Characterization of trace constituents in landfill gas and a comparison of sites in Asia

Because landfill gas (LFG) contains an abundance of methane, the utilization of LFG as a renewable energy source is becoming popular in many countries. LFG, however, contains various trace constituents, some of which may pose problems during utilization. For example, siloxanes and halogenated volatile organic compounds (VOCs) can cause difficulties when present in the fuel of gas engines. In addition, many VOCs and mercury have harmful effects on human health, especially on the health of workers at landfill sites and people living near the landfills. Energy recovery from LFG is expected to make great progress in the near future, particularly in Asia, but we found little information on the trace constituents of LFG in this region. Therefore, we sought to characterize the trace components in LFG generated in two landfill sites in China and one site in Japan, to determine the typical concentrations of these trace components in LFG, and to compare their concentrations among landfill sites in Asia. We concluded that the trace components in LFG at the sites studied were mainly siloxanes generated from sewage sludge and harmful benzene, toluene, ethylbenzene, and xylene compounds from petroleum products.     

Evaluation of different sewage sludges as a potential biodiesel source in Japan

Journal of Material Cycles and Waste Management - Wastewater treatment plants (WWTPs) are producing and treating ever-larger quantities of sewage sludge as urban populations increase in size....     

Aqueous leaching of cattle manure incineration ash to produce a phosphate enriched fertilizer

Ash produced from the combustion of livestock manure contains large amounts of phosphorus (P), which is an important resource as a fertilizer. Some studies have extracted and recovered P from incinerated biomass ash using inorganic acid or alkaline agents, which produce wastewater that requires treatment and is expensive due to the cost of chemicals. Livestock manure ash contains not only P, but also water soluble salts, which could be a negative influence on plant growth and shall be preferably removed from the recovered fertilizer. In this study, we removed salinity from cattle manure incineration ash by simple aqueous leaching, while retaining the P content. The optimal condition was a 20 min leaching time at a liquid/solid (L/S) ratio of 10 mL g-ash^?1. Under this condition, over 90 % of Cl and 20 % of Na in the original ash was removed, while over 99 % of the P was retained in the leached residue. The leached residue met the fertilizer standard in Japan in terms of citrate soluble fertilizer components and contained few heavy metals. X-ray analyses of the ash indicated that Cl was mainly present as KCl in the original ash, while P was mainly present as Ca compounds in the ash.     

An empirical model of soil chemical properties that regulate methane production in Japanese rice paddy soils

To understand which soil chemical properties are the best predictors of CH4 production in rice paddy soils, a model was developed with empirical data from nine types of rice soils collected around Japan and anaerobically incubated at 30 degrees C for 16 wk in laboratory conditions. After 1, 2, 4, 8, and 16 wk of incubation, CO2, CH4, and Fe(II) were measured to understand soil organic matter decomposition and iron (Fe) reduction. Available N (N ava) was also measured at the end of incubation. The results showed that decomposable C and reducible Fe are two key parameters that regulate soil CH(4) production (P CH4). There was a significant relationship between decomposable C and available N (N ava) (r2 = 0.975**). Except for a sandy soil sample, a significant relationship between total Fe (Fe total) and reducible Fe was found. From this experiment, a simple model of soil CH4 production was developed: P CH4 = 1.593N(ava) - 2.460Fe total/1000 (each unit was mg kg(-1) soil). After simulated CH4 production by two soil chemical properties as above, there was a significant consistency between model simulation and actual measurement (r2 = 0.831**).     

Comparison of two types of municipal solid waste incinerator fly ashes with different alkaline reagents in washing experiments

In this study, we propose a "washing-calcination-conversion of washed fly ash into cement material with bottom ash" (WCCB) system to reduce the amount of fly ash that must be specially treated so it can be used as raw cement material. Calcium hydroxide (Ca(OH)2) is widely used in air-pollution control devices of incinerators while sodium bicarbonate (NaHCO3) is not. We conducted single-, double-, and triple-washing experiments to compare the washing characteristics of two types of fly ash. Unlike NaHCO3 fly ash, Ca(OH)2 fly ash has almost twice as much washed residue and almost 2.5 times more chlorine after the same washing procedure. After washing once, the washing frequency is also important for NaHCO3 fly ash, while the mixing time and liquid/solid ratio are more critical for Ca(OH)2 fly ash. The use of NaHCO3 is more suitable for the WCCB system.     

Kinetics on the decomposition of polychlorinated biphenyls with activated carbon-supported iron

The process of destroying polychlorinated biphenyls (PCBs) generates exhaust gases that contain low quantities of PCBs, which cannot be disposed of easily. Activated carbon (AC) can be used to adsorb residual PCBs after disposal of high-level PCBs. We examined the chemical reactivity of AC-supported iron as a catalyst to decompose PCB-153, and varied three decomposition parameters (temperature, time and iron concentration) under an atmosphere of either air or N(2). We measured the Brunauer-Emmett-Teller (BET) surface area and pore volume of AC to assess the adsorption capacity of AC before and after decomposition. At low temperatures the adsorption process was more important than the decomposition process. The decomposition process was completed within 30 and 60 min under air and N(2), respectively. The efficiency of PCB-153 decomposition at 350 degrees C for 120 min was approximately 100.0% and 97.1% under air and N(2), respectively. Analysis of inorganic chloride ions revealed that PCB-153 was effectively destroyed during decomposition. The differences between decomposition under air and N(2) reflected differences in BET surface and pore volume.     

Roadside Rhododendron pulchrum leaves as bioindicators of heavy metal pollution in traffic areas of Okayama, Japan

The leaves of roadside Rhododendron pulchrum Sweet were examined as a bioindicator of traffic-related heavy metal pollution in Okayama. Total contents of heavy metals in roadside soil and the R. pulchrum leaves were determined. Results of correlation analyses showed significant correlations among Pb, Ni, and Zn contents of roadside soil and leaf samples. These results suggest that R. pulchrum is a useful bioindicator of heavy metal pollution in traffic areas. To identify traffic-related heavy metal pollution sources, traffic-related materials such as tires, asphalt pavement, and road paint were collected and analyzed. The results of analyses of our data show that Zn is emitted mainly from the abrasion of tires; Cr is emitted mainly from wear of the asphalt pavement. Furthermore, the respective lead isotope ratios in R. pulchrum leaves, soil, roadside dust, and traffic-related materials were measured using inductively coupled plasma mass spectrometry. The isotopic compositions of lead in R. pulchrum leaves were 207Pb/206Pb = 0.861-0.871 and 208Pb/206Pb = 2.093-2.127, which agrees well with ratios in automobile wheel balance weights, suggesting that lead-containing products associated with automobiles, such as wheel balance weights, contribute to traffic-related lead pollution.     

Leaching characteristics of stabilized/solidified fly ash generated from ash-melting plant

This study was designed to elucidate the leaching characteristics of stabilized/solidified (S/S) fly ash generated by ash-melting. For this study, pH-dependent leaching tests, sequential extraction procedures, and column leaching tests were carried out. The pH-dependent leaching test results for Pb, Cu, and Zn showed that the heavy metal concentrations in the high-pH range were lower than the predicted values for hydroxide and carbonate. During sequential extraction, Cu and Pb were principally distributed in the S/S ashes' organic matter fraction in the chelating agent, suggesting that metals bind to the chelating agent. The percentage of the water-soluble fraction for Pb and Cu was low (<0.2 %). The fly ashes treated with a chelating agent and cement had low leachability potential for metals in the high-pH range. Column tests for S/S fly ashes showed that two leaching stages were distinguishable: one for short time, corresponding to faster metal leaching, and another for the leaching rate. Kinetic speciation was then applied to data obtained from column leaching tests. The first-order reaction/diffusion model showed a better fit for Ca, Pb, and Cu, suggesting that the initial dissolution of soluble compounds, such as metal chloride, was controlled by the first-order reaction (surface wash off). Subsequently, insoluble compounds such as hydroxide or carbonate might penetrate into the porous matrix by diffusion.     

Historical and geographical aspects of the increasing perfluorooctanoate and perfluorooctane sulfonate contamination in human serum in Japan

Perfluorooctane sulfonate (PFOS) and perfluorooctanoate (PFOA) have recently received attention due to their widespread contamination in the environment, as well as in wildlife and humans. We measured the PFOS and PFOA concentrations in historically recorded human serum samples at an age range between 20 and 59 years collected in Kyoto, 20 persons per each time point (n=100), and also the PFOS and PFOA concentrations in human serum samples at an age range between 20 and 59 years from 10 locations throughout Japan (n=200). The historical samples collected from 1983 to 1999 demonstrated that the PFOA concentrations in males and females from Kyoto have increased 4.4-fold and 4.3-fold at a rate of increase of 0.49 ng/ml/year and 0.42 ng/ml/year, respectively. In contrast, serum concentrations of PFOS reached a plateau in the late 1980s. There are also regional differences in both the PFOS and PFOA serum concentrations. The concentrations in serum [geometric mean (geometric standard deviation)] (ng/ml) in 2003-2004 ranged from 7.6(1.6) in the town of Matsuoka in Fukui prefecture to 27.8(1.6) in Kyoto city, and ranged from 2.3(1.5) in Matsuoka to 14.5(1.3) in Osaka city for PFOS and PFOA, respectively.