Long term changes in atmospheric N and S throughfall deposition and effects on soil solution chemistry in a Scots pine forest in the Netherlands

In a Scots pine forest the throughfall deposition and the chemical composition of the soil solution was monitored since 1984. (Inter)national legislation measures led to a reduction of the deposition of nitrogen and sulphur. The deposition of sulphur has decreased by approximately 65%. The total mineral-nitrogen deposition has decreased by ca. 25%, which is mainly due to a reduction in ammonium-N deposition (−40%), since nitrate-N deposition has increased (+50%). The nitrogen concentration in the upper mineral soil solution at 10 cm depth has decreased, leading to an improved nutritional balance, which may result in improved tree vitality. In the drainage water at 90 cm depth the fluxes of NO₃⁻ and SO₄²⁻ have decreased, resulting in a reduced leeching of accompanying base cations, thus preserving nutrients in the ecosystem. It may take still several years, however, before this will meet the prerequisite of a sustainable ecosystem.     

Electroosmotic dewatering of dredged sediments: bench-scale investigation

The Indiana Harbor (Indiana, USA) has not been dredged since 1972 due to lack of a suitable disposal site for dredged sediment. As a result of this, over a million cubic yards of highly contaminated sediment has accumulated in the harbor. Recently, the United States Army Corps of Engineers (USACE) has selected a site for the confined disposal facility (CDF) and is in the process of designing it. Although dredging can be accomplished rapidly, the disposal in the CDF has to be done slowly to allow adequate time for consolidation to occur. The sediment possesses very high moisture content and very low hydraulic conductivity, which cause consolidation to occur slowly. Consolidation of the sediment is essential in order to achieve adequate shear strength of sediments and also to provide enough air space to accommodate the large amount of sediment that requires disposal. Currently, it has been estimated that if a one 3-foot (0.9-m) thick layer of sediment was disposed of at the CDF annually, it would take approximately 10 years to dispose of all the sediment that is to be dredged from the Indiana Harbor. This study investigated the feasibility of using an electroosmotic dewatering technology to accelerate dewatering and consolidation of sediment, thereby allowing more rapid disposal of sediment into the CDF. Electroosmotic dewatering essentially involves applying a small electric potential across the sediment layer, thereby inducing rapid flow as a result of physico-chemical and electrochemical processes. A series of bench-scale electrokinetic experiments were conducted on actual dredged sediment samples from the Indiana Harbor to investigate dewatering rates caused by gravity alone, dewatering rates caused by gravity and electric potential, and the effects of the addition of polymer flocculants on dewatering of the sediments. The results showed that electroosmotic dewatering under an applied electric potential of 1.0VDC/cm could increase the rate of dewatering and consolidation by an order of magnitude as compared to gravity drainage alone. Amending the sediment with polymers at low concentrations (0.5-1% by dry weight) will enhance this dewatering process; however, the optimal polymer concentration and the cost-effectiveness of using polymers should be investigated further.     

安全评价方法在危险废物处置环境风险评价中的应用探讨

对安全评价方法在危险废物处置建设项目环境风险评价中的运用进行初步探索。主要用"工艺过程风险因素分析表"对工艺过程潜在风险性识别;用蒙德法进行源项分析;用池火灾模型、蒸气云爆炸伤害模型对易燃、易爆物质的火灾、爆炸等重大事故后果进行计算,得出人员的伤亡半径和财产损失半径等参数,以便于判断风险的可接受水平。分析结果表明:采用安全评价方法对危险废物处置建设项目进行环境风险评价是适用的、可行的。     

焦化废水处理过程中固相物质的形成及处置方法评价

焦化废水处理过程中产生的焦油、污泥和结晶杂盐等固相物质,既有资源属性,又有污染特性,但目前缺乏基于能源、经济及环境影响方面的评估.本研究阐述了3类固相物质的形成机制,建立了质量当量计算及处置方法评价模型.以宝武集团韶关钢铁股份有限公司焦化厂（二期）焦化废水处理工程的A/O/H/O（厌氧/好氧/水解/好氧）流化床工艺作为考察对象,利用工程运行参数和水质统计数据进行固相物质的产量推算,结果发现,焦油、物化污泥、生物污泥（含水率为80%）和工业杂盐的产率分别为0.186、5.80、4.24和1.97 kg·m^-3.通过处置方法评价模型明确了焦油焚烧、污泥热解、结晶杂盐分盐提纯后工业应用是最佳处置方案,在60 m³·h^-1废水处理规模的固相物质处置过程中,每年约产生1177 MWh的能源,获得135.0万元的经济效益,排放627.0 t CO₂,表明能源回收、经济效益和环境影响的协同存在.     

纳米涂层/铝合金在不同pH值的海水溶液中的腐蚀行为研究

目的评价纳米涂层/铝合金在不同pH值海水溶液中的腐蚀行为。方法通过测试纳米涂层/铝合金试样在不同pH值海水溶液中的EIS值,分析试样阻抗谱图及Bode谱图的演化规律,建立不同EIS图谱的不同电极阻抗模型,并采用ZView软件解析涂层体系不同时期的电化学阻抗谱,获得涂层电阻的变化趋势,及不同pH值海水浸泡的纳米涂层体系腐蚀失效速度。结果随着浸泡时间的增加及pH值的降低,纳米涂层/铝合金体系腐蚀损伤失效速率在浸泡前期整体趋势增大,但中后期由于腐蚀产物逐渐堵塞了涂层的微孔,腐蚀介质向铝合金表面渗透的速率逐渐减小。结论 pH为2.0海水浸泡下的3涂层失效最快,其次是pH为4.0海水浸泡下的2涂层,最后为p H为6.0海水浸泡下的1涂层,该涂层体系应采用等效电路模型C进行拟合。     

固定污染源废气监测中有关问题的探讨

针对废气固定污染源监测中存在的一些疑难问题，从工况的确定、断面的选择、间断排放的监测时间、滤筒及过剩系数的影响等方面进行了探讨，提出了一些解决办法。     

总磷测定中两种稀释方法的对照

在过硫酸钾消解－钼蓝比色法测定总磷中，当显色液吸光值超出校准曲线范围时，进行了显色液稀释后再行测定的试验，试验结果与水样稀释重新消解[测定所得结果作统计检验，两者间无显著性差异，稀释倍数最大不宜超过4倍。     

新疆番茄酱企业生产废水处理利用方式探析

近年来,新疆番茄酱加工业得到了迅速发展,目前番茄酱的产销量已占全国的90%以上。与此同时，新疆番茄酱生产企业的废水排放量也大幅增加,大量未经处理的废水直接排放,已对当地的水环境构成严重的污染隐患。本文分析了新疆番茄酱企业生产废水的排放特征与目前排放出路的可行性,并结合新疆的自然地理条件及番茄酱企业的分布情况，着重探讨了土地处理这一适合新疆的废水利用方式,以期有利于新疆的环境保护和废水资源的循环利用。     

混凝沉淀用于铬鞣废液处理方法的探讨

对制革生产废水中的铬鞣废液的处理方法进行了探讨，通过投加处理效率高且费用低廉的混凝剂提高废水中铬的去除效率，并最终应用于实际工程中，取得了良好的效果。     

哈尔滨市生活垃圾处理产业化探讨

随着我国经济发展和人民生活水平的不断提高,城市垃圾产生量也不断增加,垃圾处理越来越受到人们的重视,垃圾处理产业也逐渐兴起.由于地区差异,工业发达程度和生活水平不同,不同的国家和地区有着不同的垃圾组成,相应的也采取不同的垃圾处理方法.哈尔滨市的生活垃圾处理现状具有一定的典型性,文章结合哈尔滨市实际情况,主要论述哈尔滨市生活垃圾的产量、特性及目前的处理状况,分析哈尔滨市生活垃圾问题的实质,对垃圾处理产业化存在的问题及其对策进行探讨,以期更好地促进生活垃圾处理步入产业化的发展轨道.