Emergency department visits by pediatric patients sustained as a passenger on a motorcycle

Objective: Currently only 5 out of the 50 states in the United States have laws restricting the age of passengers permitted to ride on a motorcycle. This study sought to characterize the visits by patients under the age of 16 to U.S. emergency departments (EDs) for injuries sustained as a passenger on a motorcycle.

Methods: In this retrospective cohort study, data were obtained from the Nationwide Emergency Department Sample (NEDS) for the years 2006 to 2011. Pediatric patients who were passengers on a motorcycle that was involved in a crash were identified using International Classification of Diseases, Ninth Revision (ICD-9) External Cause of Injury codes. We also examined gender, age, disposition, regional differences, common injuries, and charges.

Results: Between 2006 and 2011 there were an estimated 9,689 visits to U.S. EDs by patients under the age of 16 who were passengers on a motorcycle involved in a crash. The overall average patient age was 9.4 years, and they were predominately male (54.5%). The majority (85%) of these patients were treated and released. The average charges for discharged patients were $2,116.50 and amounted to roughly $17,500,000 during the 6 years. The average cost for admission was $51,446 per patient and totaled over $54 million. The most common primary injuries included superficial contusions; sprains and strains; upper limb fractures; open wounds of head, neck, and trunk; and intracranial injuries.

Conclusion: Although there were only about 9,700 visits to U.S. EDs for motorcycle crashes involving passengers less than 16 years old for 2006 to 2011, the total cost of visits that resulted in either ED discharge or hospital admission amounted to over $71 million.     

Fluoride removal and its impact on oral health in Sri Lanka's dry zone: Discussion and recommendation

Fifty percent of the dry zone areas in Sri Lanka have fluoride levels above 1 ppm. This paper discusses the ground conditions and recommends an appropriate range of fluoride in drinking water which can support preventive practices for improving the oral health of children 8-years old and younger. In efforts to address the Chronic Kidney Disease of Unknown etiology (CKDU), water treatment to reduce contaminant level in potable water has been implemented. Such treatment would also remove fluoride and has resulted in potable water with various fluoride levels, depending on concentrations in the raw water. While it is important to reduce fluoride levels, it is important to have appropriate residual levels for prevention of dental caries. It needs, however, to be noted fluoride in excess can cause dental fluorosis. In Sri Lanka's dry zone areas increasing prevalence of dental fluorosis with decreasing prevalence of dental caries has been noted. Consumption of tea and powdered milk could increase total intake of fluoride. Fluoridated toothpaste, when used properly, may, however, result in negligible intake of fluoride. Sri Lanka's hot tropical climate which results in substantial intake of fluids reinforces the need to consider reduction in water fluoride. Consideration of local studies and international standards indicate fluoride levels should be in the range of 0.225–0.500 ppm. In the range of 0.225–0.500 ppm, the prevalence of dental fluorosis and caries was only 14% and 8%, respectively, in an endemic district. When fluoride levels are above 0.500 ppm, the issue of dental fluorosis shall need to be addressed. When levels are below 0.225 ppm, oral health care services shall need to be directed at preventing dental caries.     

Mechanism and catalytic performance for direct dimethyl ether synthesis by CO2 hydrogenation over CuZnZr/ferrierite hybrid catalyst

Direct synthesis of dimethyl ether(DME) by CO_2 hydrogenation has been investigated over three hybrid catalysts prepared by different methods:co-precipitation,sol-gel,and solid grinding to produce mixed Cu,ZnO,ZrO_2 catalysts that were physically mixed with a commercial ferrierite(FER) zeolite.The catalysts were characterized by N_2 physisorption,X-ray diffraction(XRD),transmission electron microscopy(TEM),X-ray photoelectron spectroscopy(XPS),temperature programmed desorption of CO_2(CO_2-TPD),temperature programmed desorption of NH_3(NH_3-TPD),and temperature programmed H2 reduction(H_2-TPR).The results demonstrate that smaller CuO and Cu crystallite sizes resulting in better dispersion of the active phases,higher surface area,and lower reduction temperature are all favorable for catalytic activity.The reaction mechanism has been studied using in situ diffuse reflectance infrared Fourier transform spectroscopy(DRIFTS).Methanol appears to be formed via the bidentate-formate(b-HCOO) species undergoing stepwise hydrogenation,while DME formation occurs from methanol dehydration and reaction of two surface methoxy groups.     

Parameter values to model the soil ingestion pathway

Soil ingestion is an important exposure pathway for contaminants that are not otherwise very mobile in the environment. Health of both humans and animals can be affected. This paper summarizes the literature and recommends models and probabilistic parameter values for risk assessment applications. Models of the pathway require estimates of the amounts of soil ingested, the concentration of contaminants relative to the original soil, and the bioavailability in the gut of the contaminants ingested with soil. Using a lead-contaminated sandbox as an example, the modelling recommendations suggest that a child typically may consume 50 mg d^–1 of the sandbox soil, the soil ingested will have a tenfold higher lead concentration than the original soil, and the lead will be as bioavailable as if ingested as inorganic lead in water.The Canadian Government right to retain a non-exclusive, royalty free licence in and to any copyright is acknowledged.     

Paleolimnological assessment of Grove and Plow Shop Ponds, Ayer, Massachusetts, USA--a superfund site

Three sediment cores from each of severely polluted Grove and Plow Shop Ponds, Ayer, Massachusetts, USA, were dated using (210)Pb, characterized for plant macrofossil assemblages, and analyzed for H(2)O, loss-on-ignition, stable Pb isotopes, and concentrations of As, Ca, Cd, Cr, Cu, Fe, Hg, methyl-Hg, Ni, Pb, and Zn. A core from nearby kettle Spectacle Pond, Littleton, Massachusetts, was similarly characterized (except for plant macrofossil assemblages) to assess the regional air pollution signal in sediment for comparison with the six cores. Accumulation rates for metals (mass per area per year), the anthropogenic component (mass per area per year), and total accumulation of the anthropogenic component (mass per area) indicate that As, Cd, Cr, Cu, Hg, methyl-Hg, Ni, Pb, and Zn have accumulated in sediment as a consequence of point source pollution from within the drainage basins of Grove and Plow Shop Ponds. Three distinct sources of pollution are inferred. As is entering Plow Shop Pond via groundwater in the southwest. Cd, Ni, Pb, and Zn are entering the system predominantly at the eastern end of, or upstream from, Grove Pond. Pb also comes from the northwest corner of Grove Pond, the principal source of Cr, Cu, and Hg. These results are consistent with chemistry of modern surface sediments. The history of pollution extends back more than 100 years. Intra- and inter-core variability of concentrations and accumulation rates indicate that much of the pollution was likely in particulate form with little physical redistribution. Recently, concentrations and accumulation rates have generally decreased substantially for those elements present in excessive concentrations in the past. This is a consequence of accumulation of recent, less polluted sediment. In Spectacle Pond, the nearby reference lake, accumulation rates for As, Cd, Hg, and Pb, adjusted for background values and changes in sedimentation rate, increased above background starting in the late 19th century, peaked about 1980, and declined substantially to 2000. These decreases suggest that the anthropogenic (pollution) component of atmospheric deposition of these elements declined after 1980 by at least 50%(As), 80%(Cd), 80%(Hg), and 80%(Pb).     

Naphthalene and its biomarkers as measures of occupational exposure to polycyclic aromatic hydrocarbons

Polycyclic aromatic hydrocarbons (PAH) include compounds with two or more fused benzene rings, many of which are carcinogens. Industrial sources produce hundreds of PAH, notably in the coke- and aluminium-producing industries. Because PAH are distributed at varying levels between gaseous and particulate phases, exposure assessment has been problematic. Here, we recommend that occupational exposures to naphthalene be considered as a potential surrogate for occupational PAH exposure for three reasons. Naphthalene is usually the most abundant PAH in a given workplace; naphthalene is present almost entirely in the gaseous phase and is, therefore, easily measured; and naphthalene offers several useful biomarkers, including the urinary metabolites 1- and 2-hydroxynaphthalene. These biomarkers can be used to evaluate total-body exposure to PAH, in much the same way that 1-hydroxypyrene has been applied. Using data from published sources, we show that log-transformed airborne levels of naphthalene are highly correlated with those of total PAH (minus naphthalene) in several industries (creosote impregnation: Pearson r= 0.815, coke production: r= 0.917, iron foundry: r= 0.854, aluminium production: r= 0.933). Furthermore, the slopes of the log-log regressions are close to one indicating that naphthalene levels are proportional to those of total PAH in those industries. We also demonstrate that log-transformed urinary levels of the hydroxynaphthalenes are highly correlated with those of 1-hydroxypyrene among coke oven workers and controls (r= 0.857 and 0.876), again with slopes of log-log regressions close to one. These results support the conjecture that naphthalene is a useful metric for occupational PAH exposure. Since naphthalene has also been shown to be a respiratory carcinogen in several animal studies, it is also argued that naphthalene exposures should be monitored per se in industries with high levels of PAH.