Injection-Molded Bioblends from Lignin and Biodegradable Polymers: Processing and Performance Evaluation

This paper investigates the effects of the incorporation of lignin and small quantities of epoxidized natural rubber (ENR) as an impact modifying agent on blends of poly(3-hydroxybutyrate-co-3-hydroxyvalerate) (PHBV) and poly(ε-caprolactone) (PCL). The addition of lignin resulted in a slight improvement of flexural strength and modulus of the ternary blending system. Incorporation of ENR into the blend resulted in an increase in notched Izod impact strength from 40 to 135% depending on the concentration of ENR. The addition of lignin into the blend resulted in an improvement of thermal stability of the ternary blend system. Morphological analysis showed a good dispersion of PHBV phases and lignin within the PCL matrix. Rheological characterization revealed that the presence of lignin resulted in increased storage modulus of the bioblend.     

Improvement of Impact Toughness of Biodegradable Poly(butylene succinate) by Melt Blending with Sustainable Biobased Glycerol Elastomers

Poly(butylene succinate) (PBS) was melt blended with glycerol based polyesters (PGS) synthesized from pure and technical glycerol aiming to improve the impact strength of PBS. It was found that after addition of 30 wt% PGS to PBS its impact strength was significantly increased by 344% (from 31.9 to 110 J/m) and its elongation at break was maintained at 220%. Infrared spectra of the blends showed the presence of hydroxyl groups from the PGS phase suggesting that hydrogen bonding between the phases could be responsible for a good stress transfer and an efficient toughening in the PBS/PGS blends. Scanning electron microscopy imaging showed a good dispersion of PGS phase into PBS with a PGS particle size of 10 μm and less and no agglomeration. Addition of PGS to PBS was shown to be an effective strategy for improvement of PBS impact resistance without serious detrimental effects on its thermal and rheological properties.     

Effect of Humic Acid on the Bioavailability of γ-Hexachlorocyclohexane in Marsilea Minuta (L.)

Effect of various concentrations of humic acid (0.2 to 1%) on thebioavailability of -HCH in vegetative clones of theaquatic fern Marsilea minuta was studied in a staticexperimental bioassay system on different photoperiods. Additionof humic acid showed the reduction in the bioavailability of-HCH in all the photoperiods (72 hr light to 144 hrlight) at the interval of 16 hr light (L) and 8 hr dark (D) inboth aerial and submerged portion as compared to controlindicating its protective role in toxicity.     

Risk assessment of water pollutants

The sources of toxic xenobiotics and different factors such as ecological diversity, differences in comparative anatomy, physiology and biochemistry, food chain variation, interrelationship within species and life span, etc., are considered during risk assessment of pollutants, and their impact on aquatic ecotoxicology is identified. A fugacity and multimedia compartment model is suggested, based on toxicodynamic (toxicity of the chemical) and toxicokinetic (metabolism of the chemical) considerations to predict and screen the behaviour of pollutants quantitatively in the aquatic environment. The significance of the risk analysis approach in anticipatory actions and regulation of pollution levels is discussed.     

Will funding to Reduce Emissions from Deforestation and (forest) Degradation (REDD+) stop conversion of peat swamps to oil palm in orangutan habitat in Tripa in Aceh,Indonesia?

Tripa is the last remaining peat-swamp forest that harbours a potentially viable Sumatran orangutan (Pongo abelii) sub-population in a formally but not effectively protected area. It appears to be a simple showcase where current efforts to financially support reducing emissions from deforestation and forest degradation (REDD+) converge with biodiversity and social co-benefits. In practice, however, situation is more complex. REDD+ efforts interact with global palm oil trade and regulatory approaches (the moratorium) to achieve national goals for emissions reduction under umbrella of nationally appropriate mitigation actions (NAMA). To contextualize this debate, we assessed (i) land-use history and formal basis of palm-oil companies’ rights; (ii) carbon (C) stocks, historical emission levels and potential emissions that can be avoided; (iii) economic benefits of land-use options and opportunity costs of avoiding emissions; (iv) biodiversity and environmental services; and (v) alternative options for “high C stock development” and employment generation. Natural forest cover declined (54 % in 1995, 18 % in 2009) while oil palm increased 4–39 %. Aboveground C stocks decreased from 148 Mg ha^?1 in 1990 to 61 Mg ha^?1 in 2009, leading to average annual emissions of 14.5 Mg (carbon dioxide) CO₂e ha^?1 year^?1. While 41 % of these emissions yield less than American Dollar (USD) 5 of current economic benefits per Mg CO₂e emitted and might be compensated by REDD+, nearly all new emissions derive from a breach of existing laws, regulations and voluntary palm-oil standards. Substantial investment in alternative employment is needed, rather than carbon payments per se, to support livelihoods in a low carbon emissions economy.     

Laboratory and Field Evaluation of Measurement Methods for One-Hour Exposures to O3, PM25, and CO

ABSTRACT

While researchers have linked acute (less than 12-hr) ambient O₃, PM₂₅, and CO concentrations to a variety of adverse health effects, few studies have characterized short-term exposures to these air pollutants, in part due to the lack of sensitive, accurate, and precise sampling technologies. In this paper, we present results from the laboratory and field evaluation of several new (or modified) samplers used in the “roll-around” system (RAS), which was developed to measure 1-hr O₃, PM₂₅, and CO exposures simultaneously. All the field evaluation data were collected during two sampling seasons: the summer of 1998 and the winter of 1999.

To measure 1-hr O₃ exposures, a new active O₃ sampler was developed that uses two nitrite-coated filters to measure O₃ concentrations. Laboratory chamber tests found that the active O₃ sampler performed extremely well, with a collection efficiency of 0.96 that did not vary with temperature or relative humidity (RH). In field collocation comparisons with a reference UV photometric monitor, the active O₃ sampler had an effective collection efficiency ranging between 0.92 and 0.96 and a precision for 1-hr measurements ranging between 4 and 6 parts per billion (ppb). The limits of detection (LOD) of this method were 9 ppb-hr for the chamber tests and ~16 ppb-hr for the field comparison tests.

PM_2.5 and CO concentrations were measured using modified continuous monitors—the DustTrak and the Langan, respectively. A size-selective inlet and a Nafion dryer were placed upstream of the DustTrak inlet to remove particles with aerodynamic diameters greater than 2.5 um and to dry particles prior to the measurements, respectively. During the field validation tests, the DustTrak consistently reported higher PM_2.5 concentrations than those obtained by the collocated 12-hr PM_{2 5} PEM samples, by approximately a factor of 2. After the DustTrak response was corrected (correction factor of 2.07 in the summer and 2.02 in the winter), measurements obtained using these methods agreed well with R² values of 0.87 in the summer and 0.81 in the winter. The results showed that the DustTrak can be used along with integrated measurements to measure the temporal and spatial variation in PM_{2 5} exposures. Finally, during the field validation tests, CO concentrations measured using the Langan were strongly correlated with those obtained using the reference method when the CO levels were above the LOD of the instrument [~1 part per million (ppm)].     

Effects of soil amendments on the bioavailability of heavy metals from zinc mine tailings

A study was conducted to test the effects of soil amendments on the bioavailability of heavy metals in a zinc mine tailings containing soil to plants, using the Indian mustard plant (Brassica juncea) as a test organism. Zinc mine tailing containing soil was amended with humus soil (HS) and phosphatic clay (PC). The zinc mine tailing containing soil (ZMTS) was characterized for heavy metals. It was mixed with PC and HS, and four mixtures were prepared. The first mixture contained ZMTS, and served as a control. The second mixture contained ZMTS and PC in the ratio of 1:1 (w/w). The third mixture contained ZMTS and HS in the ratio of 1:1(w/w). The fourth mixture containing ZMTS, PC and HS in the ratio of (2:1:1) (w/w). A slight increase in the bioavailability of Pb, Cu, Zn and Mn was noticed with increase in the incubation time from 14 to 42 days. The bioavailability of Pb, Cu, Zn and Mn from ZMTS alone in Brassica plant was in the range of 94-99% up to 42 days. Addition of PC and HS to the ZMTS soil reduced the bioavailabilities of Pb by (15%), of Cu by (20%), of Zn by (20%) and of Mn by (25%) in the mustard plant. The data showed that PC in the presence of HS had a high affinity for the heavy metals in the order of Pb, Cu, Zn and Mn.     

Thermodynamics of interaction of lindane on silty loam and silty clay loam Indian soils

Abstract

Interaction of lindane with silty loam and silty clay loam soils was studied in batch tests at 23, 30 and 37° C. Sorption experiments were carried out at four concentrations and for varying time of contact upto 72 hours. This was followed by desorption studies. No desorption was observed. The sorption data was analysed using sorption equations and evaluating the thermodynamic parameters. The sorption was found to be predominantly entropic in nature and a combined effect of adsorption and chemisorption. The effect of organic matter and other chemical and mineralogical constituents of soils has also been discussed. The sorption with single application of lindane with the two soil types indicates that the insecticide is less likely to reach groundwater.     

Assessment of industrial effluent and its impact on soil and plants

The present study deals with the assessment of industrial water of an electronic component manufacturing unit with electroplating and its subsequent effects on soil and plants receiving the effluent. The physico-chemical parameters of the effluent samples showed higher value than that of ground water. The treated effluent was within the permissible limit. Microtox test was conducted and determined the degree of toxicity of untreated, treated effluents as well as the water sample collected at effluent discharge point of receiving river (confluence point). The physico- mechanical parameters of the soil samples were not changed due to irrigation of the treated effluent, but the concentration of metals were comparatively higher than the control soil. Higher accumulation of metals was found in the plant parts in naturally growing weeds and cultivated crop plant irrigated with treated effluent. Elevated accumulation of metals in Eichhornia crassipes and Marsilea sp. growing along the effluent channel has been identified as a potential source of biomonitoring of metals particularly for Cu and Ca and can be utilised for the removal of heavy metal from wastewater.     

Sample storage and extraction efficiencies in determination of polycyclic and nitro musks in sewage sludge

Analytical technology is continuously improving, developing better methods for isolating and concentrating trace compounds in environmental samples. Polycyclic and nitro musks (PNMs) are one group of emerging trace compounds detected in municipal wastewater. Differences in sample storage, preparation, and extraction methods for their measurement have led to variability in results. We analyzed 11 PNMs by GC/MS and compared the results of different storage times and extraction methods (supercritical fluid (SFE) or microwave-assisted (MAE)) for 202 samples of primary sludge, waste activated sludge (WAS), raw sludge, and aerobically/anaerobically digested biosolids collected from Canadian municipal wastewater treatment plants. Sixty-three air-dried samples were extracted by SFE, and 139 air-dried, centrifuged, or filtered samples were extracted by MAE. The mean surrogate recoveries were 89% (standard deviation (SD)=11%) for d(10)-anthracene by SFE and 88% (SD=14%) for d(10)-phenanthrene by MAE. Storage study results showed that PNM concentrations changed by a mean of 7% and 9% for primary sludge and WAS respectively after four weeks and decreased up to 25% after 13.5 months of storage in amber glass containers at -18 degrees C. Air-drying of sludge at room temperature caused losses of about 50% of PNM concentrations compared to centrifugation. The proportions of PNMs present in the liquid phase of sludge samples were less than 5% compared to proportions in the sludge solids. The most complete liquid-solid separation was achieved by filtration of frozen/thawed sludge samples, producing a liquid phase that contained less than 1% of the total musk content of the sample.