Thermal modeling,characterization, and enviro-economic investigations on inclined felt sheet solar distiller for seawater desalination

Environmental Science and Pollution Research - Sustainable desalination can be achieved by adopting renewable energy-based low-cost and low-impact desalting techniques. In this investigation,...     

Subsurface nutrient modelling using finite element model under Boro rice cropping system

Boro rice, an emerging low-risk crop variety of rice, cultivated using residual or stored water after Kharif season. To enhance the quality and production of rice, potassium (K) and phosphorus (P) are the common constituents of agricultural fertilizers. However, excess application of fertilizers causes leaching of nutrients and contaminates the groundwater system. Therefore, assessment and optimization of fertilizer dose are needed for better management of fertilizers. Towards this, the present study determines the path, persistence, and mobility of K and P under the Boro rice cropping system. The experimental site consisted of four plots having Boro rice with four different fertilizer doses of nitrogen (N), P, K viz. 100%, 75%, 50%, and 25% of the recommended dose. Disturbed soil samples were analysed for K and P from pre-sown land to tillering stage at 0–5, 5–10, 10–15, 15–30, 30–45, and 45–60 cm depths. Simultaneously, K and available P were also simulated in the subsurface soil layers through the HYDRUS-1D model. The statistical comparisons were made with RMSER, E, and PBIAS between the modelled values and laboratory-measured values. Although, the results showed that all the treatments considered had agreeable simulations for both K and P, the K simulations were found to be better as compared to P simulations except for 25% where P simulations outperformed K. The simulated concentration at all doses was found most appropriate when measured for the subsurface layers (up to 45 cm), while showed an underestimation in the bottom layers (45–60 cm) of soil.

     

A multivariate statistical approach for the evaluation of spatial and temporal dynamics of surface water quality from the small reservoir located in the drought-prone area of South-West India: a case study of Tiru reservoir (India)

Environmental Science and Pollution Research - With the use of different multivariate statistical analysis methods, spatio-temporal fluctuations in the water parameters of Tiru reservoir located at...     

Fluoride removal and its impact on oral health in Sri Lanka's dry zone: Discussion and recommendation

Fifty percent of the dry zone areas in Sri Lanka have fluoride levels above 1 ppm. This paper discusses the ground conditions and recommends an appropriate range of fluoride in drinking water which can support preventive practices for improving the oral health of children 8-years old and younger. In efforts to address the Chronic Kidney Disease of Unknown etiology (CKDU), water treatment to reduce contaminant level in potable water has been implemented. Such treatment would also remove fluoride and has resulted in potable water with various fluoride levels, depending on concentrations in the raw water. While it is important to reduce fluoride levels, it is important to have appropriate residual levels for prevention of dental caries. It needs, however, to be noted fluoride in excess can cause dental fluorosis. In Sri Lanka's dry zone areas increasing prevalence of dental fluorosis with decreasing prevalence of dental caries has been noted. Consumption of tea and powdered milk could increase total intake of fluoride. Fluoridated toothpaste, when used properly, may, however, result in negligible intake of fluoride. Sri Lanka's hot tropical climate which results in substantial intake of fluids reinforces the need to consider reduction in water fluoride. Consideration of local studies and international standards indicate fluoride levels should be in the range of 0.225–0.500 ppm. In the range of 0.225–0.500 ppm, the prevalence of dental fluorosis and caries was only 14% and 8%, respectively, in an endemic district. When fluoride levels are above 0.500 ppm, the issue of dental fluorosis shall need to be addressed. When levels are below 0.225 ppm, oral health care services shall need to be directed at preventing dental caries.     

Emerging applications of green coconut: A promising lignocellulosic biomass

Waste accumulation is a grave concern and becoming a transboundary challenge for environment. During Covid-19 pandemic, diverse type of waste were collected due to different practices employed in order to fight back the transmission rate of the virus. Covid-19 was proved to be capricious catastrophe of this 20th century and even not completely eradicated from the world. The havoc created by this imperceptible quick witted, pleomorphic deadly virus can't be ignored. Though a number of vaccines have been developed by the scientists but there is a fear of getting this virus again in our life. Medical studies prove that immunity drinks will help to reduce its reoccurrences. Coconut water is widely used among all drinks available globally. Its massive consumption created an incalculable pile of green coconut shells around the different corners of the world. This practice generating enormous problem of space acquisition for the environment. Both the environment and public health will benefit from an evaluation of quantity of coconut waste that is being thrown and its potential to generate value added products. With this context, present article has been planned to study different aspects like, coconut waste generation, its biological properties and environmental hazards associated with its accumulation. Additionally, this review illustrates, green technologies for production of different value added products from coconut waste.     

Systematic review of conservation interventions to promote voluntary behavior change

Understanding human behavior is vital to developing interventions that effectively lead to proenvironmental behavior change, whether the focus is at the individual or societal level. However, interventions in many fields have historically lacked robust forms of evaluation, which makes it hard to be confident that these conservation interventions have successfully helped protect the environment. We conducted a systematic review to assess how effective nonpecuniary and nonregulatory interventions have been in changing environmental behavior. We applied the Office of Health Assessment and Translation systematic review methodology. We started with more than 300,000 papers and reports returned by our search terms and after critical appraisal of quality identified 128 individual studies that merited inclusion in the review. We classified interventions by thematic area, type of intervention, the number of times audiences were exposed to interventions, and the length of time interventions ran. Most studies reported a positive effect (n = 96). The next most common outcome was no effect (n = 28). Few studies reported negative (n = 1) or mixed (n = 3) effects. Education, prompts, and feedback interventions resulted in positive behavior change. Combining multiple interventions was the most effective. Neither exposure duration nor frequency affected the likelihood of desired behavioral change. Comparatively few studies tested the effects of voluntary interventions on non-Western populations (n = 17) or measured actual ecological outcome behavior (n = 1). Similarly, few studies examined conservation devices (e.g., energy-efficient stoves) (n = 9) and demonstrations (e.g., modeling the desired behavior) (n = 5). There is a clear need to both improve the quality of the impact evaluation conducted and the reporting standards for intervention results.     

Feasibility of coupling a thermal/optical carbon analyzer to a quadrupole mass spectrometer for enhanced PM2.5 speciation

A thermal/optical carbon analyzer (TOA), normally used for quantification of organic carbon (OC) and elemental carbon (EC) in PM_2.5 (fine particulate matter) speciation networks, was adapted to direct thermally evolved gases to an electron impact quadrupole mass spectrometer (QMS), creating a TOA-QMS. This approach produces spectra similar to those obtained by the Aerodyne aerosol mass spectrometer (AMS), but the ratios of the mass to charge (m/z) signals differ and must be remeasured using laboratory-generated standards. Linear relationships are found between TOA-QMS signals and ammonium (NH₄⁺), nitrate (NO₃^?), and sulfate (SO₄^2-) standards. For ambient samples, however, positive deviations are found for SO₄^2-, compensated by negative deviations for NO₃^?, at higher concentrations. This indicates the utility of mixed-compound standards for calibration or separate calibration curves for low and high ion concentrations. The sum of the QMS signals across all m/z after removal of the NH₄⁺, NO₃^?, and SO₄^2- signals was highly correlated with the carbon content of oxalic acid (C?H?O?) standards. For ambient samples, the OC derived from the TOA-QMS method was the same as the OC derived from the standard IMPROVE_A TOA method. This method has the potential to reduce complexity and costs for speciation networks, especially for highly polluted urban areas such as those in Asia and Africa.

Implications: Ammonium, nitrate, and sulfate can be quantified by the same thermal evolution analysis applied to organic and elemental carbon. This holds the potential to replace multiple parallel filter samples and separate laboratory analyses with a single filter and a single analysis to account for a large portion of the PM_2.5 mass concentration.     

Improvement of Impact Toughness of Biodegradable Poly(butylene succinate) by Melt Blending with Sustainable Biobased Glycerol Elastomers

Poly(butylene succinate) (PBS) was melt blended with glycerol based polyesters (PGS) synthesized from pure and technical glycerol aiming to improve the impact strength of PBS. It was found that after addition of 30 wt% PGS to PBS its impact strength was significantly increased by 344% (from 31.9 to 110 J/m) and its elongation at break was maintained at 220%. Infrared spectra of the blends showed the presence of hydroxyl groups from the PGS phase suggesting that hydrogen bonding between the phases could be responsible for a good stress transfer and an efficient toughening in the PBS/PGS blends. Scanning electron microscopy imaging showed a good dispersion of PGS phase into PBS with a PGS particle size of 10 μm and less and no agglomeration. Addition of PGS to PBS was shown to be an effective strategy for improvement of PBS impact resistance without serious detrimental effects on its thermal and rheological properties.     

Are older drivers’ driving patterns during an on-road driving task representative of their real-world driving patterns?

Abstract

Objective: The current study investigated whether older drivers’ driving patterns during a customized on-road driving task were representative of their real-world driving patterns.

Methods: Two hundred and eight participants (male: 68.80%; mean age?=?81.52 years, SD?=?3.37 years, range?=?76.00–96.00 years) completed a customized on-road driving task that commenced from their home and was conducted in their own vehicle. Participants’ real-world driving patterns for the preceding 4-month period were also collected via an in-car recording device (ICRD) that was installed in each participant’s vehicle.

Results: During the 4-month period prior to completing the on-road driving task, participants’ median real-world driving trip distance was 2.66?km (interquartile range [IQR]?=?1.14–5.79?km) and their median on-road driving task trip distance was 4.41?km (IQR?=?2.83–6.35?km). Most participants’ on-road driving task trip distances were classified as representative of their real-world driving trip distances (95.2%, n?=?198).

Conclusions: These findings suggest that most older drivers were able to devise a driving route that was representative of their real-world driving trip distance. Future research will examine whether additional aspects of the on-road driving task (e.g., average speed, proportion of trips in different speed zones) are representative of participants’ real-world driving patterns.     

Traditional agriculture in transition: examining the impacts of agricultural modernization on smallholder farming in Ghana under the new Green Revolution

Following the renewed effort at achieving a new green revolution for Africa, emphasis has been placed on modernizing smallholder agriculture through the deployment of improved inputs especially mechanized technologies. In Ghana, the government has in the last decade emphasized the provision of subsidized mechanized ploughing services to farmers alongside a rapidly growing private sector tractor service market. While mechanized technology adoption rates have increased rapidly, the deployment of these technologies has been without critical analysis of the impacts on production patterns and local agrarian systems. This paper examines the distributional impacts of agriculture mechanization on cropping patterns and farm sizes of smallholder farmers in northern Ghana using Geographic Information Systems (GIS) techniques, and semi-structured interviews with smallholder farmers (n=60). Specifically, comparative analysis of the field sizes and cropping patterns of participant farmers prior to and after the adoption of mechanized technologies was conducted. In-depth interviews were used to contextualize the experiences of smallholder farmers toward understanding how mechanization may be impacting traditional agriculture. Our findings reveal a mechanization paradox in which farm sizes are expanding, while cropping patterns are shifting away from traditional staple crops (pearl millet and sorghum bicolor) to market-oriented crops (maize, rice and groundnuts). This transition we argue, has adverse implications on the cultural dimension of food security, the organization of social life, and climate change adaptation. We recommend a retooling of the current agricultural policy focus to ensure context sensitivity for a more robust battle against food insecurity.