Assessment of the Water Quality of Troia for the Multipurpose Usages

The aim of this study was to determine the origin and quality of waters in Troia. For this purpose total of 25 water samples including 2 springs, 14 surfaces and 9 groundwaters, were collected at eight different times. Global positioning system (GPS) was used to determine to coordinates of sampling points. The concentration of 6 minor elements (B, Cu, F, Fe, Pb and Zn), 9 major anions and cations (Na(+), Ca(2+), K(+), Mg(2+), SO(4)(2-), PO(4)(3-), HCO(3)(-), Cl(-) and, CO(3)(2-)) were determined by spectrometric, colorimetric and volumetric methods. Water pH, EC, DO, ORP and TDS were measured in situ using probes. The data showed that the concentrations of most of minor elements were below the EPA and TSE limits except Pb which ranged between 0.001 and 4.832 mg L(-1). Statistically significant relationships (P<0.01 and r>0.70) were observed between Fe and Cu, Cu and K(+), Cu and Ca(2+), B and Na(+), Na(+) and K(+). Assessing the water based on irrigation using Wilcox model showed that some well waters were not suitable for irrigation. Troia water was found to be highly corrosive and the average corrosion coefficients varied from 0.5 to 4.6. According to the Piper and Schoeller diagrams results, the water in Troia was classified as mixed water type.     

Pyrolysis of virgin and waste polypropylene and its mixtures with waste polyethylene and polystyrene

A comparison of waste and virgin polypropylene (PP) plastics under slow pyrolysis conditions is presented. Moreover, mixtures of waste PP with wastes of polyethylene (PE) and polystyrene (PS) were pyrolyzed under the same operating conditions. Not only the impact of waste on degradation products but also impacts of the variations in the mixing ratio were investigated. The thermogravimetric weight loss curves and their derivatives of virgin and waste PP showed differences due to the impurities which are dirt and food residues. The liquid yield distribution concerning the aliphatic, mono-aromatic and poly-aromatic compounds varies as the ratio of PP waste increases in the waste plastic mixtures. In addition to this, the alkene/alkane ratio of gas products shows variations depending on the mixing ratio of wastes.     

Recyling of plastic wastes via pyrolysis

Pyrolysis for the simultaneous generation of oils and gases can be convenient to obtain hydrocarbons and even to recover crude petrochemicals or to generate energy from waste plastics. A Gray–King apparatus has been used to pyrolyze waste polyethylene (PE), polystyrene (PS), both separately and with different compositions. Thermogravimetric analysis of waste plastics indicated the critical temperatures, which should be effective for pyrolysis. The chosen heating rate was low in order to achieve higher liquid yields. The results showed that waste PS yielded higher liquid, and waste PE yielded higher gaseous products. The dominant liquid product of PS waste was styrene whereas for waste PE, prophenylbenzene was the dominant pyrolysis product.     

Energy and Enviromental Issues in Turkey

The current and future projections of energy utilisation and related environmental impact has been given. Due to the heavy dependance on low grade lignites and imported hard coal, Turkey is going to have problems in the control of CO₂ emissions. Turkey was at first included as an Annex I country according to Kyoto Protocol. Later, it has been removed from the list which is justified considering the previous international environmental impact control applications and relatively much lower energy utilisation in Turkey, compared to Annex I countries. Therefore, Turkey has been removed from the Annex I list.Turkish power generation, industrial and transportation sector will be facing a difficult challenge over the coming 20 yr in complying with environmental impact levels. The developments in the liberalisation of Turkish energy sector since the 1980's is a positive step to overcome the problems.     

Removal of mercury (II) from aqueous solution by activated carbon obtained from furfural

The adsorption of Hg(II) from aqueous solution at 293 K by activated carbon obtained from furfural is studied. The carbon is prepared by polymerization of furfural following carbonization and activation of the obtained polymer material with water vapor at 800 degrees C. Adsorption studies of Hg(II) are carried out varying some conditions: treatment time, metal ion concentration, adsorbent amount and pH. It is determined that Hg(II) adsorption follows both Langmuir and Freundlich isotherms. The adsorption capacity of the carbon is 174 mg/g. It is determined that Hg(II) uptake increases with increasing pH. Desorption studies are performed with hot water. The percent recovery of Hg(II) is 6%.     

Long-term spatiotemporal patterns of CH4 and N2O emissions from livestock and poultry production in Turkey

This study quantified spatiotemporal patterns of CH₄ and N₂O emissions from livestock and poultry production in Turkey between 1961 and 2007. CH_4(enteric) (from enteric fermentation), CH_4(manure) (from manure management), and N₂O_(AWM) (from animal waste management) emissions in Turkey were estimated at 1,164, 216, and 55 Gg in 1961 and decreased to 844, 187, and 39 Gg in 2007, contributing a share of roughly 2% to the global livestock-related CH₄ emissions and %1.5 to the global N₂O_(AWM) emissions, respectively. Total CO₂-eq emissions were estimated at 50.7 Tg in 1961 and declined from a maximum value of 60.7 Tg in 1982 to a minimum value of 34.5 Tg in 2003, with a mean emission rate of 48 Tg year^???1 due to a significant reduction in the number of ruminant livestock. The highest mean share of emissions belonged to West Black Sea (14% and 16%) for CH_4(enteric) and CH_4(manure) and to North East Anatolia (12% and %13) for N₂O_(AWM) and total CO₂-eq emissions, respectively. The highest emission density was 1.7 Mg km^???2 year^???1 for CH_4(enteric), 0.3 Mg km^???2 year^???1 for CH_4(manure), and 0.07 Mg km^???2 year^???1 for the total CO₂-eq emissions in the West and North East Anatolia regions and 0.09 Mg km^???2 year^???1 for N₂O_(AWM) in the East Marmara region. Temporal and spatial variations in CH_4(enteric), CH_4(manure), and N₂O_(AWM) emissions in Turkey were estimated using regression models and ordinary kriging at a 500-m resolution, respectively.