Experimental study on explosion inhibition by heptafluoropropane and its synergy with inert gas

The inhibition effect of heptafluoropropane (CF₃CHFCF₃) on methane explosions under different inhibitor concentrations in a closed vessel was studied. A high-speed camera and a pressure sensor were adopted respectively to record flame propagation characteristics and pressure data. Results indicate that the relationship between flame propagation and pressure rising was correlated. As the equivalent ratio (ϕ)≤1, the pressure presented a trend of rising firstly and then decreasing with increasing CF₃CHFCF₃ concentration, and it was found that there existed a critical concentration for pressure decrease. As ϕ > 1, the pressure exhibited a decreasing trend. Although the pressure appeared to seemingly increase, the moment that the pressure began to rise (t_rise) and the moment that the maximum explosion overpressure appeared (t_Pmax) were obviously delayed. The average rate of pressure rise ((dP/dt)_ave) was decreased as the concentration of CF3CHFCF3 increased. It indicates that CF₃CHFCF₃ can effectively reduce the explosion reaction rate. The critical concentration of CF₃CHFCF₃ for complete inhibition was determined. Meanwhile, the synergy of CF₃CHFCF₃-inert gas can improve the inhibition effect. Compared with CF₃CHFCF₃–N₂, the synergy of CF₃CHFCF₃–CO₂ presented a better inhibition effect, and the inhibition effect was increased with increasing inert gas concentration. And the mechanisms of physical and chemical effects on explosion inhibition were analyzed.     

Numerical simulation of far-field blast loads arising from large TNT equivalent explosives

Large TNT equivalent explosions usually arise from accidents occurring during the transportation, storage, and manufacturing of chemicals relevant to process industries. The blast wave generated by the explosion will spread and interact with the surrounding factories and storehouses, damaging the building structures within several kilometers and causing significant casualties and property losses. This study aims to develop an efficient numerical simulation method to predict blast loads to estimate the consequences of accidents involving far-field free air bursts or surface burst explosions. Before its interaction with the interested target, a blast wave is generated in the numerical model by specifying the initial and boundary conditions of the disturbed air. Based on empirical data of incident overpressure, an explicit formula to calculate the air particle velocity is derived from the governing equations of a perfect inviscid gas. A simplified path line method is proposed to calculate the air density. The proposed method is applied to the LS-DYNA CESE solver to simulate the blast loads on building structures in the far field. Validations against empirical data and experiments indicate that the proposed method is sufficiently accurate for engineering applications and, through a case study, presents a more efficient performance than the LOAD_BLAST_ENHANCED (LBE) and mapping methods.     

Experimental and theoretical investigation of dry-water containing phosphoric acid for new fire suppressant

To overcome the shortcomings of phosphorus-containing compounds (PCCs, not widely used) in fire suppression, the dry water powder containing phosphoric acid was analyzed for a new fire suppressant (SiO₂-P). First, the fine conditions (solid-to-liquid ratio, stirring time and stirring speed) were determined to prepare the new powder. The particle size distributions and XPS of SiO₂-P powder were analyzed. The TG tests were conducted to study the decomposition of powder, and there was a major decomposition peak. Second, the extinguishing time of SiO₂-P powder was tested, which showed that the SiO₂-P powder containing phosphorus species could significantly improve the fire suppression ability. In addition, the kinetic parameters of powder decomposition reaction were determined by genetic algorithm based on TG results. Last, based on the decomposition products and kinetic parameters, the burning velocity and mass fraction of free radicals of CH₄/air flame with SiO₂-P powder addition were studied theoretically. The results indicated that SiO₂-P powder had great ability of reducing the burning velocity and scavenging free radicals. Furthermore, the suppression effects were analyzed, which indicated that the cooperation of H₂O and P suppression effect dominated the suppression mechanism and resulted in the good suppression efficiency.     

常州市裸露地面风蚀扬尘排放清单及分布特征研究

以2014年为基准年,以常州市行政边界为研究区域,利用卫星遥感解译的土地利用类型和裸土面积信息,并通过国土、气象等部门提供的土壤类型、气象因子等相关资料获取本地化因子和参数,估算常州市行政区域内裸露地面土壤扬尘中颗粒物的年排放量。结果表明:常州市裸露地面主要分布在金坛市、溧阳市和武进区,市中心区域最少,裸露土地利用类型主要为农田、滩涂、裸露山体、荒地及未硬化或未绿化的空地等;2014年常州市行政区域内裸露地面风蚀扬尘中TSP、PM 10、PM 2.5的年排放量分别为62.66 t、5.63 t、0.24 t,其中,金坛市土壤起尘量最大,其次为武进区,再次为新北区、溧阳市,市中心区域土壤扬尘最少。     

柱型水力旋流器对硅切割废砂浆分离性能的研究

为了研究废砂浆中碳化硅粉和硅粉的分离情况,选用混合模型对柱型水力旋流器多相流流场进行数值模拟。模拟结果表明:柱型水力旋流器的分离效率与入口速度、进口浓度等因素有关,并分析出一定条件下当主、次相的入口速度均为1.1m/s时颗粒分离效果较好,分离效率较高,实验检测分离性能较好,为进一步实验研究提供一定的指导。     

Dry deposition velocity of total suspended particles and meteorological influence in four locations in Guangzhou, China

Dry deposition velocity of total suspended particles (TSP) is an effective parameter that describes the speed of atmospheric particulate matter deposit to the natural surface. It is also an important indicator to the capacity of atmosphere self-depuration. However, the spatial and temporal variations in dry deposition velocity of TSP at different urban landscapes and the relationship between dry deposition velocity and the meteorological parameters are subject to large uncertainties. We concurrently investigated this relationship at four different landscapes of Guangzhou, from October to December of 2009. The result of the average dry deposition velocity is (1.49 ± 0.77), (1.44 ± 0.77), (1.13 ± 0.53) and (1.82 ± 0.82) cm/sec for urban commercial landscape, urban forest landscape, urban residential landscape and country landscape, respectively. This spatial variation can be explained by the difference of both particle size composition of TSP and meteorological parameters of sampling sites. Dry deposition velocity of TSP has a positive correlation with wind speed, and a negative correlation with temperature and relative humidity. Wind speed is the strongest factor that affects the magnitude of TSP dry deposition velocity, and the temperature is another considerable strong meteorological factor.We also find out that the relative humidity brings less impact, especially during the dry season. It is thus implied that the current global warming and urban heat island effect may lead to correlative changes in TSP dry deposition velocity, especially in the urban areas.     

采用体积信息熵表征颗粒污泥系统稳定性及其稳定机制

SBR反应器中培养自养硝化颗粒污泥,在絮体转化为颗粒过程中,颗粒的体积信息熵从2.05(27 d,初见颗粒)降低为1.85(95 d),熵值降低的主要动力来自于松散的絮体在较快沉速选择压条件下被淘洗出系统.当絮体被淘洗出系统即完成颗粒化过程,在129 d时测得系统中颗粒沉速分布的中位数为6.27 m.h-1,因此颗粒体积熵值的变化不再受沉速选择压(6m.h-1)的控制.颗粒的粒径、沉速及体积熵值分布均呈现周期性变化,其中信息熵的均值为2.16,最小值为1.79,最大值为2.63.在这种周期性变化过程中,系统总是表现为粒径均值先增大后减小.熵值的波动的驱动力来自于颗粒的破碎与破碎体的成长,体积分布信息熵的大小可以很好地表征系统的稳定性及其稳定机制.     

A~2/O工艺中好氧污泥絮体的分形结构与理化特征分析

采用图像法和沉降柱法分别研究了A2/O工艺中好氧污泥絮体的形貌、粒度分布、低维分形维数和沉降速率、有效密度、空隙率以及质量分形维数,并尝试探讨了上述相关性质与这些污泥宏观操作性质(沉降、压缩、脱水和稳定性)相关的各种理化指标以及胞外高分子物质(EPS)的含量之间的变化关系.结果表明,污泥絮体呈现不规则的形貌,表面具有空隙.其有效密度一般随着其粒径的增加而降低,而空隙率和沉降速率却呈现与有效密度相反的变化趋势,这些均表明了污泥絮体的分形结构的存在.2次所采集的污泥絮体的中位直径分别为248.81、332.86μm,有效密度的平均值分别为0.0040、0.0072g·cm-3,自由沉降速率的平均值分别为2.67、4.79mm·s-1,空隙率的平均值分别为0.94、0.89,一维分形维数分别为1.03、1.19,二维分形维数分别为1.64、1.84,采用基于Logan经验公式的有效密度-最大直径的双对数关系确定的质量分形维数分别为1.74、2.29.尽管第2次所采集的污泥絮体较为密实,但其表面粗糙程度却比第1次的低.此外,研究中发现絮凝能力较高或负电荷较高的A2/O好氧污泥絮体具有高的SVI和ZSV值;分形维数较低...     

A2/O工艺中好氧污泥絮体的分形结构与理化特征分析

采用图像法和沉降柱法分别研究了A²/O工艺中好氧污泥絮体的形貌、粒度分布、低维分形维数和沉降速率、有效密度、空隙率以及质量分形维数,并尝试探讨了上述相关性质与这些污泥宏观操作性质(沉降、压缩、脱水和稳定性)相关的各种理化指标以及胞外高分子物质(EPS)的含量之间的变化关系.结果表明,污泥絮体呈现不规则的形貌,表面具有空隙.其有效密度一般随着其粒径的增加而降低,而空隙率和沉降速率却呈现与有效密度相反的变化趋势,这些均表明了污泥絮体的分形结构的存在.2次所采集的污泥絮体的中位直径分别为248.81、 332.86 μm,有效密度的平均值分别为0.004 0、 0.007 2 g·cm^-3,自由沉降速率的平均值分别为2.67、 4.79　mm·s^-1,空隙率的平均值分别为0.94、 0.89,一维分形维数分别为1.03、 1.19,二维分形维数分别为1.64、 1.84,采用基于Logan经验公式的有效密度-最大直径的双对数关系确定的质量分形维数分别为1.74、 2.29.尽管第2次所采集的污泥絮体较为密实,但其表面粗糙程度却比第1次的低.此外,研究中发现絮凝能力较高或负电荷较高的A²/O好氧污泥絮体具有高的SVI和ZSV值;分形维数较低的污泥具有高的剪切敏感性和低絮体强度,相应的污泥稳定性低;EPS总量高的污泥脱水性能差,EPS中蛋白质含量高的污泥其表面电荷也较高.     

不同出口结构旋流板分离器内流场的数值模拟

基于Fluent软件,采用雷诺应力（RSM）湍流模型对不同出口结构分离器内气相旋流流场进行了数值模拟。模拟结果表明：分离器出口角度Ф变化对流场的影响显著,出口直径H变化对流场的影响甚微;有出口装置分离器内的切向速度均有所增加,最大切向速度向轴心方向移动。