SI-traceable certification of Cu, Cr, Cd and Pb in sediment and fly ash candidate reference materials

Many fields in environmental analytical chemistry deal with very low limits and thresholds as set by governmental legislations or transnational regulations. The need for the accuracy, comparability and traceability of analytical measurements in environmental analytical chemistry has significantly increased and total uncertainties are even asked for by accreditation bodies of environmental laboratories. This paper addresses achieving these goals to guarantee accuracy, quality control, quality assurance or validation of a method by means of certified reference materials. The assessment of analytical results in certified reference materials must be as accurate as possible and every single step has to be fully evaluated. This paper presents the SI-traceable certification of Cu, Cr, Cd and Pb contents in geological and environmentally relevant matrices (three sediments and one fly ash sample). Certification was achieved using isotope dilution (ID) ICPMS as a primary method of measurement. In order to reduce significantly the number of analytical steps and intermediate samples a multiple spiking approach was developed. The full methodology is documented and total uncertainty budgets are calculated for all certified values. A non-element specific sample digestion process was optimised. All wet chemical digestion methods examined resulted in a more or less pronounced amount of precipitate. It is demonstrated that these precipitates originate mainly from secondary formation of fluorides (essentially CaF2) and that their formation takes place after isotopic equilibration. The contribution to the total uncertainty of the final values resulting from the formation of such precipitates was in general < 0.1% for all investigated elements. Other sources of uncertainty scrutinised included the moisture content determination, procedural blank determination, cross-contamination from the different spike materials, correction for spectral interferences, instrumental background and deadtime effects, as well as the use of either certified values or IUPAC data in the IDMS equation. The average elemental content in the sediment samples was 30-130 micrograms g-1 for Pb, 0.5-3 micrograms g-1 for Cd and 50-70 micrograms g-1 for Cu. Cr was measured in one sample and was about 60 micrograms g-1. The concentrations in the fly ash sample were up to 2 orders of magnitude higher. Expanded uncertainty for the investigated elements was about 3% (coverae factor k = 2) except for Cr, (measured by high resolution ICPMS), for which the expanded uncertainty was about 7% (k = 2).     

Reliability and validity of aggressive driving measures in China

The present research was designed to examine the psychometric properties of Chinese versions of the Self Report Driver Behavior Aggression and Assertiveness subscales, the Driving Vengeance Questionnaire, and the Violent Driving Questionnaire. Study 1 found that the all scales demonstrated good internal consistency, with alphas ranging from .76 to .87 and that assertive driving was related to demerit points received over the past 12 months while driver aggression and violence were linked to collisions over the past 12 months. Study 2 found that the scales exhibited reasonable test-retest reliability, with correlations ranging from .82 to .89. Finally, Study 3 showed that each scale was predicted by other dangerous driving attitudes and behaviors, similar to the original versions. The consistency between the translated and original scales, the implications for use in a Chinese sample, and the uniformity of actions in the traffic environment across cultures are discussed.     

The 2014 Walrus Haul Out: A Case Study of Selective Exposure to Environmental News Coverage

In this article we examine in real time the political selective exposure process involved when the public confronted the “walrus haul out” of October 2014, a news event attributed by some climate change researchers to the effects of the climate change-driven reduction of Arctic sea ice. Analyzing data assessing the amount of major TV and cable news network coverage of the haul out, and evaluating public opinion data collected from a rolling cross-sectional survey of US adults take at the time, we show that coverage of this event was not equitably distributed across news media news sources, that exposure to news source is related to the respondents’ ideological dispositions, and that exposure to coverage of the walrus haul out is related to ideology, the selectivity of political news habits, and climate change knowledge. We conclude with a discussion of the apparent inevitability of selective exposure to media coverage of climate change-related events and the implications for effective climate change communication.     

The impact of visual perspective and anger on the actor-observer bias among automobile drivers

OBJECTIVE: The present study was designed to examine the combined impact of the Actor-Observer Bias and driver anger on attributions of other drivers. METHODS: Participants watched a simulated driving sequence in which a car swerved in front of a truck in near collision. Half viewed from the perspective of the offending motorist while the other half viewed from the perspective of a trailing motorist. Participants then rated the general riskiness of the offending motorist and the responsibility of the victim driver. RESULTS: Findings support the visual perspective explanation of the Actor-Observer Bias in that attributions within a single event differed based on the random assignment of visual perspective. However, the nature of the attributions interacted with the level of anger experienced over the incident. Those viewing as a trailing motorist provided greater riskiness ratings for the offending motorist than did those viewing from the perspective of the offending motorist, but only when scoring/rating high on personal feelings of anger regarding the observed incident. CONCLUSION: The present study demonstrates that personal factors and common cognitive biases can influence how events in the traffic environment are perceived, and the subsequent judgments made of other drivers following negative events.     

Laboratory and field evaluation of a pretreatment system for removing organics from produced water

Co-produced water from the oil and gas industry accounts for a significant waste stream in the United States. This "produced water" is characterized by saline water containing a variety of pollutants, including water soluble and immiscible organics and many inorganic species. To reuse produced water, removal of both the inorganic dissolved solids and organic compounds is necessary. In this research, the effectiveness of a pretreatment system consisting of surfactant modified zeolite (SMZ) adsorption followed by a membrane bioreactor (MBR) was evaluated for simultaneous removal of carboxylates and hazardous substances, such as benzene, toluene, ethylbenzene, and xylenes (BTEX) from saline-produced water. A laboratory-scale MBR, operated at a 9.6-hour hydraulic residence time, degraded 92% of the carboxylates present in synthetic produced water. When BTEX was introduced simultaneously to the MBR system with the carboxylates, the system achieved 80 to 95% removal of BTEX via biodegradation. These results suggest that simultaneous biodegradation of both BTEX and carboxylate constituents found in produced water is possible. A field test conducted at a produced water disposal facility in Farmington, New Mexico confirmed the laboratory-scale results for the MBR and demonstrated enhanced removal of BTEX using a treatment train consisting of SMZ columns followed by the MBR. While most of the BTEX constituents of the produced water adsorbed onto the SMZ adsorption system, approximately 95% of the BTEX that penetrated the SMZ and entered the MBR was biodegraded in the MBR. Removal rates of acetate (influent concentrations of 120 to 170 mg/L) ranged from 91 to 100%, and total organic carbon (influent concentrations as high as 580 mg/L) ranged from 74 to 92%, respectively. Organic removal in the MBR was accomplished at a low biomass concentration of 1 g/L throughout the field trial. While the transmembrane pressure during the laboratory-scale tests was well-controlled, it rose substantially during the field test, where no pH control was implemented. The results suggest that pretreatment with an SMZ/MBR system can provide substantial removal of organic compounds present in produced water, a necessary first step for many water-reuse applications.     

Sorption of arsenic from soil-washing leachate by surfactant-modified zeolite

Post-treatment of leachate from soil-washing remedial actions may be necessary depending on the amounts of dissolved contaminants present. Uptake of arsenic species by surfactant-modified zeolite (SMZ) from a synthetic soil leachate (pH of approximately 12 [NaOH]) was measured as a test of SMZ as a post-treatment sorbent. Batch sorption isotherms were prepared using leachate to SMZ ratios from 40:1 to 4:1, and temperatures of 25 and 15 degrees C. Equilibrium levels of dissolved and total solution arsenic were similar. At each temperature, sorption appeared to reach a plateau or maximum, then decreased at the highest solution concentration, corresponding to the lowest amount of zeolite added (2.5 g). A maximum sorption value of 72.0 mmol of arsenic per kg of SMZ (5400 mg/kg) was observed at 25 degrees C, and 42.1 mmol/kg (3150 mg/kg) at 15 degrees C. Total arsenic recoveries varied from 74 to 125%. Surfactant-modified zeolite removed up to 97% of dissolved organic carbon and decolorized the leachate solutions. Excluding the points for the highest arsenic to SMZ ratio, the sorption isotherms were well described by the linearized form of the Langmuir equation, with coefficients of determination greater than 0.90 at both temperatures. Sorption of arsenic by SMZ is attributed to anion exchange with counterions on the surfactant head groups, and/or partitioning of organic carbon-complexed arsenic into the surfactant bilayer.