Physico-chemical characterization of Residual Household Waste for energy recovery in insular territories: Case study of Reunion Island

Waste-to-energy is a promising approach to face the current challenge of waste overproduction in Reunion Island, a French territory. In this particular context of an isolated and tropical territory, it is essential to study the properties of potential feedstocks to choose the most appropriate conversion process. This article reports on the composition of Residual Household Waste from Reunion Island and its physico-chemical parameters. Twelve representative samples of Residual Household Waste were subjected to thermal and elemental analysis. The results showed that their composition had a significant influence on the physico-chemical properties, including calorific value. Residual Household Waste from the selective sorting (rich in wood, plastic, and sanitary textiles) as well as dry mixed RHW are the most interesting for energy recovery. Due to their high volatile matter and high carbon content, and their low moisture content, these types of waste have a high calorific value exceeding 18 MJ/kg. Furthermore, the RHW sample comply with the environmental and health criteria applied by French regulations concerning halogen and heavy metal. Thus, it seems that Residual Household Waste can be an alternative to conventional fuels used in incineration or pyro-gasification processes. However, the study also points the need for a pre-treatment process for these wastes. Indeed, it is necessary to sort them correctly in order to avoid the risks of pollution and important maintenance. And more importantly, drying beforehand is unavoidable to improve combustibility and obtain optimal energy conversion.     

煤对CO2，N2和CH4的吸附速率经验公式与异同性研究*

为了解决吸附速率拟合公式缺乏而解吸经验公式众多的问题，通过替换解吸参数、定性和对比分析各经验公式对煤吸附CO₂，N₂，CH₄吸附速率的适用性，选取4种不同煤质的煤样在0.5，1.0和2.0 MPa下进行定温吸附实验，分析压力和煤质对吸附速率的影响规律。研究结果表明:时间函数式对3种气体在不同压力和煤质下的吸附速率拟合效果最佳；压力和煤质对3种气体吸附速率的影响既存在共性又具有差异性，气体吸附速率与压力符合指数函数关系，与挥发分呈现出二次函数关系，并且压力升高会导致最低吸附速率趋向于较高变质程度煤样；CH₄和N₂的吸附速率随压力升高而升高，而CO₂的吸附速率因煤样而不同，且在同压下，不同气体的最高和最低吸附速率煤样的变质程度也不同。     

基于响应曲面法的遗煤自燃分析与研究*

为研究高瓦斯易自燃煤层不同供风量、高抽巷抽采流量、低抽巷抽采流量3因素对采空区自燃“三带”分布影响规律，选取阳煤五矿8406工作面为研究对象，在数值模拟研究基础上，采用Design Expert软件进行Box Behnken试验设计，构建采空区氧化升温带宽度在3因素、3水平条件下的二次回归响应曲面模型，并对不同条件下采空区氧化升温带宽度进行预测与分析。结果表明:二次回归方程P值为0.001 6，预测模型显著，模型的失拟项为0.606 3，不显著，回归方程具有统计学意义；当供风量为1 500~2 000 m3/min，低抽流量为450~650 m3/min，高抽流量为100~200 m3/min时，对氧化升温带宽度一次项重要度排序为C（高抽巷抽采流量）>A（供风量）>B（低抽巷抽采流量），二次项重要度排序为AC（供风量和高抽巷抽采流量）>AB（供风量和低抽巷抽采流量）>BC（低抽巷抽采流量和高抽巷抽采流量），且AB,AC,BC之间均无交互作用。     

屏蔽服冷却系统对人体表面温度影响的研究*

为科学有效地论证多种方式组合的冷却屏蔽服在不同环境条件下对人体表面温度控制的效果，需要对冷却系统及人体敏感部位发热量进行客观评估。通过对5名健康男性的高温测试，探究人体在不同环境温度下体表温度的变化，得出胸部、背部及额头为热量最高部位，并构建以“人体-降温屏蔽服-外界环境”为主体的冷却系统数值模型，对不同环境中的屏蔽服冷却效果展开研究，分析穿戴冷却屏蔽服时人体躯干部分的温度分布及影响。结果表明:在屏蔽服中靠近胸部、背部部位引入相变材料和风扇，均可帮助人体降低体温，提高舒适度。     

Environmental pollution,hydropower and nuclear energy generation before and after catastrophe: Bathtub-Weibull curve and MS-VECM methods

In this paper, the life span of hydro and nuclear energy generations and the relationship between hydro and nuclear energy generations, environmental pollution, and economic growth were investigated for Japan covering the period of 1960–2018 by employing the Bathtub-Weibull curve and Markov switching-vector error correcting (MSVEC) method, respectively. According to the Bathtub-Weibull curve analysis, a rising failure rate for nuclear energy was found, indicating that the life of nuclear energy has expired, but a decreasing failure rate for hydroelectric energy has been detected. Then two different MSVEC models were used. The MSVEC method, unlike traditional approaches, determines the relationship between variables under different regimes. The results of MSVEC methods indicate three important points. First, regime-dependent asymmetry and regime changes are crucial for policy recommendations. Second, the shocks to hydropower and nuclear energy generations cause temporary deviations from the long-run growth path in both regimes. Lastly, the increase in hydropower generation leads to a decrease in environmental pollution and an increase in GDP, and an increase in nuclear power generation increases pollution and growth in both regimes.     

Effect of pyrolysis and oxidation characteristics on lauric acid and stearic acid dust explosion hazards

The effect of pyrolysis and oxidation characteristics on the explosion sensitivity and severity parameters, including the minimum ignition energy MIE, minimum ignition temperature MIT, minimum explosion concentration MEC, maximum explosion pressure P_max, maximum rate of pressure rise (dP/dt)_max and deflagration index K_st, of lauric acid and stearic acid dust clouds was experimentally investigated. A synchronous thermal analyser was used to test the particle thermal characteristics. The functional test apparatuses including the 1.2 L Hartmann-tube apparatus, modified Godbert-Greenwald furnace, and 20 L explosion apparatus were used to test the explosion parameters. The results indicated that the rapid and slow weight loss processes of lauric acid dust followed a one-dimensional diffusion model (D1 model) and a 1.5 order chemical reaction model (F1.5 model), respectively. In addition, the rapid and slow weight loss processes of stearic acid followed a 1.5 order chemical reaction model (F1.5 model) and a three-dimensional diffusion model (D3 model), respectively, and the corresponding average apparent activation energy E and pre-exponential factor A were larger than those of lauric acid. The stearic acid dust explosion had higher values of MIE and MIT, which were mainly dependent on the higher pyrolysis and oxidation temperatures and the larger apparent activation energy E determining the slower rate of chemical bond breakage during pyrolysis and oxidation. In contrast, the lauric acid dust explosion had a higher MEC related to a smaller pre-exponential factor A with a lower amount of released reaction heat and a lower heat release rate during pyrolysis and oxidation. Additionally, due to the competition regime of the higher oxidation reaction heat release and greater consumption of oxygen during explosion, the explosion pressure P_m of the stearic acid dust was larger in low concentration ranges and decayed to an even smaller pressure than with lauric acid when the concentration exceeded 500 g/m³. The rate of explosion pressure rise (dP/dt)_m of the stearic acid dust was always larger in the experimental concentration range. The stearic acid dust explosion possessed a higher P_max, (dP/dt)_max and K_st mainly because of a larger pre-exponential factor A related to more active sites participating in the pyrolysis and oxidation reaction. Consequently, the active chemical reaction occurred more violently, and the temperature and overpressure rose faster, indicating a higher explosion hazard class for stearic acid dust.     

肥煤自燃全过程热动力学特征参数研究

实验测定了林西矿肥煤样品30~900℃煤自燃全过程热动力学特征参数,得出:TG/DTG曲线显示煤样DTG初始临界温度45℃,干裂温度122℃,活性温度195℃,增速温度265℃,质量极大值温度342℃,着火温度465℃,最大热失重速率温度515℃和燃尽温度690℃;DSC曲线显示,煤样初始放热温度60℃、最大热释放速率温度511℃。结合TG-DTG-DSC曲线综合分析可知,煤温达到510℃左右时煤样反应最剧烈。由煤自燃标志气体测定实验系统得出:煤温130℃后CO,CO 2释放量迅速增加,210℃增加速度下降;CH 4,C 2 H 6含量变化具有规律性且两者变化相近;C 2 H 4出现温度为130℃;C 2 H 4/C 2 H 6比值在190~350℃有较强的规律性,呈上升趋势且上升速度较快;350℃之后,CH 4,C 2 H 6,C 2 H 4体积分数均开始急剧增大;C 2 H 4/CO与C 2 H 4/CO 2变化趋势大致相同,在130~350℃时缓慢增长,达到350℃后比值呈指数形式上升。经拟合曲线,得到活化能的3个突变点温度:70,180,220℃,其中180℃与交叉点温度相吻合。通过以上研究,得到了肥煤自燃全过程的热力学特征参数,为实际生产中防治煤自燃提供了理论依据。     

Experimental research of LNG accidental underwater release and combustion behavior

Evaluating potential hazards caused by accidental LNG release from underwater pipelines or vessels is a significant consideration in marine transportation safety. The aim of this study was to capture the dynamic behavior of LNG jet released under water and to analyze its vapor dispersion characteristics and combustion characteristics on the water surface during different release scenarios. Controlled experiments were conducted where LNG was jet released from a cryogenic storage tank. The dynamic process of LNG being jet released from orifices of different sizes and shapes, as well as the rising plume structure, were captured by a high-speed camera. The leakage flow rate and pipeline pressure were recorded by a flow meter and pressure gauge, respectively. The concentration distribution that emanated from the water surface was measured utilizing methane sensors in different positions with various wind speeds. The flame combustion characteristics of LNG vapor clouds, which immediately ignited upon the enclosed water tank, were also recorded. Additionally, the mass burning rate of the flame on the water surface was evaluated, and a new correlation between the ratio of flame length and width was established. The results indicated a large dimensionless heat release rate (Q*) and a continuous release flow rate in a limited burning area. This study could provide greater understanding of the mechanisms of LNG release and combustion behavior under water.     

不同边沿高度油池火燃烧行为的实验和数值模拟研究

采用实验和FDS数值模拟相结合的方法,探讨了边沿高度对油池火燃烧特性的影响。在实验部分,研究了燃烧速率和表观火焰高度随边沿高度的变化趋势,并分别分析了各个阶段的热反馈机制。在实验获得不同尺度、边沿高度正庚烷油池火燃烧速率的前提下,建立相应尺度的不同边沿高度油池火的Fire Dynamics Simulator(FDS)计算模型以针对火焰高度进行了数值模拟研究,分析了实际火焰高度、火焰下探高度随边沿高度的变化趋势,并提出了相关的无量纲拟合式。     

Effects of falling weight impact on industrial safety helmets used in conjunction with eye and face protection devices

Industrial workplaces pose concurrent hazards to the upper part of the head and the eyes. Under the circumstances, workers may use protective helmets in conjunction with protective goggles or spectacles. In order to assess the compatibility of this equipment, a method and a test stand for evaluating the behavior of safety helmets and protective goggles/spectacles upon the impact of a falling weight were designed. The results of tests concerning the displacement and deformation of helmets and spectacles/goggles, the forces acting on the helmets, as well as the forces exerted by the spectacles/goggles on the headform upon falling weight impact are presented. The results revealed the ways in which the tested equipment interacted with each other. The influence of equipment construction on the test results was analyzed and inferences concerning the safety of the studied protective devices were made. Some general construction guidelines were formulated for the compatibility of the equipment.