Effectiveness of autoencoder for lake area extraction from high-resolution RGB imagery: an experimental study

Environmental Science and Pollution Research - The surface areas of lakes alter constantly due to many factors such as climate change, land use policies, and human interventions, and their surface...     

A numerical study on the effects of EGR and spark timing to combustion characteristics and NOx emission of a GDI engine

EGR is one of the most significant strategies for reducing especially nitrogen oxides (NO_x) emissions from internal combustion engines. The thermal efficiency of spark ignition engines is lower than compression ignition engines because of its lower compression ratio. If the compression ratio is increased to obtain higher thermal efficiency, there may be a knocking tendency in spark ignition engines. EGR can be used in order to reduce NO_x emissions and avoid knocking phenomena at higher compression ratios. In-cylinder temperature at the end of combustion is decreased and heat capacity of fresh charge is increased when EGR applied. Besides EGR, spark timing is another significant parameter for reducing exhaust emissions such as nitrogen oxides, and unburned hydrocarbon (UHC). In this study the effects of EGR and spark timing on spark ignition engine were investigated numerically. KIVA codes were used in order to model combustion process. The combustion process has been modeled for a single cylinder, four stroke and gasoline direct injection (GDI) spark ignition engine. The results showed that in-cylinder pressure and heat release rate decrease as EGR ratio increase. In-cylinder pressure increases with the advancing of spark timing. Advancing spark timing increases the heat release rate and in-cylinder temperature. The simulation results also showed that EGR reduced exhaust gas temperature and NO_x emissions.     

A review of post-modern management techniques as currently applied to Turkish forestry

This paper reviews the effects of six post-modern management concepts as applied to Turkish forestry. Up to now, Turkish forestry has been constrained, both in terms of its operations and internal organization, by a highly bureaucratic system. The application of new thinking in forestry management, however, has recently resulted in new organizational and production concepts that promise to address problems specific to this Turkish industry and bring about positive changes. This paper will elucidate these specific issues and demonstrate how post-modern management thinking is influencing the administration and operational capacity of Turkish forestry within its current structure.     

Potentiometric studies of mixed complexes of cobalt(II) and copper(II) with l‐Asparagine and adenine

A potentiometric titration technique has been used to determine the stability constants for the various complexes of Co(II) and Cu(II) with L‐asparagine and from DNA base, e.g. adenine. Stability constants of ternary systems have been evaluated by the method suggested by Irwing‐Rossotti. In addition, the conditional constants were calculated as a function of pH. The maximum values of the conditional formation constants were found to be in accordance with the mixed‐ligand complex formation constants in a determined pH region. Furthermore, the molar fractions of different species from mixed complexes were calculated by means of formation constants. The values of stability constants of mixed‐ligand complexes at 25°C are as follows: log K= 5.25 for Co(II)‐L‐asparagine‐adenine; log K= 9.30 for Cu(II)‐L‐asparagine‐adenine. The ionic strength was kept constant at I = 0.20 with NaClO₄.     

Interrelationships among foreign direct investments,renewable energy,and CO2 emissions for different European country groups: a panel ARDL approach

Environmental Science and Pollution Research - This study estimated unbalanced panel data analysis to investigate the relationship among CO2 emissions, GDP, renewable and non-renewable energy...     

The impact of pretreatment and inoculum to substrate ratio on methane potential of organic wastes from various origins

Biochemical methane potentials (BMP) of two different substrates from macroalgae (MA) and market place wastes (MPW) were investigated using anaerobic granulated sludge from food industry with different ratios of substrate to inoculum (S/X). The substrates were used as MA only, MPW only, MA–MPW mixture, pretreated MA, and pretreated MA–MPW mixture. Research involved investigation of the effects of parameters such as temperature (35, 45, and 55 °C), substrate to inoculum ratio (S/X = 0.5, 2.0, 4.0, and 6.0 as g VS_substrate/g VS_inoculum), and the type of pretreatment (by microwave, thermal, and ultrasonic) on BMP. BMP assays were performed for all substrates. The highest cumulative biogas production (and BMP) were obtained for MA only at an S/X ratio of 4.0 g VS/g VS as 357 L_biogas/kg VS (197 L CH₄/kg VS) and 33 L_biogas/kg VS (17 L CH₄/kg VS), respectively, at 35 and 55 °C. For pretreated substrates, the highest cumulative biogas production and BMP were observed as 287 L_biogas/kg VS and 146 L CH₄/kg VS using pretreated macroalgae at 35 °C. Results suggested that MA only and MA–MPW mixtures are suitable substrates for biogas production. It is also concluded that any type of pretreatment has adverse effects on biogas and methane productions.     

Allocation of supplementary aeration stations in the Chicago waterway system for dissolved oxygen improvement

The Chicago Waterway System (CWS), used mainly for commercial and recreational navigation and for urban drainage, is a 122.8 km branching network of navigable waterways controlled by hydraulic structures. The CWS receives pollutant loads from 3 of the largest wastewater treatment plants in the world, nearly 240 gravity Combined Sewer Overflows (CSO), 3 CSO pumping stations, direct diversions from Lake Michigan, and eleven tributary streams or drainage areas. Even though treatment plant effluent concentrations meet the applicable standards and most reaches of the CWS meet the applicable water quality standards, Dissolved Oxygen (DO) standards are not met in the CWS during some periods. A Use Attainability Analysis was initiated to evaluate what water quality standards can be achieved in the CWS. The UAA team identified several DO improvement alternatives including new supplementary aeration stations. Because of the dynamic nature of the CWS, the DUFLOW model that is capable of simulating hydraulics and water quality processes under unsteady-flow conditions was used to evaluate the effectiveness of new supplementary aeration stations. This paper details the use of the DUFLOW model to size and locate supplementary aeration stations. In order to determine the size and location of supplemental aeration stations, 90% compliance with a 5 mg/l DO standard was used as a planning target. The simulations showed that a total of four new supplementary aeration stations with oxygen supply capacities ranging from 30 to 80 g/s would be sufficient to meet the proposed target DO concentration for the North Branch and South Branch of the Chicago River. There are several aeration technologies, two of which are already being used in the CWS, available and the UAA team determined that the total capital costs of the alternatives range from $35.5 to $89.9 million with annual operations and maintenance costs ranging from $554,000 to $2.14 million. Supplemental aeration stations have been shown to be a potentially effective means to improve DO concentrations in the CWS and will be included in developing an integrated strategy for improving water quality in the CWS.     

Performance Enhancement of a Beta Type Rhombic Drive Stirling engine

ABSTRACT

Stirling engines maintain attraction because of their high energy conversion efficiencies. In this study, experimental comparison of a beta-type Stirling engine for two different rhombic-drive mechanisms was presented. In one of the rhombic mechanisms, spur gears were used and the gear shaft was supported in bearings from one side. In the other mechanism, two helical gears were placed on crankshafts and the crankshafts were supported in bearings from both sides. Rhombus lengths of the mechanisms were determined as 66 mm and 80 mm to provide same constant compression ratio of 2.5 for both configurations. Both mechanisms were used in the same beta-type Stirling engine having same cylinder, piston and displacer dimensions. Performance parameters of the engines were evaluated at different helium charge pressures (2–4 bar) and hot-end temperatures (400–600°C). The hot-end of the displacer cylinder was heated by a liquefied petroleum gas (LPG) burner. The engine power increased by 132%, friction losses and gear noses were reduced by supporting the rhombic-drive mechanism from both side and using helical gears. The maximum output torque and power of the engine were obtained as 13.14 Nm at 428 rpm engine speed and 663 W at 800 rpm engine speed, respectively, at 600°C hot-end temperature and 4 bar charge pressure.     

Assessing water quality in the Ceyhan River basin (Turkey) with the use of aquatic macrophytes

As a major biotic component of many lotic ecosystems, macrophytes consist a major component of running waters are often used as indicators within the European Water Framework Directive (WFD) to establish ecological quality. In this study, we investigated macrophyte community structure (e.g. composition, abundance and diversity) in Ceyhan River Basin located in the Southeastern Anatolian Region in Turkey. Data was collected during 2014–2015 from river sites located throughout the basin to evaluate the relationship between aquatic vegetation and river physico-chemical factors. The ecological status of the river basin was also calculated based on Macrophyte Biological Index for River (IBMR). In total, 33 macrophyta taxa were observed. According to their biological classification (life form), filamentous algae (FA), free floating (FF), floating leaved (FL) and submersed (S) macrophytes reached their maximum abundance value in summer, while emergent (E) macrophytes were at their maximum abundance in both summer and autumn. The ecological status of the Ceyhan River basin ranged from moderate to bad. The values found are reasonably comparable to IBMR scores recorded in rivers of other Mediterranean countries. IBMR index may be suitable to some extent to establish a basis for ecological quality assessment in Turkish River systems.     

Evaluation of metal contents of household detergent samples from Turkey by flame atomic absorption spectrometry

The concentrations of cadmium, copper, chromium, cobalt, iron, lead, manganese, nickel, and zinc in detergent samples from Kayseri, Turkey were determined by flame atomic absorption spectrometry. HClO₄ (10 mL)/HNO₃ (10 mL) mixture was used for the digestion of household detergent samples. The correctness of the analytical procedures was checked with standard addition–recovery tests in different detergent samples for the investigated metal ions. The concentration ranges of the elements in the detergent samples were found as 17.2–60.1, 11.1–40.1, 2.5–32.3, 8.1–10.5, 7.2–21.6, 9.8–17.9, 1.7–3.8, 12.5–22.5, and 2.0–5.8 μg/g for iron, manganese, zinc, copper, lead, cobalt, cadmium, nickel, and chromium, respectively. The values found in this work were compared with some other studies around the world conducted on detergent samples.