基于不同废污泥源的短程反硝化快速启动及稳定性

为探究不同废污泥源快速启动短程反硝化和实现稳定NO_2~--N积累的可行性,在3个完全相同的SBR反应器(S1、S2和S3)分别接种:实验室城市污水反硝化除磷系统排泥、城市污水厂剩余污泥及河涌底泥,比较其短程反硝化启动快慢和NO_2~--N积累特性,考察系统短程反硝化活性和NO_3~--N→NO_2~--N转化性能,并从微生物学角度分析反应器功能菌群特征.结果表明,在乙酸钠为唯一碳源、高碱度和适宜COD/NO_3~--N比进水条件下,3个SBR短程反硝化反应器在短时间内均能够成功启动,系统平均NO_3~--N→NO_2~--N转化率为S1 S2 S3(75. 92% 73. 36% 69. 90%).同时发现持续低温条件下S1和S2呈现不同程度的短程反硝化性能恶化趋势,但S3能够稳定维持良好NO_2~--N积累性能.微生物高通量测序表明,变形菌门和拟杆菌门居PD系统主导地位,3个短程反硝化反应器NO_2~--N积累关键功能菌属Thauera属丰度差异明显:S3 S1 S2(25. 09% 4. 71% 3. 60%),表明S3具备稳定高效的NO_2~--N积累性能,同时高丰度Thauera属可能是维持低温短程反硝化活性的重要原因.     

河岸过滤中氨氮的削减及其浓度对细菌与氨氧化微生物的影响

通过小试滤柱模拟河岸过滤,结合荧光定量PCR和高通量测序等手段研究了河岸过滤对氨氮的削减效能和进水氨氮浓度对细菌与氨氧化微生物的影响.结果表明,低浓度（0.2 mg·L^-1）氨氮未被削减,较高浓度（1.0 mg·L^-1和2.0 mg·L^-1）氨氮的削减率可达70%.进水处细菌丰度随氨氮浓度升高而增加,细菌群落组成随氨氮浓度升高发生规律性变化.出水处氨氧化古菌（Ammonia oxidizing archaea,AOA）丰度与氨氮浓度呈负相关,氨氧化细菌（Ammonia oxidizing bacteria,AOB）丰度与氨氮浓度无显著相关关系;进水处AOA-α多样性与氨氮浓度呈正相关,但AOB-α多样性与氨氮浓度呈负相关;进水处AOA群落组成受氨氮浓度影响,而进、出水处AOB群落组成均受氨氮浓度影响.可见,进水氨氮浓度会影响河岸过滤对氨氮的削减效能,还会影响细菌、氨氧化微生物的丰度及群落结构,AOB对氨氮浓度的变化比AOA更敏感.     

固定化微藻流化床反应器去除低碳污水中氨氮的潜力

以固定化微藻颗粒为原料,通过搭建流化床反应器强化微藻对氨氮（NH₄⁺-N）的去除,设计了藻种、污水上升流速、光周期和光照强度四组单一变量实验,系统地研究了不同条件下微藻去除NH₄⁺-N的能力.结果表明,当以固定化斜生栅藻为原料、污水上升流速为6.8m/h、光周期为8：16h和光照强度为4800Lux时,NH₄⁺-N去除效果最优（96.7%）.在最优操作条件下,探究了COD为200mg/L时微藻去除NH₄⁺-N的潜力,结果表明,当NH₄⁺-N初始浓度不高于50mg/L时,NH₄⁺-N去除率高于95%.本实验建立了一套半连续微藻流化床实验方法,该方法显著减弱了微藻在生物同化过程中对有机碳源的依赖性,为低COD条件下微藻生物脱氮工艺的设计提供了技术参考和理论基础.     

雨水管道沉积物中典型无机氮的干期粒径分布

以南京江北新区分流制雨水管道沉积物为研究对象,考察不同粒径沉积物中铵态氮（NH₃-N）和硝态氮（NO₃^--N）干期分布特征,分析其随干期长度的变化关系,并探讨沉积物理化性质及微生物菌群结构对NH₃-N和NO₃^--N干期分布的影响.结果表明：粒径≤0.075mm的沉积物中NH₃-N占比最高（交通区30.8%,商业区36.7%）;交通区粒径≤0.075mm的沉积物中NO₃^--N占比最高（33.0%）,而商业区粒径0.075~0.15mm沉积物中NO₃^--N占比最高（34.4%）;干期长度与交通区0.075~0.15mm粒径段的沉积物中NO₃^--N含量及商业区粒径≥0.3mm的沉积物中NH₃-N含量之间的相关性均最显著;雨水管道沉积物中NH₃-N和NO₃^--N的干期分布与O-H和N-H等官能团、表面极性和亲水性、微观形貌等有一定关联;交通区雨水管道沉积物中Gemmobacter等反硝化优势菌种（相对丰度总和为20.15%）对NO₃^--N干期分布影响更显著.     

Investigation to meet China II emission legislation for marine diesel engine with diesel methanol compound combustion technology

In order to reduce the pollutant emission and alleviate the pressure of petroleum resources shortage and greenhouse gas emission at the same time, the use of clean and renewable alternative fuel for marine engines is a promising option. In this study, a marine diesel engine, which was modified to run in diesel methanol compound combustion (DMCC) mode, was investigated. After the diesel injection parameters were calibrated, and combined with a sample after-treatment device DOC (diesel oxidation catalyst), the engine could meet the requirements of China II legislation. The overall MSP (methanol substitute percent) reached 54.1%. The value of each pollutant emission was much lower than that in China II emission legislation, and there was almost no methanol and formaldehyde emissions. When methanol was injected into the inlet manifold, the intake air temperature decreased a lot, as well as the exhaust gas temperature, which were beneficial to increase engine thermal efficiency and improve engine room environment. Compared with the engine running in pure diesel mode, when the engine ran in diesel/methanol dual fuel mode, the combustion phase was advanced, and the combustion duration became shorter. Therefore, the engine thermal efficiency increased, and fuel consumption decreased significantly.     

邻苯二甲酸二丁酯降解过程的单体同位素分析

研究对比了邻苯二甲酸二丁酯（DBP）在不同降解过程（水解、UV/H₂O₂光解、直接光解、过硫酸钾光氧化）中的碳、氢同位素组成变化、分馏特征及二维同位素（Δδ²H-Δδ¹³C）的相关性.水解反应中DBP分子产生了显著的碳同位素分馏,未发现氢同位素分馏,而且碳同位素富集因子ε_C为（-2.7±0.4）‰,表明DBP水解时发生C-O键断裂,氢原子不参与反应.而UV/H₂O₂光解和直接光解反应（pH值分别为2、7和10）中,DBP分子呈现了相似的二维同位素相关性Λ值[（9±2）~（11±2）],推测经历了相同的反应过程.过硫酸钾光氧化降解时,明显偏大的Λ值（31±3）说明反应可能发生C-H键断裂.结果表明：二维单体同位素分析（2D-CSIA）技术可以有效区分DBP的水解、光解、光氧化3种不同类型的降解过程,有助于分析其降解路径.     

A study on the interactions among several plant secondary compounds and aphids

The research, focused on the specific interactions among seven plant secondary compounds and aphids, was carried out and the preliminary results showed: (1) "T-typed tube method" was regarded as the best method compared with others designed to observe the interactions. (2) Cabbage aphid was able to be attracted by laurolene while it was not susceptible to α-pinene, β-pinene and diamylene. (3) Gossypol, a major secondary substance in cotton, was able to be implicated as feeding attractant to cotton aphid. (4) Rutin might be implicated repellent to cotton aphid.     

亚铵法制浆造纸厂中段废水处理技术分析研究

通过对采用两级气浮做预处理 ,生物硫化床串联接触氧化做深度处理的治理技术的分析研究 ,结合废水处理工程实例 ,说明了用两级串联气浮 +硫化床 +接触氧化工艺处理造纸中段水技术切实可靠 ,该治理工艺对处理亚铵法麦草制浆造纸中段废水有较强的针对性和可行性。     

A Global Overview of Atmospheric Acid Deposition Fluxes

This paper presents a summary of globalacid deposition flux data taken from a globalassessment report on acid deposition prepared forUNEP/WMO (Whelpdale and Kaiser, 1996). There is a largevariation in the spacial coverage and reliability ofmonitoring around the world. Many more stationsmeasure wet deposition than collect appropriate datafor estimating dry deposition. The widespread regionswith highest precipitation concentrations anddeposition fluxes of sulphate and nitrate coincideclosely with the regions of highest density ofSO₂ and NO_x precursor emissions occurringprimarily in the mid-latitude, northern hemispherebelt where a large fraction of the worlds fossilfuels is consumed. Organic acids in precipitation makea minor contribution to acidity (<20%) inindustrial regions, but in the rest of the world theyare of same order, or even exceed, inorganic acids.Less is known about dry deposition, but it appears topredominate near strong emission sources with wetdeposition predominating farther downwind. The molarratio of the N/S contribution to acidic deposition isclose to 1.0 over large areas of Europe and NorthAmerica, but is highly variable elsewhere, beinghighest in equatorial regions due to biomass burningand lowest near smelters and other large sources of SO₂.     

悬浮态TiO_2光催化降解苯系物的方法研究

以高压汞灯为光源 ,在TiO2 粉末悬浮体系内 ,系统地研究了光照时间、光照距离、催化剂用量、苯系物浓度和溶液pH、空气流量、H2 O2 浓度、Fe3+ 浓度等因素对模拟水样中苯系物的光催化降解效率的影响。研究结果表明 ,当光照时间为 2 0min、光照距离为 6cm ,TiO2 用量为 4 0 0mg L、pH =7、苯系物浓度为 10 0mg L ,空气流量为 4 0 0mL min,苯系物降解率可达 93% ,添加H2 O2 与Fe3+ 能增加苯系物的降解率 ,当H2 O2 浓度为 6mmol L ,Fe3+ 浓度为 0 2mmol L ,苯系物可完全降解。实验测定精密度RSD为 0 5 %。