Monitoring of carbon monoxide in residences with bulk wood pellet storage in the Northeast United States

The interest in biomass fuel is continuing to expand globally and in the northeastern United States as wood pellets are becoming a primary source of fuel for residential and small commercial systems. Wood pellets for boilers are often stored in basement storage rooms or large bag-type containers. Due to the enclosed nature of these storage areas, the atmosphere may exhibit increased levels of carbon monoxide. Serious accidents in Europe have been reported over the last decade in which high concentrations of carbon monoxide (CO) have been found in or near bulk pellet storage containers. The aim of this study was to characterize the CO concentrations in areas with indoor storage of bulk wood pellets. Data was obtained over approximately 7 months (December 2013 to June 2014) at 25 sites in New Hampshire and Massachusetts: 16 homes using wood pellet boilers with indoor pellet storage containers greater than or equal to 3 ton capacity; 4 homes with wood pellet heating systems with outdoor pellet storage; 4 homes using other heating fuels; and a university laboratory site. CO monitors were set up in homes to collect concentrations of CO in the immediate vicinity of wood pellet storage containers, and data were then compared to those of homes using fossil fuel systems. The homes monitored in this study provided a diverse set of housing stock spanning two and a half centuries of construction, with homes built from 1774 to 2013, representing a range of air exchange rates. The CO concentration data from each home was averaged hourly and then compared to a threshold of 9 ppm. While concentrations of CO were generally low for the homes studied, the need to properly design storage locations for pellets is and will remain a necessary component of wood pellet heating systems to minimize the risk of CO exposure.

Implications: This paper is an assessment of carbon monoxide (CO) exposure from bulk wood pellet storage in homes in New Hampshire and Massachusetts. Understanding the CO concentrations in homes allows for better designs for storage bins and ventilation for storage areas. Hence, uniform policies for stored wood pellets in homes, schools, and businesses can be framed to ensure occupant safety. Currently in New York State rebates for the installation of wood pellet boilers are only provided if the bulk pellet storage is outside of the home, yet states such as New Hampshire, Vermont, and Maine currently do not have these restrictions.     

Polychlorinated biphenyls and links to cardiovascular disease

The pathology of cardiovascular disease is multi-faceted, with links to many modifiable and non-modifiable risk factors. Epidemiological evidence now implicates exposure to persistent organic pollutants, such as polychlorinated biphenyls (PCBs), with an increased risk of developing diabetes, hypertension, and obesity; all of which are clinically relevant to the onset and progression of cardiovascular disease. PCBs exert their cardiovascular toxicity either directly or indirectly via multiple mechanisms, which are highly dependent on the type and concentration of PCBs present. However, many PCBs may modulate cellular signaling pathways leading to common detrimental outcomes including induction of chronic oxidative stress, inflammation, and endocrine disruption. With the abundance of potential toxic pollutants increasing globally, it is critical to identify sensible means of decreasing associated disease risks. Emerging evidence now implicates a protective role of lifestyle modifications such as increased exercise and/or nutritional modulation via anti-inflammatory foods, which may help to decrease the vascular toxicity of PCBs. This review will outline the current state of knowledge linking coplanar and non-coplanar PCBs to cardiovascular disease and describe the possible molecular mechanism of this association.     

Magnetic properties of biogenic selenium nanomaterials

Environmental Science and Pollution Research - Bioreduction of selenium oxyanions to elemental selenium is ubiquitous; elucidating the properties of this biogenic elemental selenium (BioSe) is thus...     

Does Including Soil Moisture Observations Improve Operational Streamflow Forecasts in Snow‐Dominated Watersheds?

Changing climate and growing water demand are increasing the need for robust streamflow forecasts. Historically, operational streamflow forecasts made by the Natural Resources Conservation Service have relied on precipitation and snow water equivalent observations from Snow Telemetry (SNOTEL) sites. We investigate whether also including SNOTEL soil moisture observations improve April‐July streamflow volume forecast accuracy at 0, 1, 2, and 3‐month lead times at 12 watersheds in Utah and California. We found statistically significant improvement in 0 and 3‐month lead time accuracy in 8 of 12 watersheds and 10 of 12 watersheds for 1 and 2‐month lead times. Surprisingly, these improvements were insensitive to soil moisture metrics derived from soil physical properties. Forecasts were made with volumetric water content (VWC) averaged from October 1 to the forecast date. By including VWC at the 0‐month lead time the forecasts explained 7.3% more variability and increased the streamflow volume accuracy by 8.4% on average compared to standard forecasts that already explained an average 77% of the variability. At 1 to 3‐month lead times, the inclusion of soil moisture explained 12.3‐26.3% more variability than the standard forecast on average. Our findings indicate including soil moisture observations increased statistical streamflow forecast accuracy and thus, could potentially improve water supply reliability in regions affected by changing snowpacks.     

ATRAZINE IN SPRING RUNOFF AS RELATED TO ENVIRONMENTAL SETTING EBRASKA, 19921

ABSTRACT: A synoptic sampling of five surface-water sites in central Nebraska was conducted by the U.S. Geological Survey as part of its National Water-Quality Assessment Program during storm runoff in May 1992 to relate transport, yields, and concentrations of atrazine to environmental setting. Atrazine was the most extensively applied pesticide in the study unit. Atrazine transport was related to the size of contributing drainage area, quantity of atrazine applied, amount of precipitation, and volume of stream-flow. Estimated yields and mean concentrations of atrazine were related to the percentage of cropland in a drainage area. The largest estimated yields and mean concentrations of atrazine in surface water were associated from drainage areas with the highest percentage of cropland, and the smallest was associated with the smallest amount of cropland. Atrazine concentrations increased as streamflow increased but decreased at or near the time of peak streamflows, perhaps due to dilution. Atrazine concentrations then increased and remained elevated far into the stream recession. Atrazine is a regulated contaminant in finished public-water supplies. Large concentrations of atrazine could affect the management of public-water supplies because atrazine remains in solution in contrast to many other pesticides that are more easily removed.     

LANDSAT MID-INFRARED DATA AND GIS IN REGIONAL SURFACE SOIL-MOISTURE ASSESSMENT1

ABSTRACT: Landsat satellite Thematic Mapper (TM) data were used to assess regional soil moisture conditions. The mid-infrared (MIR) data of TM band 7 were overlain onto four principal land-use categories (Agricultural/Irrigated, Urban/Clearings, Forest/ Wetlands, Water) using a geographic information system (GIS). M data were used to assess four qualitative surface soil-moisture conditions (water/very wet, wet, moist, and dry) within each land-use category of a 208,354 ha southwestern Florida study area. The MIR response was inversely related to the qualitative surface soil-moisture content. Integration of Landsat TM MIR data with land use through GIS appears to be a useful technique for high-resolution regional soil moisture assessment, and further research to reline this technique is recommended.     

The effect of five forage species on transport and transformation of atrazine and isoxaflutole (balance) in lysimeter leachate

A field lysimeter study with bare ground and five different ground covers was established to evaluate the effect of forage grasses on the fate and transport of two herbicides in leachate. The herbicides were atrazine (ATR; 2-chloro-4-ethylamino-6-isopropylamino-1,3,5-triazine) and isoxaflutole [IXF; 5-cyclopropyl-4-(2-methylsulfonyl-4-trifluormethyl-benzoyl)isoxazole], which has the commercial name Balance (Aventis Crop Science, Strasbourg, France). The ground covers included orchardgrass (Dactylis glomerata L.), smooth bromegrass (Bromus inermis Leyss.), tall fescue (Festuca arundinacea Schreb.), timothy (Phleum pratense L.), and switchgrass (Panicum virgatum L.). The results suggested that the total IXF (parent + metabolites) showed higher mobility than ATR and its metabolites. Differences in the timing of transport reflected the rapid degradation of IXF to the more soluble, stable, and biologically active diketonitrile (DKN) metabolite in the system. Although grass treatments did not promote the hydrolysis of DKN, they significantly reduced its transport in the leachate through enhanced evapotranspiration. Grass treatments significantly enhanced ATR degradation in the leachates and soils, especially through N dealkylation, but they did not reduce total ATR transported in the leachate. Leachate from the orchardgrass lysimeters contained the highest proportion of ATR metabolites (64.2%). Timothy and smooth bromegrass treatments also displayed a significant increase in ATR metabolites in leachate. Grass-treated lysimeters showed higher microbial biomass carbon than bare ground. For ATR treatments, the proportion of metabolites in the leachate strongly correlated with the elevated soil microbial biomass carbon in forage treatments. In contrast, DKN degradation was poorly correlated with soil microbial biomass carbon, suggesting that DKN degradation is an abiotic process.     

Empirical models based on the universal soil loss equation fail to predict sediment discharges from Chesapeake Bay catchments

The Universal Soil Loss Equation (USLE) and its derivatives are widely used for identifying watersheds with a high potential for degrading stream water quality. We compared sediment yields estimated from regional application of the USLE, the automated revised RUSLE2, and five sediment delivery ratio algorithms to measured annual average sediment delivery in 78 catchments of the Chesapeake Bay watershed. We did the same comparisons for another 23 catchments monitored by the USGS. Predictions exceeded observed sediment yields by more than 100% and were highly correlated with USLE erosion predictions (Pearson r range, 0.73-0.92; p < 0.001). RUSLE2-erosion estimates were highly correlated with USLE estimates (r = 0.87; p < 001), so the method of implementing the USLE model did not change the results. In ranked comparisons between observed and predicted sediment yields, the models failed to identify catchments with higher yields (r range, -0.28-0.00; p > 0.14). In a multiple regression analysis, soil erodibility, log (stream flow), basin shape (topographic relief ratio), the square-root transformed proportion of forest, and occurrence in the Appalachian Plateau province explained 55% of the observed variance in measured suspended sediment loads, but the model performed poorly (r(2) = 0.06) at predicting loads in the 23 USGS watersheds not used in fitting the model. The use of USLE or multiple regression models to predict sediment yields is not advisable despite their present widespread application. Integrated watershed models based on the USLE may also be unsuitable for making management decisions.     

Gearing-up governance for sustainable development: Patterns of policy appraisal in UK central government

The UK is reportedly an international leader in the application of environmental policy appraisal (EPA). From the late 1980s until 2004, UK central government sought to produce ex ante assessments of the potential environmental impacts of different policy options. Critics maintain that EPA had a very limited impact on policy-making activities in Whitehall departments. However, the empirical basis for these claims is surprisingly thin. This paper seeks to better understand what facilitated or retarded EPA by looking at its use in Whitehall, with the aim being to draw lessons for the UK's new and more integrated appraisal regime, as well as similar systems in the European Union. The paper finds that the implementation of EPA was both weak and highly sectorised, and that there is an underlying resistance to policy appraisal per se in Whitehall. These weaknesses urgently need to be addressed otherwise new systems of integrated appraisal will not deliver what is expected of them.