Effect of manufacturing methods of AgCl/Al2O3 catalyst on selective catalytic reduction of NOx

The AgCl/Al2O3 catalyst has potential for use in the selective catalytic reduction (SCR) of NOx. A compound hydrocarbon, following oxygenation is used as a type of reducing agent. In this experiment, the AgCl/Al2O3 catalyst was produced by four different methods, and the differences among their reduction catalysis of NOx were compared. Ethanol was used as a type of reducing agent. X-ray diffraction analysis was performed to study the crystalline structure and scanning electron microscope and transmission electron microscope (TEM) were applied to determine the microindentation. The results indicated that, in the range of 350–400°C, there was no significant difference on the NOx reduction rate; however, there was dispersion at high and low temperature ranges. The size of the AgCl particles was about 20–100 nm.     

Water purification with sintered porous materials fabricated at 400℃ from sea bottom sediments

A sintering technology for preparing porous materials from sea bottom sediments was developed for use in water purification. The purpose of the present study was to develop methods for converting the sea bottom sediments dredged from Ago Bay into value-added recycled products. The sintered products fabricated at 400℃ were found to be very effective adsorbents for the removal of heavy metals.     

Impact assessment of human diet changes with rapid urbanization on regional nitrogen and phosphorus flows—a case study of the megacity Shanghai

Regional material flows are strongly influenced by human diets. To diagnose and prevent environmental problems that threaten urban sustainability, the impact of human diet changes with rapid urbanization on the regional nitrogen (N) and phosphorus (P) flows were quantitatively evaluated. A survey of day-to-day activities was conducted of 450 individuals surveyed (adults over 18 years old) in three representative areas (the central district, the new district, and the suburban/rural areas) of Shanghai, a megacity which has attracted worldwide attention. The lifestyle (eating habits, domestic sanitation, drainage facilities, etc.) pattern was determined and the potential N and P loads from human diets on the environment were calculated. The daily potential nitrogen and phosphorus loads from human diets was 19.36 g-N, 1.80 g-P in the central district, 16.48 g-N, 1.52 g-P in the new district, and 13.04 g-N, 1.20 g-P in the suburban/rural areas of Shanghai. Respondents in all three areas, especially those in the suburban/rural areas reported a preference for increasing the intake of animal-derived as well as processed foods, which means that the potential N and P load from human diets to the environment will increase further. In addition, most respondents consider industrial wastewater discharge as the main cause of eutrophication of waterbodies, though in recent years water pollution caused by domestic wastewater has increased rapidly, but this has received much less attention. Environment-friendly eating habits and improvements in the environmental awareness will be required.     

Spatial simulation and LCA evaluation on the plastic waste recycling system in Tianjin

With the rapid economic development in China, the amount of plastic waste (PW) generated has greatly increased and much of the waste is currently not treated. To reduce greenhouse gas (GHG) emissions from recycling of PW, we estimated the PW flow and considered methods to improve the household PW recycling system in Tianjin by adjusting processes during transportation and establishing a PW recycling factory in Zi’ya Industrial Park. The goal of the study was to identify reasonable improvements for the recycling system and clarify the environmental load. Geographic information system (GIS) technology was used to simulate transport processes for comparing GHG emissions from the transport processes between the present case and an improved case. Life cycle assessment (LCA) was used to compare GHG emissions between a projected scenario and a baseline scenario. Estimated GHG emissions during transport processes in the improved case were reduced by about 12,197 t CO₂ eq per year compared to the present case, equivalent to about 65.9 % of the total emissions in the present case. GHG emissions in the projected scenario were about 101,738 t CO₂ eq less per year than the baseline scenario, equivalent to about 75.5 % of the total emissions in the baseline scenario.     

Host preference of a symbiotic flatworm in relation to the ecology of littoral snails

Some polyclads associate with other marine invertebrates such as gastropods, but how these associations evolve is not well understood. This study examined the relationships between a polyclad, Stylochoplana pusilla, and six species of snails in 10 eulittoral sites in Mutsu Bay, northern Japan, in 2010 and 2011. Of the six potential host snail species, Monodonta labio was present at all sites and the prevalence of S. pusilla in the snails’ mantle cavities overall was 82.6 %. Four other snail species occurred at five or six sites in comparable densities, but of these, only Chlorostoma turbinatum and Omphalius rusticus had S. pusilla in their mantle cavities (prevalence of 42.0 and 15.4 %). A congener of M. labio, Monodonta neritoides, occurred at only one site and had no S. pusilla. The mantle, which provides habitat space for S. pusilla, was proportionally the longest in M. labio. In laboratory experiments, the flatworms preferentially entered M. labio over other snail species with the same mantle length. Observed vertical distributions of snails in the littoral zone indicate that M. labio is present in the eulittoral at both high and low tides, while C. turbinatum and O. rusticus are usually found in the sublittoral. In an evolutionary sense, the relationship between S. pusilla and its host may have developed as a mechanism for the flatworm to avoid predation by living in the eulittoral and to avoid desiccation by establishing commensal relationships with certain snails.     

Global evaluation of the effects of agriculture and water management adaptations on the water-stressed population

Fresh water is one of the most important resources required for human existence, and ensuring its stable supply is a critical issue for sustainable development. The effects of a general set of agriculture and water management adaptations on the size of the world’s water-stressed population were assessed for a specific but consistent scenario on socio-economic development and climate change during the 21st century. To maintain consistency with agricultural land use change, we developed a grid-based water supply–demand model integrated with an agro-land use model and evaluated the water-stressed population using a water withdrawals-to-availability ratio for river basins. Our evaluation shows that, if no adaptation options are implemented, the world’s water-stressed population will increase from 1.8 billion in 2000 to about 3.3 billion in 2050, and then remain fairly constant. The population and economic growth rather than climate change will be dominant factors of this increase. Significant increase in the water-stressed population will occur in regions such as North Africa and the Middle East, India, Other South Asia, China and Southeast Asia. The key adaptation options differ by region, depending on dominant crops, increase in crop demand and so on. For instance, ‘improvement of irrigation efficiency’ and ‘enhancement of reclamation water’ seem to be one of important options to reduce the water stress in Southeast Asia, and North Africa and the Middle East, respectively. The worldwide implementation of adaptation options could decrease the water-stressed population by about 5 % and 7–17 %, relative to the scenario without adaptations, in 2050 and 2100, respectively.     

Sources and distribution of hexabromocyclododecanes (HBCDs) in Japanese river sediment

The distribution of hexabromocyclododecane (HBCD) in the sediment of three Japanese rivers with different characteristics (i.e., population and potential source in the catchment) was investigated and compared with the results estimated using a multimedia fate model (ChemCAN). High concentrations of HBCD in sediments in the range of 134-2060 ng g(-1) were found in a river receiving textile wastewater. This contrasted with the much lower concentrations (0.8-4.8 ng g(-1)) observed for an urban river (with a surrounding population of 1.8 million). The medians of observed HBCD concentrations in each river were close to those estimated based on the assumed input source (e.g., 1810 ng g(-1) for the observed median concentration, and 1436 ng g(-1) for the estimation, in the Kuzuryu River). These results demonstrated the importance of considering source contributions of HBCD, including both industrial and consumer sources, to aquatic environments, for reliable risk management.     

Rapid hydropyrolysis of model compounds for epoxy resin oligomers and biomass tar

The rapid hydropyrolysis of model compounds for epoxy resin oligomers and biomass tar was carried out in a hydrogen atmosphere at 1073 K and 973 K. The assumed oligomers were partially pyrolyzed epoxy resin with biomass tar as solvent for the resin. The product distributions obtained from rapid hydropyrolysis of phenol and bisphenol-A are shown. We also discuss the effects of reaction temperature and hydrogen partial pressure on the product yield. In particular, more phenol was produced from bisphenol-A at 973 K than at 1073 K. The yield of methane, which was the final hydropyrolysis product, increased with increasing hydrogen partial pressure, whereas benzene and phenol were believed to behave as intermediate products in the hydropyrolysis reaction. The results suggest that phenol could be obtained with high selectivity from tar by optimizing the reaction conditions.     

Ozone Injection into an Activated Carbon Bed to Remove Hydrogen Sulfide in the Presence of Concurrent Substances

ABSTRACT

Adsorption using activated carbon is one of the most reliable techniques for preventing odor by substances such as H₂S. Concurrent substances in effluent gas often reduce the removal capacity of activated carbon for H₂S. As a means of restoring capacity under such conditions, ozone injection into an activated carbon column was examined. When activated carbon was saturated with substances such as toluene, ethanol, n-butanol, or iso-butanol, its capacity to remove H₂S decreased in proportion to the amount of the saturating substance. Under such conditions, ozone injection greatly increased capacity. Toluene, which is not easily decomposed by ozone, was displaced by ozone and by oxidized products of H₂S. Ethanol, which is adsorbed in small amounts by activated carbon and easily decomposed by ozone, was removed by ozone injection. Butanols, which are also decomposed by ozone and adsorbed in large quantities by activated carbon, showed intermediate behavior between that of toluene and ethanol.