钙钛矿型催化剂催化湿式氧化处理煤气化废水纳滤浓缩液

采用溶胶-凝胶法制备了Mn掺杂钙钛矿型催化剂LaFexMn1-xO3，并以其为催化剂催化湿式双氧水氧化处理煤气化废水纳滤浓缩液。采用XRD，SEM，FTIR技术对催化剂进行了表征。表征结果显示：制备的催化剂均具有标准的钙钛矿型结构，其中，LaFe0.9Mn0.1O3的结构稳定，比表面积大。实验结果表明：制备的催化剂中LaFe0.9Mn0.1O3的催化活性最高，且稳定性好，连续使用5次后催化活性未见明显减弱；在H2O2投加量3.0 g/L、n（H2O2）∶n（LaFe0.9Mn0.1O3）=12∶1、反应温度160 ℃、反应压力1 MPa、浓缩液pH 3、反应时间60 min的最优条件下，COD、UV254和TOC的去除率分别达到80.9%、95.2%和68.0%，BOD5/COD由0.02提升至0.40，可生化性大幅提高。     

硫酸盐还原菌污泥固定化特性

采用玉米芯为碳源,聚乙烯醇(PVA)为包埋载体,饱和硼酸(H3BO3)为交联剂,研究了硫酸盐还原菌污泥(SRBS)、铁屑、麦饭石共固处理合成煤矿酸性废水的最优配比与机理,并分析了固定化过程中小球稳定性及活性的变化规律。实验结果表明,SRBS投加量是影响处理效果的最显著因子,当投加30%SRBS、2%铁屑、3%麦饭石时SO2-4、Mn2+去除率分别为94.13%和84.39%,溶液p H为7.03,未检测出Fe2+;随着交联时间的延长,小球膨胀率及SO2-4还原率分别呈线性与指数下降,从保持小球稳定性与活性角度考虑,可将交联时间设定为4~8 h;该法可为市政污泥的处置以及生物法处理煤矿酸性废水的工程应用提供技术参考。     

Packed in-tube solid phase microextraction with graphene oxide supported on aminopropyl silica: Determination of target triazines in water samples

On-line in-tube solid phase microextraction (in-tube SPME) coupled to high performance liquid chromatography and tandem mass spectrometry (HPLC-MS/MS) was successfully applied to the determination of selected triazines in water samples. The method based on the employment of a packed column containing graphene oxide (GO) supported on aminopropyl silica (Si) showed that the extraction phase has a high potential for triazines extraction aiming to its physical-chemical properties including ultrahigh specific surface area, good mechanical and thermal stability and high fracture strength. Injection volume and loading time were both investigated and optimized. The method validation using Si-GO to extract and concentrate the analytes showed satisfactory results, good sensitivity, good linearity (0.2–4.0 µg L^?1) and low detection limits (1.1–2.9 ng L^?1). The high extraction efficiency was determined with enrichment factors ranging from 1.2–2.9 for the lowest level, 1.3–4.9 intermediate level and 1.2–3.0 highest level (n = 3). Although the analytes were not detected in the real samples evaluated, the method has demonstrated to be efficient through its application in the analysis of spiked triazines in ground and mineral water samples.     

钙钛矿型La_(0.8)Ce_(0.2)Fe_(1-x)Co_xO_3催化剂的制备及其三效催化活性

采用自燃烧法制备了一组钙钛矿型复合氧化物La_(0.8)Ce_(0.2)Fe_(1-x)Co_xO_3(x=0.9,0.7,0.5,0.3,0.1),并考察了其对CO、C_3H_6和NO的三效催化活性。XRD和SEM表征结果显示,La_(0.8)Ce_(0.2)Fe_(1-x)Co_xO_3具有良好的钙钛矿型晶体结构,晶粒大小为纳米级并自组装成片状结构。催化剂的比表面积为14.73~22.43 m~2/g,含有微孔和介孔结构。催化活性评价结果表明:La_(0.8)Ce_(0.2)Fe_(0.1)Co_(0.9)O_3具有很好的三效催化活性,在理论空燃比的条件下,CO、C_3H_6和NO的起燃温度分别为195℃、264℃和290℃,完全转化温度分别为239℃、418℃和415℃,低温三效催化活性良好;Fe和Co的掺杂量同时影响着La_(0.8)Ce_(0.2)Fe_(1-x)Co_xO_3的催化效果。     

模糊综合评价法在钢铁企业安全投资合理性评价中的应用

为了对钢铁企业安全投资进行模糊综合评价,建立了钢铁企业安全投资的评价体系,确定各因素的权重。得出模糊综合评价矩阵,可对各因素进行评价分析;得出某钢铁企业安全投资现状分数为83.9分,等级为较好,需着重加强安全培训、劳保品、工业卫生等人因素方面的投资;在环境方面的投资较合理。     

纳米铁氧化物吸附处理重金属废水的研究进展

概述了用于吸附重金属的主要纳米铁氧化物的种类及其吸附效果,介绍了常见的纳米铁氧化物制备方法及改性方法,讨论了影响纳米铁氧化物吸附重金属的主要因素,并对纳米铁氧化物在水环境保护领域中的研究方向提出了展望:如发展绿色、高效的纳米铁氧化物制备工艺,探讨纳米铁氧化物结构调控和表面功能化对其吸附性能的影响等。     

300MW锅炉低NOx燃烧系统改造效果分析

针对日益严重的环境污染、锅炉热效率低等问题，阐述了燃煤锅炉炉内空间分级燃烧技术、煤粉浓淡高效分离技术改造项目和特点，提出了对燃烧器系统、一次风管道、二次风系统和空预器系统等系统进行具体的低氮改造措施。分析了300 MW燃煤锅炉低氮改造后的热经济性和安全性。经试验验证，1号锅炉低氮改造后，锅炉NOx 排放量大幅减少，排放浓度降到了280 mg／m3。     

电絮凝去除废水中多种重金属影响因素研究

目的以铁作为电极,研究电絮凝法处理含多种重金属废水的影响因素及效果。方法通过控制pH、停留时间、电流密度、电导率、废水初始浓度等因素至不同水平,考察处理效果、能耗及极板消耗的变化。结果随着停留时间、pH值及电流密度的升高,处理效果越好,但升高至一定程度后,处理效果提升并不明显;电导率对处理效果影响并不显著,但过低的电导率会增加能耗;废水初始浓度越高,要达到处理目标所需的能耗及极板消耗均越高。结论当pH为8.5~9.0、进水电导率为1500~2000μs/cm、停留时间为3~4 min、废水初始质量浓度20 mg/L、电流密度为13.2~19.8 A/m2时,处理效果最理想,对总铜、总镍、总铅、总锌、总镉及总铬的去除率达到99%以上,且能耗与极板消耗均为最低,电絮凝法更适合于重金属废水的深度处理。     

Mo-modified Pd/Al2O3 catalysts for benzene catalytic combustion

Mo-modified Pd/Al2O3catalysts were prepared by an impregnation method and tested for the catalytic combustion of benzene. The catalysts were characterized by N2 isothermal adsorption, X-ray diffraction（XRD）, X-ray photoelectron spectroscopy（XPS）, temperatureprogrammed desorption of NH3（NH3-TPD）, H2temperature-programmed reduction（H2-TPR）, and high-angle annular dark-field scanning transmission electron microscopy（HAADF-STEM）. The results showed that the addition of Mo effectively improved the activity and stability of the Pd/Al2O3catalyst by increasing the dispersion of Pd active components, changing the partial oxidation state of palladium and increasing the oxygen species concentration on the surface of catalyst. In the case of the Pd-Mo/Al2O3catalyst,benzene conversion of 90% was obtained at temperatures as low as 190°C, which was 45°C lower than that for similar performance with the Pd/Al2O3catalyst. Moreover, the 1.0% Pd-5% Mo/Al2O3catalyst was more active than the 2.0% Pd/Al2O3catalyst. It was concluded that Pd and Mo have a synergistic effect in benzene catalytic combustion.     

Debromination of decabromodiphenyl ether by organo-montmorillonite-supported nanoscale zero-valent iron：Preparation, characterization and influence factors

An organo-montmorillonite-supported nanoscale zero-valent iron material(M-NZVI) was synthesized to degrade decabromodiphenyl ether(BDE-209). The results showed that nanoscale zero-valent iron had good dispersion on organo-montmorillonite and was present as a core-shell structure with a particle size range of nanoscale iron between 30–90 nm, characterized by XRD, SEM, TEM, XRF, ICP-AES, and XPS. The results of the degradation of BDE-209 by M-NZVI showed that the efficiency of M-NZVI in removing BDE-209 was much higher than that of NZVI. The efficiency of M-NZVI in removing BDE-209 decreased as the pH and the initial dissolved oxygen content of the reaction solution increased, but increased as the proportion of water in the reaction solution increased.