An LC-MS/MS method for creatine and creatinine analysis in paraquat-intoxicated patients

Abstract

A sudden increase in serum creatinine after paraquat intoxication has been reported in several clinical studies. However, this dramatic change of creatinine may be possibly due to an interconversion of creatine-creatinine in relation to paraquat toxicity. In order to investigate the creatine-creatinine relationship, a liquid chromatography tandem mass spectrometry in combination with electrospray ionization was developed and validated for simultaneous determination of creatine and creatinine in the serum. The chromatographic separation was achieved on a Gemini® C₆-Phenyl column with a gradient elution consisting of 0.1% formic acid in ultrapure water and methanol as the mobile phase. The method yielded suitable levels of specificity and selectivity, and calibration curves of creatine and creatinine in serum were linear over the concentration range of 0.5–200?µg mL^?1. The limit of quantification of both compounds was 0.5?µg mL^?1, and the method was accurate within the recovery range of 96.23–102.75%, indicating the robustness of the method. The method was successfully applied to toxicological samples from paraquat-intoxicated patients, and the concentrations of creatine and creatinine were quantified. High creatine concentrations in serum samples were observed which may lead to high serum creatinine despite normal kidney function as creatine is converted to creatinine in proportion to its concentration.     

Effect of particle size on CO adsorption and thermodynamic analysis

The liquid nitrogen adsorption method was used to characterize the pore structure of non-cohesive coal in the 061,404 working face of the Lingxin coal mine. The amount of specific surface area of micropores in the sample continuously rose as particle sizes reduced. The volumetric method was used to measure the CO isothermal adsorption curves of three samples (sample I, 0.425–0.25 mm, sample II, 0.18–0.25 mm, and sample III, 0.15–0.18 mm). The experimental results were fitted by the Langmuir model. According to the experimental results, it was conducive to CO adsorption with the conditions of high pressure and low-temperature. The decrease in grain diameter increased the number and volume of micropores in the sample, which improved the adsorption capacity of the sample. In addition, according to the adsorption data, the CO adsorption thermodynamics of three samples were analyzed, including surface potential (Ω), Gibbs free energy change (ΔG) and entropy change (ΔS). The results demonstrated that CO adsorption by coal was a spontaneous process. Sample III has the most substantial adsorption capacity, whereas the sample I has the weakest adsorption capacity.     

低碳高氮污水处理应用技术研究

针对碳氮比小于7的污水,其碳源不能满足硝化与反硝化的要求这一问题,通过改变SBR工艺的运行方式、调解工艺参数等技术手段,使其能够达标处理此类工业废水,并通过某淀粉厂的工程实例进行了验证:采用改良的SBR工艺可以对低碳高氮污水进行有效的处理。     

A 1-dodecanethiol-based phase transfer protocol for the highly efficient extraction of noble metal ions from aqueous phase

A 1-dodecanethiol-based phase-transfer protocol is developed for the extraction of noble metal ions from aqueous solution to a hydrocarbon phase, which calls for first mixing the aqueous metal ion solution with an ethanolic solution of 1-dodecanethiol, and then extracting the coordination compounds formed between noble metal ions and 1-dodecanethiol into a non-polar organic solvent. A number of characterization techniques, including inductively coupled plasma atomic emission spectroscopy, Fourier transform infrared spectroscopy, and thermogravimetric analysis demonstrate that this protocol could be applied to extract a wide variety of noble metal ions from water to dichloromethane with an efficiency of >96%, and has high selectivity for the separation of the noble metal ions from other transition metals. It is therefore an attractive alternative for the extraction of noble metals from water, soil, or waste printed circuit boards.     

液氮泡沫发生器内流动特性研究

低温液氮与泡沫混合液直接接触产生氮气泡沫是一种新型的掺混形式,利用液氮高汽化比的特点,搭建液氮泡沫可视化实验装置,进行氮气-水两相流及液氮泡沫流动特性的研究。结果表明,液氮相变产生大量氮气,其与泡沫液混合产生泡沫,温度有所回升,最终趋于泡沫混合液温度;管路沿程压降较小;液氮射流破碎及流动过程可分为6个区域:低温液氮区、向上循环翻滚区、滞留区、泡沫与泡沫混合液混合区、致密泡沫区、泡沫混合液区。流体向下游流动过程中持续发泡;为防止管路结冰,需合理控制泡沫混合液与液氮流量。     

Development of heat transfer and evaporation model of LNG covered by Hi-Ex foam

Natural gas is a kind of clean, efficient green energy source, which is used widely. Liquefied natural gas (LNG) is produced by cooling natural gas to −161 °C, at which it becomes the liquid. Once LNG was released, fire or explosion would happen when ignition source existed nearby. The high expansion foam (Hi-Ex foam) is believed to quickly blanket on the top of LNG spillage pool and warm the LNG vapor to lower the vapor cloud density at the ground level and raising vapor buoyancy. To identify the physical structure after it contacted with LN₂ and to develop heat transfer model, the small-scale field test with liquid nitrogen (LN₂) was designed. In experiment, three layers including frozen ice layer, frozen Hi-Ex layer and soft layer of Hi-Ex foam were observed at the steady state. By characterizing physical structure of the foam, formulas for calculating the surface of single foam bubble and counting foam film thickness were deduced. The micro heat transfer and evaporation model between cryogenic liquid and Hi-Ex foam was established. Indicating the physical structure of the frozen ice layer, there were a certain number of icicles below it. The heat transfer and evaporation mathematical model between the frozen ice layer and LNG was derived. Combining models above with the heat transfer between LNG, ground and cofferdam, the heat transfer and evaporation mathematical model of LNG covered by Hi-Ex foam was developed eventually. Finally, LN₂ evaporation rate calculated by this model was compared with the measured evaporation rate. The calculated results are 1.2–2.1 times of experimental results, which were acceptable in engineering and proved the model was reliable.     

Evaporating liquid flow in a channel (An integral model based on shallow water flow approximation)

Liquefied Natural Gas (LNG) storage facilities generally include channels to convey potential spills of the liquid to an impoundment. There is increasing concern that dispersion of vapors generated by flow of LNG in a channel may lead to higher than limit vapor concentrations for safety at site boundary from channels that may be close to the dike walls. This issue is of recent concern to regulatory agencies, because the calculation of vapor hazard distance(s) from LNG flow in a channel is not required under existing LNG facility siting standards or regulations.An important parameter that directly affects the calculated LNG vapor dispersion distance is the source strength (i.e., the rate of vaporization of LNG flow from the wetted channel surfaces, as a function of spatial position and time). In this paper a model is presented which considers the variation of the depth of the flowing LNG with spatial location and time, and calculates the spatial and temporal dependence of the mass rate of vapor generation. Self similar profiles for the spatial variation of the thermal boundary layer in the liquid wetted wall and liquid depth variation are assumed. The variation with time of the location of the liquid spread front and the evaporation rate are calculated for the case of a constant LNG spill rate into a rectangular channel. The effects of two different channel slopes are evaluated. Details of the results and their impact on dispersion distances are discussed.     

Tissue distribution of perfluoroalkyl acids and health status in wild Mozambique tilapia (Oreochromis mossambicus) from Loskop Dam, Mpumalanga, South Africa

This study examined concentrations of 15 perfluoroalkyl acids (PFAAs) in tissues from male Mozambique tilapia (Oreochromis mossambicus) collected at Loskop Dam, Mpumalanga, South Africa in 2014 and 2016. Nine of the 15 PFAAs were detected frequently and were included in statistical analysis and included two of the most commonly known PFAAs, perfluorooctanesulfonic acid (PFOS) (median, 41.6 ng/g) and perfluorooctanoic acid (PFOA) (median, 0.0825 ng/g). Of the tissues measured, plasma (2016 and 2014 median, 22.2 ng/g) contained the highest PFAA burden followed by (in descending order): liver (median, 11.6 ng/g), kidney (median, 9.04 ng/g), spleen (median, 5.92 ng/g), adipose (median, 2.54 ng/g), and muscle (median, 1.11 ng/g). Loskop Dam tilapia have been affected by an inflammatory disease of the adipose tissue known as pansteatitis, so this study also aimed to investigate relationships between PFAA tissue concentrations and incidence of pansteatitis or fish health status. Results revealed that healthy tilapia exhibited an overall higher (p-value < 0.05) PFAA burden than pansteatitis-affected tilapia across all tissues. Further analysis showed that organs previously noted in the literature to contain the highest PFAA concentrations, such as kidney, liver, and plasma, were the organs driving the difference in PFAA burden between the two tilapia groups. Care must be taken in the interpretations we draw from not only the results of our study, but also other PFAA measurements made on populations (human and wildlife alike) under differing health status.     

菌渣中阿维菌素残留检测方法及其无害化工艺研究

文章建立了简单、快速的阿维菌素菌渣中阿维菌素残留量高校液相色谱检测方法以及利用水热法处理阿维菌素菌渣。采用固相萃取-高效液相色谱检测方法测定阿维菌素菌渣中阿维菌素残留量,提取剂为乙腈/水=4/1(V/V),采用HLB固相萃取柱进行净化。加标回收率90.3%~107.3%,相对标准偏差(RSD)为3.00%~5.69%,阿维2菌素标准曲线线性相关系数R~2=0.999 6,线性范围为1.0~1 000 mg/L。利用正交实验,水热法处理阿维菌素菌渣,在190℃的温度下处理2 h后,菌渣中阿维菌素残留量由991.30降至0.84 mg/kg,去除率达99.92%。处理前后的菌渣与有机肥标准作对比,除含水率外其余检测指标均达到有机肥标准要求。该项研究为阿维菌素菌渣的资源化利用提供了理论依据。     

Determination of antibiotics in sewage from hospitals, nursery and slaughter house, wastewater treatment plant and source water in Chongqing region of Three Gorge Reservoir in China

Sewage samples from 4 hospitals, 1 nursery, 1 slaughter house, 1 wastewater treatment plant and 5 source water samples of Chongqing region of Three Gorge Reservoir were analyzed for macrolide, lincosamide, trimethoprim, fluorouinolone, sulfonamide and tetracycline antibiotics by online solid-phase extraction and liquid chromatography-tandem mass spectrometry. Results showed that the concentration of ofloxacin (OFX) in hospital was the highest among all water environments ranged from 1.660 μg/L to 4.240 μg/L and norfloxacin (NOR, 0.136-1.620 μg/L), ciproflaxacin (CIP, ranged from 0.011 μg/L to 0.136 μg/L), trimethoprim (TMP, 0.061-0.174 μg/L) were commonly detected. Removal range of antibiotics in the wastewater treatment plant was 18-100% and the removal ratio of tylosin, oxytetracycline and tetracycline were 100%. Relatively higher removal efficiencies were observed for tylosin (TYL), oxytetracycline (OXY) and tetracycline (TET)(100%), while lower removal efficiencies were observed for Trimethoprim (TMP, 1%), Epi-iso-chlorotetracycline (EICIC, 18%) and Erythromycin-H₂O (ERY-H₂O, 24%). Antibiotics were removed more efficiently in primary treatment compared with those in secondary treatment.