废旧硬质聚氨酯泡沫塑料的木质素改性及再生

采用含有二乙二醇(DEG)和乙醇胺(ETA)的双组分解交联剂降解废旧硬质聚氨酯泡沫塑料(PU硬泡),并利用降解得到的低聚物多元醇与木质素复合制备出性能增强的再生PU硬泡。通过对制备的再生PU硬泡的红外光谱、密度、吸水率、抗压强度、热稳定性、导热系数、热重曲线等进行分析测试,考察m(DEG)∶m(ETA)对再生PU硬泡性能的影响。实验结果表明:m(DEG)∶m(ETA)=1∶3时废旧PU硬泡的降解效果最好;木质素加入量为2.0%(w)时再生PU硬泡的密度低、抗压强度高、保温性能良好,达到国家标准《建筑绝热用硬质聚氨酯泡沫塑料》(GB/T 21558—2008)的品质要求。     

Analysis and residue levels of forchlorfenuron (CPPU) in watermelons

This paper describes the application of liquid chromatography-tandem mass spectrometry (LC/MS-MS) for analysis of residues of forchlorfenuron (CPPU), a new plant growth regulator, in watermelons, after a sample preparation step based on the buffered Quick, Easy, Cheap, Effective, Rugged and Safe extraction method. Analytical determinations were carried out in a triple quadrupole system fitted with an electrospray interphase operating in the positive ionisation mode (ESI+). Three simultaneous MS-MS transitions of the quasi-molecular ion m/z 248 (precursor ion) were monitored for data acquisition (248 > 129, 248 > 155, and 248 > 248), using the transition 248 > 129 for quantitation. Recovery studies on watermelons at levels of 1-200 microg/kg, performing five replicates at each level and using bracketing single-level calibration with matrix-matched standards for quantitation, gave forchlorfenuron mean recoveries ranging from 82 to 106% with relative standard deviations (RSD) lower than 18%. The limit of determination was established at 1 microg/kg. The method was applied to evaluate the persistence of forchlorfenuron residues in watermelons grown in plastic greenhouses, after applying an individual spray treatment to the flower ovary at the anthesis stage (45 mu g/flower and 60 mu g/flower for cv "Extazy" and cv "reina de corazones" watermelons, respectively). One month after treatment, 20 "Extazy" watermelon units (1.5-2 kg/unit) and 20 "Reina de corazones" watermelon units (4-5 kg/unit) were collected and analyzed individually. None of the samples contained forchlorfenuron residues higher than 1 microg/kg.     

Preliminary assessment of polybrominated diphenyl ethers (PBDEs) in the Scottish aquatic environment, including the Firth of Clyde

This paper presents preliminary data on polybrominated diphenyl ethers (PBDEs) in the Scottish aquatic environment. Sediment and biota (fish liver, fish muscle and mussels) from a number of locations around Scotland were analysed for PBDEs with samples being from both remote and from potentially contaminated areas such as the former sewage sludge dump site at Garroch Head in the Clyde. PBDEs were measured in both cultivated, rope grown mussels and wild mussels collected from 5 sites around Scotland in 2006. Total PBDE concentrations (sum of tri- to hepta-BDEs) ranged from 相似文献   

Particle size distributions and elemental composition of atmospheric particulate matter in southern Italy

Three 2-wk seasonal field campaigns were performed in 2003 and 2004 at a sampling site on the southern Tyrrhenian coast of Italy with the aim to investigate the dynamics and characteristics of particle-bound pollutants in the Mediterranean area. Fine (PM(2.5)) and coarse particulate matter (PM(10-2.5)) size fractions were collected by a manual dichotomous sampler on 37-mm Teflon filters over a 24-hr sampling period. On average, 70% of the total PM(10) (PM(2.5) + PM(10-2.5)) mass was associated with the coarse fraction and 30% with the fine fraction during the three campaigns. The ambient concentrations of Pb, Ni, Cr, Zn, Mn, V, Cd, Fe, Cu, Ca, and Mg associated with both size fractions were determined by atomic absorption spectrometry. Ambient concentrations showed differences in their absolute value, ranging from few ng x m(-3) to microg x m(-3), as well as in their variability within the PM(2.5) and PM(10-2.5) size fractions. PM(10) levels were well below the European Union (EU) limit value during the study period with the exception of three events during the first campaign (fall) and five events during the third campaign (spring). Two main sources were identified as the major contributors including mineral dust, transported from North Africa, and sea spray from the Tyrrhenian Sea. Comparing the results with backward trajectories, calculated using the Hybrid Single-Particle Lagrangian Integrated Trajectory Model (HYSPLIT) and Total Ozone Mapping Spectrometer-National Aeronautics and Space Administration (TOMS-NASA) maps, it was observed that in central and eastern Europe, the Tyrrhenian Sea and North Africa were the major emission source regions that affected the temporal variations and daily averages of PM(2.5) and PM(10-2.5) concentrations.     

Information technologies and the sharing of disaster knowledge: the critical role of professional culture

A comparative survey of a diverse sample of 96 US and Italian emergency management agencies shows that the diffusion of new information technologies (IT) has transformed disaster communications. Although these technologies permit access to and the dissemination of massive amounts of disaster information with unprecedented speed and efficiency, barriers rooted in the various professional cultures still hinder the sharing of disaster knowledge. To be effective the available IT must be attuned to the unique settings and professional cultures of the local emergency management communities. Findings show that available technology, context, professional culture and interaction are key factors that affect the knowledge transfer process. Cultural filters appear to influence emergency managers' perceptions of their own professional roles, their vision of the applicability of technology to social issues, and their perspective on the transferability of disaster knowledge. Four cultural approaches to the application of IT to disaster communications are defined: technocentric; geographic,; anthropocentric; and ecocentric.     

Degradation of the herbicide dichlobenil and its metabolite BAM in soils and subsurface sediments

The worldwide used herbicide dichlobenil (2,6-dichlorobenzonitrile) has resulted in widespread presence of its metabolite 2,6-dichlorobenzamide (BAM) in surface water and groundwater. To evaluate the potential for natural attenuation of this BAM pollution in groundwater, we studied the degradation of BAM and dichlobenil in 16 samples of clayey till, unconsolidated sand and limestone, including sediments from both oxidized and reduced conditions. The degradation of dichlobenil occurred primarily in the upper few meters below surface, although dichlobenil was strongly sorbed to these sediments. However, the degradation of dichlobenil to BAM could not be correlated to either sorption, water chemistry, composition of soils or sediments. Degradation of dichlobenil to BAM was limited (<2% degraded) in the deeper unsaturated zones, and no degradation was observed in aquifer sediments. This illustrates, that dichlobenil transported to aquifers does not contribute to the BAM-contamination in aquifers. A small, but significant degradation of BAM was observed in the upper part of the unsaturated zones in sandy sediments, but no degradation was observed in the clayey till sediment or in the deeper unsaturated zones. The insignificant degradation of BAM in aquifer systems shows that BAM pollution detected in aquifers will appear for a long time; and consequently the potential for natural attenuation of BAM in aquifer systems is limited.     

Soil subsampling in environmental sciences: the role of granulometry

Uncertainty associated to analytical results is an issue of major interest for the whole analytical community. A large effort has been made to improve analytical techniques and procedures aimed to achieve a well characterized uncertainty associated with analysis. However, it is becoming increasingly recognised that uncertainty deriving from sampling and subsampling can even dominate the global uncertainty budget. A study on subsampling activities on different soil typologies has been performed by granulometry determinations. The differences between sieving methodologies based on both wet and dry mode have been studied. Subsampling is approached by replicated measurements providing a quantitative assessment of the distribution heterogeneity, a suitable method validation scheme and an empirical determination of uncertainty.     

Effects of flow regime and flooding on heavy metal availability in sediment and soil of a dynamic river system

The acid volatile sulphide (AVS) and simultaneously extracted metals (SigmaSEM) method is increasingly used for risk assessment of toxic metals. In this study, we assessed spatial and temporal variations of AVS and SigmaSEM in river sediments and floodplain soils, addressing influence of flow regime and flooding. Slow-flowing sites contained high organic matter and clay content, leading to anoxic conditions, and subsequent AVS formation and binding of metals. Seasonality affected these processes through temperature and oxygen concentration, leading to increased levels of AVS in summer at slow-flowing sites (max. 37micromolg(-1)). In contrast, fast-flowing sites hardly contained AVS, so that seasonality had no influence on these sites. Floodplain soils showed an opposite AVS seasonality because of preferential inundation and concomitant AVS formation in winter (max. 3-30micromolg(-1)). We conclude that in dynamic river systems, flow velocity is the key to understanding variability of AVS and SigmaSEM.     

Lichen and moss bags as monitoring devices in urban areas. Part II: trace element content in living and dead biomonitors and comparison with synthetic materials

Lobes of the lichen Pseudevernia furfuracea (L.) Zopf and shoots of the moss Hypnum cupressiforme Hedw. were subjected to different treatments (water washing, oven drying, HNO3 washing, NH4-oxalate extraction) to assess the influence of vitality on accumulation efficiency, during a 6-week exposure in bags in two Italian cities, Trieste and Naples. No trend emerged between treatments, in terms of accumulation ability, for major and trace elements. Only water-washed lichens showed an increased C and N content after exposure in both cities. Element concentrations generally reached higher values in mosses than in lichens, especially for Al, Fe, and Zn (both cities), and for Cu, Mg and Na (Naples). Surface development strongly influenced accumulation capacity of the biomonitors. Quartzose and cation exchange filters revealed, on a weight basis, a poor performance. In urban environments, surface interception of atmospheric particulate seems to play a major role in accumulation, irrespective of organism vitality.     

Determination of selected quaternary ammonium compounds by liquid chromatography with mass spectrometry. Part I. Application to surface, waste and indirect discharge water samples in Austria

A method for simultaneous quantitative determination of alkyl benzyl, dialkyl and trialkyl quaternary ammonium compounds (QACs) has been developed, validated and subsequently applied to real water samples in Austria. The method employs liquid-liquid extraction (LLE) followed by liquid chromatography/tandem mass spectrometry (LC-MS/MS), using electrospray ionization (ESI) in positive mode. The overall method quantification limits range from 4 to 19ng/L for the enrichment of 500mL water samples and analyte recoveries are between 80 and 99%. The method was applied to 62 of the respective water samples without filtration to avoid the loss of the analytes due to the high adsorption capacity of these compounds. Maxima in the mg/L range, especially in the wastewater of hospitals and laundries, could be detected for the selected target compounds.