Public perception of air pollution sources across Europe

Air pollution is one of the primary concerns of our society for its effect on human health and the environment. Among the policy measures that can be put in place to limit air pollutant emissions, end-of-pipe technologies and/or regulatory instruments may be implemented through legislative acts. Also, equally important are behavioural measures, requiring citizens’ active involvement. The success of any measure to limit pollutant emissions requires the acceptance by the citizens that, in turn, implies a correct perception of the main pollutant emission drivers. We present here the comparison between the public perception of air pollution sources and the real-world situation through a survey carried out in seven European countries and involving 16 101 respondents. Our study shows a dramatic underestimation of the contribution of the agri-food sector to air pollution. This result is common to all respondents in the seven countries examined and only to a small extent depends on gender, age and socio-economic status of the respondents.     

Numerical simulation of far-field blast loads arising from large TNT equivalent explosives

Large TNT equivalent explosions usually arise from accidents occurring during the transportation, storage, and manufacturing of chemicals relevant to process industries. The blast wave generated by the explosion will spread and interact with the surrounding factories and storehouses, damaging the building structures within several kilometers and causing significant casualties and property losses. This study aims to develop an efficient numerical simulation method to predict blast loads to estimate the consequences of accidents involving far-field free air bursts or surface burst explosions. Before its interaction with the interested target, a blast wave is generated in the numerical model by specifying the initial and boundary conditions of the disturbed air. Based on empirical data of incident overpressure, an explicit formula to calculate the air particle velocity is derived from the governing equations of a perfect inviscid gas. A simplified path line method is proposed to calculate the air density. The proposed method is applied to the LS-DYNA CESE solver to simulate the blast loads on building structures in the far field. Validations against empirical data and experiments indicate that the proposed method is sufficiently accurate for engineering applications and, through a case study, presents a more efficient performance than the LOAD_BLAST_ENHANCED (LBE) and mapping methods.     

火焰脉动在火灾领域相关研究进展

为研究火焰脉动在火灾领域相关研究进展，总结了不同燃料类型的火焰脉动形成机理，较为详细地介绍了火焰脉动现象研究中常用的脉动频率测量方法，列举了LDV、TDLAS、自由基团高频采集等新方法；介绍了池火脉动、射流/羽流气体火脉动在不同燃烧器尺寸，不同外部环境和不同燃料比等影响因素方面的研究内容与进展；对常见的3种不同的火焰脉动模型进行描述和归类；对火焰脉动的规律、机理等在火灾领域的早期识别和检测中的作用、特殊条件对于火焰脉动频率的影响和更加精细的火焰脉动模型的研究等方向提出展望。     

水平管内不同煤质煤尘爆炸火焰传播特性实验研究

为研究水平管道空间不同煤质煤尘爆炸火焰传播特性，选取褐煤、长焰煤、不粘煤、气煤4种煤尘，对爆炸火焰焰峰特性、火焰加速传播特性、火焰传播距离与持续时间展开研究。研究结果表明:褐煤在500 ms内焰峰的形状由尖锐向平滑再向钝化不断演变，长焰煤与不粘煤在375 ms时焰峰前端出现明显焰体分离现象，分析认为这与管体冷壁效应、空间尺度效应及空间氧气消耗直接相关；气煤在375 ms时焰峰出现大面积火焰碎纹，说明气煤爆炸火焰猛烈传播的持续时间相对较短，整体爆炸强度相对较弱；褐煤与长焰煤爆炸火焰存在2次间断性加速，分析认为这与管体空间受限、常温管壁散热、局部助燃氧气瞬间不足等因素有关；褐煤在爆炸后400～600 ms内火焰2次加速完全，火焰传播距离达740 mm，明显大于长焰煤、不粘煤与气煤，说明低变质褐煤爆炸火焰持续时间更长，火焰传播距离更远且传播更剧烈；虽然气煤火焰最远传播距离比长焰煤大30 mm，但由于气煤火焰在375 ms左右出现大片火焰碎纹，因此气煤整体的爆炸强度小于长焰煤。     

济南市空气污染现状及控制对策

利用2013年1—12月济南市大气监测数据,分析该市空气质量现状及时空分布特征,结果表明:2013年济南市空气主要污染物质量浓度均超过《环境空气质量标准》(GB 3095—2012)二级标准限值,空气污染严重时段为冬季采暖期,颗粒物污染严重区域为该市西部和西北部地区,SO2、NO2污染严重区为中心城区,并从点源、面源和移动源3个方面提出相应的污染防治对策。在SO2、NOx和工业烟粉尘分别减排22.5%、18.2%和31.4%的条件下,运用Models-3/CMAQ模型模拟计算得出:2015年1月和7月,济南市空气中SO2、NO2、PM10和PM2.5的质量浓度与2010年同期相比将分别降低23.9%和29.7%、11.4%和15.9%、21.9%和32.6%、13.5%和26.9%,空气质量得到明显改善。     

泰州市冬季空气质量变化特征

为了解泰州市冬季空气质量变化特征,于2013年12月27日—2014年1月7日对NO2,SO2,O3,CO,PM10和PM2.5进行了监测,结合地面气象资料和HYSPLIT轨迹模式分析了污染物的来源与传输过程。结果表明,观测期间AQI优良率仅为25%,PM10和PM2.5日均值超标率分别为58.3%,75.0%;有机碳是泰州市ρ(PM2.5)中最高的化学组分,其次是富钾和元素碳。PM2.5主要来源为汽车尾气、工业源、燃煤,分别占来源比例21.76%,16.52%,15.54%。局地污染源和不利气象条件是造成大气污染的主要原因。     

空气质量AQI实时发布的改进探讨

针对《环境空气质量指数(AQI)技术规定(试行)》(HJ 633-2012)中对空气质量AQI实时发布存在的欠缺,从增加颗粒物1 h浓度的AQI分级浓度限值及颗粒物24 h滑动平均值计算方法改进着手,解决PM2.5和PM10的24 h滑动平均值实时延迟、1 h平均值代替24 h滑动平均值偏高等问题。     

Influence of vacuum degree on the effect of gas explosion suppression by vacuum chamber

In order to study the influence of vacuum degree on gas explosion suppression by vacuum chamber, this study used the 0.2 mm thick polytetrafluoroethylene film as the diaphragm of vacuum chamber to carry out a series of experiments of gas explosion suppression by vacuum chamber with the vacuum degree from −0.01 MPa to −0.08 MPa. The experimental results show that: under the condition of any vacuum degree, vacuum chamber can effectively suppress the explosion flame and overpressure; as vacuum degree changes, the effect of gas explosion suppression using vacuum chamber is slightly different. Vacuum chamber has obvious influence on propagation characteristics of the explosion flame. After explosion flame passes by vacuum chamber, the flame signal weakens, the flame thickness becomes thicker, and the flame speed slows down. With the increase of the vacuum degree of vacuum chamber, the flame speed can be prevented from rising early by vacuum chamber. The higher the vacuum degree is, the more obviously the vacuum chamber attenuates the explosion overpressure, the smaller the average overpressure is, and the better effect of the gas explosion suppression is. Vacuum chamber can effectively weaken the explosion impulse under each vacuum degree. From the beginning of −0.01 MPa, the vacuum chamber can gradually weaken explosion impulse as the vacuum degree increases, and the effect of gas explosion suppression gradually becomes better. When the vacuum degree is greater than −0.04 MPa, the increase of vacuum degree can make the explosion overpressure decrease but have little influence on the explosion impulse. Therefore, the vacuum chamber has the preferable suppression effect with equal to or greater than −0.04 MPa vacuum degree.     

不同边沿高度油池火燃烧行为的实验和数值模拟研究

采用实验和FDS数值模拟相结合的方法,探讨了边沿高度对油池火燃烧特性的影响。在实验部分,研究了燃烧速率和表观火焰高度随边沿高度的变化趋势,并分别分析了各个阶段的热反馈机制。在实验获得不同尺度、边沿高度正庚烷油池火燃烧速率的前提下,建立相应尺度的不同边沿高度油池火的Fire Dynamics Simulator(FDS)计算模型以针对火焰高度进行了数值模拟研究,分析了实际火焰高度、火焰下探高度随边沿高度的变化趋势,并提出了相关的无量纲拟合式。     

大气细颗粒物在线源解析方法研究进展

基于对国内外关于PM2.5化学组分特征、二次气溶胶生成机理、源解析模型的研究综述,引入实现PM2.5在线源解析的2种可能方法,即气溶胶质谱+解析算法与3类化学组分组合观测+受体模型。重点阐述了气溶胶质谱及在线水溶性离子、EC/OC和金属元素仪器的应用研究现状,并分析了不同仪器测定结果的可靠性、优势及缺陷,在此基础上提出加强城市尺度的大气化学二次反应机理及关键技术参数研究、大气颗粒物化学组分连续观测应用于在线源解析的研究、基于多种信息来源和技术手段的在线源解析方法集成研究等建议。