Supercritical water gasification of sewage sludge using bench-scale batch reactor: advantages and drawbacks

Sewage sludge, a byproduct of municipal wastewater treatment, was gasified by supercritical water using a bench-scale batch reactor. Configuration of bench-scale batch reactor and operation procedures are discussed in detail. Experience and challenges that arose during the experiment are also shared. Using the bench-scale reactor under the condition of 600 °C, 23 MPa, and a reaction time of 60 min without catalyst presence, a total gas yield of 9.8 mol/(kg-sewage sludge) was obtained. Furthermore, investigations on operational parameters were conducted. Extension of reaction time up to 60 min increased the gasification, reaching a plateau thereafter. Investigation on pressure indicated the superiority of supercritical pressure. The addition of Ni as a catalyst also promoted gasification, although inorganic salts and char seemed to cover the catalyst surface. With regard to the prospect of future operation at a municipal waste water treatment plant, the effect of operational parameters on heavy metal concentration in the liquid phase is also discussed.     

Mobile monitoring along a street canyon and stationary forest air monitoring of formaldehyde by means of a micro-gas analysis system

A micro-gas analysis system (μGAS) was developed for mobile monitoring and continuous measurements of atmospheric HCHO. HCHO gas was trapped into an absorbing/reaction solution continuously using a microchannel scrubber in which the microchannels were patterned in a honeycomb structure to form a wide absorbing area with a thin absorbing solution layer. Fluorescence was monitored after reaction of the collected HCHO with 2,4-pentanedione (PD) in the presence of acetic acid/ammonium acetate. The system was portable, battery-driven, highly sensitive (limit of detection = 0.01 ppbv) and had good time resolution (response time 50 s). The results revealed that the PD chemistry was subject to interference from O(3). The mechanism of this interference was investigated and the problem was addressed by incorporating a wet denuder. Mobile monitoring was performed along traffic roads, and elevated HCHO levels in a street canyon were evident upon mapping of the obtained data. The system was also applied to stationary monitoring in a forest in which HCHO formed naturally via reaction of biogenic compounds with oxidants. Concentrations of a few ppbv-HCHO and several-tens of ppbv of O(3) were then simultaneously monitored with the μGAS in forest air monitoring campaigns. The obtained 1 h average data were compared with those obtained by 1 h impinger collection and offsite GC-MS analysis after derivatization with o-(2,3,4,5,6-pentafluorobenzyl)hydroxylamine (PFBOA). From the obtained data in the forest, daily variations of chemical HCHO production and loss are discussed.     

Field study of nitrous oxide production with in situ aeration in a closed landfill site

Nitrous oxide (N₂O) has gained considerable attention as a contributor to global warming and depilation of stratospheric ozone layer. Landfill is one of the high emitters of greenhouse gas such as methane and N₂O during the biodegradation of solid waste. Landfill aeration has been attracted increasing attention worldwide for fast, controlled and sustainable conversion of landfills into a biological stabilized condition, however landfill aeration impel N₂O emission with ammonia removal. N₂O originates from the biodegradation, or the combustion of nitrogen-containing solid waste during the microbial process of nitrification and denitrification. During these two processes, formation of N₂O as a by-product from nitrification, or as an intermediate product of denitrification. In this study, air was injected into a closed landfill site and investigated the major N₂O production factors and correlations established between them. The in-situ aeration experiment was carried out by three sets of gas collection pipes along with temperature probes were installed at three different distances of one, two and three meter away from the aeration point; named points A-C, respectively. Each set of pipes consisted of three different pipes at three different depths of 0.0, 0.75 and 1.5 m from the bottom of the cover soil. Landfill gases composition was monitored weekly and gas samples were collected for analysis of nitrous oxide concentrations. It was evaluated that temperatures within the range of 30–40°C with high oxygen content led to higher generation of nitrous oxide with high aeration rate. Lower O₂ content can infuse N₂O production during nitrification and high O₂ inhibit denitrification which would affect N₂O production. The findings provide insights concerning the production potentials of N₂O in an aerated landfill that may help to minimize with appropriate control of the operational parameters and biological reactions of N turnover.

Implications: Investigation of nitrous oxide production potential during in situ aeration in an old landfill site revealed that increased temperatures and oxygen content inside the landfill site are potential factors for nitrous oxide production. Temperatures within the range of optimum nitrification process (30–40°C) induce nitrous oxide formation with high oxygen concentration as a by-product of nitrogen turnover. Decrease of oxygen content during nitrification leads increase of nitrous oxide production, while temperatures above 40°C with moderate and/or low oxygen content inhibit nitrous oxide generation.     

Impacts of Asian dust storm associated with the stratosphere-to-troposphere transport in the spring of 2001 and 2002 on dust and tritium variations in Mount Wrangell ice core,Alaska

The relation of interannual connection between Asian dust outbreaks and stratosphere-to-troposphere transport (STT) in spring was suggested by the dust and tritium variations in the Mount Wrangell ice core, Alaska in [Yasunari, T.J., Shiraiwa, T., Kanamori, S., Fujii, Y., Igarashi, M., Yamazaki, K., Benson, C.S., Hondoh, T., 2007. Intra-annual variations in atmospheric dust and tritium in the North Pacific region detected from an ice core from Mount Wrangell, Alaska. J. Geophys. Res., 112, D10208. doi: 10.1029/2006JD008121]. However, these impacts on the ice core site in each event scale have not been investigated. Hence, the present paper focuses on the material transport and deposition processes for further understanding these impacts on the ice core. The variations in dust and tritium concentrations in spring in an ice core taken at Mt. Wrangell, Alaska are explained by meteorological analysis and simulation of trajectories associated with Asian dust outbreaks and STT. Material transport and deposition at Mt. Wrangell are examined in two contrasting years (2001 and 2002). Dust and tritium concentrations both reached peak values in the early spring of 2002, while the dust peak occurred in early spring and the tritium peak occurred in late spring in 2001. Six severe East Asian transpacific dust storms over this period are modeled by forward trajectory and meteorologically analyzed. It is found that 5 of 6 events contributed to the ice core record in Alaska. Stratospheric air is also transported to the ice core site in most cases. Tritium deposition is found to have been suppressed in the cases of the 2001 dust storms due to lack of snowfall at appropriate times. Taken the detailed transport and deposition processes after the severe dust storms with atmospheric circulations into account, we can well explain spring dust and tritium variations in the Mount Wrangell ice core.     

Influence of aeration modes on leachate characteristic of landfills that adopt the aerobic–anaerobic landfill method

As far as the optimal design, operation, and field application of the Aerobic–Anaerobic Landfill Method (AALM) are concerned, it is very important to understand how aeration modes (different combinations of aeration depth and air injection rate) affect the biodegradation of organic carbon and the transformation of nitrogen in landfill solid waste. Pilot-scale lysimeter experiments were carried out under different aeration modes to obtain detailed information regarding the influence of aeration modes on leachate characteristics. Results from these lysimeter experiments revealed that aeration at the bottom layer was the most effective for decomposition of organic carbon when compared with aeration at the surface or middle layers. Moreover, the air injection rate led to different nitrogen transformation patterns, unlike the lesser influence it has on organic carbon decomposition. Effective simultaneous nitrification and denitrification were observed for the aeration mode with a higher air injection rate (=1.0 L/min). On the other hand, the phenomenon of sequenced nitrification and denitrification could be observed when a low air injection rate (=0.5 L/min.) was employed. Finally, it is concluded that, for AALM, air injection with a higher air injection rate at the deepest layer near the leachate collection pipe tends to accelerate the stabilization of landfill waste as defined in terms of the enhancement of denitrification as well as organic carbon decomposition.     

Production of carbon-based precursor from non-recyclable waste poly(ethylene) terephthalate: effect of multilayer structure on carbonized product

Journal of Material Cycles and Waste Management - In this paper, the carbonization of multilayer PET containing an oxygen barrier layer was investigated. The oxygen barrier layer was identified as...     

Characteristics of environmental factors and their effects on CH4 and CO2 emissions from a closed landfill: An ecological case study of Shanghai

To elucidate the influence of landfill gas (LFG) emission on environmental factors, an ecological investigation that was primarily concerned with the characteristics of vegetation, cover soil, and solid waste in the landfill was carried out. Temporal and spatial variations in vegetation diversity and coverage and their effects on reducing the emission of methane in the landfill were investigated. The results showed that both vegetation coverage and diversity increased with elapsed landfill closure time. The transition trend of the vegetation species was from perennial plant (Phragmites australis) to annual plants. Perennial vegetation was the dominant type of vegetation during the early closure period, and annual vegetation coverage increased with closure time. Vegetation preferentially appeared in areas of comparatively high depth of cover soil, which was characterized by high moisture retentiveness that enabled vegetation growth. The concentrations of methane and carbon dioxide in the cover soil significantly decreased with increasing closure time. The concentrations of methane and carbon dioxide from bare cover soil were higher than those from vegetated cover soil whereas the CO₂ flux of bare cover soil was less than that of vegetated cover soil.     

The chemical characteristics of ashes from cattle, swine and poultry manure

Animal manure is waste that contains large amounts of fertilizer resources. Incineration technology is effective in decreasing the volume of animal manure and concentrating the nutrients. In this study, the nutrient concentration and chemical compounds of several types of animal manure ash were examined to promote their recycling for agriculture. The nutrient concentration of manure ash was dependent on the reduction rate of solid materials by incineration. The phosphorus (P) and potassium (K) of cattle and layer manure were not concentrated greatly because of high silicon (Si) and calcium (Ca) concentrations, respectively. On the other hand, the P concentration of swine manure and broiler litter was increased to 10.1–12.0 % (3.6–4.6 times compared with original materials), equivalent to that of phosphate rock used as fertilizer material. The K concentration of broiler litter ash (16.1 %) was highest of all. The phosphate compounds of cattle and swine manure ashes were determined as Ca₉Fe(PO₄)₇ or Ca₉MgK(PO₄)₇. Hydroxyapatite (Ca₅(PO₄)₃(OH)) was detected in layer manure and broiler litter ashes. By acid treatment of ash, P and K availability of the fertilizer made from layer manure ash (33 % of materials) was equivalent to that of conventional chemical fertilizer.