Migration Pathways and Remediation of Urban Runoff for PAH Control

The migration pathways for polyaromatic hydrocarbons (PAH) and the associated active attenuating mechanisms within the urban environment are examined. The interest in developing an improved understanding of PAH migration/attenuation is focused toward quantification of the cost-effectiveness of urban runoff control strategies for mitigation of PAH inputs to receiving water bodies.A case study application to the City of Sault Ste Marie demonstrates that snow removal from sub-basins with the largest deposition rates, and relatively small wet and/or dry stormwater management ponds, are the most cost-effective remediation strategies.     

POLLUTANT LOADS IN URBAN STORMWATER: REVIEW OF METHODS FOR PLANNING-LEVEL ESTIMATES1

ABSTRACT: A review of methods for planning-level estimates of pollutant loads in urban stormwater focuses on transfer of charac. teristic runoff quality data to unmonitored sites, runoff monitoring, and simulation models. Load estimation by transfer of runoff quality data is the least expensive, but the accuracy of estimates is unknown. Runoff monitoring methods provide best estimates of existing loads, but cannot be used to predict load changes resulting from runoff controls, or other changes of the urban system. Simulation models require extensive calibration for reliable application. Models with optional formulations of pollutant build up, washoff, and transport can be better calibrated and the selection of options should be based on a statistical analysis of calibration data. Calibrated simulation models can be used for evaluation of control alternatives.     

Influence of test conditions on solubility controlled leaching predictions from air-pollution-control residues.

Leaching of Al, Ca, Mg, Si, S, Ba, Sr, Mo, Zn, Cd, Pb, and Cu from waste incineration air-pollution-control (APC) residues was investigated. Real-life conditions, i.e. removal of readily soluble compounds and longer equilibration time, were considered. Three different pH-static leaching experiments evaluating the importance of salt level and equilibration time were performed: (i) 48-h test on untreated APC residue samples, (ii) 48-h test on washed residue samples, and finally (iii) a 172-h test on washed residue samples. Experimental data were evaluated by geochemical modelling to identify potential solubility controlling minerals. For some elements (Al, Ca, Mg, Si, S, Mo, Zn, Cd, and Cu) the same controlling minerals were suggested regardless of the equilibration period or untreated/washed character of the tested material, whereas leaching of other elements (Ba, Sr) was far better described by considering a longer equilibration time, thereby pointing out the kinetic effects. Finally, a significant fraction of total lead (57%) was found to be rather mobile in the initial stage of leaching. Both pre-washing of the residues and longer equilibration times were shown to be simple yet useful methods to identify mineral phases that could control the release of constituents after the removal of readily soluble compounds in the initial stage of leaching.     

Effects of food-borne ZnO nanoparticles on intestinal microbiota of common carp (Cyprinus carpio L.)

Environmental Science and Pollution Research - Ingestion of nanoparticles (NPs) with antimicrobial properties may disrupt the balance of intestinal microbiota. To investigate the effects of zinc...     

Thermoluminescence as a tool for monitoring ozone-stressed plants

The effect of ozone (6 h, various concentrations from 0 to 350 ppb) on barley (Hordeum vulgare L., cv. Bomi) and tomato (Lycopersicon esculentum L., cv. Yellow Cherry) leaves was investigated in parallel by thermoluminescence (TL) and fluorescence (FL) methods. Several significant changes were found in TL glow curves measured after excitation by one single turnover flash at +2 degree C in the temperature range from 2 to 170 degree C immediately after ozone exposure. Contrary to TL, ozone induced only negligible changes in FL parameters F0, FM and Fv/FM. Measurements done 24 h after ozone exposure showed partial recovery of ozone-induced changes. The extent of recovery was not the same in different parts of TL curves. Fluorescence parameters were not significantly changed. The results demonstrate that TL parameters are more sensitive to ozone than conventially used FL parameters F0, FM and Fv/FM. Moreover, TL measurements seem to give information not only about the PSII electron transport, but also about the extent of oxidative damage and membrane lipid peroxidation. It is concluded, that TL can be a highly informative tool for monitoring the impact of ozone on plants.     

The influence of air flow on maximum explosion characteristics of dust–air mixtures

A standard spherical apparatus for measuring explosion characteristics was modified to give increased and controlled turbulence within a dust–air mixture. This was intended to mimic the local effects which may occur during industrial dust explosions, particularly secondary ones which may develop in ducts or mine galleries where the initial explosion causes an increased air velocity and suspension of further quantities of dust.The results show that there may be a doubling of the maximum explosion pressure and of the rate of pressure rise during the explosion under more turbulent conditions. This is significant for modelling of dust explosions and suggests that explosion relief may be inadequate if this factor is not taken into consideration.The modified apparatus therefore gives a laboratory method for assessing the effect of turbulence in dust explosions.     

Diversity of chlorobiphenyl-metabolizing bacteria and their biphenyl dioxygenases in contaminated sediment

Bacteria and bacterial communities in sites contaminated with polychlorinated biphenyls have been extensively studied in the past decades. However, there are still major gaps in the knowledge of environmental processes, especially in the behavior of previously described bacteria in vitro, their real degradation abilities and the enzymes that are involved in the degradation processes.