Influence of preparation method on structural,optical, magnetic,and adsorption properties of nano-NiFe2O4

Nickel ferrite (NiFe₂O₄) nanoparticles are prepared through different routes (microwave, co-precipitation, and pyrolysis) and tested for water purification applications through adsorption removal of an acid red dye B as a model organic pollutant. The characterizations of the prepared samples were done using XRD, FT-IR, SEM, TEM, BET, UV-Vis absorbance, Raman spectrum, and vibrating sample magnetometer (VSM). All samples showed an inverse spinel crystal structure. The obtained results pointed out to the effect of the synthetic route on the morphology, particle size, optical, and magnetic properties of the prepared ferrites. Magnetic measurements showed super-paramagnetic behavior for all samples. The magnetic saturation (M_s) of the sample prepared by pyrolysis, was found to possess the highest saturation value, 34.8 emu/g. Adsorption experiments were performed under the change in several parameters, such as pH, adsorbent dosage, and initial dye concentration. A dye removal percentage of 99% was reached under the optimum state. The isothermal adsorption of the acid red dye was investigated using several models, in which the experimental data could be best described by the Freundlich model. Several kinetic and equilibrium models were inspected by linear regression analysis and showed best fitting for the adsorption data through pseudo-second-order model. The calculated thermodynamic parameters indicated that the adsorption of acid red dye onto all the ferrite samples is a spontaneous and endothermic physical adsorption process.

     

Investigation of PM2.5 and carbon dioxide levels in urban homes

PM_2.5 (particulate matter with an aerodynamic diameter <2.5 μm) samples were collected in the indoor environments of 15 urban homes and their adjacent outdoor environments in Alexandria, Egypt, during the spring time. Indoor and outdoor carbon dioxide (CO₂) levels were also measured concurrently. The results showed that indoor and outdoor PM_2.5 concentrations in the 15 sites, with daily averages of 45.5 ± 11.1 and 47.3 ± 12.9 µg/m³, respectively, were significantly higher than the ambient 24-hr PM_2.5 standard of 35 µg/m³ recommended by the U.S. Environmental Protection Agency (EPA). The indoor PM_2.5 and CO₂ levels were correlated with the corresponding outdoor levels, demonstrating that outdoor convection and infiltration could lead to direct transportation indoors. Ventilation rates were also measured in the selected residences and ranged from 1.6 to 4.5 hr^?1 with median value of 3.3 hr^?1. The indoor/outdoor (I/O) ratios of the monitored homes varied from 0.73 to 1.65 with average value of 0.99 ± 0.26 for PM_2.5, whereas those for CO₂ ranged from 1.13 to 1.66 with average value of 1.41 ± 0.15. Indoor sources and personal activities, including smoking and cooking, were found to significantly influence indoor levels.

Implications: Few studies on indoor air quality were carried out in Egypt, and the scarce data resulted from such studies do not allow accurate assessment of the current situation to take necessary preventive actions. The current research investigates indoor levels of PM_2.5 and CO₂ in a number of homes located in the city of Alexandria as well as the potential contribution from both indoor and outdoor sources. The study draws attention of policymakers to the importance of the establishment of national indoor air quality standards to protect human health and control air pollution in different indoor environments.     

Hair as a marker for pesticides exposure

Rats were orally treated with mixtures of chlorinated pesticides. Hair was collected and analyzed for pesticide residues over a period of up to four weeks. Quantitative and qualitative analysis of the recovered pesticides in hair were determined using gas chromatography with electron capture detector. Results suggest that hair can be used as a biomarker for the monitoring of organochlorinated pesticide residues at low parts per billion levels. Chlorinated pesticides were also detected in human hair of environmentally exposed and occupationally exposed individuals, which indicates that hair can be used for monitoring pesticides exposure.     

Potential protective effects of Spirulina platensis on liver,kidney, and brain acrylamide toxicity in rats

Environmental Science and Pollution Research - Acrylamide (AA) is a hazardous chemical that is widely used in industrial practices. Spirulina platensis (SP) is a blue green alga that is rich in...     

Comparative immuno-modulatory effects of basil and sesame seed oils against diazinon-induced toxicity in rats; a focus on TNF-α immunolocalization

Environmental Science and Pollution Research - Diazinon (DZN), a common organophosphorus insecticide (OPI), has hazardous effect to human and animals with its ubiquitous use. Considering the...     

MicroRNAs’ role in the environment-related non-communicable diseases and link to multidrug resistance,regulation, or alteration

Environmental Science and Pollution Research - The discovery of microRNAs (miRNAs) 20 years ago has advocated a new era of “small molecular genetics.” About 2000 miRNAs are present that...     

Degradation of direct azo dye by Cucurbita pepo free and immobilized peroxidase

Enzymatic decolourization of the azo dye, Direct Yellow (DY106) by Cucurbita pepo (courgette) peroxidase (CP) is a complex process, which is greatly affected by pH, temperature, enzyme activity and the concentrations of H₂O₂ and dye. Courgette peroxidase was extracted and its performance was evaluated by using the free-CP (FCP) and immobilized-CP (ICP) forms in the decolourization of DY106. Immobilization of peroxidase in calcium alginate beads was performed according to a strategy aiming to minimize enzyme leakage and keep its activity at a maximum value by optimizing sodium alginate content, enzyme loading and calcium chloride concentration. The initial conditions at which the highest DY106 decolourization yield was obtained were found at pH 2, temperature 20℃, H₂O₂ dose 1 mmol/L (FCP) and 100 mmol/L (ICP). The highest decolourization rates were obtained for dye concentrations 50 mg/L (FCP) and 80 mg/L (ICP). Under optimal conditions, the FCP was able to decolorize more than 87% of the dye within 2 min. While with ICP, the decolourization yield was 75% within 15 min. The decolourization and removal of DY106 was proved by UV-Vis analysis. Fourier transform infrared (FT-IR) spectroscopy analysis was also performed on DY106 and enzymatic treatment precipitated byproduct.     

Vulnerability risk assessment and adaptation to climate change induced sea level rise along the Mediterranean coast of Egypt

Consequence of the sea level rise (SLR) on the Mediterranean coastal areas in Egypt, particularly the Nile River Delta, has become an issue of major concern to Egypt’s population and the government. Previous publications disregard the entire Mediterranean coast of Egypt as an integral unit subject to the impacts of the SLR. This study aims to analyzing the risks, ranking the vulnerability and suggesting adaptation measures to mitigate the impact of the SLR along the Mediterranean coast of Egypt. Although the prominent features of Egypt’s Mediterranean coastal zone are the low lying coast of the Nile Delta, associated with land subsidence, tectonic activities and erosion; the contiguous coastal sectors are backed by shore-parallel carbonate ridges and Plateau (the western coast) and sand dune belts (Sinai coast). The coastal zone is ranked as high, moderate, and low vulnerable to the SLR. The social and biophysical vulnerabilities demonstrate the asymmetrical impacts of the SLR on the Mediterranean coast of Egypt. Areas at risk in the Alexandria region are Mandara and El Tarh whereas in the Nile Delta region, they are the Manzala Lagoon barrier, east and west of the Rosetta City, Gamil, and the Tineh plain. Risk associated with these impacts may be reduced provided the consideration of immediate and adequate adaptation measures.     

Natural resistance of rose petals to microbial attack

Petals of red, yellow and white roses (Rosa damascene Mill.) of the family Rosaceae were extracted with (1:1) methylene chloride/methanol and tested for their antimicrobial activities against four species of Gram-positive bacteria (Bacillus cereus, Bacillus subtilis, Micrococcus luteus and Staphylococcus aureus), five species of Gram-negative bacteria (Enterobacter aerogenes, Escherichia coli, Klebsiella pneumonia, Pseudomonas aeruginosa and Serratia marcescens) and five species of fungi (Penicillium notatum, Aspergillus niger, Rhizopus stolonifer, Saccharomyces cerevisiae and Fusarium oxysporum). All of the crude extracts showed a wide range of antimicrobial activities according to the tested organism and rose's type. Micrococcus luteus was found to be the most susceptible bacteria to all crude extracts. Red and yellow petal extracts showed much higher antibacterial activity than the white petals extract. Bacillus subtilis was found to be the least susceptible to all extracts. The fungus, Penicillium notatum was found to be the most susceptible with white petal extract being the most effective. Saccharomyces cerevisiae and Fusarium oxysporum were the least susceptible to all extracts. White roses extract showed much higher antifungal activities against Penicillium notatum than red or yellow roses, therefore, it was subjected to several bioassay guided chromatographic fractionations and purification to isolate the active chemical(s) responsible for the antifungal activity. Chemical structure of the isolated antifungal compounds were identified by spectroscopy techniques and found to be a γ-sitosterol and (Z,Z)-9,12-octadecadienoic acid. Antibacterial activity of the various types of rose extracts were due to complex mixtures of organic compounds which are still under chemical investigation and will be published later.     

Preparation and Characterization of Biodegradable Blend Membranes of PBS/CA

Asymmetric membranes of cellulose acetate/poly (butylene succinate) were prepared using immersion precipitation technique. The blended membranes were characterized by contact angle, scanning electron microscopy, thermogravimetric analysis, degradation test in compost and dynamic test of raisin wastewater treatment. Results demonstrated that hydrophilicity of cellulose acetate was enhanced by addition of poly (butylene succinate) up to 50 %. Furthermore, polymeric composition affects cross sectional structure of the membranes by controlling formation of macrovoids. Addition of poly (butylene succinate) improved the membranes thermal stability and obviously their degradation in compost. The prepared membranes were able to reject the wastewater pollutants properly.