Uptake and concentration of heavy metals in dominant mangrove species from Hainan Island,South China

Environmental Geochemistry and Health - By investigating three dominant mangrove species, namely Aegiceras corniculatum, Kandelia candel, Ceriops tagal and their rhizosediment in Mangrove wetlands...     

Research progress and hot spots of hydrothermal liquefaction for bio-oil production based on bibliometric analysis

Environmental Science and Pollution Research - Hydrothermal liquefaction (HTL) of biomass used HTL reaction under high temperature and pressure to produce bio-oil. This technology is considered as...     

Comparison on surface properties and desulfurization of MnO2 and pyrolusite blended activated carbon by steam activation

In this study, MnO₂ and pyrolusite were used as the catalysts to prepare modified activated carbon, that is, AC-Mn and AC-P, respectively, from coals by blending method and steam activation. The Brunauer–Emmett–Teller (BET) results indicated that the AC-P had higher surface areas and micropore volumes than the AC-Mn with the same blending ratio. The relative contents of basic functional groups (i.e., C = O, π-π*) on AC-P were slightly lower than those on AC-Mn, while both contained the same main metal species, namely, MnO. The desulfurization results showed that with 3 wt% of blending ratio, AC-Mn3 and AC-P3 had higher sulfur capacities at 220 and 205 mg/g, respectively, which were much higher than for the blank one (149.6 mg/g). Moreover, the AC-P had relatively higher sulfur capacity than the AC-Mn with the same contents of Mn, which might be attributed to the existence of other metals in pyrolusite. After the desulfurization process, MnO were gradually transferred into MnSO₄, and the relative contents of basic functional groups decreased evidently for both AC-Mn3 and AC-P3. The results demonstrated that pyrolusite could be one good alternative to MnO₂ to prepare modified activated carbon for desulfurization.

Implications: MnO₂ and pyrolusite were used as the additives to prepare modified activated carbon from coals by a blending method and by steam activation, that is, AC-Mn and AC-P, respectively. The AC-P had higher surface areas and micropore volumes than the AC-Mn with the same blending ratio. The AC-Mn and AC-P had higher sulfur capacities than a blank one. Moreover, the AC-P had relatively higher sulfur capacity than the AC-Mn with the same contents of Mn. The results demonstrated that pyrolusite could be one good alternative to MnO₂ to prepare modified activated carbon for desulfurizatio.     

密相塔半干法烟气脱硫塔内加湿降温及其对脱硫效率的影响

为了实现密相塔半干法脱硫工艺的精确加湿进一步提高系统脱硫效率,利用推导出的传热传质计算方法,得到烟气温度降低和加水量的关系.结合3组密相塔半干法工程实际数据,发现理论计算值和实测值误差区间仅为2.9％ ～5.4％.通过选取河北某钢厂210 m2烧结烟气密相塔半干法脱硫项目实际在线检测数据,发现循环脱硫灰含湿量为3％的系统脱硫效率整体高于含湿量为5％和4％的样品,最大值达93.56％.通过粒度分析、扫描电镜、X射线衍射及差热-热重对2种不同含湿量的循环脱硫灰进行表征,结果表明,含湿量为3％的循环脱硫灰较含湿量为5％的样品粒径小、比表面积大,无团聚现象,物相分析还证实相对于含湿量为5％样品,其Ca(OH)2和结晶水含量少,几乎都是CaSO4和CaS03干态物质,因此脱硫反应进行彻底,脱硫效率较高.     

警用头盔的人机工程学分析

警用头盔是武警部队使用最为频繁的单兵防护用具，本文基于人机工程学的理论，用人机工程学的观点对武警部队现装备的警用头盔进行分析和探讨，提出解决途径的设想，展望警用头盔的发展前景。     

序批式反应器生物强化处理苯酚废水的研究

将4株高效苯酚分解菌湿菌体分3批投加于序批式反应器(SBR),对活性污泥进行生物强化试验,分析活性污泥状态与性能变化,测定生物强化后对苯酚的降解能力.结果表明,随着生物强化过程的进行,沉降性能改善,污泥颗粒化趋势明显;生物强化后,活性污泥对苯酚降解能力、降解速率及对苯酚的耐受性明显提高:苯酚质量浓度为730～960mg/L时,苯酚完全降解时间可由正常的6h缩短至2h;6h内可完全降解苯酚的质量浓度由原来的880mg/L提高到2080mg/L,处理能力提高了1.36倍;当进水苯酚质量浓度增加到2400mg/L时,6h内污泥对苯酚的降解率仍达到60.1%.     

烟花爆竹用氯酸钾的安全化研究进展

含有氯酸钾的烟花爆竹药剂化学稳定性差、机械感度高,是烟花爆竹安全生产的一大隐患,通过改性与替代可以改善其安全性.包覆技术是一种创新的改性方法,效果明显.目前,研究的氯酸钾替代品多为高氯酸盐及其与硝酸盐的复合氧化剂,而含能材料作新型烟花爆竹氧化剂是今后的一个发展方向.     

Fenton法氧化处理水中土霉素的研究

为了评价Fenton法预处理抗生素生产废水中残留的高浓度土霉素的可行性,对Fenton试剂(Fe2 -H2O2)法催化氧化降解水溶液中的土霉素进行了研究.探讨了H2O2与Fe2 投加比例、投加量以及起始pH值对降解效果的影响,同时考察了土霉素废水中大量共存的草酸根离子对氧化过程的影响.结果表明,当H2O2与Fe2 按照5:1的比例投加时降解效率最高,最佳初始pH值在3.0-4.0之间.在最佳投加比例下,H2O2投加量为0.9 mmol/L,100 mg/L的土霉素可在10 min内得到完全降解.最佳反应条件下经过处理后土霉素水溶液TOC的去除率达40%左右,可生化性(BOD5/COD)也得到明显的改善.水中共存的草酸根离子对氧化效率具有明显的影响,但通过增加亚铁离子的量可以消除草酸的影响.     

压力板仪法测土-水特征曲线试验研究

非饱和土土-水特征曲线(SWCC)表示了土中含水量与吸力之间的关系。针对非饱和土干-湿循环过程中的吸力变化特征,开展试验研究。采用体积压力板仪实现非饱和土的脱湿和吸湿过程。试验成果显示:(1)土-水特征曲线是不稳定的,它与土体含水率的变化路径有关;(2)在干湿循环过程中,相同的基质吸力具有不同的含水量。     

优势菌的筛选及其强化活性污泥好氧反硝化的研究

利用含活性污泥提取物的贫培养基筛选SBR系统中的好氧异养优势菌。结合自然温度（15～20℃）、延长培养时间等条件来提高菌群的可培养性。从SBR活性污泥系统中分离出5种细菌。4株去除COD优势菌，1株异养硝化细菌，能在好氧条件下实现对总氮的去除。反应池底采用边缘对称曝气，反应池内细菌在时间顺序和空间位置上循环经历好氧过程及微氧过程。将PVA铝盐法固定的细菌对反应器进行生物强化。结果显示，在好氧工艺的条件下，投加优势菌群后，与未加优势菌群的反应器相比，可以显著改善污泥的沉降性能，COD、NH₃-N和TN降解率显著提高，分别达到98%、97%和90%。生物强化作用明显，反应器内具有良好的好氧反硝化环境。