非柔性连接石化储罐配管温差应力分析与对策

储罐配管在温差作用下产生热位移会导致管壁产生热应力，未采用柔性连接的配管由于热应力集中作用可能发生破漏。针对与石油化工储罐非柔性连接的配管的安全问题，应用ANSYS有限元分析软件模拟计算石化企业典型配管的热应力分布；根据不同类型配管的分析结果，提出了工程技术与管理方面的针对性安全措施。研究结果表明:温差效应对石化储罐配管热应力影响显著，随内外温差的增加，配管应力集中的区域增大，最大热应力值增大；补偿措施能够改善配管的柔性，降低配管应力；约束载荷限制配管热膨胀从而增大配管应力；三通管是多根配管接合的区域，这种复杂管道交汇处会形成明显应力集中。研究结果对于提高石油化工非柔性连接配管安全性有一定的指导意义。     

呼吸效应对矿井封闭火区氧浓度的影响分析

为避免因火区封闭导致重大安全事故发生，通过采集某矿井1 d内3个不同监测点的大气压力变化情况，建立大气压力波动模型并分析计算，同时建立火区内外压差100，750 Pa情形下的氧浓度模型进而获得火区内侧氧气浓度因呼吸效应，在不同压差、体积大小火区、风阻、瓦斯涌出量、封闭时刻等多因素耦合影响下随时间的变化规律，以评估火区危险性。研究结果表明:井下大气随地面大气周期波动，封闭火区内、外侧之间的气压差因外界大气波动呈现16 h的余弦波动和8 h的线性波动周期变化；密闭质量好的火区具有更好地抗干扰性，内侧氧浓度的降低主要依靠瓦斯稀释；密闭质量差的火区，内侧氧浓度易受到火区涌出瓦斯、外界涌入大气双重影响；火区氧浓度在2%~12%之间波动，以至火区存在发生瓦斯爆炸的可能性；火区内外压差较大时，氧浓度波动变化幅度更大，危险作用持续时间更长。结合火区氧浓度波动模型，可有效地对矿井火区采取安全的防范措施，避免瓦斯爆炸事故发生。     

不同类型活性炭处理废水中重金属离子的研究进展

重金属对人体的显著毒性和难降解的特性,使重金属水体污染成为全球性关注的环境问题。本文综述了重金属废水的危害、来源及常用处理方法,比较了不同类型活性炭处理废水中重金属离子的差异,阐述了不同类型活性炭处理技术的优势和特点,并对今后的重金属废水处理技术研究方向进行了展望。     

Experimental research of LNG accidental underwater release and combustion behavior

Evaluating potential hazards caused by accidental LNG release from underwater pipelines or vessels is a significant consideration in marine transportation safety. The aim of this study was to capture the dynamic behavior of LNG jet released under water and to analyze its vapor dispersion characteristics and combustion characteristics on the water surface during different release scenarios. Controlled experiments were conducted where LNG was jet released from a cryogenic storage tank. The dynamic process of LNG being jet released from orifices of different sizes and shapes, as well as the rising plume structure, were captured by a high-speed camera. The leakage flow rate and pipeline pressure were recorded by a flow meter and pressure gauge, respectively. The concentration distribution that emanated from the water surface was measured utilizing methane sensors in different positions with various wind speeds. The flame combustion characteristics of LNG vapor clouds, which immediately ignited upon the enclosed water tank, were also recorded. Additionally, the mass burning rate of the flame on the water surface was evaluated, and a new correlation between the ratio of flame length and width was established. The results indicated a large dimensionless heat release rate (Q*) and a continuous release flow rate in a limited burning area. This study could provide greater understanding of the mechanisms of LNG release and combustion behavior under water.     

2013-2017年京津冀区域PM2.5浓度变化特征

利用2013-2017年京津冀区域13个城市PM_2.5监测数据，综合探讨了该区域PM_2.5浓度的时空变化特征。结果表明：京津冀区域PM_2.5污染整体较重，但治理成效显著，2013-2017年区域PM_2.5年均质量浓度分别为106、93、77、71、64 μg/m³，完成《大气污染防治行动计划》PM_2.5浓度下降25%左右的目标；13个城市PM_2.5浓度各百分位数总体呈现下降趋势，且随百分位数增大而下降速率加大，PM_2.5年均质量浓度平均每年下降10.6 μg/m³，污染严重的太行山沿线城市邢台、石家庄、邯郸3个城市平均每年分别下降20.3、16.1、13.9 μg/m³；京津冀区域PM_2.5重度污染天数比例分别为19.9%、16.6%、9.5%、9.0%、7.0%，呈下降趋势。2013-2017年京津冀区域PM_2.5平均质量浓度与非重度污染天相比升高19 μg/m³，PM_2.5重度污染天平均质量浓度较非重度污染天时高244.4%。     

微波强化CWPO工艺CuO_x-CeO_2/GAC催化剂的制备及其对二甲亚砜的降解

以颗粒活性炭(GAC)为载体、铜为活性组分、铈为助剂组分、草酸钠为沉淀剂,采用浸渍焙烧法制得CuO_x-CeO_2/GAC催化剂。以H_2O_2为氧化剂,微波强化催化湿式过氧化氢氧化(CWPO)处理二甲亚砜(DMSO)初始质量浓度为1 000 mg/L的废水,处理3 min后DMSO去除率达93.8%。催化剂第7次使用时DMSO去除率仍保持在75%以上。初始废水pH在3~9范围内,DMSO去除率均在85%以上。助剂Ce的加入提高了催化剂表面活性组分的分散性和稳定性,使催化剂的活性稳定性和使用寿命显著提高。     

三维电极电Fenton氧化法处理染料废水

采用三维电极电Fenton氧化法处理实际染料废水,探究了染料废水处理效果的影响因素。实验结果表明：以钌铱镀层钛电极为阳极、不锈钢板为阴极、粉末活性炭为颗粒电极,在粉末活性炭投加量为2.0 g/L、电流密度为0.5 mA/mm²、极板间距为3 cm、pH为2.0、硫酸亚铁投加量为0.50 g/L的最优工艺条件下,反应2 h后COD、TOC、氨氮、色度的去除率达到最大,分别为62.80%、41.15%、42.48%和95.00%;粉末活性炭作为颗粒电极可使染料废水COD去除率提高18个百分点;重复使用10次的处理效果与第2次基本持平。     

Review: recent advances in biogas purifying technologies

Biomethane production through biogas upgrading is a promising renewable energy for some industries which could be part of the equilibrium needed with fossil fuels consumption to achieve a sustainable society. This paper presents a comprehensive list of biogas upgrading technologies focused on carbon dioxide removal as well as recent advances reported by researcher with wide expertise in this topic. Additionally, an extensive costs–performance comparison among the technologies studied is discussed. Among the different alternatives, chemical scrubbing stood out to achieve high biomethane purities while cryogenic technologies proved to be effective against methane losses. Regarding the different costs, water scrubbing and membrane separation seem to be the most affordable techniques.     

CeO2/TiO2纳米管催化剂脱硝性能研究

利用废气中本身含有的CO催化还原烟气中的NO_x,可以实现以废治废。采用TiO₂纳米管负载CeO₂,制备CeO₂/TiO₂纳米管催化剂,并对其进行了SEM表征及影响因素实验。实验结果表明：在n（Ce）∶n（Ti）=3∶7、焙烧温度500 ℃、焙烧时间3 h时制备的CeO₂/TiO₂纳米管催化剂形貌较好,表面颗粒分布相对均匀;反应温度400~600 ℃时NO脱除率达98%;该催化剂具有一定的抗氧性能;当n（SO₂）∶n（NO）=（1∶2）~（2∶1）时,NO脱除率仍然在95%以上。