Fluoride removal and its impact on oral health in Sri Lanka's dry zone: Discussion and recommendation

Fifty percent of the dry zone areas in Sri Lanka have fluoride levels above 1 ppm. This paper discusses the ground conditions and recommends an appropriate range of fluoride in drinking water which can support preventive practices for improving the oral health of children 8-years old and younger. In efforts to address the Chronic Kidney Disease of Unknown etiology (CKDU), water treatment to reduce contaminant level in potable water has been implemented. Such treatment would also remove fluoride and has resulted in potable water with various fluoride levels, depending on concentrations in the raw water. While it is important to reduce fluoride levels, it is important to have appropriate residual levels for prevention of dental caries. It needs, however, to be noted fluoride in excess can cause dental fluorosis. In Sri Lanka's dry zone areas increasing prevalence of dental fluorosis with decreasing prevalence of dental caries has been noted. Consumption of tea and powdered milk could increase total intake of fluoride. Fluoridated toothpaste, when used properly, may, however, result in negligible intake of fluoride. Sri Lanka's hot tropical climate which results in substantial intake of fluids reinforces the need to consider reduction in water fluoride. Consideration of local studies and international standards indicate fluoride levels should be in the range of 0.225–0.500 ppm. In the range of 0.225–0.500 ppm, the prevalence of dental fluorosis and caries was only 14% and 8%, respectively, in an endemic district. When fluoride levels are above 0.500 ppm, the issue of dental fluorosis shall need to be addressed. When levels are below 0.225 ppm, oral health care services shall need to be directed at preventing dental caries.     

Development of a composite line source emission model for traffic interrupted microenvironments and its application in particle number emissions at a bus station

A composite line source emission (CLSE) model was developed to specifically quantify exposure levels and describe the spatial variability of vehicle emissions in traffic interrupted microenvironments. This model took into account the complexity of vehicle movements in the queue, as well as different emission rates relevant to various driving conditions (cruise, decelerate, idle and accelerate), and it utilised multi-representative segments to capture the accurate emission distribution for real vehicle flow. Hence, this model was able to quickly quantify the time spent in each segment within the considered zone, as well as the composition and position of the requisite segments based on the vehicle fleet information, which not only helped to quantify the enhanced emissions at critical locations, but it also helped to define the emission source distribution of the disrupted steady flow for further dispersion modelling. The model then was applied to estimate particle number emissions at a bi-directional bus station used by diesel and compressed natural gas fuelled buses. It was found that the acceleration distance was of critical importance when estimating particle number emission, since the highest emissions occurred in sections where most of the buses were accelerating and no significant increases were observed at locations where they idled. It was also shown that emissions at the front end of the platform were 43 times greater than at the rear of the platform. Although the CLSE model is intended to be applied in traffic management and transport analysis systems for the evaluation of exposure, as well as the simulation of vehicle emissions in traffic interrupted microenvironments, the bus station model can also be used for the input of initial source definitions in future dispersion models.     

Air ion concentrations in various urban outdoor environments

Atmospheric ions are produced by many natural and anthropogenic sources and their concentrations vary widely between different environments. There is very little information on their concentrations in different types of urban environments, how they compare across these environments and their dominant sources. In this study, we measured airborne concentrations of small ions, particles and net particle charge at 32 different outdoor sites in and around a major city in Australia and identified the main ion sources. Sites were classified into seven groups as follows: park, woodland, city centre, residential, freeway, power lines and power substation. Generally, parks were situated away from ion sources and represented the urban background value of about 270 ions cm^?3. Median concentrations at all other groups were significantly higher than in the parks. We show that motor vehicles and power transmission systems are two major ion sources in urban areas. Power lines and substations constituted strong unipolar sources, while motor vehicle exhaust constituted strong bipolar sources. The small ion concentration in urban residential areas was about 960 cm^?3. At sites where ion sources were co-located with particle sources, ion concentrations were inhibited due to the ion-particle attachment process. These results improved our understanding on air ion distribution and its interaction with particles in the urban outdoor environment.     

Demonstrations of coal-fired oxy-fuel technology for carbon capture and storage and issues with commercial deployment

As one of the three major carbon capture technologies associated with carbon capture and storage (CCS), oxy-fuel technology is currently undergoing rapid development with a number of international demonstration projects of scale 10–30 MW_e having commenced and units with a scale of 250–300 MW_e emerging in the progression towards commercialisation. Industrial scale testing of coal combustion and burners is also being conducted by technology vendors.The paper details the current international status of the technology; the contributions of current demonstrations; and a roadmap for commercial deployment.At its current state of maturity oxy-fuel technology may be considered semi-commercial, in that even if a unit was economically viable and could be provided by a vendor, the generator and vendor would need to share the technical risk. This is because guarantees could not at present be provided for operating characteristics associated with mature technologies such as reliability, emissions, ramp rate and spray control. This is due to the maturity of the technology associated with the capability of vendors and associated design and operational uncertainties, associated with a lack of plant experience at scale.The projected development of oxy-fuel technology for first-generation plant is provided, using an ASU for oxygen supply, standard furnace designs with externally recirculated flue gas, and limited thermal integration of the ASU and compression plant with the power plant. Potential features of second generation technology are listed.Listed issues delaying deployment indicate that market, economic, legal and issues of public acceptance are more significant than technical barriers.     

Magnetic properties of biogenic selenium nanomaterials

Environmental Science and Pollution Research - Bioreduction of selenium oxyanions to elemental selenium is ubiquitous; elucidating the properties of this biogenic elemental selenium (BioSe) is thus...     

Deriving state-and-transition models from an image series of grassland pattern dynamics

We present how state-and-transition models (STMs) may be derived from image data, providing a graphical means of understanding how ecological dynamics are driven by complex interactions among ecosystem events. A temporal sequence of imagery of fine scale vegetation patterning was acquired from close range photogrammetry (CRP) of 1 m quadrats, in a long term monitoring project of Themeda triandra (Forsskal) grasslands in north western Australia. A principal components scaling of image metrics calculated on the imagery defined the state space of the STM, and thereby characterised the different patterns found in the imagery. Using the state space, we were able to relate key events (i.e. fire and rainfall) to both the image data and aboveground biomass, and identified distinct ecological ‘phases’ and ‘transitions’ of the system. The methodology objectively constructs a STM from imagery and, in principle, may be applied to any temporal sequence of imagery captured in any event-driven system. Our approach, by integrating image data, addresses the labour constraint limiting the extensive use of STMs in managing vegetation change in arid and semiarid rangelands.     

Industrial water conservation by water footprint and sustainable development goals: a review

Environment, Development and Sustainability - Application of advanced techniques to ensure the environment sustainability and freshwater ecosystem conservation is a paramount importance. Industrial...     

Using adaptive governance to rethink the way science supports Australian drought policy

In this paper we show how ideas from a longstanding but little recognised literature on adaptive governance can be used to rethink the way science supports Australian drought policy. We compare and contrast alternative ways of using science to support policy in order to critique traditional commentary on Australian drought policy. We find that criticism from narrow disciplinary and institutional perspectives has provided few practical options for policy makers managing these complex and interacting goals. In contrast, ideas from a longstanding but little recognised literature on adaptive governance have potential to create innovative policy options for addressing the multiple interacting goals of Australian drought policy.From an adaptive governance perspective, the deep concern held by Australian society for rural communities affected by drought can be viewed as a common property resource that can be sustainably managed by governments in cooperation with rural communities. Managing drought assistance as a common property resource can be facilitated through nested and polycentric systems of governance similar to those that have already evolved in other arenas of natural resource management in Australia, such as Landcare groups and Catchment Management Authorities. Essential to delivering these options is the creation of flexible, regionally distributed scientific support for drought policy capable of integrating local knowledge and informing the livelihood outcomes of critical importance to governments and rural communities.     

Supporting the risk management process with land information: a case study of Australia

It is frequently argued that, at the parcel level, 1 stakeholders are capable of and well supported in managing their land‐related risks. Yet, evidence from the contemporary Australian context suggests otherwise: numerous large‐scale disaster events have revealed that citizens are ill‐prepared to respond and recover adequately. This paper begins with the premise that information, specifically land information, could better support parcel‐level risk preparation, mitigation, response, and recovery. State land administration organisations in Australia primarily maintain this information and make it accessible. Land information is used regularly across all levels of government to support risk management activities; however, such application has not always occurred at the parcel and citizen level. Via a case study approach, this paper initially explores the land information available in Australia to stakeholders interested in parcel‐level detail, and then goes on to propose how the utilisation of parcel‐level land information could serve to enhance risk management practices.