Preliminary air pollution monitoring in San Miguel, Buenos Aires

Passive diffusion samplers were employed in San Miguel(Buenos Aires Metropolitan Area) for a preliminary airpollution monitoring. The highest loads were observedin downtown, compared with an urban background site.Total suspended particulate matter (TSPM) varied from0.257 to 0.033 mg cm^-2 month^-1; dust was examinedfor particle nature and size distribution. A similartrend was observed for nitrogen dioxide (NO₂) andTSPM spatial distribution, suggesting that traffic isthe major pollution source. Sulphur dioxide (SO₂)values were low and rather homogeneous. Levels for theinvestigated pollutants are below EPA's guide linevalues. Geographic (flat area, near to Rio de LaPlata) and climatologic factors (rainfalls andvariable wind directions) contribute to disperse pollutants.     

Aquatic Plant and Dissolved Oxygen Changes in a Reference‐Condition Prairie Stream Subjected to Experimental Nutrient Enrichments

Effects of controlled nutrient additions on a prairie stream were studied using a before‐after‐control‐impact paired design. The site is in a reference condition with low soluble nitrate (NO₃) and phosphate (soluble reactive phosphorus [SRP]) in summer (3 μg NO₃‐N/L, 4 μg SRP/L). Nutrients were added to two reaches over the growing season at two levels (Low Dose — 39 μg NO₃‐N/L and 4.4 SRP/L; High Dose — 119 μg NO₃‐N/L and 15.6 μg SRP/L). Continuously measured dissolved oxygen (DO) and changes in aquatic flora were compared to an upstream Control. Enrichment led microalgae and filamentous algae to increase in density, areal coverage, and thickness, and the magnitude of the changes were largely concordant with dosing (more in the High Dose); algal growth also suppressed macrophytes in the High Dose. Enrichment caused significant increases in diel DO swings whose magnitudes were consistent with dosing level. In the High Dose, benthic algae flourished in the growing season and then senesced en masse in fall. The decomposing algae led DO to crash (ca. 0 mg/L on the bottom), but DO impacts were out‐of‐sync with peak algal growth and photosynthesis, which occurred weeks earlier. This finding provides a plausible explanation as to why high DO delta in streams impacts aquatic life even when concurrently measured DO is not low. When DO crashed, DO was longitudinally patchy, some areas having low DO near the bottom, others near saturation. Geomorphology and exposure to wind may have caused this pattern.     

An atmospheric dispersion model for the environmental impact assessment of thermal power plants in Japan--a method for evaluating topographical effects

An atmospheric dispersion model was developed for the environmental impact assessment of thermal power plants in Japan, and a method for evaluating topographical effects using this model was proposed. The atmospheric dispersion model consists of an airflow model with a turbulence closure model based on the algebraic Reynolds stress model and a Lagrangian particle dispersion model (LPDM). The evaluation of the maximum concentration of air pollutants such as SO2, NOx, and suspended particulate matter is usually considered of primary importance for environmental impact assessment. Three indices were therefore estimated by the atmospheric dispersion model: the ratios (alpha and beta, respectively) of the maximum concentration and the distance of the point of the maximum concentration from the source over topography to the respective values over a flat plane, and the relative concentration distribution [gamma(x)] along the ground surface projection of the plume axis normalized by the maximum concentration over a flat plane. The atmospheric dispersion model was applied to the topography around a power plant with a maximum elevation of more than 1,000 m. The values of alpha and beta evaluated by the atmospheric dispersion model varied between 1 and 3 and between 1 and 0.4, respectively, depending on the topographical features. These results and the calculated distributions of y(x) were highly similar to the results of the wind tunnel experiment. Therefore, when the slope of a hill or mountain is similar to the topography considered in this study, it is possible to evaluate topographical effects on exhaust gas dispersion with reasonable accuracy using the atmospheric dispersion model as well as wind tunnel experiments.     

Novel two-step vapor-phase synthesis of UV–Vis light active Fe2O3/WO3 nanocomposites for phenol degradation

Supported Fe₂O₃/WO₃ nanocomposites were fabricated by an original vapor phase approach, involving the chemical vapor deposition (CVD) of Fe₂O₃ on Ti sheets and the subsequent radio frequency (RF)-sputtering of WO₃. Particular attention was dedicated to the control of the W/Fe ratio, in order to tailor the composition of the resulting materials. The target systems were analyzed by the joint use of complementary techniques, that is, X-ray diffraction (XRD), field emission-scanning electron microscopy (FE-SEM), atomic force microscopy (AFM), energy dispersive X-ray spectroscopy (EDXS), X-ray photoelectron spectroscopy (XPS), secondary ion mass spectrometry (SIMS), and optical absorption spectroscopy. The results showed the uniform decoration of α-Fe₂O₃ (hematite) globular particles by tiny WO₃ aggregates, whose content could be controlled by modulations of the sole sputtering time. The photocatalytic degradation of phenol in the liquid phase was selected as a test reaction for a preliminary investigation of the system behavior in wastewater treatment applications. The system activity under both UV and Vis light illumination may open doors for further material optimization in view of real-world end-uses.

     

An Atmospheric Dispersion Model for the Environmental Impact Assessment of Thermal Power Plants in Japan—A Method for Evaluating Topographical Effects

Abstract

An atmospheric dispersion model was developed for the environmental impact assessment of thermal power plants in Japan, and a method for evaluating topographical effects using this model was proposed. The atmospheric dispersion model consists of an airflow model with a turbulence closure model based on the algebraic Reynolds stress model and a Lagrangian particle dispersion model (LPDM). The evaluation of the maximum concentration of air pollutants such as SO₂, NO_x, and suspended particulate matter is usually considered of primary importance for environmental impact assessment. Three indices were therefore estimated by the atmospheric dispersion model: the ratios (α and β, respectively) of the maximum concentration and the distance of the point of the maximum concentration from the source over topography to the respective values over a flat plane, and the relative concentration distribution [γ(x)] along the ground surface projection of the plume axis normalized by the maximum concentration over a flat plane. The atmospheric dispersion model was applied to the topography around a power plant with a maximum elevation of more than 1000 m. The values of α and β evaluated by the atmospheric dispersion model varied between 1 and 3 and between 1 and 0.4, respectively, depending on the topographical features. These results and the calculated distributions of γ(x) were highly similar to the results of the wind tunnel experiment. Therefore, when the slope of a hill or mountain is similar to the topography considered in this study, it is possible to evaluate topographical effects on exhaust gas dispersion with reasonable accuracy using the atmospheric dispersion model as well as wind tunnel experiments.