Pre-concentration and separation of heavy metal ions by chemically modified waste paper gel

Iminodiacetic acid was immobilized on waste paper by chemical modification in order to develop a new type of adsorption gel for heavy metal ions. Adsorption behavior of the gel was investigated for a number of metal ions, specifically Cu(II), Pb(II), Fe(III), Ni(II), Cd(II), and Co(II) at acidic pH. From batch adsorption tests, the order of selectivity was found to be as follows: Cu(II)  Fe(III) > Pb(II) > Ni(II)  Co(II) > Cd(II). Column tests were carried out for pairs of metal ions to understand the separation and pre-concentration behavior of the gel. It was found that mutual separation of Ni(II) from Co(II) and that of Pb(II) from Cd(II) can be achieved at pH 3. Similarly, selective separation of Cu(II) from Cu(II)–Fe(III) and Cu(II)–Pb(II) mixtures at pH 1.5 and 2, respectively, was observed by using this new adsorption gel. In all cases, almost complete recovery of the adsorbed metal was confirmed by elution tests with HCl.     

Removal of thiobencarb in aqueous solution by zero valent iron

A cost-effective method with zero valent iron (ZVI) powder was developed for the purification of thiobencarb (TB)-contaminated water. The removal treatment was performed in the batch system. A sample solution of 10 ml containing 10 microg ml(-1) of TB could be almost completely treated by 100mg of ZVI at 25 degrees C for 12h of treatment time. Since the formation of chloride ion in the aqueous solution during the treatment of TB was observed, the removal of TB with ZVI may contain two processes: reduction (degradation) and adsorption. Because the present treatment for TB is simple, easy handling and cheap, the developed technology with ZVI can contribute to the treatment of agricultural wastewaters.     

Initial ecological risk assessment of eight selected human pharmaceuticals in Japan.

Eight pharmaceuticals were selected on the basis of their domestic consumption in Japan, the excretion ratio of the parent compound and the frequency of detection in the aquatic environment or wastewater treatment plant effluent. Toxicity tests on these pharmaceuticals were conducted using Japanese medaka (Oryzias latipes), daphnia (Daphnia magna), and green algae (Psuedokirchneriella subcapitata). Predicted no effect concentration (PNEC) was calculated using lethal or effect concentration 50 (LC50 or EC50) values and no effect concentration (NOEC) obtained in the toxicity tests for these compounds. Predicted environmental concentration (PEC) was also calculated from annual consumption, the excretion rate of the parent compound, and removal rate in the preliminary batch activated sludge treatment performed in this study. Maximum concentrations found in the aquatic environment or sewage effluent in Japan or foreign countries were also used for another calculation of PEC. Initial risk assessment on the selected pharmaceuticals was performed using the PEC/PNEC ratio. The results of initial risk assessment on the eight selected pharmaceuticals suggest neither urgent nor severe concern for the ecological risk of these compounds, but further study needs to be conducted using chronic toxicity tests, including reproduction inhibition and endocrine disruption assessments.     

Application of compost in agricultural practice could potentially cause contamination of foodstuffs with pathogenic bacteria such as Escherichia coli O157:H7. This study investigated pathogenic bacteria in compost collected from the compost facilities, an

IntroductionIncreasing public interests have been concerned onsafety foods and the environmental aspects recently,especially on the so-called organic foods , which are madefromcrops grown with organic fertilizers or compost but notchemical fertilizers .Pu…     

Effectiveness of resistivity monitoring for interpreting temporal changes in landfill properties

It is always possible for impermeable layers to exist in landfills. When they do, the properties of the solution at the exit of the leachate-collection system might not accurately reflect the overall properties of the landfill. This study examines whether resistivity monitoring is effective for determining the influence of impermeable layers on the leachate. The test cell used in this study was filled with waste made up mainly of incinerator ash and shredded incombustible material. Three lines of resistivity sensors were laid in the uppermost layer of the fill. A resistivity profile was recorded periodically from each of these lines. The water-table level and leachate properties were measured concurrently. Leachate conductivity was mainly controlled by concentrations of the main ions, and it correlated inversely to variations in resistivity. Temporal changes in the resistivity of the fills are an excellent means of assessing the leaching in fills. Monitoring the properties of leachate, combined with resistivity profiling, is extremely useful for interpreting the temporal changes of properties in landfills containing impermeable layers.     

Reduction of hazardous elements contained in sewage sludge incineration ash

Research and experimental studies were carried out in relation to reduction of hazardous elements contained in sewage sludge incineration ash. A questionnaire survey was conducted in 69 Japanese municipalities with sewage sludge incineration facilities. Selenium content in bag filter ash and ceramic filter ash was relatively higher than that in ash of cyclone and electrostatic precipitators. It was assumed that selenium vaporized in the furnace was due to adsorb in the fly ash on filter when passing through the low-temperature filter. To reduce high boiling point heavy metals in the ash, sewage sludge and incineration ash were heated up using a small muffle furnace. As the result, the chrome and nickel contents were reduced. A decrease in the surface area of ash and the reduction of elements occurred at the same time in sewage sludge and incineration ashes tested in this study.     

Influence of oxygen flow rate on reaction rate of organic matter in leachate from aerated waste layer containing mainly incineration ash

It is known that aeration reduces rapidly the concentration of organic matter in leachate. However, the oxygen flow rate required to attain a certain reaction rate of organic matter should be carefully estimated. In this study, using the oxygen ratio (the ratio of oxygen flow rate by aeration to oxygen consumption rate of waste layer) as a parameter, the reaction rate of organic matter in leachate from landfilled incineration ash and incombustible waste upon aeration was evaluated. Total organic carbon (TOC) in the leachate was reduced rapidly when the oxygen ratio was high. The decomposition rate exceeded the elution rate of TOC in the leachate from the waste layer for several days when the oxygen ratio was above 10². The results indicate that the oxygen ratio can be used as a parameter for the aeration operation in actual landfill sites, to rapidly stabilize organic matter in leachate.     

Removal of Linear and Branched p-Alkylphenols from Aqueous Solution by Combined Use of melB Tyrosinase and Chitosan Beads

In this study, melB tyrosinase was applied for enzymatic removal of linear and branched p-alkylphenols from aqueous solutions. First, systematic studies were carried out to estimate the effects of the process parameters such as the temperature, pH value, and enzyme dose on quinone conversion of p-cresol as a model phenol compound. A variety of p-alkylphenols were removed from aqueous solutions through the tyrosinase-catalyzed quinone conversion and subsequent nonenzymatic adsorption of quinone derivatives on chitosan beads at pH 6.0 and 30 °C under the optimum conditions determined for p-cresol. The % removal values of 98–100 were obtained for p-n-alkylphenols. Branched p-alkylphenols with a weak estrogenic activity containing 4-tert-butylphenol and 4-tert-pentylphenol, which underwent no quinone conversion by commercially available mushroom tyrosinase in the absence of H₂O₂, were also effectively removed by further increasing either the melB tyrosinase concentration or the amount of added chitosan beads. The present technique is much effective in the fact that a series of reactions rapidly progress under mild conditions and the chitosan beads can be readily separated from the reaction medium after the enzymatic treatment.     

Effect of acid solutions on plants studied by the optical beam deflection method

The optical beam deflection method was applied to study the effects of acid solution on both a terrestial and aquatic plants Egeria and Cerastium, which are common aquatic plant and terrestial weed respectively. A probe beam from a He-Ne laser was passed through a vicinity of a leaf of the plants, which were put in culture dishes filled with acid solutions. Deflection signals of the probe beam were monitored and compared for acid solutions with different pH values. The results of Egria showed that the deflection signals changed dramatically when pH values of acid solutions were 2.0 and 3.0, while little at pH of 4.0 and 5.0. For Cerastium when pH were below 3.0, deflection signals changed greatly with time at the begining. After a certain period of time, deflection signals changed little with time. When pH value was above 4.0, deflection signals of Cerastium were still changing with time even after 20 hours. The results suggested that the damage threshold of pH was between 3.0 and 4.0 for both the land and aquatic plants.     

The effects of mating status and time since mating on female sex pheromone levels in the rice leaf bug,Trigonotylus caelestialium

Although mating status affects future mating opportunities, the biochemical changes that occur in response to mating are not well understood. This study investigated the effects of mating status on the quantities of sex pheromone components found in whole-body extracts and volatile emissions of females of the rice leaf bug, Trigonotylus caelestialium. When sampled at one of four time points within a 4-day postmating period, females that had copulated with a male had greater whole-body quantities of sex pheromone components than those of virgin females sampled at the same times. The quantities of sex pheromone components emitted by virgin females over a 24-h period were initially high but then steadily decreased, whereas 24-h emissions were persistently low among mated females when measured at three time points within the 4 days after mating. As a result, soon after mating, the mated females emitted less sex pheromones than virgin females, but there were no significant differences between mated and virgin females at the end of the experiment. Thus, postmating reduction in the rate of emission of sex pheromones could explain previously observed changes in female attractiveness to male T. caelestialium.