Denitrification of nitrate wastewater using packed-bed columns.

Columnar packed-bed (PB) reactors with a specific surface area of 127 m2/m3 were investigated in this study for treating nitrate wastewater. This study demonstrated that a single-stage packed bed was able to achieve total nitrogen (TN) and chemical oxygen demand (COD) removal efficiencies higher than 83 and 75%, respectively. The highest achievable TN and COD removal rates were 47.2 g N/m2 x d and 158.0 g COD/m2 x d, respectively. The substrate removal rate in the PB column was found to follow half-order reaction kinetics, with a reaction coefficient, kappa, of 53.62 (mg/L)1/2/d. A dual-stage PB system was capable of achieving TN and COD removal efficiencies greater than 99 and 98%, respectively. Effluent TN and COD concentrations less than 6.5 mg NO3(-)-N/L and 50.0 mg COD/L, respectively, were obtained when the dual PB system was used.     

Effect of formaldehyde on biofilm activity and morphology in an ultracompact biofilm reactor for carbonaceous wastewater treatment.

The effects of formaldehyde on biofilm morphology and biomass activity were investigated in an ultracompact biofilm reactor (UCBR) for carbonaceous wastewater treatment. The wastewater contained a fixed amount of glucose (with a chemical oxygen demand concentration of 600 mg/L) and an increasing concentration of formaldehyde (ranging from 21.4 to 271.1 mg/L). An influent formaldehyde concentration higher than 75 mg/L could facilitate filamentous growth (on biofilm) control and lead to a higher biofilm density, which is desirable as it enhanced the UCBR performance stability. However, at an influent formaldehyde concentration higher than 214.4 mg/L, biomass production was inhibited and deteriorations of biofilm morphology and biomass activity were observed. This study showed that it was desirable to maintain an influent formaldehyde concentration lower than 202.2 mg/L, as this concentration could achieve a good biofilm morphology while not inhibiting its microbial activity.     

Overview of surface measurements and spatial characterization of submicrometer particulate matter during the DISCOVER-AQ 2013 campaign in Houston,TX

The sources of submicrometer particulate matter (PM₁) remain poorly characterized in the industrialized city of Houston, TX. A mobile sampling approach was used to characterize PM₁ composition and concentration across Houston based on high-time-resolution measurements of nonrefractory PM₁ and trace gases during the DISCOVER-AQ Texas 2013 campaign. Two pollution zones with marked differences in PM₁ levels, character, and dynamics were established based on cluster analysis of organic aerosol mass loadings sampled at 16 sites. The highest PM₁ mass concentrations (average 11.6 ± 5.7 µg/m³) were observed to the northwest of Houston (zone 1), dominated by secondary organic aerosol (SOA) mass likely driven by nighttime biogenic organonitrate formation. Zone 2, an industrial/urban area south/east of Houston, exhibited lower concentrations of PM₁ (average 4.4 ± 3.3 µg/m³), significant organic aerosol (OA) aging, and evidence of primary sulfate emissions. Diurnal patterns and backward-trajectory analyses enable the classification of airmass clusters characterized by distinct PM sources: biogenic SOA, photochemical aged SOA, and primary sulfate emissions from the Houston Ship Channel. Principal component analysis (PCA) indicates that secondary biogenic organonitrates primarily related with monoterpenes are predominant in zone 1 (accounting for 34% of the variability in the data set). The relevance of photochemical processes and industrial and traffic emission sources in zone 2 also is highlighted by PCA, which identifies three factors related with these processes/sources (~50% of the aerosol/trace gas concentration variability). PCA reveals a relatively minor contribution of isoprene to SOA formation in zone 1 and the absence of isoprene-derived aerosol in zone 2. The relevance of industrial amine emissions and the likely contribution of chloride-displaced sea salt aerosol to the observed variability in pollution levels in zone 2 also are captured by PCA.

Implications: This article describes an urban-scale mobile study to characterize spatial variations in submicrometer particulate matter (PM₁) in greater Houston. The data set indicates substantial spatial variations in PM₁ sources/chemistry and elucidates the importance of photochemistry and nighttime oxidant chemistry in producing secondary PM₁. These results emphasize the potential benefits of effective control strategies throughout the region, not only to reduce primary emissions of PM₁ from automobiles and industry but also to reduce the emissions of important secondary PM₁ precursors, including sulfur oxides, nitrogen oxides, ammonia, and volatile organic compounds. Such efforts also could aid in efforts to reduce mixing ratios of ozone.     

Exposure Programme on Atmospheric Corrosion Effects of Acidifying Pollutants in Tropical and Subtropical Climates

Many national exposure programmes have been performed in tropical and subtropical climates during the last 50 years. However, ambitious programmes involving more than a few countries are scarce. In this paper a recently formed network of test sites is described involving 12 test sites in Asia (India, Vietnam, Thailand, Malaysia and China including Hong Kong) and four test sites in Africa (South Africa, Zambia and Zimbabwe). This effort is part of the 2001–2004 Swedish International Development Agency (SIDA) funded Programme on Regional Air Pollution in Developing Countries (RAPIDC). Corrosion attack after one (2002–2003) year of exposure (carbon steel, zinc, copper, limestone and paint coated steel) are presented together with environmental data (SO₂, NO₂, HNO₃, O₃, particles, amount and pH of precipitation, temperature and relative humidity) for all the test sites. The obtained corrosion values are substantially higher than expected for limestone, higher than expected for carbon steel and lower than expected for zinc compared to values calculated using the best available dose–response functions.     

Contamination levels of selected organochlorine and organophosphate pesticides in the Selangor River, Malaysia between 2002 and 2003

In Malaysia, rivers are the main source of public water supplies. This study was conducted from 2002 to 2003 to determine the levels of selected organochlorine and organophosphate pesticides in the Selangor River in Malaysia. Surface water samples have been collected seasonally from nine sites along the river. A liquid-liquid extraction followed by gas chromatography-mass spectrometry technique was used to determine the trace levels of these pesticide residues. The organochlorine pesticides detected were lindane, heptachlor, endosulfan, dieldrin, endosulfan sulfate, o,p'-DDT, p,p'-DDT, o,p'-DDE and p,p'-DDE whereas for organophosphate pesticides, they were chlorpyrifos and diazinon. At the river upstream where a dam is located for public water supply, incidents of pesticide levels exceeding the European Economic Community Directive of water quality standards have occurred. Furthermore, the wetland ecosystems located at the downstream of the river which houses the fireflies community is being threatened by occasional pesticide levels above EPA limits for freshwater aquatic organisms. The occurrence of these residual pesticides in the Selangor River can be attributed to the intense agriculture and urban activity.     

Monitoring and Assessment of Exhaust Emission in Bangkok Street Air

Measurement of the exhaust emission from gasoline-powered motor vehicles in Bangkok were performed on chassis dynamometer. A fleet of 10 vehicles of different model, years and manufacturers were selected to measure the air pollutants in the exhaust effluent. The study revealed that the carbon monoxide and hydrocarbon emissions averaged 32.3–64.2 and 1.82–2.98 g km^–1, respectively, for 1990–1992 cars and decreased to 17.8–40.71 and 0.75–1.88 g km^–1, respectively, for 1994–1995 cars. A monitoring program for air pollutant concentrations in ambient air was also conducted to evaluate the air pollution problems in Bangkok arising from vehicle exhaust emission. Four air sampling stations were strategically established to cover the Bangkok Metropolitan Region (BMR). Composite air samples in this study area were collected during the day/night times and weekday/weekend. The average concentrations of suspended particulate matter, carbon monoxide, and nitrogen dioxide in Bangkok street air were found to be 0.65 mg/m³ (24 hr ave.), 19.02 mg/m³ (8 hr ave.) and 0.021 mg/m³ (1 hr ave.), respectively. The average concentrations of benzene and toluene in the ambient air of the study area were found to be 15.07–50.20 and 25.76–130.95 g/mf³, respectively, for 8 hr average. These results indicated that there was a significant increase in air pollutant emissions with increasing car mileage and model year. Subsequent analysis of data showed that there were only 20% of the test vehicles complied to approved emission standard. The finding also revealed that there was a correlation between the average air pollutant concentrations with average traffic speed in each traffic zone of the Bangkok Metropolitan Region (BMR).     

An Environmentally Sound Method for Disposal of Both Ash and Sludge Wastes by Mixing with Soil: A Case Study of Bangkok Plain

This study reported the test done on ash-sludge mixture foramendment of soil in pot experiments. Ash-sludge mixture ratiostudies revealed that 1:5 fly ash-sludge mixture and 1:10 bottom ash-sludge mixture were the optimum mixture ratio thatminimized toxic element and provided sufficient nutrients. Experiments indicated that ash-sludge mixtures is more suitablefor amendment of acid soil than neutral soil which can increasesoil pH and reduce available heavy metal toxicity. The maximumheavy metal adsorption occurred in a pH range of 4 to 6 for allsoil studied. The finding also revealed that fly ash applicationseemed more effective than bottom ash, due to its higher loadingrate and metal contents. Heavy metal toxicity was monitored usingseed germination test. Marigold and tomato seeds were the two crops selected for this test. Seed germination test result showsthat percentage of seed germination increased in pot experimentswith sludge only and ash-sludge mixtures. In addition, higherpercentages of seed germination were observed to vary with longer incubation time (1–8 weeks). After week 12 of the incubation period, percentage of seed germination began to decline, as a result of reduced soil pH and release of toxic heavy metals.     

An environmental approach for used oil management in Asian cities: a Bangkok' s experience

This paper addresses increasing concern about the pollution threat of used oil being illegally dumped and the impact of oil on air pollution and freshwater ecosystems in Asian countries. Used oil is a very serious waste management problem. These results call for management action such as maximising the collection and recovery of used oil. The Thai government recognizes the need to recycle used oil and has been active in encouraging programs to accomplish this goal. Thus unless new approaches and incentives are developed, used oil generation may become an increasing serious problem to our environment. The purpose of this study is to examine the technical and economic feasibility, of recycling used oils. In addition, this paper briefly discusses the problems to be overcome and outlines potential mechanisms for providing the necessary disposal controls in order to maximize the protection to public health and environmental quality from potential hazards posed by used lube oil disposal.     

Effect of mean cell residence time on the performance and microbial diversity of pre-denitrification submerged membrane bioreactors

The effect of mean cell residence time (MCRT) (5, 8.3, 16.7, and 33.3d) on domestic wastewater treatment performance had been investigated using four bench-scale pre-denitrification submerged membrane bioreactors (MBR) operated in parallel. The 33.3-d MCRT MBR had the lowest microbial activities in terms of specific oxygen uptake rate, specific denitrification rate and observed sludge yield. Excellent COD removal efficiency (more than 95%) and nitrification (more than 97%) were observed in all the four MBRs investigated. Even though high nitrification can be achieved in all the MBRs, total nitrogen (TN) removal efficiency was found to be affected by MCRT with a maximum of 77% at 33.3-d MCRT. Better TN removal efficiency achieved in the 33.3-d MCRT MBR was due to the combined effect of high mixed liquor concentration and lower dissolved oxygen concentration in the recycled mixed liquor. A comparison of terminal-restriction fragment length polymorphisms (T-RFLP) fingerprints based on 16S rRNA and nirS gene revealed that the microbial communities of 5- and 8.3-d MCRT are grouped under the same branch while 16.7- and 33.3-d MCRT are grouped in another branch. T-RFLP based on amoA gene shows that members from the Nitrosomonas genus were more dominant under shorter MCRT operating environment. Clustering analysis did not show any correlation with the organic and nitrogen removal performance obtained in this study.