Pore structure and adsorption properties of activated carbon prepared from granular molded waste paper

We have previously manufactured activated carbon using waste paper board, which was prepared by adding 8% phenol resin adhesive to torn waste newspaper and hot-pressing. In this study, the pretreatment process of the raw material was simplified; the waste paper was extruded to form granules. The activated carbon was manufactured by the carbon dioxide activation method using the granules as the raw material. The properties of the activated carbon were evaluated based on the pore structure, the iodine adsorption number, and the adsorption of toluene vapor in a sealed chamber. The activated carbon, which was manufactured at an activation temperature of 1100°C and a treatment time of 60min, exhibited a specific surface area of 1241m²/g and an iodine adsorption number of 1120mg/g. These results were similar to those obtained for two commercially available activated carbons. The extent of toluene vapor adsorption by this activated carbon was similar to that observed for the two commercial activated carbons over a period of 130min.     

Determination of chlorine in air with the pyridine-pyrazolone reagent

An improved method for the determination of chlorine in air is described. The principle of this method is based on the absorption of chlorine in p-toluenesulfonamide aqueous solution, followed by color development with a pyridine-pyrazolone reagent. Both the chlorine absorbed in the solution and the color developed with the reagent were stable. Positive interference by nitrogen dioxide was not observed.     

Reductive dechlorination of non-ortho substituted polychlorinated biphenyls by ultraviolet irradiation in alkaline 2-propanol

The photodechlorination pathways of 3,3′,4,5,5′-pentachlorobiphenyl (3,3′,4,5,5′-PentaCB) and the related lower polychlorinated biphenyl congeners irradiated at 254 nm in alkaline 2-propanol were elucidated. Steric effect is the most important factor for controlling the dechlorination pattern of these substrates. Electronic effect also influences the photoreactivity of chlorine substituents.     

Niche differentiation and fine-scale projections for Argentine ants based on remotely sensed data.

Modeling ecological niches of species is a promising approach for predicting the geographic potential of invasive species in new environments. Argentine ants (Linepithema humile) rank among the most successful invasive species: native to South America, they have invaded broad areas worldwide. Despite their widespread success, little is known about what makes an area susceptible--or not--to invasion. Here, we use a genetic algorithm approach to ecological niche modeling based on high-resolution remote-sensing data to examine the roles of niche similarity and difference in predicting invasions by this species. Our comparisons support a picture of general conservatism of the species' ecological characteristics, in spite of distinct geographic and community contexts.     

道路交通事故信息文本预处理技术研究与实践

文本预处理是文本挖掘的关键一步,建立与信息相匹配的标准语义集合能缩短信息处理的时间,提高信息的提取率和识别精度。根据国家交通事故信息采集规范要求,从国家公共安全行业标准中抽取相关交通事故基本信息的标准词汇及代码,构建了一套含有12个属性项目、185个标准词汇的交通事故信息文本预处理用标准化语义集合,并将其应用于国家安全生产监督管理总局的事故查询系统,对系统中2004—2014年期间所收集的8 156件重大道路交通事故信息中的文本数据进行分析。结果表明:利用这套语义集合能更多地提取交通事故信息,可为准确捕捉交通事故特征和研究交通事故发生机理提供重要依据,也为开发交通事故自动信息识别系统创造了重要的条件。     

Identification and characterization of coagulation inhibitor proteins derived from cyanobacterium Microcystis aeruginosa

The excess growth of cyanobacteria in semi enclosed water areas caused by eutrophication brings about coagulation inhibition in drinking water treatment processes. In this study, coagulation inhibitor proteins produced by Microcystis aeruginosa, a major cyanobacterium in algal bloom, were acquired by a phage display technique, an aluminum-immobilized affinity chromatography and a protein expression technique using Escherichia coli cells. Two cyanobacterial peptides with a high ratio of metallophilic amino acids were recovered, which were a part of homologues of a thiol oxidase enzyme Ero1p and a trans-acting repressor ArsR. It was also shown that the homologue of ArsR exhibited a stronger inhibitory effect on the coagulation of kaolin suspension with polyaluminum chloride than the control proteins. This is the first report to identify a cyanobacterial cell component to inhibit coagulation. The compositions of polar amino acids were critical to explain the strength of coagulation inhibition potential. Polar proteins from cyanobacteria could collectively consume coagulants or stabilize clay particles, which would be plausible explanations for causing coagulation inhibition. Meanwhile, results from the kaolin coagulation tests using the control proteins implied that the neutralization of positive charges of coagulant constituents by simple electrostatic interactions might not be the key mechanism on the protein-induced coagulation inhibition.     

Deposition velocity of PM2.5 sulfate in the summer above a deciduous forest in central Japan

In order to increase knowledge of aerosol dry deposition for the regional assessment of acid deposition and transboundary air pollution in East Asia, an experimental study on PM2.5 sulfate deposition was implemented in the early summer of 2009. The experimental field was located in a deciduous forest at the foot of Mt. Asama, central Japan. Aerosol fluxes were obtained using the aerodynamic gradient method. Three aerosol samplers were placed on an experimental tower at 21, 24 and 27 m above the ground surface, and collected PM2.5 on filters for chemical analysis. Vertical concentration differences between 21 m and 27 m of PM2.5 sulfate were detected significantly when the concentration exceeded 1 μg m^?3. Mean deposition velocity was estimated to be 0.9 ± 1.0 cm s^?1 in the daytime and 0.3 ± 0.3 cm s^?1 in the nighttime. In the case that a height-dependent correction in the roughness sub-layer was taken into account, the deposition velocities increased more, especially in daytime. Higher deposition velocities in the daytime were associated with larger friction velocities and unstable conditions. The deposition velocities observed in this study were in agreement with other experimental results found in the literature. On the other hand, they were higher than those calculated by theoretical models. Two empirical parameterizations (Wesely, M.L., Cook, D.R., Hart, R.L., 1985. Measurement and parameterization of particulate sulfur dry deposition over grass. Journal of Geophysical Research 90, 2131–2143; Ruijgrok, W., Tieben, H., Eisinga, P., 1997. The dry deposition of particles to a forest canopy: a comparison of model and experimental results. Atmospheric Environment 31, 399–415) were validated by the observations. The general trend of higher daytime and lower nighttime deposition velocities was similar among the observation and the two parameterizations. The large variability found in the measurement was not reproduced by the parameterizations, because it is attributable to random error from the differences between the samplers. The observations were in accordance with the parameterization of Ruijgrok et al. (1997) for a forest, although much larger than that of Wesely et al. (1985) for grasslands. This indicates the large difference in aerosol deposition velocities between forests and grasslands.     

Thelytokous parthenogenesis by queens in the dacetine ant Pyramica membranifera (Hymenoptera: Formicidae)

Thelytokous parthenogenesis in which diploid females are produced from unfertilized eggs, was recently reported for some ant species. Here, we document thelytokous reproduction by queens in the polygynous species Pyramica membranifera. Queens that emerged in the laboratory were kept with or without workers under laboratory conditions. Independent colony founding was successful for a few queens if prey was provided. All artificial colonies, which started with a newly emerged queen and workers produced new workers and some of the colonies also produced female sexuals. Some of the female sexuals shed their wings in the laboratory and started formation of new polygynous colonies. Workers had no ovaries and thus, were obligatorily sterile.     

Factors affecting the biodegradability of biodegradable polyester in soil

The biodegradabilities of two polyester, P(3HB-co-3HV) and PCL, in soil were studied to examine the factors affecting the biodegradability of biodegradable plastics in soil. The polymers were mixed with soil and the time course of the biodegradation of the polymer was measured by analyzing the residual polymer. The polymer biodegraded little in early period of the test, but did in the first-order kinetics after a certain time which was dependent on the test substance and soil used. The rate constant and the induction period of the biodegradation were determined from the residual curve. The rate constant and the induction period for P(3HB-co-3HV) increased and reached to the constant values with increasing the particle size of the test substance. Both values depended on the kind of test soil and on the sampling date for the same kind of soil. The variation in the biodegradability among the same kind of soil was primarily attributed to the variation in water content of the soil. The rate constant and the induction period of PCL were smaller and longer than P(3HB-co-3HV), respectively.