Study of Meteorological Aspects and Urban Concentration of SO2 in Atmospheric Environment of La Plata, Argentina

This article presents and discusses SO₂ (ppbv) concentration measurements combined with meteorological data (mainly wind speed and direction) for a five-year campaign (1996 to 2000), in a site near an oil refinery plant close to the city of La Plata and surroundings (aprox. 740.000 inh.), considered one of the six most affected cities by air pollution in the country. Since there is no monitoring network in the area, the obtained results should be considered as medium term accumulated data that enables to determine trends by analyzing together gas concentrations and meteorological parameters. Preliminary characterization of the behaviour of the predominant winds of the region in relation with potential atmospheric gas pollutants from seasonal wind roses is possible to carry out from the data. These results are complemented with monthly averaged SO₂ measurements. In particular, for year 2000, pollutant roses were determined which enable predictions about contamination emission sources. As a general result we can state that there is a clear increase in annual SO₂ concentration and that the selected site should be considered as a key site for future survey monitoring network deployment. Annual SO₂ average concentration and prevailing seasonal winds determined in this work, together with the potential health impact of SO₂ reveals the need for a comprehensive and systematic study involving particulate matter an other basic pollutant gases.     

Analyzing SO 2 concentrations and wind directions during a short monitoring campaign at a site far from the industrial pole of La Plata, Argentina

This article presents and discusses SO2 air quality concentrations (ppbv) together with wind velocities and directions measurements carried out between September 1st and December 21st 2005 at a site located 8.5 km away from the Industrial Pole of La Plata area. As the city and its surroundings have no official monitoring network, the current work enlarges the air quality information available from the zone and sets some initial considerations to the future siting of monitoring stations. The statistical analysis of the data was performed using techniques of tests for outliers and trends, dissimilarity measures and robust regression. In relation to SO2 concentrations, low values were found during this short campaign considering daily averages (with a maximum of 8.5 ppbv) and hourly averages (with a maximum of 25.9 ppbv); World Health Organization guidelines were never surpassed. Nevertheless, a strong dependence between wind directions carrying air pollutants from the Industrial Pole and hourly concentration peaks were found. Due to low monthly SO2 concentrations and because a decreasing time trend was found, the authors propose, as an example, the implementation of an alternative discontinuous method to the continuous analyzer used in the current campaign. Our results state that sampling every 7 days at 13:00-13:59 hours (local time) would be enough to get representative values of the air quality. As a general remark it is possible to highlight that longer and systematic studies should be encouraged to confirm the seasonal wind pattern and to evaluate the air quality.     

Greenhouse gases emissions from a closed old landfill cultivated with biomass crops

Closed landfills need after-closure rehabilitation. The chosen option should ensure greenhouse gases release, from the landfill, is not promoted once settled. The objective of this study was to estimate and confront, during different seasons, CH₄, CO₂ and N₂O emissions under three vegetation covers in a closed landfill in Buenos Aires, Argentina. CH₄ (methane), CO₂ (carbon dioxide) and N₂O (nitrous oxide) emissions from landfill’s technosol under spontaneous vegetation (control), Pennisetum purpureum and Miscanthus giganteus (biomass crops), were quantified with non-steady-state non-flow-through chambers, in July 2014 and from February to July 2015. A linear regression analysis was performed to relate the variables “flux of a gas” and “concentration of that gas” from the 3 treatments and 6 dates, separating the 5 sampling times. A high correlation between concentrations and fluxes of CO₂ and N₂O was found, but no correlation was established for CH₄. Mean emissions (2014–2015) varied from: ?2.3 to 639.41 mgCH₄ m^?2 day^?1, 3884 to 46,365 mgCO₂ m^?2 day^?1 and 0.40 to 14.59 mgN₂O m^?2 day^?1. Vegetation covers had no significant effect on CH₄ and N₂O concentration in time, but they had on CO₂ concentration. Season of the year had a significant effect on concentration of the three gases. This is the first study on CH₄, CO₂ and N₂O emissions from a landfill closed 27 years ago covered with biomass crops.     

Study of meteorological aspects and urban concentration of SO2 in atmospheric environment of La Plata, Argentina

This article presents and discusses SO(2) (ppbv) concentration measurements combined with meteorological data (mainly wind speed and direction) for a five-year campaign (1996 to 2000), in a site near an oil refinery plant close to the city of La Plata and surroundings (aprox. 740.000 inh.), considered one of the six most affected cities by air pollution in the country. Since there is no monitoring network in the area, the obtained results should be considered as medium term accumulated data that enables to determine trends by analyzing together gas concentrations and meteorological parameters. Preliminary characterization of the behaviour of the predominant winds of the region in relation with potential atmospheric gas pollutants from seasonal wind roses is possible to carry out from the data. These results are complemented with monthly averaged SO(2) measurements. In particular, for year 2000, pollutant roses were determined which enable predictions about contamination emission sources. As a general result we can state that there is a clear increase in annual SO(2) concentration and that the selected site should be considered as a key site for future survey monitoring network deployment. Annual SO(2) average concentration and prevailing seasonal winds determined in this work, together with the potential health impact of SO(2) reveals the need for a comprehensive and systematic study involving particulate matter an other basic pollutant gases.     

A Processing,Characterization and Marine Biodegradation Study of Melt-Extruded Polyhydroxyalkanoate (PHA) Films

A series of polyhydroxyalkanoates (PHA), all containing 1% nucleating agent but varying in structure, were melt-processed into films through single screw extrusion techniques. This series consisted of three polyhydroxybutyrate (PHB) and three polyhydroxybutyrate-valerate (PHBV) resins with varying valerate content. Processing parameters of temperature in the barrel (165–173 °C) and chill rolls (60 °C) were optimized to obtain cast films. The gel-permeation chromatography (GPC) results showed a loss of 8–19% of the polymer’s initial molecular weight due to extrusion processing. Modulated differential scanning calorimetry (MDSC) displayed glass transition temperatures of the films ranging from −4.6 to 6.7 °C depending on the amount of crystallinity in the film. DSC data were also used to calculate the percent crystallinity of each sample and slightly higher crystallinity was observed in the PHBV series of samples. X-ray diffraction patterns did not vary significantly for any of the samples and crystallinity was confirmed with X-ray data. Dynamic mechanical analysis (DMA) verified the glass transition trends for the films from DSC while loss modulus (E′) reported at 20 °C showed that the PHBV (3,950–3,600 MPa) had the higher E′ values than the PHB (3,500–2,698 MPa) samples. The Young’s modulus values of the PHB and PHBV samples ranged from 700 to 900 MPa and 900 to 1,500 MPa, respectively. Polarized light microscopy images revealed gel particles in the films processed through single-screw extrusion, which may have caused diminished Young’s modulus and tensile strength of these films. The PHBV film samples exhibited the greatest barrier properties to oxygen and water vapor when compared to the PHB film samples. The average oxygen transmission rate (OTR) and water vapor transmission rate (WVTR) for the PHBV samples was 247 (cc-mil/m²-day) and 118 (g-mil/m²-day), respectively; while the average OTR and WVTR for the PHB samples was 350 (cc-mil/m²-day) and 178 (g-mil/m²-day), respectively. Biodegradation data of the films in the marine environment demonstrated that all PHA film samples achieved a minimum of 70% mineralization in 40 days when run in accordance with ASTM 6691. For static and dynamic incubation experiments in seawater, microbial action resulting in weight loss as a function of time showed all samples to be highly biodegradable and correlated with the ASTM 6691 biodegradation data.     

Calibration and uncertainty analysis of a simple model of silica-limited diatom growth in the Elbe River

A simple Lagrangian water quality model was designed to investigate the hypothesis of sporadic silica limitations of diatom growth in the lower Elbe River in Germany. For each fluid parcel a limited reservoir of silica was specified to be consumed by diatoms. The model's simplicity notwithstanding, a set of six selected model parameters could not be fully identified from existing observations at one station. After the introduction of prior knowledge of the ranges of meaningful parameter values, calibration of the over-parameterised model manifested itself primarily in the generation of posterior parameter covariances. Estimations of the covariance matrix based on (a) second order partial derivatives of a quadratic cost function at its optimum and (b) Monte Carlo simulations exploring the whole space of parameter values gave consistent results. Diagonalisation of the covariance matrix yielded two linear parameter combinations that were most effectively controlled by data from periods with and without lack of silica, respectively. The two parameter combinations were identified as the essential inputs that govern the successful simulation of intermittently decreasing chlorophyll a concentrations in summer. A satisfactory simulation of the pronounced chlorophyll a minimum in spring, by contrast, was found to be beyond the means of the simple model.     

Physical and Thermal Analysis of the Degradation of Poly(3-Hydroxybutyrate-<Emphasis Type="Italic">co</Emphasis>-4-Hydroxybutyrate) Coated Paper in a Constructed Soil Medium

The degradation of poly(3-hydroxybutyrate-co-4-hydroxybutyrate) (P(3HB-co-4HB)) coated brown Kraft paper and its components in a constructed soil environment was investigated. Soil burial tests were carried out over 8 weeks. Weight loss measurements, photographic analysis, environmental scanning electron microscopy (ESEM), dynamic mechanical analysis (DMA) and differential scanning calorimetry (DSC) were conducted to assess the physical, structural, mechanical and thermal behavior before and after the soil burial test. Paper showed the highest physical degradation and weight loss. With respect to the control samples, the stiffness of the partially degraded samples decreased. The overall crystallinity of the biopolymer and the coated paper was affected significantly by burial. The pure biopolymer’s weight loss was substantially enhanced when coated on paper. This result reveals a possible increased microbial population in the coated paper relative to the pure biopolymer.     

Wet Strength and Water Resistance of Modified Soy Protein Adhesives and Effects of Drying Treatment

Soy protein isolate (SPI) was modified using sodium dodecyl sulfate (SDS) and guanidine hydrochloride (GuHCl). Adhesion performance of the modified SPI on fiberboard was studied. The Water-soluble mass of the modified SPI adhesives was examined following modified ASTM D5570. The SDS-modified SPI containing 91% protein had a water-soluble mass of 1.7%. To be considered a water-resistant adhesive, the water-soluble mass of adhesive should be less than 2%. The wet shear strength test showed 100% cohesive failure within fiberboard, indicating that the modified SPI has good water resistance. The effect of drying treatment on adhesion performance of the SDS-modified SPI on fiberboard was then investigated. Drying treatment significantly affected the final adhesion performance. Shear strength did not change much, but the percentage of cohesive failure within fiberboard increased markedly as drying temperature increased. All the unsoaked, soaked, and wet specimens glued by the adhesives treated at 70° or 90°C had 100% cohesive failure within fiberboard. Viscosity also increased greatly with an increase in drying temperature. This information will be useful in developing low-cost adhesive processing system in the future.     

Reef coral reproduction in the Abrolhos Reef Complex, Brazil: the endemic genus Mussismilia

The current contribution deals with the reproductive biology of a genus endemic to Brazil –Mussismilia Ortmann, 1890 – including all three species of the genus: M. braziliensis (Verrill, 1868), M. hartti (Verrill, 1868), and M. hispida (Verrill, 1902), which occur sympatrically in the studied area, the Abrolhos Reef Complex, Brazil. Sexuality patterns, modes of reproduction, synchrony and spawning periods are reported, and were determined by histological examination of material. All three species started to develop female and male gametes over different periods in the same breeding season. The three species are probably broadcast spawners, since no embryos or planulae were observed in any species at any given time of the year. Each reproductive cycle lasted approximately 11 months. Oogenesis and spermatogenesis started in different periods, with spermaries appearing in approximately the eighth month of ovary development and lasting about 3 months. Reproductive cycles were annual. Spawning probably occurred in consecutive months in each species. In M. braziliensis, spawning presumably happened between March and the middle of May in 1996 and 1997. Evidence suggested that spawning events of M. hispida took place between the end of April and mid-June. M. hartti may have spawned between September and November. The data presented here suggested that all studied species have at least one exclusive spawning period, asynchronically with the others. A possible exception may be the simultaneous (or close) spawnings of M. braziliensis and M. hispida in May. It is suggested that asynchrony in spawning periods among species may reduce the chance of hybridization, gamete waste and the competition for settlement surfaces. The occurrence of extended spawning periods for each species may also reduce the risks of reproductive failure, due to temporary adverse conditions. Received: 8 December 1998 / Accepted: 15 July 1999     

Rapid assessment of insect pollination services to inform decision-making

Pollinator declines have prompted efforts to assess how land-use change affects insect pollinators and pollination services in agricultural landscapes. Yet many tools to measure insect pollination services require substantial landscape-scale data and technical expertise. In expert workshops, 3 straightforward methods (desk-based method, field survey, and empirical manipulation with exclusion experiments) for rapid insect pollination assessment at site scale were developed to provide an adaptable framework that is accessible to nonspecialist with limited resources. These methods were designed for TESSA (Toolkit for Ecosystem Service Site-Based Assessment) and allow comparative assessment of pollination services at a site of conservation interest and in its most plausible alternative state (e.g., converted to agricultural land). We applied the methods at a nature reserve in the United Kingdom to estimate the value of insect pollination services provided by the reserve. The economic value of pollination services provided by the reserve ranged from US$6163 to US$11,546/year. The conversion of the reserve to arable land would provide no insect pollination services and a net annual benefit from insect-pollinated crop production of approximately $1542/year (US$24∙ha^–1∙year^–1). The methods had wide applicability and were readily adapted to different insect-pollinated crops: rape (Brassica napus) and beans (Vicia faba) crops. All methods were rapidly employed under a low budget. The relatively less robust methods that required fewer resources yielded higher estimates of annual insect pollination benefit.