Distribution and transport of coal tar-derived PAHs in fine-grained residuum

We investigated the distribution and transport of coal tar-derived polycyclic aromatic hydrocarbons (PAHs) in fine-grained residuum and alluvial floodplain deposits that underlie a former manufactured gas plant. All 16 USEPA priority pollutant PAHs are present at this site and have penetrated the entire 4-5m thickness of clayey sediments, which unconformably overly limestone bedrock. Concentrations of less hydrophobic PAHs (e.g., naphthalene, 0.011-384mg kg(-1)) were about 10 times higher than those of highly hydrophobic PAHs (e.g., benzo[g,h,i]perylene -0.002 to 56.03mgkg(-1)). Microscopic examination of thin-sections of the clay-rich sediments showed that fractures and rootholes, which can act as pathways for flow, occur throughout the profiles. Tarry residue was found coating some fractures and rootholes, indicating that coal tar was, in some cases, able to penetrate as an immiscible phase. However, in the vast majority of samples in which PAHs were detected, there was no detectable tar residue, suggesting that much of the transport occurred in the dissolved phase. Examination of thin-sections with an epifluorescent microscope indicated that PAHs, which fluoresce brightly when exposed to UV light, are distributed throughout the soil matrix, rather than being confined to fractures and rootholes. The widespread distribution of PAHs is most likely due to diffusion-controlled exchange between the fast-flow pathways in the fractures and rootholes and the relatively immobile water in the fine-grained matrix. This implies that fractures and rootholes can play a major role in controlling transport of highly hydrophobic compounds in fine-grained sediments, which would otherwise act as barriers to contaminant migration.     

In situ treatment of metals in contaminated soils with phytate

Batch experiments were conducted to evaluate the ability of various forms of phytate, the hexaphosphoric form of myo-inositol (IP6), to immobilize U, Ni, and other inorganic contaminants in soils and sediments. A Ca-phytate precipitate (Ca(n)-IP6), dodeca sodium-phytate (Na12-IP6), and hydroxyapatite (HA) were added to contaminated soil at rates of 0, 10, 25, and 50 g kg(-1) and equilibrated in 0.001 M CaCl2. The samples were then centrifuged, the solution pH was measured, and the supernatants were filtered prior to analysis for dissolved organic carbon (DOC), U, Ni, P, and other inorganic contaminants, such as As, Cr, Se, and Pb. The residual sediments were air-dried prior to characterization by analytical electron microscopy and extraction with the Toxicity Characteristic Leaching Procedure (TCLP). The solubility of several metals (e.g., U, Pb, Cu) increased with increasing Na12-IP6 when compared with the nonamended control. In some cases immobilization was observed at the lowest Na12-IP6 application rate (10 g kg(-1)) with an increase in solubility observed at the higher rates, demonstrating the importance of metal to ligand ratio. In contrast, Ca(n)-IP6 and HA decreased the solubility of U, Ni, Al, Pb, Ba, Co, Mn, and Zn. For example, soluble U decreased from 2242 to 76 microg kg(-1) and Ni from 58 to 9.6 mg kg with the Ca(n)-IP6 addition, similar to the results observed for HA. Arsenic and Se solubility increased for HA and both forms of IP6, but to a much greater degree for Na12-IP6, suggesting that the increase in pH observed for HA and Na12-IP6, combined with added competition from PO4 and IP6 for sorption sites, resulted in the release of sorbed oxyanion contaminants. The analytical electron microscopy results indicated that metals such as U and Ni were closely associated with secondary Al-rich precipitates in the HA-treated soils, rather than unreacted HA. The analytical electron microscopy results were less definitive for the Ca(n)-IP6-treated soil, although the residual P-containing material was enriched in Al, with lesser amounts of U and Ni.