Novel pipette-tip graphene/poly (vinyl alcohol) cryogel composite extractor for the analysis of carbofuran and carbaryl in water

A novel pipette-tip extractor of a graphene/poly (vinyl alcohol) cryogel (graphene/PVA) composite sorbent was prepared to preconcentrate carbamate pesticides in environmental water samples before analysis with a gas chromatograph-flame ionization detector (GC-FID). This novel pipette-tip extractor with the graphene/PVA sorbent exhibited a high porosity when observed through a scanning electron micrograph (SEM). Under optimal conditions, using only 1.0 mL of sample and 0.75 mL of eluting solvent, the developed method provided a wide linear range of 10–700 ng mL^?1 and 10–500 ng mL^?1 with limit of detection (LOD) of 6.40 ± 0.18 and 9.17 ± 0.34 ng mL^?1 for carbofuran (2,3-dihydro-2,2-dimethylbenzofuran-7-yl methylcarbamate) and carbaryl (1-naphthyl methylcarbamate), respectively. The pipette-tip extractor provided high extraction efficiency with high accuracy indicated, by good recoveries in the range of 74.5 ± 4.8% to 119.7 ± 1.6% and 76 ± 15% to 114 ± 19% for carbofuran and carbaryl, respectively. In addition, the fabrication procedure showed a good pipette-tip extractor-to-pipette-tip extractor reproducibility with a relative standard deviation of 1.3–9.8% (n = 5). When the developed pipette-tip extractor was applied for the extraction of carbofuran and carbaryl in surface water samples near vegetable plantation areas, 25.9 ± 8.2 ng mL^?1 of carbofuran was found, and carbaryl was also detected in concentrations that ranged from 45.0 ± 4.0 to 191 ± 13 ng mL^?1.     

Online microchannel preconcentrator for carbofuran detection

A simple and rapid online microchannel preconcentrator coupled with an amperometric detection for the analysis of carbofuran using polyethylene glycol coated onto magnetic particle (PEG-magnetic particles) sorbents was developed. This simple-to-prepare microchannel preconcentrator used an external magnet to retain the PEG-magnetic particle sorbents inside the microchannel. Under optimum conditions, the system provided two linear ranges, from 0.01 to 10.0 mg L^?1 and from 10.0 to 130.0 mg L^?1 with a limit of detection of 8.7 ± 0.1 μg L^?1. The microchannel preconcentrator provided very good stability; it can be used for up to 326 consecutive injections of 5.0 mg L^?1 carbofuran with a relative standard deviation of less than 3%. The developed system provided a good microchannel-to-microchannel and a good electrode-to-electrode reproducibility (n = 6, %RSD < 1). It also provided an excellent selectivity when it was tested with two other carbamate pesticides, carbaryl and methomyl, with a 43 and 256 times higher detection sensitivity for carbofuran, respectively. The developed system was successfully applied to detect carbofuran in surface water samples obtained near vegetable plantation areas. The concentrations of carbofuran in these samples were found to be in the range of non-detectable to 0.047 ± 0.001 mg L^?1. The developed system is easy to operate and easy to couple with other analytical instruments and it could be easily adapted for the analysis of other polar organic contaminants.     

Tea bag filter paper as a novel protective membrane for micro-solid phase extraction of butachlor in aqueous samples

An innovative, cost-effective, simple, and environmental friendly tea bag filter paper protected micro-solid phase extraction (μ-SPE) technique was developed for the first time with the aim to miniaturize and minimize the use of organic solvents for the extraction and determination of butachlor in aqueous samples. The μ-SPE device was produced by packing 3.0 mg of an easily synthesized new sorbent, hydroxyl-functionalized polypyrrole (OH-PPY), inside a small tea bag filter paper sachet (1.0 cm × 0.5 cm) that served as a protective envelope. Both the extraction and desorption procedures were facilitated by sonication. Due to the high porosity and the fast water absorption of the tea bag filter paper, the analyte could easily diffuse through and enhance the interaction with the sorbent. Under the optimized conditions for the GC-ECD and the μ-SPE, the limit of detection (S/N ≥ 3) was 2.0 μg L^?1 while the limit of quantitation (S/N ≥ 10) was 10.0 μg L^?1. The recoveries of the butachlor spiked at 0.050, 0.10, and 0.50 μg mL^?1 ranged from 77.9 ± 3.0 to 112.5 ± 2.9%. The proposed method was successfully applied for the determination of butachlor in water samples from paddy cultivation sites. The levels found were from non-detectable to 24.71 ± 0.37 μg L^?1.