Magnetic photocatalysts from δ-FeOOH and TiO2 and application in reactions for degradation of methylene blue and paracetamol with UV-C and sunlight

Environmental Science and Pollution Research - Water contamination is a common problem, especially considering dyes and drugs disposal. A possible and effective treatment method to remove these...     

Critical analysis of the waste management performance of two uranium production units in Brazil--part II: Caetite production center

This paper discusses the environmental waste management of the Heap-Leach Uranium Production Facility of Caetité located in a semi-arid region in Brazil. A comparison is made with the first uranium production site of the country located in Poços de Caldas. It is demonstrated that differences in the operational process along with different environmental conditions can lead to different impacts. In the present case groundwater is the potential most sensitive environmental medium despite the well-established consensus in the literature that radon and aerosol emissions may turn-out to be the most relevant environmental aspects of an installation located at this type of region. Most of the ²²⁶Ra content in the ore remains in the leached ore that is deposited with the waste rock. A lack in appropriate prediction of the hydrological balance has been causing unanticipated emissions of liquid effluents into the environment. Chemical treatment of this effluent may be needed. Contamination of groundwater in the short term by the waste ponds is not to be expected but it can be a relevant issue in the long term. As a consequence, careful closure schemes will need to be put in place. Finally, the overall costs with remediation in the Caetité production center are lower than those observed at the Poços de Caldas mining site.     

Landfill leachate treatment by immediate one-step lime precipitation,carbonation, and phytoremediation fine-tuning

The high pollutant load of sanitary landfill leachates poses a huge challenge in the search for efficient and environment friendly solutions for their treatment. The objective of this work was to study an integrated solution of environmentally friendly technologies — immediate one-step lime precipitation (IOSLP), carbonation (CB), and phytoremediation (Phyt) — to treat a sanitary landfill leachate. In the leachate sample treatment by IOSLP, the influence of CaO concentration (18.2–33.3 g_CaO L^?1) and stirring time (2–60 min) on the sludge sedimentability and pollutant removal was studied. Organic load and ammonia nitrogen (AN) removal increases with CaO added, as well as sludge volume. Stirring time has a small influence on organic load and AN removal, presenting a minimum for sludge volume. Thus, the best operational conditions were chosen as 27.6 g_CaO L^?1, and 40-min stirring time, with 64% chemical oxygen demand (COD) removal. Sludge humidity was 2.1%, making dewatering needless. IOSLP supernatant was submitted to CB by atmospheric CO₂, and 100% removals in AN and hardness were attained. Effluents from IOSLP and IOSLP?+?CB were utilized in Phyt tests, with Vetiver (Chrysopogon zizanioides (L.) Roberty). The best COD removal (37%) during Phyt was attained for the samples treated by IOSLP?+?CB.

     

Determination of microcontaminants in sediments by on-line solid-phase extraction-gas chromatography-mass spectrometry

Two simple and straightforward analytical procedures for the screening of sediment samples are reported. They involve extraction with ethyl acetate or methanol and subsequent analysis by means of gas chromatography-mass spectrometry (GC-MS) using large-volume injection (LVI) or solid-phase extraction (SPE). The latter, which was originally developed for the analysis of aqueous samples, can be used without any modification. In general, 10 ml of organic solvent were added to 2 g of sediment, and the mixture was shaken and allowed to stand overnight. The methanolic extracts were then diluted in water and subjected to preconcentration and analysis using on-line SPE-GC-MS. The ethyl acetate extracts were injected directly into the GC using LVI. Both methods were used for the detection and identification of microcontaminants during a monitoring study of the river Nitra (Slovak Republic). They included polyaromatic hydrocarbons (PAHs), chlorofluorohydrocarbons, alkoxylated and alkylated phenols and benzothiazole derivatives. Semi-quantitative profiles of the contaminants were constructed and provisionally interpreted. The results indicate that SPE-GC-MS, and also LVI-GC-MS, have good potential for a rapid screening of sediment samples and the identification of microcontaminants. The analytical procedures pose no problems, and the on-line set-up is user-friendly.     

Heavy metal content of edible plants collected close to an area of intense mining activity (southern Portugal)

The Neves-Corvo mining complex (MC) situated in southern Portugal exploits one of the most world’s important copper deposits. Agricultural soils surrounding the MC, used by the inhabitants for crop production, contain excessive amounts of As, Cu, Pb, and Zn. Thus, a potential risk to human consumption exists if edible plants grow on these substrata. Arsenic and Pb were not detected in edible samples collected near the MC and 5 km away, but in the leaves—structural or adsorbed onto the surface. In general, Zn was the most mobile element in both contaminated and reference areas as seen by the bioaccumulation factors (BAF). The tolerable upper intake (TUI) values for Cu are a reason of concern, since in 57.1% of the cases, the TUI values are above the recommended upper limit of 5 mg/day, in the case of Ficus carica, Cucurbita pepo, and Phaseolus vulgaris, whereas in 28.6% of the cases, the TUI values are near this limit (C. pepo and Citrus x sinensis). The consumption of such vegetables from these areas must be banned or strongly reduced, since long-term accumulation of Cu can cause a chronic toxicity in humans.     

Radioecological characterization of a uranium mining site located in a semi-arid region in Brazil

The work presents the radioecological characterization of the new Brazilian uranium mining and milling site located in a semi-arid region of the country. The process characterization demonstrated that in heap leach plants most of the 226Ra remains in the leached ore. Despite the potential higher availability of radium isotopes in the soils of the studied region the lack of precipitation in that area reduces the leaching/mobilization of the radionuclides. High 226Ra and 228Ra concentrations were found in manioc while 210Pb was significant in pasture. It was suggested that a range from 10(-3) to 10(-1) may conveniently encompass most of the transfer factors (TF) values for soil/plant systems (i.e. involving different cultures, different soils and natural radionuclides). Impacts due to aerial transportation of aerosols and radon generated in the mining were proved to be minimal and restricted to an area not greater than 15 km2. Finally, uranium complexation by carbonates was shown to be the main mechanism responding for the elevated radionuclide concentration in groundwater.     

Biodegradation of azo dyes by the yeast Candida zeylanoides in batch aerated cultures

A number of simple azo dyes was degraded in liquid aerated batch cultures by a strain of the yeast Candida zeylanoides. The standard decolorization medium contained glucose as a carbon and energy source, and its pH was either controlled to 5.0-5.2, or allowed to decrease to 3.2-2.8, in the course of microorganism growth. The extent of colour removal in the culture medium was assessed through the decrease in dye absorbance of the supernatants. The extent of colour removal ranged from 44 to 90%, after 7 days, for 5 out of 6 dyes studied in shaked cultures, without pH control, and from 46 to 67%, after 22 hours, for 6 out of 8 dyes in batch experiments, at controlled pH.     

Detection of fungal development in closed spaces through the determination of specific chemical targets

In addition to the biodegradation problems encountered in buildings, exposure of their occupants to moulds is responsible for numerous diseases: infections (invasive nosocomial aspergillosis), immediate or delayed allergies, food-borne infections and different types of irritation. In this context, the aim of our work has been to determine specific chemical tracers for fungal development on construction materials. More generally, by detecting a specific chemical fingerprint of fungal development, our objective was to propose a microbiological alert system which could control systems and/or procedures for the microbiological treatment of indoor areas.

We therefore characterized the chemical emissions from six types of construction material contaminated artificially by moulds. Chemical fingerprints were established for 19 compounds arising specifically from fungal metabolism: 2-ethylhexanoic acid methyl ester, 1-octen-3-ol, 3-heptanol, 3-methyl-1-butanol, 2-methyl-1-butanol, 1,3-octadiene, 2-(5H)-furanone, 2-heptene, -pinene, 2-methylisoborneol, 4-heptanone, 2-methylfuran, 3-methylfuran, dimethyldisulfide, methoxybenzene, a terpenoid and three sesquiterpenes.

Determining the origin of these compounds and their specific links with a growth substrate or fungal species made it possible to judge the pertinence of choosing these compounds as tracers.

Thus the detecting specific volatile organic compounds emitted as from the second day of fungal growth demonstrated that this approach had the advantage of detecting fungal development both reliably and rapidly before any visible signs of contamination could be detected.