Devils Lake is a terminal lake located in northeast North Dakota. Because of its glacial origin and accumulated salts from evaporation, the lake has a high concentration of sulfate compared to the surrounding water bodies. From 1993 to 2011, Devils Lake water levels rose by ~10 m, which flooded surrounding communities and increased the chance of an overspill to the Sheyenne River. To control the flooding, the State of North Dakota constructed two outlets to pump the lake water to the river. However, the pumped water has raised concerns about of water quality degradation and potential flooding risk of the Sheyenne River. To investigate these perceived impacts, a Soil and Water Assessment Tool (SWAT) model was developed for the Sheyenne River and it was linked to a coupled SWAT and CE‐QUAL‐W2 model that was developed for Devils Lake in a previous study. While the current outlet schedule has attempted to maintain the total river discharge within the confines of a two‐year flood (36 m3/s), our simulation from 2012 to 2018 revealed that the diversion increased the Sheyenne River sulfate concentration from an average of 125 to >750 mg/L. Furthermore, a conceptual optimization model was developed with a goal of better preserving the water quality of the Sheyenne River while effectively mitigating the flooding of Devils Lake. The optimal solution provides a “win–win” outlet management that maintains the efficiency of the outlets while reducing the Sheyenne River sulfate concentration to ≤600 mg/L. 相似文献
Microplastics have recently become a major environmental issue due to their ubiquitous distribution, uncontrolled environmental occurrences, small sizes and long lifetimes. Actual remediation methods include filtration, incineration and advanced oxidation processes such as ozonation, but those methods require high energy or generate unwanted by-products. Here we tested the degradation of fragmented, low-density polyethylene (LDPE) microplastic residues, by visible light-induced heterogeneous photocatalysis activated by zinc oxide nanorods. The reaction was monitored using Fourier-transform infrared spectroscopy, dynamic mechanical analyser and optical imaging. Results show a 30% increase of the carbonyl index of residues, and an increase of brittleness accompanied by a large number of wrinkles, cracks and cavities on the surface. The degree of oxidation was directly proportional to the catalyst surface area. A mechanism for polyethylene degradation is proposed.
Journal of Material Cycles and Waste Management - Material flow analysis (MFA) is a well-established tool for supporting decisions on nutrient management. This paper shows the importance of the... 相似文献
Pentachlorotoluene (PCT) and pentabromotoluene (PBT) are environmental contaminants detected in the Great Lakes ecosystem. In view of the paucity of toxicity data and the potential for human exposure, a subacute (28 day) and a subchronic (91 day) study were conducted in the rat. In the subacute study, groups of 10 male and 10 female rats were fed the diet containing PCT or PBT at 0, 0.5, 5.0, 50 or 500 ppm for 28-days. In the subchronic study, the group size was increased to 15, the dose levels were 0, 0.05, 0.5, 5.0, 50 and 500 ppm in the diet and the exposure period was 91 days. Growth rate and food consumption were not affected by exposure to either chemical in the subacute and subchronic study. Clinical observations revealed no abnormalities. Decreased hemoglobin was observed in female rats fed 5.0 ppm PCT and higher levels in the subacute (28 day) study. In the same study the hematocrit value and erythrocyte numbers of females fed 5.0 or 500 ppm PCT diets were significantly lower than the control. In both subacute and subchronic studies mild dose-dependent histopathological changes were observed in the thyroid, liver and kidney of rats fed PCT and PBT diets. In general male rats were more susceptible than females to the treatment of PCT and PBT. Based on these data, it was concluded that the no observable adverse effect level for PCT was 50 ppm in the diet (3.5 mg/kg b.w./day) and that of PBT was 5.0 ppm (0.35 mg/kg b.w./day). 相似文献
A microbubble ozonation process for enhancing sludge solubilization was proposed and its performance was evaluated in comparison to a conventional ozone bubble contactor. Microbubbles are defined as bubbles with diameters less than several tens of micrometers. Previous studies have demonstrated that microbubbles could accelerate the formation of hydroxyl radicals and hence improve the ozonation of dyestuff wastewater. The results of this study showed that microbubble ozonation was effective in increasing ozone utilization and improving sludge solubilization. For a contact time of 80 min, an ozone utilization efficiency of more than 99% was obtained using the microbubble system, while it gradually decreased from 94% to 72% for the bubble contactor. The rate of microbial inactivation was obviously faster in the microbubble system. At an ozone dose of 0.02 g O3 g−1 TSS, about 80% of microorganisms were inactivated in the microbubble system, compared with about 50% inactivation for the bubble contactor. Compared to the bubble contactor, more than two times of COD and total nitrogen, and eight times of total phosphorus content were released from the sludge into the supernatant by using the microbubble system at the same ozone dosage. The application of microbubble technology in ozonation processes may provide an effective and low cost approach for sludge reduction. 相似文献
This study presents the chemical composition of dry deposition by using dry deposition plate and water surfaces sampler during daytime and nighttime sampling periods at a near highway traffic sampling site. In addition, the characterization for mass and water soluble species of total suspended particulate (TSP), PM2.5 and PM10 were also studied at this sampling site during August 22 to October 31 of 2006 around central Taiwan. The samples collected were analyzed by using Ion Chromatography (DIONEX 100) for the ionic species analysis. Results of the particulate dry deposition fluxes are higher in the water surfaces sampler than that of the dry deposition plate. In other words, the results also indicated that water surface can absorb more ambient dry deposition inorganic pollutants than that of dry deposition plate in this study. The results obtained in this study indicated that the ionic species of Cl(-), NO3(-) and SO4(2-) occupied about average 60-70% downward flux out of total ionic species for either dry deposition plate or water surfaces sampler during August to October of 2006 at this near highway traffic sampling site. 相似文献
In this paper, we investigate the presence of economies of scale in the global iron-making industry for integrated steel plants, iron making being the first stage in the steel-making process. Iron making depends on basic commodities, such as iron ore, coke and various forms of energy, required in the operation of the blast furnace, which can be classified as essential inputs and used in fixed proportions to produce iron. A generalized Leontief cost function is estimated using panel data for 69 integrated plants, such a specification being appropriate for technologies with essential inputs that are used in fixed proportions in production. A significant scale effect is observed due to the existence of fixed costs and a linear dependence of the cost function on production. Under a simple linear cost function, a rough estimate of the breakeven scale of plant, where costs equal revenue, is 4.5 Mt per year. Competitiveness, as measured by the ratio of plant average cost per tonne to best practice cost per tonne, can be shown to be positively related to the scale of production as well as the cost of essential inputs. Therefore, low-cost producers are also often producers with low raw material costs and production levels below the estimated breakeven scale of operation. Labor costs, although significant, are comparatively less important as a driver towards low costs. 相似文献
This paper argues that important issues of sustainable development have been addressed through single-issue landscape plans, and that these plans have carried little weight within the land use decision-making process. A more consolidated approach, based on multi-function landscape plans, is proposed. After reviewing the range of plans which, in the UK, cover woodland, farmscapes, visual amenity, coasts, catchments and biodiversity, the case is made for an integrative plan capable of addressing natural resource issues at the landscape scale. The preliminary character of an integrative plan is outlined. Whilst landscape plans have a relatively weak basis for implementation, it is concluded that a sufficient range of powers is available to ensure some progress. 相似文献