Measurement of respiration amount of white birch(Betula platyphylla) population in the mountainousregion of Beijing

Ｍｅａｓｕｒｅｍｅｎｔｏｆｒｅｓｐｉｒａｔｉｏｎａｍｏｕｎｔｏｆｗｈｉｔｅｂｉｒｃｈ（Ｂｅｔｕｌａｐｌａｔｙｐｈｙｌｌａ）ｐｏｐｕｌａｔｉｏｎｉｎｔｈｅｍｏｕｎｔａｉｎｏｕｓｒｅｇｉｏｎｏｆＢｅｉｊｉｎｇＦａｎｇＪｉｎｇｙｕｎ，ＷａｎｇＸｉａｏｋｅ（...     

大直径TA2卷焊坯制备工艺

此文介绍尺寸为φ1547×L900×δ30的大直径TA2卷焊坯的制备工艺。主要包括卷焊坯设计、展开下料的计算、卷圆工艺、焊接工艺等,可供同类材质圆筒件卷圆时参考。     

呼和浩特市不同粒径空气颗粒物中汞的分布规律

采用分级采样装置 ,于冬夏两季采集呼市三个不同功能区不同粒径空气颗粒物中的汞进行分析 ,结果表明 :呼市空气颗粒物中的汞含量冬季明显高于夏季 ;冬季空气颗粒物中的汞含量为居民区 >交通区 >对照区 ,夏季为交通区 >居民区 >对照区 ;空气中汞主要富集在可吸入粒子中。     

南京市城区气溶胶粒度分布特征

以九段串级式撞击采样器对南京市气溶胶进行采样测定。经统计分析发现，气溶胶呈双峰分布，粒度分布规律明显，峰值粒径在0.37μm-0.65μm和4．3μm-5.6μm之间，气溶胶浓度季节变化显著，秋季＞夏秋，秋季颗粒物中细粒子质量百分比较夏季的多，两季质量中位位直径分别为6．5μm,4,4μm，说明与季节变化密切相关。     

Effect of catalyzed diesel particulate filter and its catalyst loading on emission characteristics of a non-road diesel engine

In this study, the effects of a diesel oxidation catalyst (DOC) coupled with a catalyzed diesel particulate filter (CDPF) with different catalyst loadings on the power, fuel consumption, gaseous and particulate emissions from a non-road diesel engine were investigated. Results showed that the after-treatment had a negligible effect on the power and fuel consumption. The reduction effect of the DOC on the CO and hydrocarbon (HC) increased with the engine load. Further reductions occurred coupling with the CDPF. Increasing the catalyst loading resulted in a more significant reduction in the HC emissions than CO emissions. The DOC could increase the NO₂ proportion to 37.9%, and more NO₂ was produced when coupled with the CDPF below 250°C; above 250°C, more NO₂ was consumed. The after-treatment could reduce more than 99% of the particle number (PN) and 98% of the particle mass (PM). Further reductions in the PN and PM occurred with a higher CDPF catalyst loading. The DOC had a better reduction effect on the nucleation particles than the accumulation ones, but the trend reversed with the CDPF. The DOC shifted the particle size distribution (PSD) to larger particles with an accumulation particle proportion increasing from 13% to 20%, and the geometric mean diameter (GMD) increased from 18.2 to 26.0 nm. The trend reversed with the CDPF and the accumulation particle proportion declined to less than 10%. A lower catalyst loading on the CDPF led to a higher proportion of nucleation particles and a smaller GMD.     

水泥土搅拌桩的桩径分析

针对搅拌桩施工会引起周围土体的位移及产生很高的超静孔隙水压力的工程现象,首先分析了搅拌桩施工中固化剂的注入体积与膨胀压力、成桩直径的关系。结果表明,5%~10%的注入浆液的体积可以对周围土体产生1.8~3.0倍不排水抗剪强度的膨胀压力,成桩直径比搅拌叶片的名义直径大5%~10%。然后量测室内模型桩、现场搅拌桩的成桩直径,分析了注入浆液的体积与成桩直径的关系。结果表明,对于深度不太大的水泥土搅拌桩,有约45%的注入体积会通过上浮隆起的土体损失掉;大约5%的注入体积通过劈裂裂缝渗入到周围土体中;大约50%的注入体积会转化为成桩直径,使桩体膨胀5%~10%,即实测桩径比搅拌叶片的名义直径大5%~10%。     

垃圾填埋场微生物气溶胶粒径分布研究

为了了解垃圾填埋场微生物气溶胶粒径分布规律,在北京市某垃圾卫生填埋场填埋区、渗滤液处理区、生活区分别选定监测点,利用安德森六级微生物采样器,对填埋场空气微生物进行了系统的定点取样、测定和分析。研究结果表明，空气细菌粒径分布均为第Ⅰ级(>8.2 μm)最高,填埋区空气细菌粒径呈偏态分布,渗滤液处理区、生活区分别在第Ⅳ级和第Ⅲ级出现第2个峰值。携带细菌的可吸入微粒在渗滤液处理区比例最大。空气真菌与放线菌均在第Ⅳ级分布最高,携带真菌和放线菌的可吸入粒子的比例显著大于细菌(P<0.05)。填埋区不同作业时段空气微生物粒径在各级分布比例基本一致。填埋区细菌气溶胶中值直径为5.7 μm,渗滤液处理区为3.7 μm,生活区为5.3 μm，显著大于真菌气溶胶和放线菌气溶胶的中值直径(P<0.05)。     

畜禽养殖场空气中可培养抗生素耐药菌污染特点研究

畜禽养殖场被认为是空气环境中耐药基因和致病菌的重要来源.本研究对北京地区22个畜禽养殖场逸散细菌、四环素和红霉素耐药菌气溶胶的浓度进行检测,对其粒径分布和动力学粒径进行分析.结果表明,所调查的3种生物气溶胶(细菌、四环素耐药菌和红霉素耐药菌),在猪舍内浓度最高,牛舍内最低.蛋鸡舍内两种抗生素耐药菌气溶胶的浓度均低于肉鸡.本研究在蛋鸡和肉鸡舍外空气中检测到了四环素和红霉素耐药菌,所占丰度分别为8.81%、15.89%和23.19%、36.53%.不同养殖场舍内外细菌、四环素耐药菌和红霉素耐药菌气溶胶浓度的粒径分布特点存在差异.动力学粒径研究结果显示,4种动物舍内的四环素和红霉素耐药菌气溶胶主要沉降在人体的咽喉和支气管.本研究结果将为评价养殖场生物气溶胶对周边空气环境污染及人类健康造成的危害提供基础数据.     

活性滤料滤池气提系统影响因素研究

为了研究气量、水深和提砂管规格对活性滤料滤池提砂系统性能的影响,本实验以石英砂作为活性滤料滤池的提升介质,在恒定水头状态下,测量了不同管径下被提升的水和砂的体积和质量随压缩空气流量的变化.结果表明:随着气量的增大,提升系统的提砂量和提砂效率均呈先增大后减小的趋势;提砂管管径是最大提砂量的限制因素,但提升的砂水体积比与管径无关;相同气量条件下,单位空气提砂量与水深呈线性关系.因此,在活性滤料滤池提砂系统的设计应用过程中应选择合适的提砂管径,尽量增加浸水率,并注意控制气量以提升系统能效.     

Adsorption of lead on multi-walled carbon nanotubes with different outer diameters and oxygen contents: Kinetics, isotherms and thermodynamics

The effects of different outer diameters and surface oxygen contents on the adsorption of heavy metals onto six types of multi-walled carbon nanotubes (MWCNTs) were investigated in an aqueous solution and lead was chosen as a model metal ion. The results indicated that the percentage removal and adsorption capacity of lead remarkably increased with decreasing outer diameter due to larger specific surface area (SSA). The SSA-normalized maximum adsorption capacity (qm /SSA) and SSA-normalized adsorption coefficient (Kd /SSA) were strongly positively correlated with surface oxygen content, implying that lead adsorption onto MWCNTs significantly increases with the rise of oxygen content and decreases with decreasing SSA. The calculated thermodynamic parameters indicated that adsorption of lead on MWCNTs was endothermic and spontaneous. When the oxygen content of MWCNTs increased from 2.0% to 5.9%, the standard free energy (△ G0 ) became more negative, which implied that the oxygenated functional groups increased the adsorption affinity of MWCNTs for lead. Through calculation of enthalpy (△ H0 ), G0 and free energy of adsorption (Ea ), lead adsorption onto MWCNTs was recognized as a chemisorption process. The chemical interaction between lead and the phenolic groups of MWCNTs could be one of the main adsorption mechanisms due to highly positive correlations between the phenolic groups and K d /SSA or q m /SSA.