Modelling and Optimization of Uranium (VI) Ions Adsorption Onto Nano-ZnO/Chitosan Bio-composite Beads with Response Surface Methodology (RSM)

Nano-ZnO-chitosan bio-composite beads were prepared for the sorption of \({\text{UO}}_{2}^{{2+}}\) from aqueous media. The resulting nano-ZnO/CTS bio-composite beads were characterized by TEM, XRD etc. The sorption of \({\text{UO}}_{2}^{{2+}}\) by bio-composite beads was optimized using RSM. The correlation between four variables was modelled and studied. According to RSM data, correlation coefficients (R²?=?0.99) and probability F-values (F?=?2.24?×?10^??10) show that the model fits the experimental data well. Adsorption capacity for nano-ZnO/CTS bio-composite beads was obtained at 148.7 mg/g under optimum conditions. The results indicate that nano-ZnO/CTS bio-composite beads are appropriate for the adsorption of \({\text{UO}}_{2}^{{2+}}\) ions from aqueous media. Also, the suitability of adsorption values to adsorption isotherms was researched and thermodynamic data were calculated.     

Estimating Potential Climate Change Effects on the Upper Neuse Watershed Water Balance Using the SWAT Model

Climate change poses water resource challenges for many already water stressed watersheds throughout the world. One such watershed is the Upper Neuse Watershed in North Carolina, which serves as a water source for the large and growing Research Triangle Park region. The aim of this study was to quantify possible changes in the watershed’s water balance due to climate change. To do this, we used the Soil and Water Assessment Tool (SWAT) model forced with different climate scenarios for baseline, mid‐century, and end‐century time periods using five different downscaled General Circulation Models. Before running these scenarios, the SWAT model was calibrated and validated using daily streamflow records within the watershed. The study results suggest that, even under a mitigation scenario, precipitation will increase by 7.7% from the baseline to mid‐century time period and by 9.8% between the baseline and end‐century time period. Over the same periods, evapotranspiration (ET) would decrease by 5.5 and 7.6%, water yield would increase by 25.1% and 33.2%, and soil water would increase by 1.4% and 1.9%. Perhaps most importantly, the model results show, under a high emission scenario, large seasonal differences with ET estimated to decrease by up to 42% and water yield to increase by up to 157% in late summer and fall. Planning for the wetter predicted future and corresponding seasonal changes will be critical for mitigating the impacts of climate change on water resources.     

A study on the determination of the natural park’s sustainable tourism potential

The surface site of Yesilyuva Nature Park encompasses natural, social, economic, and cultural characteristics and has become a marker of the region’s natural and cultural heritage. To support the preservation of this site, promotional activities should be planned. In this study, because of tourism and related opinions of residents and visitors alike in terms of their natural determination, an important cultural and historical feature is aimed at evaluating the tourism potential of Yesilyuva Nature Park. This framework is designed to establish prospective tourism sustainability. As a result, Yesilyuva Nature Park’s natural and cultural properties have been determined to be suitable for sustainable tourism activities using geographic information systems (GIS). This protection in the field, which balances sustainability and landscape design, will provide for the development of tourism activities. In the Strengths, Weaknesses, Opportunities and Threats (SWOT) analysis and survey, residents and visitors reported that the most important feature of the Yesilyuva Nature Park was its natural beauty. Visitors often come to observe traditional and natural life and to engage in tourism activities. All the data, which includes maps derived from GIS, represents landscape planning for sustainable tourism areas in Yesilyuva Nature Park.     

Effects of calcium hydroxide and calcium chloride addition to bentonite in iron ore pelletization.

Pyrite ash is created as waste from the roasting of pyrite ores during the production of sulphuric acid. These processes generate great amounts of pyrite ash waste that is generally land filled. This creates serious environmental pollution due to the release of acids and toxic substances. Pyrite ash waste can be utilized in the iron production industry as a blast furnace feed to process this waste and prevent environmental pollution. The essential parameters affecting the pelletization process of pyrite ash were studied using bentonite as a binder. Experiments were then carried out using bentonite and a mixture of bentonite with calcium hydroxide and calcium chloride in order to make the bentonite more effective. The metallurgical properties of pyrite ash, bentonite, calcium hydroxide, calcium chloride, a mixture of these and sintered pellets were studied using X-ray analysis. The crushing strength tests were carried out to investigate the strength of pyrite ash waste pellets. The results of these analyses showed that pyrite ash can be agglomerated to pellets and used in the iron production industry as a blast furnace feed. The crushing strength of the pellets containing calcium hydroxide and calcium chloride in addition to bentonite was better than the strength of pellets prepared using only bentonite binder.     

Single-source impact analysis using three-dimensional air quality models

Isolating the effects of an individual emissions source on secondary air pollutants such as ozone and some components of particulate matter must incorporate complex nonlinear processes, be sensitive to small emissions perturbations, and account for impacts that may occur hundreds of kilometers away. The ability to evaluate these impacts is becoming increasingly important for efficient air quality management. Here, as part of a recent compliance enforcement action for a violation of the Clean Air Act and as an evaluation of ozone response to single-source emissions plumes, two three-dimensional regional photochemical air quality models are used to assess the impact on ozone from approximately 2000 to 3000 excess t/month of nitrogen oxides emitted from a single power plant in Ohio. Periods in May, July, and August are evaluated. Two sensitivity methods are applied: the "brute-force" (B-F) method and the decoupled direct method (DDM). Using DDM, maximum 1-hr averaged ozone concentrations are found to increase by up to 1.8, 1.3, and 2.2 ppbv during May, July, and August episodes, respectively, and concentration increases greater than 0.5 ppbv occur in Ohio, Pennsylvania, Maryland, New York, West Virginia, Virginia, and North and South Carolina. B-F results for the August episode show a maximum 1-hr averaged ozone concentration increase of 2.3 ppbv. Significant localized decreases are also simulated, with a maximum of 3.6 ppbv in Ohio during the August episode and decreases of 0.50 ppbv and greater in Ohio, Pennsylvania, Maryland, West Virginia, and Virginia. Maximum increases are compared with maximum decreases for the August period using second-order DDM and are found, in aggregate, to be greater in magnitude by 42%. When evaluated during hours when ozone concentrations exceed 0.060 ppm, the maximum increases in ozone are higher than decreases by 82%. The spatial extent of ozone increase in both cases is about triple that of reduction.     

Mineral contents and proximate composition of Pistacia vera kernels

The mineral contents of Pistacia vera kernels were determined by inductively coupled plasma-atomic emission spectroscopy (ICP-AES). The minimum and maximum values of K, P, Ca, Mg, and S elements ranged from 6,333 to 8,064 mg/kg, 3,630 to 5,228 mg/kg, 1,614 to 3,226 mg/kg, 1,716 to 2,402 mg/kg, and 1,417 to 1,825 mg/kg, respectively. In addition, the mean values of Fe, Zn, Cu, Mn, B, Mo, Cr and Ni elements were determined as 42.48, 20.52, 12.81, 7.48, 11.31, 0.106, 0.511 and 1.67 mg/kg, respectively. Ash levels of kernels were found between 2.28 % (Urfa) and 2.79 % (Halebi). In addition, crude oil and protein contents were determined between 48.8 % (Halebi) to 55.3 % (Siirt) and 23.33 % (Uzun) to 27.16 % (Halebi), respectively.     

Electrochemical advanced oxidation processes: today and tomorrow. A review

In recent years, new advanced oxidation processes based on the electrochemical technology, the so-called electrochemical advanced oxidation processes (EAOPs), have been developed for the prevention and remediation of environmental pollution, especially focusing on water streams. These methods are based on the electrochemical generation of a very powerful oxidizing agent, such as the hydroxyl radical (^?OH) in solution, which is then able to destroy organics up to their mineralization. EAOPs include heterogeneous processes like anodic oxidation and photoelectrocatalysis methods, in which ^?OH are generated at the anode surface either electrochemically or photochemically, and homogeneous processes like electro-Fenton, photoelectro-Fenton, and sonoelectrolysis, in which ^?OH are produced in the bulk solution. This paper presents a general overview of the application of EAOPs on the removal of aqueous organic pollutants, first reviewing the most recent works and then looking to the future. A global perspective on the fundamentals and experimental setups is offered, and laboratory-scale and pilot-scale experiments are examined and discussed.     

Electro-oxidation of the dye azure B: kinetics,mechanism, and by-products

In this work, the electrochemical degradation of the dye azure B in aqueous solutions was studied by electrochemical advanced oxidation processes (EAOPs), electro-Fenton, and anodic oxidation processes, using Pt/carbon-felt and boron-doped diamond (BDD)/carbon-felt cells with H₂O₂ electrogeneration. The higher oxidation power of the electro-Fenton (EF) process using BDD anode was demonstrated. The oxidative degradation of azure B by the electrochemically generated hydroxyl radicals (^?OH) follows a pseudo-first-order kinetics. The apparent rate constants of the oxidation of azure B by ^?OH were measured according to pseudo-first-order kinetic model. The absolute rate constant of azure B hydroxylation reaction was determined by competition kinetics method and found to be 1.19?×?10⁹ M^?1 s^?1. It was found that the electrochemical degradation of the dye leads to the formation of aromatic by-products which are then oxidized to aliphatic carboxylic acids before their almost mineralization to CO₂ and inorganic ions (sulfate, nitrate, and ammonium). The evolution of the TOC removal and time course of short-chain carboxylic acids during treatment were also investigated.     

Determination of Au(III) and Pd(II) ions by flame atomic absorption spectrometry in some environmental samples after solid phase extraction

A simple and sensitive solid phase extraction method was developed for simultaneous separation and preconcentration of gold and palladium ions with N-(4-methylphenyl)-2-{[(4-phenyl-5-pyridine-4-yl-4H-1,2,4-triazol-3-yl)thio]acetyl}hydrazine carbo thioamide complex on Amberlite XAD-1180 resin before their determination by flame atomic absorption spectrometry. Some analytical parameters such as HNO₃ concentration of the sample solution, amount of complexing agent, sample volume, eluent type and volume, effects of foreign ions and adsorption capacity of the resin were investigated for quantitative recovery of gold and palladium ions. The effects of some anions and cations were also examined. Under optimum conditions, the detection limits for gold and palladium ions were found to be 0.29 and 0.19 μg L^?1, respectively. The preconcentration factor for gold and palladium was 250. After being validated by standard addition and analysis of standard reference material, the procedure was successfully applied to the analysis of sea and stream water, anodic slime, gold ore, soil and electronic waste.     

Some phenolic compounds of extracts obtained from Origanum species growing in Turkey

Caffeic acid, rosmarinic acid, rutin, apigenin 7-O-glucoside, apigenin, and acesetin were the main phenolic compounds of Origanum onites extracts in all applications. While acesetin contents ranged from 133.59 mg/100 g (U1) to 437.25 mg/100 g (S3), rosmarinic acid changed between 215.94 mg/100 g (U4) and 1120.56 mg/100 g (S2) in Origanum vulgare L. subsp. hirtum (Link) Ietsw. Both rosmarinic acid and acesetin were not found in U5 application. Only caffeic acid (19.39 mg/100 g) was found in U5 application. Rosmarinic acid contents of O. onites extract changed between 158.62 mg/100 g (U5) and 799.87 mg/100 g (S2). Generally, dominant phenolic compound of Origanum extracts was rosmarinic acid compared with other extracts. In addition, methanol:water:acetic acid mixture (S2) (95:4.5:0.5) was found as the best application. Phenolic contents of extracts obtained with U series mixtures were found low.