用LS-DYNA动力学有限元程序,模拟210 m钢筋混凝土烟囱的控制爆破拆除倒塌过程。采用数值模拟方法,不仅可以对控制爆破拆除工程中构筑物倾倒、破坏的重要影响因素进行分析,对有关理论研究结果的正确性和有效性进行验证,还能优化爆破拆除方案、预测实际爆破拆除效果,提高爆破拆除设计与施工的经济性、可靠性和安全性。     

综合管廊内火灾自动报警探测器实验研究

为了能够有效提升综合管廊内火灾自动报警系统的准确性和可靠性,本文采用火灾实体试验的方法,通过对各类型火灾自动报警探测器响应时间的情况进行分析和比较,研究综合管廊电力舱内常用探测器的性能。研究结果表明:接触式缆式线型感温火灾探测器可以较早的探测到电缆温度异常变化的现象,可用于早期预警。点型感烟探测器对烟粒子浓度较为敏感,可用于综合管廊电力舱室的空间探测。分布式光纤型感温火灾探测器对明火温度的变化较为敏感,作为空间型的火灾探测器比较可靠。     

深部煤层钻屑粒度随钻进深度分布规律

为了研究煤层钻屑粒度随钻进深度分布规律，选取具有冲击危险性的平煤八矿己15煤作为研究对象，采取钻屑量测试和孔口瓦斯浓度监测，通过筛分实验煤样并应用Rosin Rammler分布模型，探究了钻屑粒度和钻屑量大小随孔深变化关系，分析不同点钻屑粒度分布特征。结果表明:小于0.075 mm钻屑粒度分布随孔深变化与钻屑量变化规律相吻合；不同钻孔随深度变化分别对应不同Rosin Rammler分布函数，随着应力过渡越平缓，粒径分布宽度系数n值越小，煤体应力越大粒径相关系数D越大；不同范围钻屑粒度占比大小也会影响钻屑量大小；在钻屑量较大时，孔口瓦斯体积分数会出现增高现象。通过对钻屑粒度分布规律分析，更好地了解深部煤体应力分布，有助于冲击危险的预警。     

贵阳市不同粒级地表灰尘中As、Ni水平及权重

根据贵阳市城区土地利用的情况,在不同功能区地表采集灰尘样品,分析As、Ni含量及变异规律。结果表明:贵阳市地表灰尘As、Ni含量分别为17.4mg/kg和50.0mg/kg。工业区地表灰尘中As、Ni含量最高,商贸区和校园等区域As、Ni水平较低。贵阳市地表灰尘中不同颗粒物的质量百分比大小为细颗粒(<105μm)>中等颗粒(105～250μm)>粗颗粒(250～425μm)。As在不同粒径灰尘中含量差别不大,Ni在不同粒径灰尘中含量随粒径增加而降低。细颗粒对灰尘As、Ni的贡献分别为42%和47%。除垃圾站外,贵阳市各功能区地表灰尘不同粒径颗粒物百分比随粒径增大而减小,其中交通区地表灰尘细颗粒所占比例最大。垃圾站地表灰尘中不同粒径颗粒百分比则随粒径增大而增大,As、Ni在垃圾站地表灰尘中颗粒物贡献为中等颗粒>粗颗粒>细颗粒,其余功能区不同粒径颗粒物的贡献基本为细颗粒大于粗颗粒。     

灰霾天气成因危害及控制治理

随着经济社会发展、城市迅速扩大和城市化进程加快,大气气溶胶污染日趋严重,由气溶胶颗粒物造成能见度恶化事件越来越多,灰霾天气已成为一种常见环境灾害污染事件。简要概述了灰霾天气定义分级、分布特征与雾霾比较,深入研究了灰霾天气形成原因、影响因素与存在危害,系统探讨了灰霾天气控制措施、监测方法与治理对策。指出在现有灰霾天气成因危害及控制治理状况下,加强理念宣贯,建立预报预警,开展PM2.5防治,推进城区绿化,科学布设规划,可有效解决中国资源节约型、环境友好型、生态文明型可持续发展过程中所面临灰霾天气防控治理问题。     

邻菲罗啉对蒙脱石吸附镍离子性能影响

利用镍离子能与邻菲罗啉反应生成螯合物的性质,研究了加与未加邻菲罗啉条件下,蒙脱石对金属镍离子的吸附行为,考察了镍离子浓度、吸附时间、温度和溶液pH值等因素对吸附性能的影响.结果表明:加入邻菲罗啉后,蒙脱石对镍的螯合离子的吸附量明显增大;吸附平衡时间约为120min;蒙脱石对[Ni(phen)n]2+的吸附性基本不受pH值的影响.动力学研究表明该吸附过程符合准二级反应动力学模型,吸附量随温度升高而增大.二级动力学参数证明加入邻菲罗啉可显著提高蒙脱石对Ni2+的吸附性.蒙脱石对简单Ni2+的吸附符合Langmuir的单层吸附等温式;而蒙脱石对镍的螯合离子的吸附则符合Freundlich等温式.蒙脱石对Ni2+和[Ni(phen)n]2+的吸附均为自发、吸热和更无序的;XRD及FTIR研究表明,蒙脱石对[Ni(phen)n]2+的吸附以层间的物理吸附为主.     

Investigation of the hydrodynamic behavior of diatom aggregates using particle image velocimetry

The hydrodynamic behavior of diatom aggregates has a significant influence on the interactions and flocculation kinetics of algae. However, characterization of the hydrodynamics of diatoms and diatom aggregates in water is rather difficult. In this laboratory study, an advanced visualization technique in particle image velocimetry (PIV) was employed to investigate the hydrodynamic properties of settling diatom aggregates. The experiments were conducted in a settling column filled with a suspension of fluorescent polymeric beads as seed tracers. A laser light sheet was generated by the PIV setup to illuminate a thin vertical planar region in the settling column, while the motions of particles were recorded by a high speed charge-coupled device (CCD) camera. This technique was able to capture the trajectories of the tracers when a diatom aggregate settled through the tracer suspension. The PIV results indicated directly the curvilinear feature of the streamlines around diatom aggregates. The rectilinear collision model largely overestimated the collision areas of the settling particles. Algae aggregates appeared to be highly porous and fractal, which allowed streamlines to penetrate into the aggregate interior. The diatom aggregates have a fluid collection efficiency of 10%-40%. The permeable feature of aggregates can significantly enhance the collisions and flocculation between the aggregates and other small particles including algal cells in water.     

Ultrafine particle emission characteristics of diesel engine by on-board and test bench measurement

This study investigated the emission characteristics of ultrafine particles based on test bench and on-board measurements. The bench test results showed the ultrafine particle number concentration of the diesel engine to be in the range of (0.56-8.35) × 10⁸ cm^-3. The on-board measurement results illustrated that the ultrafine particles were strongly correlated with changes in real-world driving cycles. The particle number concentration was down to 2.0 × 10⁶ cm^-3 and 2.7 × 10⁷ cm^-3 under decelerating and idling operations and as high as 5.0 × 10⁸ cm^-3 under accelerating operation. It was also indicated that the particle number measured by the two methods increased with the growth of engine load at each engine speed in both cases. The particle number presented a "U" shaped distribution with changing speed at high engine load conditions, which implies that the particle number will reach its lowest level at medium engine speeds. The particle sizes of both measurements showed single mode distributions. The peak of particle size was located at about 50-80 nm in the accumulation mode particle range. Nucleation mode particles will significantly increase at low engine load operations like idling and decelerating caused by the high concentration of unburned organic compounds.