TiO2 nanotubes as solid-phase extraction adsorbent for the determination of polycyclic aromatic hydrocarbons in environmental water samples

An analytical method based on TiO2 nanotubes solid-phase extraction (SPE) combined with gas chromatography (GC) was established for the analysis of seven polycyclic aromatic hydrocarbons (PAHs): acenaphtylene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene and pyrene. Factors a ecting the extraction e ciency including the eluent type and its volume, adsorbent amount, sample volume, sample pH and sample flow rate were optimized. The characteristic data of analytical performance were determined to investigate the sensitivity and precision of the method. Under the optimized extraction conditions, the method showed good linearity in the range of 0.01–0.8 g/mL, repeatability of the extraction (RSD were between 6.7% and 13.5%, n = 5) and satisfactory detection limits (0.017–0.059 ng/mL). The developed method was successfully applied to the analysis of surface water (tap, river and dam) samples. The recoveries of PAHs spiked in environmental water samples ranged from 90% to 100%. All the results indicated the potential application of titanate nanotubes as solid-phase extraction adsorbents to pre-treat water samples.     

Comparative study of the sensitivity to cadmium of two populations of Gambusia affinis from two different sites

This study aims to demonstrate the influence of animals' origin on their sensitivity toward heavy metals. For this purpose, we compared LC(50) of cadmium in two populations of Gambusia affinis captured in two geographically isolated environments in the east of Tunisia; Oued El Gsil in the city of Monastir (S2) and Oued Chenini in the region of Gabes (S1). Although physicochemical parameters of the water (pH, dissolved oxygen and salinity) are similar in the two studied sites, cadmium concentrations in water, sediments and fish tissues from S1 are significantly higher (P < 0.01) than those from S2, 48-h and 96-h LC(50) of the (S1) population are significantly higher than those from S2. In the same way, the offspring of the polluted site (S1) population exhibit 48-h and 96-h LC(50) values much higher than those of the reference site (S2) population. These results show that the population of the Gabes region is more resistant to cadmium than that of the Monastir region and that this resistance could have a genetic basis. These results indicate the influence of the origin of animals that has to be taken into account not only in laboratory toxicity tests, but also in field ecotoxicological studies.     

Removal of bisphenol A and some heavy metal ions by polydivinylbenzene magnetic latex particles

In this study, magnetic polydivinylbenzene latex particles MP_DVB with a core-shell structure were tested for the removal of bisphenol A (BPA), copper Cu(II), lead Pb(II), and zinc Zn(II) from aqueous solutions by a batch-adsorption technique. The effect of different parameters, such as initial concentration of pollutant, contact time, adsorbent dose, and initial pH solution on the adsorption of the different adsorbates considered was investigated. The adsorption of BPA, Cu(II), Pb(II), and Zn(II) was found to be fast, and the equilibrium was achieved within 30 min. The pH 5–5.5 was found to be the most suitable pH for metal removal. The presence of electrolytes and their increasing concentration reduced the metal adsorption capacity of the adsorbent. Whereas, the optimal pH for BPA adsorption was found 7, both hydrogen bonds and π–π interaction were thought responsible for the adsorption of BPA on MP_DVB. The adsorption kinetics of BPA, Cu(II), Pb(II), and Zn(II) were found to follow a pseudo-second-order kinetic model. Equilibrium data for BPA, Cu(II), Pb(II), and Zn(II) adsorption were fitted well by the Langmuir isotherm model. Furthermore, the desorption and regeneration studies have proven that MP_DVB can be employed repeatedly without impacting its adsorption capacity.     

Association of spinal deformities with heavy metal bioaccumulation in natural populations of grass goby, Zosterisessor ophiocephalus Pallas, 1811 from the Gulf of Gabès (Tunisia)

The present study illustrates an analysis of spinal deformities associated with metal accumulation in natural populations of Zosterisessor ophiocephalus derived from polluted (S1) and unpolluted (S2) areas in the Gulf of Gabès in Tunisia. Three basic types of spinal deformities were detected: kyphosis, scoliosis and lordosis. These basic deformities frequently co-occur. Spinal deformities were observed in 10.72% of the total examined fish (n = 494). Deformed fish were 3.85 times more frequent in S1 than in S2. In both sexes, the highest occurrence of deformities was observed in the 111-120 mm class decreasing thereafter with fish length. Hepatic concentrations of cadmium (Cd), copper (Cu) and zinc (Zn) were significantly higher in Z. ophiocephalus from S1 than those from S2. Comparisons between fish in each site showed that liver concentrations of Cd and Zn were significantly higher in deformed fish than in normal fish. The relationship between metals accumulation and observed spinal deformities as well as the suitability of this kind of studies for environmental monitoring are discussed.     

Endosulfan sulfate sorption on natural organic substances

This work proposes a viable remediation method based on the use of natural organic substances (NOSs) that characterize the Mediterranean region to improve the ecological system. A series of experiments, including variable conditions, such as temperature, pH, contact time, and pesticide concentration, were performed to demonstrate the efficiency of endosulfan sulfate removal from water by NOSs. Experimental results showed that the pH and temperature of pesticide solutions negatively affect the adsorption process. The maximum adsorption capacity for a specific initial concentration of endosulfan sulfate (0.5 microg/L) was achieved with Origanum compactum (75%), followed by Cistus ladaniferus and Raphanus raphanistrum (72 and 68%, respectively). The adsorption tests gave very satisfying results and point to the possible application of these supports as a remediation technique to prevent pesticide contamination of aquatic ecosystems.     

Adsorption of dyes onto activated carbon prepared from olive stones

Activated carbon was produced from olive stones（OSAC） by a physical process in two steps. The adsorption character of this activated carbon was tested on three colour dyes molecules in aqueous solution： Methylene blue（MB）, Rhodamine B（RB） and Congo Red（CR）. The adsorption equilibrium was studied through isotherms construction at 30℃, which were well described by Langmuir model. The adsorption capacity on the OSAC was estimated to be 303 mg/g, 217 mg/g and 167 mg/g respectively for MB, RB and CR. This activated carbon has a similar adsorption properties to that of commercial ones and show the same adsorption performances. The adsorption kinetics of the MB molecule in aqueous solution at different initial concentrations by OSAC was also studied. Kinetic experiments were well fitted by a simple intra-particle diffusion model. The measured kinetics constant was influenced by the initial concentration and we found the following correlation： Kid = 1.55 C0^0.51.     

Cadmium bioaccumulation in three benthic fish species, Salaria basilisca, Zosterisessor ophiocephalus and Solea vulgaris collected from the Gulf of Gabes in Tunisia

To select a marine teleost fish which can be used as a bioindicator of cadmium (Cd) pollution in the Gulf of Gabes in Tunisia, Cd concentrations in liver and gill were compared in three benthic fish species including Salaria basilisca, Zosterisessor ophiocephalus and Solea vulgaris. Fish samples were collected from three selected sites in the Gulf of Gabes, with different degrees of Cd contamination: the industrialized coast of Sfax (S1), the coast of Douar Chatt (S2) and the coast of Luza (S3). The results shows that Cd concentrations in both sediment and water collected from S1 were significantly higher (p < 0.0001) than those from S2 and S3. For each species, Cd concentrations, in both liver and gill, showed the decreasing order: S1 > S2 > S3. The highest concentration of Cd was detected in the liver of S. basilisca, and only S. basilisca showed bioaccumulation factors (BAF) greater than 1 in all studied sites. In S1 and S2, BAF values respect the following order: S. basilisca > Z. ophiocephalus > S. vulgaris. These results of significant bioaccumulation of Cd, in terms of hepatic concentrations and bioaccumulation factors, indicated that S. basilisca can be used as bioindicator to evaluate the evolution of Cd pollution in the Gulf of Gabes.     

Electrochemical analysis of endosulfan using a C18-modified carbon-paste electrode

Successful applications of different analytical procedures to determine quantitatively endosulfan and its metabolites in aqueous media can be found in recent literature. Fundamentally, they have made use of solid-phase extraction (SPE) and gas (GC) or liquid chromatography (LC), sometimes coupled to mass spectrometry (MS). In this paper, a new and alternative methodology to determine quantitatively endosulfan in aqueous media is reported. A C18-modified carbon-paste electrode has been used to determine voltammetrically endosulfan, despite its unfavourable electrochemical properties and behaviour. The methodology proposed is based on the decrease experienced by the peak intensity corresponding to voltammetric signals of Cu(II) when successive and constant additions of endosulfan are carried out. This decrease is directly proportional to the concentration of endosulfan what allows to perform an indirect quantification of the pesticide. The detection limit obtained is 40 ng l⁻¹, this value being under the limits specified by European norms and EPA reports.     

Extraction and Characterization of Nanocrystalline Cellulose from Doum (<Emphasis Type="Italic">Chamaerops humilis</Emphasis>) Leaves: A Potential Reinforcing Biomaterial

The aim of this investigation was to extract nanocrystalline cellulose (NCC) from Moroccan Doum fibers (Chamaerops humilis) by chemical treatment to examine their potential for use as reinforcement fibers in bionanocomposite applications. The chemical composition, morphological and structural properties of the Doum fibers was determined at different stages of chemical treatment. Morphological (transmission electron microscopy and scanning electron microscopy), structural characterization (X-ray diffraction, Fourier transformed infrared), thermal characterization (thermogravimetric analysis). The suspension electrostatic stabilization (zeta potential) of NCCs was also carried out. The results of these characterization analysis found that average size of the NCC is 220 nm in length and 11 nm in diameter, with high crystallinity index (93 %), a thermal stability comparable to that of untreated Doum fibers (degradation temperature 340 °C), which is reasonably promising for the use of these nanofibers in reinforced-polymer manufacturing, and a good stability in water suspension that it allows their utilization such as reinforcement of the water-soluble polymers to prepare the bio-nanocomposite.