Improved desalination by polyamide membranes containing hydrophilic glutamine and glycine

Environmental Chemistry Letters - Water desalination and recycling of wastewater is a key challenge to meet water shortage issues. Thin film composite polyamide membranes are widely used for...     

Fungicidal values of bio-oils and their lignin-rich fractions obtained from wood/bark fast pyrolysis

Pine wood, pine bark, oak wood and oak bark were pyrolyzed in an auger reactor. A total of 16 bio-oils or pyrolytic oils were generated at different temperatures and residence times. Two additional pine bio-oils were produced at the National Renewable Energy Laboratory in a fluidized-bed reactor at different temperatures. All these bio-oils were fractionated to obtain lignin-rich fractions which consist mainly of phenols and neutrals. The pyrolytic lignin-rich fractions were obtained by liquid-liquid extraction. Whole bio-oils and their lignin-rich fractions were studied as potential environmentally benign wood preservatives to replace metal-based CCA and copper systems that have raised environmental concerns. Each bio-oil and several lignin-rich fractions were tested for antifungal properties. Soil block tests were conducted using one brown-rot fungus (Gloeophyllum trabeum) and one white-rot fungus (Trametes versicolor). The lignin-rich fractions showed greater fungal inhibition than whole bio-oils for a impregnation solution 10% concentration level. Water repellence tests were also performed to study wood wafer swelling behavior before and after bio-oil and lignin-rich fraction treatments. In this case, bio-oil fractions did not exhibit higher water repellency than whole bio-oils. Comparison of raw bio-oils in soil block tests, with unleached wafers, at 10% and 25% bio-oil impregnation solution concentration levels showed excellent wood preservation properties at the 25% level. The good performance of raw bio-oils at higher loading levels suggests that fractionation to generate lignin-rich fractions is unnecessary. At this more effective 25% loading level in general, the raw bio-oils performed similarly. Prevention of leaching is critically important for both raw bio-oils and their fractions to provide decay resistance. Initial tests of a polymerization chemical to prevent leaching showed some success.     

An Analysis of the Annual and Seasonal Trends of Air Quality Index of Delhi

The Air Quality Index (AQI) is an index for reporting daily air quality. A study on the annual and seasonal variations of Air Quality Index over a period of 9 years (1996-2004) based on daily averaged concentration data of criteria air pollutants has been conducted for Delhi. An attempt has been made to quantify the changes in the AQI on annual and seasonal (winter, summer, monsoon and post monsoon) basis for 9 years. Measurements for the seven monitoring sites (Nizamuddin, Ashok Vihar, Shahzada Baug, Shahadara, Janakpuri, Sirifort and ITO) in Delhi were analysed and trends were also compared amongst these sites. Maximum Operator Function method was used to compute the Air Quality Index of the above areas and percentage variations in different severity class is discussed which provides in depth analysis of the trends. The best air quality was depicted by Shahzada Baug followed by Shahdara, both of these were classified as industrial areas indicating that policy measures relating to the industries in the city during past years have helped in improving the air quality. The air quality in other areas have improved slightly in the span of nine years but still remains critical indicating continued rigorous efforts in this direction. Increased traffic density seems to have resulted into the worst air quality at ITO in the city amongst all the monitoring stations. There is a shift for the worst AQI in the city from winter to summer season in a time span of these nine years. Change of season for worst AQI from Winter to Summer may also be likely due to increased photochemical reactions playing major role with change in the nature of emissions imposed due to different control measures such as CNG implementation, significant shift to LPG in domestic sector etc. calling for a detailed study, those which started after the year 2000. After the year 2000, there is a significant increase in the Nitrogen-dioxide (NO(2)) concentration at all stations. ITO which has shown continuous exponential increase in pollution levels has first time showed a declining AQI trend in the year 2004 and one of the contributing factors could have been the Delhi metro (initiated in 2002) passing through congested neighbouring areas causing traffic decongestion here. In general, the areas which are farthest from metro route viz., Siri-fort, Nizamuddin, Janakpuri etc. did not record declining AQI in 2003 onwards as happened with stations closer to Metro route such as Ashok Vihar and ITO. An attempt has been made to quantify the reasons that lead to the changes in the values of the AQI.     

Barriers Beyond the Partners: Bureaucratic and Political Constraints to Implementing Joint Forest Management in Tamil Nadu,India

Whereas past research has treated co-management of common pool resources as if villagers and project implementing authorities were the only relevant actors, numerous external factors beyond the control of these two partners create barriers to successful co-management. This paper draws on discussions with Forest Department officials to examine the influence of these forces on the outcomes of Joint Forest Management (JFM) in Tamil Nadu, India. An empirical inquiry into the operational aspects of JFM indicates the important roles of political parties, powerful people, and other state institutions and functionaries as well as the flow of foreign funding. Further, the strong demand by local people for socio-economic development interventions as opposed to improvement of degraded forests belittles the role of the Forest Department relative to other departments. Numerous other conditioning factors and relationships are explored. The authors call for reforms in public governance to allow better participation of all the actors involved for this participatory management approach to succeed and sustain.     

锐钛矿型二氧化钛的低温合成及其吸附除氟性能的研究

通过水解法在50℃低温条件下合成了锐钛矿型TiO₂,使用XRD、FT-IR、BET等方法对TiO₂进行了表征,并研究其对水中氟离子的吸附行为。结果表明:所合成锐钛矿型TiO₂比表面积达到278.93 m2/g,常温下对氟离子的最大吸附量为30.02 mg/g。吸附过程符合Langmuir等温线模型和准一级动力学模型,是自发性的吸热过程,吸附机理为静电吸引。     

Advanced molecular-fingerprinting analysis of dissolved organic sulfur by electrospray ionization-Fourier transform ion cyclotron resonance mass spectrometry using optimal spray solvent

Molecular level characterization of dissolved organic sulfur (DOS) by electrospray ionization-Fourier transform ion cyclotron resonance mass spectrometry (ESI-FTICR MS) is necessary for further understanding of the role of DOS in the environment. Here, ESI spray solvent, a key parameter for ion production during ESI process, was investigated for its effect on the molecular characterization of DOS by ESI-FTICR MS. 100% MeOH as spray solvent was found for the first time to remarkably enhance the ionization efficiency of the majority of CHOS-molecules in NOM, which facilitated a total of 1473 CHOS-molecular formulas with one sulfur atom to be detected. The number of CHOS-molecular formulas obtained using 100%MeOH as spray solvent increased notably over 740 in comparison with those using 50% MeOH aqueous solution (731) or 50% ACN aqueous solution (653). Moreover, due to the enhancement of ionization efficiency of DOS during ESI processes, the tandem mass spectra of the NOM CHOS-molecules could be easily obtained using 100% MeOH as spray solvent, which were hardly obtained using 50% MeOH aqueous solution as spray solvent. The results of the tandem mass spectra suggested the first discovery of organosulfates or sulfonic acids in Suwannee River NOM sample. A simple method based on 100% MeOH as ESI spray solvent for advanced molecular characterization of DOS by ESI-FTICR MS was proposed and applied, and the results revealed more molecular information of DOS in sea DOM samples.     

Heavy metals in the SPM of air in the environment surrounding a ferro-alloy industrial plant in India

Prices for ferro-alloys have hardened due to the closure of plants in developed countries on account of increasingly stringent pollution control legislation, resulting in a higher cost of production. A ferro-alloy industry with a capacity of 80000 MT per annum was selected to study the nature of pollution. Because of the objectionable nature of polluting air in and around the plant it was located in a rural area where there was no other industry. The area was agriculturally active and there was no effective control system for this plant.The quality of ambient air around the plant site is discussed in this paper along with the meteorological conditions. The maximum concentration of suspended particulate matter (SPM) was 768 µg/NM³ downwind of the plant, minimum 184 µg/NM³, and the average was more than 446 µg/NM³. The presence of heavy metals, viz. Fe, Mn, Cr and Pb, was also assessed. The concentration of Fe was 50 µg/NM³ downwind and 10 µg/NM³ upwind. The concentration of other metals followed a similar trend.     

Flue gas treatability studies: a tool for techno-economic control of industrial air pollution

Air pollution problems in developing countries have gained larger fraction in the last decade especially due to non functioning and non implementation of effective air pollutioncontrol devices in industries. In industrial wastewater management, adequate treatability studies are conducted to arrive at a techno-economic treatment option. However no suchstudies were done for reducing air pollution or emission fromindustries until now in India. Little information was availableabout such studies in other countries. This article provides information about a novel technique known asflue gas treatability studies and to undertake such studies, a pilot scale system is installed in Air Pollution Control Divisionof M/s National Environmental Engineering research Institute, NEERI, Nagpur-20, India. This study is a tool for techno-economicselection of air pollution control systems specially for small/medium scale industrial emissions.     

建筑物地基安全性监测

建筑物地基安全性监测是及时掌握建筑在施工和最初使用阶段地基是否出现异常变形的重要方法。本文根据大量工程监测实践，分析了建筑物地基安全性异常的表现形式及产生原因，总结了建筑物安全性监测应注意的几个问题。