Assessment of odour problem in sewage-treated effluent in a closed loop irrigation system

Uses of wastewater drives significant economic activity, supports countless livelihoods particularly those for developing countries. While using wastewater, the challenge is to identify practical, affordable safeguards that do not threaten the health of users. In Yanbu Al-Sinaiyah, treated sewage effluent (TSE) is used for landscape purposes. In the present study, the odour problem caused by TSE in community area has been addressed. Samples were collected and analysed for total coliform, odour, trihalomethanes (THMs), total organic carbon (TOC) and other physicochemical parameters. Results show that in distribution network, residual chlorine was below the detection limit, turbidity, THMs, TOC and total coliform concentration was much higher than point source, and concentration of these parameters was further increased in problematic areas. It was also observed that areas with odourous problem were at the tail of irrigation network. This indicates that odour problem was due to less residual chlorine high turbidity, high rate of coliform and TOC. In odourous water samples, carbon disulphide and dimethyl sulphide were also identified by GC/MS, while in other areas where there was no odour, both these compounds were not detected. Odour problem was successfully resolved by improving sand filtration system to minimise turbidity the main cause of odour, increasing the residual chlorine at the treatment plant and regularly flushing the distribution network.     

The trade-off between economic growth and environmental quality: does economic freedom asymmetric matter for Pakistan?

Environmental Science and Pollution Research - This empirical study investigates the dynamic effects of economic freedom on economic growth and air quality for Pakistan over the period...     

Comparison of in-house-developed ELISA with HPLC techniques for the analysis of atrazine residues

In-house developed ELISA was standardized to monitor atrazine residues in different environmental samples. The standard curve was linear, indicating an increase in log concentration with decrease in absorbance (%B/B(0)=1.075-0.042 Log C; r= -0.966). The middle of the test was at 75 ng/L and the lowest detection limit at 4 ng/L. ELISA significantly correlated with the high performance liquid chromatography (HPLC) (r=0.990). Internal validation showed good accuracy and precision. Maximum atrazine residues were present in Jehlum River water/sediments and maize/sugarcane plant roots. Most of the food samples were found to be contaminated. ELISA required less clean-up steps than HPLC, but showed matrix effect in soil/colored extracts.     

Leaching of styrene and other aromatic compounds in drinking water from PS bottles

Bottled water may not be safer, or healthier, than tap water. The present studies have proved that styrene and some other aromatic compounds leach continuously from polystyrene （PS） bottles used locally for packaging. Water sapmles in contact with PS were extracted by a preconcentration technique called as ＂purge and trap＂ and analysed by gas chromatograph-mass spectrometer （GC/MS）. Eleven aromatic compounds were identified in these studies. Maximum concentration of styrene in PS bottles was 29.5 μg/L. Apart from styrene, ethyl benzene, toluene and benzene were also quantified but their concentrations were much less than WHO guide line values. All other compounds were in traces. Quality of plastic and storage time were the major factor in leaching of styrene. Concentration of styrene was increased to 69.53 μg/L after one-year storage. In Styrofoam and PS cups studies, hot water was found to be contaminated with styrene and other aromatic compounds. It was observed that temperature played a major role in the leaching of styrene monomer from Styrofoam cups. Paper cups were found to be safe for hot drinks.     

Importance of nutrient availability for soluble microbial products formation during a famine period of activated sludge: Evidence from multiple analyses

Much remains unknown about compositional variations in soluble microbial products (SMP) with the shift of the substrate condition from a feast to a famine phase in biological treatment systems. This study demonstrated that the formation of SMP could be suppressed by up to 75% during the famine phase with the addition of essential nutrients. In contrast, presence of electron acceptor did not play any significant role during the stress condition, showing the similar amounts of SMP (r?=?0.98, p?<?0.05) formation between the bioreactors supplied with air and N₂. The SMP formed in the famine phase was more bio-refractory in the famine versus the feast phase with a linear correlation shown between the production and their aromatic structures in the composition (R²?>?0.95). The fluorescence excitation–emission matrix coupled with parallel factor analysis (EEM-PARAFAC) revealed the presence of four different fluorescent components, including two protein-like (C1 and C4), fulvic-like (C2), and humic-like (C3) components, in the SMP and bEPS formed at different conditions. Both C1 and C4 showed increasing trends (R²?>?0.95) with the length of starvation in the bioreactors without essential nutrients. Nutrient availability was found to be a key factor to quench the production of large-sized biopolymers. This study provides a wealth of information on operation conditions of activated sludge treatment systems to minimize large sized SMP molecules (particularly proteins), which typically exert many environmental concerns to effluent organic matter quality.     

Determination of aflatoxin-B1 in poultry feed and its components employing enzyme-linked immunosorbent assay (ELISA)

A highly sensitive enzyme immunoassay was standardized for aflatoxin B₁ determination in poultry feed and its components using Riedel-de-Haen, ELISA Systems_. A microtitration plate method was optimized using anti-aflatoxin B₁ antibodies and peroxidase – aflatoxin B₁ conjugate, based on competitive enzyme immunoassay principle. Standards of concentrations of 5, 10, 20, 50, 100, 500?ng/L aflatoxin B₁, prepared in phosphate-buffered saline, were used. Standard curves showed that as the concentration of antigen decreased, absorbance values increased. Fifty percent inhibition was observed at 37?ng/L. Regression analysis showed that log concentration was inversely related to %B/B₀, with a highly significant negative correlation (?0.980). The lowest detection limit for aflatoxin B₁ was 5?ng/L. Using this standardized ELISA, aflatoxin B₁ was detected in most of the commercially available poultry feed samples and their components.

The data suggest that this test is suitable for the accurate determination of aflatoxin B₁ concentrations in poultry feed and its components.     

Successful outcome following prenatal intervention in a female fetus with bladder outlet obstruction

Bladder outlet obstructions are a diverse and heterogeneous group of developmental abnormalities that generally involve obstruction of the proximal urethra in the male fetus. Indications for prenatal intervention are few and are usually restricted to the male fetus because bladder outlet obstruction in female fetuses is usually caused by complex cloacal development anomalies. We report on a female fetus with an enlarged bladder and a dilated proximal urethra (known as typical keyhole sign). A vesicoamniotic shunt was performed despite non-reassuring prognostic factors, but the procedure resulted in a successful outcome. We propose that in selected cases of bladder outlet obstruction, fetal intervention should be considered even when the fetus is female. Copyright © 2005 John Wiley & Sons, Ltd.     

Development of ELISA technique for the analysis of atrazine residues in water

A highly sensitive enzyme immunoassay is described for the detection of atrazine residues in water. Atrazine derivative was conjugated to Bovine Serum Albumin (BSA) to obtain an immunizing antigen and to Horseradish Peroxidase enzyme (POD) to obtain a marker for immunoassay. The formation of these conjugations was confirmed by UV spectroscopy as well as by gel-electrophoresis. Polyclonal antibodies were raised in rabbits by immunization with an atrazine-BSA conjugate containing 29 atrazine residues per BSA molecule. An ELISA on microtitration plates was optimized with peroxidase-atrazine conjugate. The middle of the test (50% B/Bo) was found to be at 90 ng/l, which is well below the maximum concentration permitted by the EC guidelines for drinking water. Detection limits for atrazine of about 1 ng/l could be reached. The assay did not require concentration or cleanup steps for drinking or ground water samples. Validation experiments showed good accuracy and precision. No cross-reactivities were shown by other s-triazines like terbutryn, ametryn, terbuthylazine, des-isopropylatrazine, and de-ethylatrazine except hydroxyatrazine. The latter was present at very low levels that can be calibrated/standardized before analysis or it may be considered as leftover residues of atrazine. Based on these results, it is suggested that this test can be applied to obtain fairly accurate results for atrazine concentration in water samples from different sources.