Fe0/厌氧微生物联合体系处理2,4,6-三氯酚影响因素的研究

利用Fe⁰/厌氧微生物联合体系对2,4,6-三氯酚(2,4,6-TCP)进行降解研究。结果表明，Fe0/厌氧微生物联合体系可以有效降解2,4,6-TCP，Fe⁰与厌氧微生物之间存在明显的协同效应。Fe⁰/厌氧微生物联合体系处理2,4,6-TCP的最优条件为：微生物接种量0.434 g VSS/L，Fe⁰投加量15 g/L，体系初始pH值7.0～8.0。     

火电厂机组负荷调整对SCR脱硝效果的影响分析

为研究火电厂机组负荷调整对选择性催化还原法(Selective Catalytic Reduction,SCR)脱硝效果的影响,试验以SCR脱硝系统为研究对象,采用控制变量的方式,分别对5台火电厂机组在不同负荷条件下的烟气的温度、氧含量、污染物含量、脱硝效率以及SO2/SO3转化率等进行测量比较。结果表明,随着负荷的降低,氧含量以及NOx质量浓度升高,温度、脱硝效率以及SO2/SO3转化率降低;同温度相比,氧含量变化对NOx生成量的影响更大;而温度对于脱硝效率以及SO2/SO3转化率有较为显著的影响。     

4-氯苯酚在水溶液中的光化学反应(Ⅰ)单线态氧和自由基的产生

在模拟太阳光照射下，４氯苯酚（４ＣＰ）浓度迅速降低，反应过程对应着产生大量的单线态氧和自由基．金属离子Ｆｅ２＋、Ｆｅ３＋、Ａｌ３＋能够加速这一过程，尤以Ｆｅ２＋、Ｆｅ３＋的影响更明显；在模拟太阳光照射下，向４ＣＰ体系加入的富里酸（ＦＡ），对４ＣＰ浓度降低略起抑制作用，这表明二者之间存在相互作用．但当再加入金属离子Ｆｅ２＋、Ｆｅ３＋、Ａｌ３＋后，能够加速４ＣＰ浓度降低，尤以Ｆｅ２＋、Ｆｅ３＋的影响更显著．     

土壤中钼的形态分析方法研究

本文对土壤中有效钼的浸取条件进行最佳化，并利用提高灰化温度达到消除浸取剂对石墨炉原子吸收测定钼的影响，方法用于国标样品和武汉市区土壤样品中钼的形态分析，获得满意的分析结果。     

复合诱变菌处理氨氮废水

采用诱变技术对微生物菌种进行了诱变处理，分别研究了紫外线诱变菌、硫酸二乙酯（DES）诱变菌和复合诱变菌对含氨废水的降解性能。结果表明，复合诱变后获得的变异菌株Z5对含氨废水中NH4^ -N的去除率比单独采用紫外线或DES诱变后获得的菌株有明显的提高。混合菌种对化肥行业废水中COD的NH4^ -N的去除率可以达到95%～98%，出水能达到行业一级排放标准。     

4-氯苯酚在水溶液中的光化学反应(Ⅱ)反应的动力学研究

研究了在模拟太阳光和紫外光作用下，４－氯苯酚的光反应动力学，研究表明，紫外光的作用更为显。４－ＣＰ的反应速率与４－ＣＰ起始浓度、ｐＨ值，金属离子浓度、富里酸浓度等因素有关，通入空气，能够加速４－ＣＰ降解。     

沼泽红假单胞菌H3对酸性红B2GL染料的厌氧脱色和降解作用

从印染厂污泥中分离到一株沼泽红假单胞菌（ＲｈｏｄｏｐｓｅｕｄｏｍｏｎａｓｐａｌｕｓｔｒｉｓＨ３），在光照厌氧条件下该菌生长细胞可将１００ｍｇ／Ｌ酸性红Ｂ２ＧＬ染料去除到３０ｍｇ／Ｌ．完整细胞脱色的最适条件为ｐＨ７０，温度３０℃，细胞浓度２０—２５ｍｇ／ｍＬ（湿重）．低浓度的阳离子对脱色影响不大．在通Ａｒ气使严格厌氧和加有还原性辅酶Ｉ的条件下无细胞提取液的脱色活性最高，比活率为１５４×１０－２ｍｇ／（ｍｇ·ｈ）．根据降解产物的分析，推断了该菌对酸性红染料的降解代谢途径．     

悬挂链生物接触氧化工艺处理河道污水

采用悬挂链曝气式接触氧化工艺在3个时段内处理城市河道污水,通过采用磷脂法、TTC-脱氢酶活性法和MPN法研究载体表面生物膜特性,来验证装置的水质净化效果。结果表明,进水水质变化幅度较大的时段1内,水质对缺氧区和好氧区内生物膜量及活性有很大冲击,对污染物的去除效果影响不大,COD、NH+4-N、TN和TP的平均去除率分别达到75.9%、80.8%、64.6%和78.3%;进水水质稳定的时段2内,缺氧区和好氧区内生物膜量和活性要高于其他时段,COD、NH+4-N、TN和TP的平均去除率分别达到77.0%、80.6%、69.4%和55.3%;低温运行的时段3内,缺氧区和好氧区内生物膜量和活性都低于其他时段,水质净化效果明显下降,COD、NH+4-N、TN和TP的平均去除率分别为71.1%、68.5%、48.9%和46.6%。     

Chemical compositions and sources of atmospheric PM10 in heating, non-heating and sand periods at a coal-based city in northeastern China

Mass concentrations and chemical components (18 elements, 9 ions, organic carbon [OC] and elemental carbon [EC]) in atmospheric PM(10) were measured at five sites in Fushun during heating, non-heating and sand periods in 2006-2007. PM(10) mass concentrations varied from 62.0 to 226.3 μg m(-3), with 21% of the total samples' mass concentrations exceeding the Chinese national secondary standard value of 150 μg m(-3), mainly concentrated in heating and sand periods. Crustal elements, trace elements, water-soluble ions, OC and EC represented 20-47%, 2-9%, 13-34%, 15-34% and 13-25% of the particulate matter mass concentrations, respectively. OC and crustal elements exhibited the highest mass percentages, at 27-34% and 30-47% during heating and sand period. Local agricultural residuals burning may contribute to EC and ion concentrations, as shown by ion temporal variation and OC and EC correlation analysis. Heavy metals (Cr, Ni, Zn, Cu and Mn) from coal combustion and industrial processes should be paid attention to in heating and sand periods. The anion/cation ratios exhibited their highest values for the background site with the influence of stationary sources on its upper wind direction during the sand period. Secondary organic carbon were 1.6-21.7, 1.5-23.0, 0.4-17.0, 0.2-33.0 and 0.2-21.1 μg m(-3), accounting for 20-77%, 44-88%, 4-77%, 8-69% and 4-73% of OC for the five sampling sites ZQ, DZ, XH, WH and SK, respectively. From the temporal and spatial variation analysis of major species, coal combustion, agricultural residual burning and industrial emission including dust re-suspended from raw material storage piles were important sources for atmospheric PM(10) in Fushun at heating, non-heating and sand periods, respectively. It was confirmed by principal component analysis that coal combustion, vehicle emission, industrial activities, soil dust, cement and construction dust and biomass burning were the main sources for PM(10) in this coal-based city.     

复合沸石滤床修复北方景观水体的实验研究

以天然矿物质沸石、细砂及煤渣取代传统滤料构建复合基质生态床，表面种植景观植物，采用下向流-上向流运行方式修复北方景观水体。分别进行静态实验及不同循环速率下的动态实验，考察对水体污染物去除过程。结果表明，2种运行方式下对水体NH⁺₄-N去除率都在85%以上，其中以1 h为循环周期的运行方式去除率达97%，较静态提高12.8%；TN去除率最高为84%；TP去除不稳定，过程缓慢。煤渣层对NH⁺₄-N的去除效果差，硝化作用不彻底与反硝化作用的加强使下层出水NH⁺₄-N 、NO^-₂-N及NO^-₃-N浓度均高于上层。提高循环速率有利于对氮的去除。