Determination and potential importance of diterpene (kaur-16-ene) emitted from dominant coniferous trees in Japan

Reactive volatile organic compounds (VOCs) are known to affect atmospheric chemistry. Biogenic VOCs (BVOCs) have a significant impact on regional air quality due to their large emission rates and high reactivities. Diterpenes (most particularly, kaur-16-ene) were detected in all of the 205 enclosure air samples collected over multiple seasons at two different sites from Cryptomeria japonica and Chamaecyparis obtusa trees, the dominant coniferous trees in Japan,. The emission rate of kaur-16-ene, was determined to be from 0.01 to 7.1 μg dwg⁻¹ h⁻¹ (average: 0.61 μg dwg⁻¹ h⁻¹) employing branch enclosure measurements using adsorbent sampling followed by solid phase-liquid extraction techniques. The emission rate was comparable to that of monoterpenes, which is known major BVOC emissions, collected from the same branches. In addition, total emission of kaur-16-ene at 30 °C was estimated to exceed that of total anthropogenic VOC emissions.     

LB复合膜选择性检测水中痕量镉离子的方法研究

开发了一种利用LB复合膜选择性地检测水中痕量镉离子的技术方法,研究了最佳LB复合膜检测器的制作条件.用表面活性剂十二烷基-(2-噻唑偶氮)间苯二酚(DTAR)作显色剂,对乙烯基硬脂酸盐(PVS)、十八烷基异丁烯酸盐(PMOA)、乙烯基-N-氨基甲酸十八烷基酯(PVOC)和顺丁烯二酸酐-1-十八烯(PMO)4种聚合物进行了强度实验,得出稳定的检测器结构,即偶数层DTAR上附着单层PVOC的LB复合膜.经过灵敏度实验,制作出最佳LB复合膜检测器DTAR6-PVOC1,在pH为7.5,温度40℃且搅拌的反应条件下,该检测器可以在10 min之内检出10-7mol/L镉,并可目视定性及半定量检测出水中痕量镉离子.水中可能共存的离子中只有CU2+和Zn2+会干扰镉离子的检测,需要抑制.      

Availability of colloidal ferric oxides to coastal marine phytoplankton

Cell growth of a coastal marine diatom, Phaeodactylum tricornutum (stock cultures), and two red tide marine flagellates, Heterosigma akashiwo and Gymnodinium mikimotoi (stock cultures), in the presence of soluble chelated Fe(III)-EDTA (1:2) and of four different phases of ferric oxide colloids were experimentally measured in culture experiments at 20°C under 3000 lux fluorescent light. Soluble Fe(III)-EDTA induced the maximal growth rates and cell yields. The short-term uptake rate of iron by H. akashiwo in Fe(III)-EDTA medium was about eight times faster than that in solid amorphous hydrous ferric oxide (Fe₂O₃·xH₂O) medium. In culture experiments supplied with four different ferric oxide forms, the orders of cell yields are amorphous hydrous ferric oxide>-FeOOH (lepidocrocite)>Fe₅O₇(OH)·4H₂O (hydrated ferric oxyhydroxide polymer >-FeOOH (goethite). The specific growth rates () at logarithmic growth phase in Fe(III)-EDTA, amorphous hydrous ferric oxide and -FeOOH media were significantly greater than those in Fe₅O₇ (OH)·4H₂O and -FeOOH media. The thermodynamically stable forms such as Fe₅O₇(OH)·4H₂O and -FeOOH supported a little or no phytoplankton growth. The iron solublities and/or proton-promoted iron dissolution rates of these colloidal ferric oxides in seawater at 20°C were determined by simple filtration techniques involving -activity measurements of ⁵⁹Fe. The orders of solubilities and estimated dissolution rate constants of these ferric oxides in seawater were consistent with that of cell yields in the culture experiments. These results suggest that the availability of colloidal iron to provide a source of iron for phytoplankton is related to the thermodynamic stability and kinetic lability of the colloidal ferric oxide phases, which probably control the uptake rate of iron by phytoplankton.     

Temporal comparison of global inventories of CO2 emissions from biomass burning during 2002–2011 derived from remotely sensed data

Environmental Science and Pollution Research - Biomass burning is a large important source of greenhouse gases and atmospheric aerosols, and can contribute greatly to the temporal variations of CO2...     

Evaluation of non-methane hydrocarbon (NMHC) emissions based on an ambient air measurement in Tokyo area,Japan

Non-methane hydrocarbons (NMHCs) are known to have an important role on air quality due to their high reactivity. NMHC analysis has been performed on 148 ambient air samples collected at five different sites in the Kanto area (Tokyo metropolitan area and surrounding six prefectures) of Japan in summer and winter of 2008, and fifty NMHCs have been determined and quantified. A field measurement campaign has been conducted at one of the busiest intersections in Tokyo metropolitan area in winter of 2008. NMHC emissions are evaluated through comparison of distributions of individual NMHCs emitted from motor vehicles, which are estimated from the measurements, with those determined from the current emissions inventory. The comparison revealed that the measured distributions of acetylene, ethylene and toluene showed a good agreement with those estimated from the emissions inventory (the values estimated from the measurements are a factor of 1.5, 0.56 and 2.3 larger than the emissions inventory in median, respectively), however, propane and isobutane are found to be significantly underestimated in the emissions inventory (the measured values were a factor of 18 and 5.1 larger than the emissions inventory, respectively). The significant underestimate of propane can be explained by that the current emissions inventory does not consider emissions from liquefied propane gas (LPG) fueled vehicles. However, for isobutane, reasons for the underestimate are still unclear. Another field measurement has been conducted in summer of 2008, where the air samples have been collected at three different sites on the ground and by a helicopter as well. Remarkable high concentrations of 1-butene and cis- and trans-2-butenes have been sporadically observed in the samples collected at Urayasu in the coastal area of Tokyo bay. Calculated propylene equivalent (PE) concentrations of butenes revealed that those have a significantly important role in ozone formation when the air plume is affected by emissions from their emission sources. The PE concentrations of butenes varied from 0.1 to 39 ppbC, and accounted for 1.5–75% of total PE concentrations at Urayasu. Most of the continuous air quality monitoring stations does not record concentrations of individual hydrocarbons, therefore, the importance of reactive and low concentration hydrocarbon such as butenes might be overlooked in the current emissions inventory and/or air quality model. In this paper, the reliability of NMHC emissions is evaluated based on the field measurements. Their possible impacts on air quality in the Kanto area are discussed as well, based on the calculated propylene equivalent concentrations.     

Fitness of occupational exposure data to inverse Gaussian distribution

Short-term exposure datasets of 10 workers exposed to organic solvents and daily average exposure datasets of seven workers exposed to cobalt and organic solvents were analyzed in order to clarify whether these exposure data fit an inverse Gaussian distribution. The goodness-of-fit test showed that time-weighted average (TWA) values with averaging times of 30 min, 60 min and 8 hours can be described by an inverse Gaussian distribution, but not those with averaging times of 7.5 min and 15 min.     

The impacts of reactive terpene emissions from plants on air quality in Las Vegas,Nevada

A three-part study was conducted to quantify the impact of landscaped vegetation on air quality in a rapidly expanding urban area in the arid southeastern United States. The study combines in situ, plant-level measurements, a spatial emissions inventory, and a photochemical box model. Maximum plant-level basal emission rates were moderate: 18.1 μgC gdw^?1 h^?1 (Washingtonia spp., palms) for isoprene and 9.56 μgC gdw^?1 h^?1 (Fraxinus velutina, Arizona ash) for monoterpenes. Sesquiterpene emission rates were low for plant species selected in this study, with no measurement exceeding 0.1 μgC gdw^?1 h^?1. The high ambient temperatures combined with moderate plant-level emission factors resulted in landscape emission factors that were low (250–640 μgC m^?2 h^?1) compared to more mesic environments (e.g., the southeastern United States). The Regional Atmospheric Chemistry Mechanism (RACM) was modified to include a new reaction pathway for ocimene. Using measured concentrations of anthropogenic hydrocarbons and other reactive air pollutants (NO_x, ozone), the box model employing the RACM mechanism revealed that these modest emissions could have a significant impact on air quality. For a suburban location that was downwind of the urban core (high NO_x; low anthropogenic hydrocarbons), biogenic terpenes increased time-dependent ozone production rates by a factor of 50. Our study demonstrates that low-biomass density landscapes emit sufficient biogenic terpenes to have a significant impact on regional air quality.     

Diphenylmethane diisocyanate self-polymerization: Thermal hazard evaluation and proof of runaway reaction in gram scale

Thermal analysis by differential scanning calorimetry and thermogravimetric/differential thermal analysis mass spectrometry, adiabatic calorimetry, a gram-scale heating test, and infrared spectroscopy were performed to evaluate the thermal hazards of diphenylmethane diisocyanate (MDI) and prove the occurrence of a runaway reaction. The self-polymerization of MDI was found to occur at about 340 °C under rapid heating conditions. Carbon dioxide was eliminated and heat was generated to allow polymerization. Under adiabatic and closed conditions, the runaway reaction of MDI can begin at least from 220 °C. Besides it is highly probable that the runaway reaction of MDI can begin from a lower temperature in an actual process scale. More heat was generated than in the previous case and the pressure rose rapidly. A closed 2-mm-thick glass vessel exploded because of the runaway reaction of MDI even if the temperature was lower than 300 °C. Therefore, MDI could cause fatal runaway reactions below 300 °C, where MDI had been assumed to self-polymerize by eliminating carbon dioxide previously.     

Electrochemical control of bacterial cell accumulation on submerged glass surfaces

 Accumulation of bacterial cells on a transparent electrode was controlled by applying an alternating potential. Live and dead cells on a transparent electrode can be distinguished as blue and red cells, by staining with two fluorescent dyes, propidium iodide (PI) and 4′, 6-diamidino-   2-phenylindole dihydrochloride (DAPI) and propidium iodide (PI), respectively. Cells of the gram-negative marine bacterium, Vibrio alginolyticus attached to an indium/tin oxide (ITO) electrode were killed by applying a potential of 1.1 V versus saturated calomel electrode in seawater. By applying –0.4 V, 73% of the cells on the ITO electrode were desorbed in 10 min. Changes in pH and generation of chlorine were not observed after applying potentials in the range of –0.4∼1.2 V. After 21 h of immersion in V. alginolyticus cell suspension with the application of an alternating potential of 1.1 and –0.4 V, cells on the electrode were completely killed and the cell number decreased to 20% of that of no potential. Elution of indium and tin was not observed after 10 days application of alternating potential. Received: 11 August 1998 / Accepted: 30 September 1998