Photochemical Smog Modelling Using the Air Pollution Chemical Transport Model (TAPM-CTM) in Ho Chi Minh City,Vietnam

Environmental Modeling & Assessment - This paper describes the application of the air pollution model (TAPM-CTM) for photochemical airshed modelling in the Ho Chi Minh region. The model was...     

Photocatalytic oxidation of gas-phase elemental mercury by nanotitanosilicate fibers

Photocatalytic fibers were generated from the continuous evaporation of titanium tetraisopropoxide with tetraethyl orthosilicate through a flame burner. The morphology, the crystal form, and the components of the nanotitanosilicate fibers were analyzed by Raman spectroscopy, Field emission-scanning electron microscope, X-ray diffraction, and Brunauer-Emmett-Teller surface area analysis. The nanotitanosilicates prepared by three different carrier gases (air, N(2), and Ar) were tested for their photocatalytic ability to remove/oxidize gas-phase elemental mercury. Under UV black light, the Hg(0) capture efficiencies were 78%, 86%, and 85% for air, N(2), and Ar, respectively. For air, the value was close to 90%, even under household fluorescent light. The Hg(0) capture efficiency by nanotitanosilcate was measured under fluorescent light, UV black light, and sunlight.     

Characterization of PM2.5 aerosols dominated by local pollution and Asian dust observed at an urban site in Korea during aerosol characterization experiments (ACE)--Asia Project

Daily fine particulate matter (PM2.5) samples were collected at Gwangju, Korea, during the Aerosol Characterization Experiments (ACE)-Asia Project to determine the chemical properties of PM2.5 originating from local pollution and Asian dust (AD) storms. During the study period, two significant events occurred on April 10-13 and 24-25, 2001, and a minor event occurred on April 19, 2001. Based on air mass transport pathways identified by back-trajectory calculation, the PM2.5 dataset was classified into three types of aerosol populations: local pollution and two AD aerosol types. The two AD types were transported along different pathways. One originated from Gobi desert area in Mongolia, passing through Hunshandake desert in Northern Inner Mongolia, urban and polluted regions of China (AD1), and the other originated in sandy deserts located in the Northeast Inner Mongolia Plateau and then flowed southward through the Korean peninsula (AD2). During the AD2 event, a smoke plume that originated in North Korea was transported to our study site. Mass balance closures show that crustal materials were the most significant species during both AD events, contributing -48% to the PM2.5 mass; sulfate aerosols (19.1%) and organic matter (OM; 24.6%) were the second greatest contributors during the AD1 and AD2 periods, respectively, indicating that aerosol properties were dependent on the transport pathway. The sulfate concentration constituted only 6.4% (4.5 microg/m3) of the AD2 PM2.5 mass. OM was the major chemical species in the local pollution-dominated PM2.5 aerosols, accounting for 28.7% of the measured PM2.5 mass, followed by sulfate (21.4%), nitrate (15%), ammonium (12.8%), elemental carbon (8.9%), and crustal material (6.5%). Together with substantial enhancement of the crustal elements (Mg, Al, K, Ca, Sc, Ti, Mn, Fe, Sr, Zr, Ba, and Ce), higher concentrations of pollution elements (S, V, Ni, Zn, As, Cd, and Pb) were observed during AD1 and AD2 than during the local pollution period, indicating that, in addition to crustal material, the AD dust storms also had a significant influence on anthropogenic elements.     

Effects of equipment loadings on geosynthetic-lined slope behaviour.

When combined in the lining and covering of waste-containment facilities, soil and geosynthetic components protect the environment by acting as a hydraulic barrier. Equipment loading may significantly increase the tensile stress induced in geosynthetic components, leading to a potential stability problem. Large equipment loadings may also result in a localized circular slip surface during construction operations. New analytical method based on discrete element modelling is proposed for estimating the distribution of tensile force developed in the individual geosynthetic components of the lining system and for evaluating the safety factor of slope failure due to equipment loading. The analytical results of an example are presented to demonstrate the applicability of the analytical method for the lining system of a waste landfill. The analyses of the example show that equipment loading provide a substantial increase in the tensile forces of the geosynthetic components of a lining system and that the possibility of shallow failure due to equipment loading increases as the slope becomes steeper. This method is a useful tool for analysing the lining system of waste landfills with complex lining components.     

Induction of cytochrome P4501A and endocrine disrupting effects of school incinerator residues

The emission of the dioxin-like compounds from on-site waste incinerators of seven schools in Kyonggi Province of Korea was evaluated by determination of the cytochrome P4501A(CYP1A) catalytic activity and antiestrogenic activity using cell culturemicrobioassay. The residue samples were extracted in a Soxhlet apparatus using toluene for 20 hr. The concentrated crude extractswere fractionated with a basic alumina column. Dioxin-like compounds were then extracted. Induction of CYP1A activity in a rat(H4IIE) hepatoma cell line was used as indicator of biologicaleffect of incinerator residues and measured as 7-ethoxyresorufin-O-deethylase(EROD) activities. The EROD activities of fraction II extracts (one of the two extracts) in the H4IIE cells were from 0.044±0.002 to 4.424±0.351 ng-TEQ g^-1 (TCDD Toxicity equivalent), showing relatively high inducing capacity. Antisetrogenicity of the extracts was measured as decrease in E₂-induced cell proliferation. Most of the extracts showed antiestrogenic activity in MCF7-BUS cell.The TEQ levels of the incinerator residues and the antiestrogenicactivities were in good correlation, strongly suggesting that thepotent toxic emissions were indeed produced from the on-site school waste semi-incinerators and could cause the antiestrogenicity.     

Prediction of Leachate Level in Kimpo Metropolitan Landfill Site by Total Water Balance

Kimpo metropolitan landfill has received various kinds of wastessince January 1992. The leachate level was measured to be 10.3 m in May 1995 and the level increased to 12.2 m in August 1996. Therefore, to prove the reason for the increasing leachate level, we calibrated hydraulic conductivity of each waste andintermediate layer using the HELP (Hydrologic Evaluation ofLandfill Performance) model. The leachate generation data measured from February 1993 to October 1995 was used in the model calibration. As a result of a model calibration, we obtained anaverage infiltration ratio and used this in analysis of the total water balance to predict elevation of leachate level. Main causes of the elevation of the leachate level were the high water content of the waste and the degradation of the leachate-drainage system caused by the subsidence of a naturalbarrier layer.     

Effect of temperature on single and competitive adsorptions of Cu(II) and Zn(II) onto natural clays

This study conducted a combined adsorption-sequential extractionanalysis (CASA), by which five phases (i.e., exchangeable, carbonate, Mn-Oxide, organic, and Fe-Oxide phases) of adsorbed heavy metals were analyzed, to investigate temperature effects on single and competitive adsorptions of Zn(II) and Cu(II) ontonatural clays. In the case of single adsorption of Zn, the exchangeable phase adsorption decreased from 65 to 40%, but thecarbonate phase adsorption increased from 30 to 40%, with an increase in temperature from 15 to 55 °C. However, in itscompetitive adsorption with Cu, Zn was mostly present in the exchangeable phase (over 90%), and with an increase in temperature, the exchangeable phase adsorption decreased only 10%. In the case of Cu, over 50% among the total amount of adsorption was present in the carbonate phase in both cases ofsingle and competitive adsorptions. The carbonate phaseadsorption of Cu increased from 56 to 61% and from 60 to 66% in single and competitive adsorptions, respectively, with atemperature increase. These results show that in the case of Zn,the major mechanism of retention in natural clay soils might beexchangeable phase adsorption, especially in the case of competitive adsorption with Cu. However, in the case of Cu, the major mechanism might be carbonate phase adsorption, which is known to be a more immobile phase than exchangeable phase adsorption. It seems that the adsorption of Zn and Cu onto natural clays is an endothermic reaction, which represents thatthe adsorption equilibrium constants and capacities increase with a temperature increase, with the exception of exchangeablephase adsorption.     

A comparative study of US EPA 1996 and 1999 emission inventories in the west Gulf of Mexico coast region, USA

Emission inventory is one of the required inputs to air quality models. To assist in the urban and regional modeling efforts, United States Environmental Protection Agency (EPA) has compiled a National Emission Inventory (NEI) for criterion pollutants, and the precursors of ozone and particulate matter (PM). In December 2002, EPA released the 1999 NEI estimates (NEI99), which represent the most recent national emission data. However, the data sets are not in model-ready format for air quality simulations. This present work converts the NEI99 Final Version 2 data sets into Inventory Data Analyzer (IDA) format and processes the data using the Sparse Matrix Operator Kernel Emissions (SMOKE) modeling system to generate a gridded emission inventory in a domain covering the west Gulf Coast Region, USA. The spatial and diurnal emission characteristics of the gridded emission inventories are then assessed and compared with those of the National Emission Trend 1996 (NET96). The NEI99 database contains more complete emission records in both area and point sources. It is also found that NEI99 data exhibit greater emissions with respect to point and mobile sources but smaller emissions with respect to area sources when compared to the corresponding gridded NET96 data in the same study domain. The most distinct differences between the NEI99 and NET96 databases are CO emission of mobile sources, SO2 emissions of point sources, and VOC/PM/NH3/NOx emissions of area and non-road sources. The gridded NEI99 data show low VOC/NOx ratios (<2-5) in the urban areas of the study domain.     

Using of “pseudo-second-order model” in adsorption

A research paper's contribution exists not only in its originality and creativity but also in its continuity and development for research that follows. However, the author easily ignores it. Citation error and quotation error occurred very frequently in a scientific paper. Numerous researchers use secondary references without knowing the original idea from authors. Sulaymon et al. (Environ Sci Pollut Res 20:3011–3023, 2013) and Spiridon et al. (Environ Sci Pollut Res 20:6367–6381, 2013) presented wrong pseudo-second-order models in Environmental Science and Pollution Research, vol. 20. This comment pointed the errors of the kinetic models and offered information for citing original idea of pseudo-second-order kinetic expression. In order to stop the proliferation of the mistake, it is suggested to cite the original paper for the kinetic model which provided greater accuracy and more details about the kinetic expression.