Accumulation and mobility of zinc in soil amended with different levels of pig-manure compost

Applying manure compost not only results in zinc accumulation in the soil but also causes an increase in zinc mobility and enhances zinc leaching. In this study, the physical and chemical characteristics of zinc, zinc profiles, and zinc balance were investigated to characterise the fate of zinc in fields where the quality and amount of pig manure compost applied have been known for 13 years. Moreover, we determined zinc fractionation in both 0.1 mol L^?1HCl-soluble (mobile) and -insoluble (immobile) fractions. Adsorption of zinc in the soil was enhanced with increasing total carbon content following the application of pig manure compost. The 159.6 mg ha^?1 year^?1manure applied plot (triplicate) exceeded the Japanese regulatory level after only 6 years of applying pig manure compost, whereas the 53.2 mg ha^?1 year^?1 manure applied plot (standard) reached the regulatory level after 13 years. The zinc loads in the plots were 17.0 and 5.6 kg ha^?1 year^?1, respectively. However, 5.9 % and 17.2 % of the zinc loaded in the standard and the triplicate pig manure compost applied plots, respectively, were estimated to be lost from the plough layer. Based on the vertical distribution of mobile and immobile zinc content, a higher rate of applied manure compost caused an increase in the mobile zinc fraction to a depth of 40 cm. Although the adsorption capacity of zinc was enhanced following the application of pig manure compost, a greater amount of mobile zinc could move downward through the manure amended soil than through non manure-amended soil.     

Radiation Effects on Blends of Poly(ε-Caprolactone) and Diatomites

Poly(-caprolactone) (PCL) was blended with diatomaceous earth (diatomite) and irradiated with -rays to introduce cross-linking between PCL molecules or both components. The unwashed diatomite containing a little of a volatile component showed high efficiency of introduction of cross-linking, whereas that with no volatile component showed low efficiency of introduction of cross-linking. Elongational viscosity, melt viscosity, and modulus of PCL/diatomite blend irradiated at various doses were significantly improved. Enzymatic degradation of the PCL/diatomite blend became faster than that of the PCL, though that of the blend irradiated became slower.     

Investigation of 1,4-dioxane originating from incineration residues produced by incineration of municipal solid waste

As a groundwater contaminant, 1,4-dioxane is of considerable concern because of its toxicity, refractory nature to degradation, and rapid migration within an aquifer. Although landfill leachate has been reported to contain significant levels of 1,4-dioxane, the origin of 1,4-dioxane in leachate has not been clarified until now. In this study, the origins of 1,4-dioxane in landfill leachate were investigated at 38 landfill sites and three incineration plants in Japan. Extremely high levels of 1,4-dioxane 89 and 340 microg l(-1), were detected in leachate from two of the landfill sites sampled. Assessments of leachate and measurement of 1,4-dioxane in incineration residues revealed the most likely source of 1,4-dioxane in the leachate to be the fly ash produced by municipal solid waste incinerators. Effective removal of 1,4-dioxane in leachate from fly ash was achieved using heating dechlorination systems. Rapid leaching of 1,4-dioxane observed from fly ash in a sequential batch extraction indicated that the incorporation of a waste washing process could also be effective for the removal of 1,4-dioxane in fly ash.     

An empirical model of soil chemical properties that regulate methane production in Japanese rice paddy soils

To understand which soil chemical properties are the best predictors of CH4 production in rice paddy soils, a model was developed with empirical data from nine types of rice soils collected around Japan and anaerobically incubated at 30 degrees C for 16 wk in laboratory conditions. After 1, 2, 4, 8, and 16 wk of incubation, CO2, CH4, and Fe(II) were measured to understand soil organic matter decomposition and iron (Fe) reduction. Available N (N ava) was also measured at the end of incubation. The results showed that decomposable C and reducible Fe are two key parameters that regulate soil CH(4) production (P CH4). There was a significant relationship between decomposable C and available N (N ava) (r2 = 0.975**). Except for a sandy soil sample, a significant relationship between total Fe (Fe total) and reducible Fe was found. From this experiment, a simple model of soil CH4 production was developed: P CH4 = 1.593N(ava) - 2.460Fe total/1000 (each unit was mg kg(-1) soil). After simulated CH4 production by two soil chemical properties as above, there was a significant consistency between model simulation and actual measurement (r2 = 0.831**).     

A badge-type personal sampler for measurement of personal exposure to NO2 and NO in ambient air

A badge-type personal sampler was developed for measuring personal exposure to nitrogen dioxide (NO₂). An absorbent sheet containing triethanolamine (TEA) solution absorbed NO₂ which diffused through five layers of hydrophobic fiber filter. Wind effects on absorption rate were suppressed by these filter layers. NO₂ was measured by the sampler with a sensitivity of 124.8 μg h/m³ (66 ppb h) and an accuracy of within ± 20%. It could be used for measuring personal exposure to NO₂ without interfering with the wearer's daily activities. Nitric oxide (NO) could be measured after a small modification to the sampler provided oxidation ability to the layers of diffusion filter. Three layers of hydrophobic fiber filter were replaced by 12 layers of glass fiber filter containing chromium trioxide solution. NO was oxidized to NO₂ in the oxidation layers and absorbed by the absorbent sheet together with the coexisting NO₂. Sensitivity and accuracy of the sampler for NO were nearly equal to that for NO₂.     

Development of a new antifouling method for a marine cooling water system

Variations in meristic characters occur within and between samples of milkfish Chanos chanos (Forsskal) collected on June 1977 from five localities in Philippine waters. The unbranched anal and ventral fin rays are the most plastic, and vertebral number is the most stable of nine meristic characters examined. The number of ventral fin rays is the only meristic feature which differed consistently enough to suggest distinct population groups: South China Sea, comprising samples from Ilocos and Panay Island; Pacific Ocean from Bicol; and Celebes Sea, from Zamboanga and Davao. A discriminant analysis which incorporated generalized distance (Mahanalobis D²) and percent overlap of a reduced set of characters indicated several morphometric subgroups of milkfish in Philippine waters, although geographic subgroups were not clearly demonstrated.SEAFDEC Contribution No. 218     

Geographical differences in early growth of walleye pollock Theragra chalcogramma,estimated by back-calculation of otolith daily growth increments

The relationship between otolith length and body length (total length) was examined in walleye pollock Theragra chalcogramma (Pallas), collected from Pacific Ocean waters adjacent to Hokkaido, Japan, and in larvae reared from fertilized eggs. A linear relationship was found between log-transformed body length and otolith length data with two inflection points at ca. 11 mm and 100 mm total length. This relationship was found to be applicable also to samples from the Japan Sea, Bering Sea and Okhotsk Sea. The early growth pattern estimated by back-calculation of otolith increments of 1-yr fish from Funka (Uchiura) Bay (Hokkaido) accorded with that obtained from size-at-age data of 0 yr fish collected in the preceding year. Differences were found in comparisons of the back-calculated early growth pattern between samples from waters adjacent to Hokkaido, the Pacific Ocean, the Japan Sea and the Okhotsk Sea. The growth curve of the Okhotsk samples was markedly different from others, showing rapid initial growth up to about 100 d after hatching and attaining a small body size in the first year.     

Research to develop a predicting system of mammalian subacute toxicity (3) construction of a predictive toxicokinetics model

A new predictive toxicokinetics model was developed to estimate subacute toxicity (target organs, severity, etc.) of non-congeneric industrial chemicals, where the chemical structures and physico-chemical properties are only available. Thus, a physiological pharmacokinetics model, which consists of blood, liver, kidney (these were experimentally found as major toxicological targets), muscle and fat compartments , was established to simulate the chemical concentrations in organs/tissues with pharmacokinetic parameters by means of Runge-Kutta-Gill algorithm. The pliarmacokinetic parameters, i.e. absorption rate, absorption ratio, hepatic extraction ratio of metabolism and renal clearance were calculated by using separately established Quantitative Structure-Pharmacokinetics Relationship equations. The developed predictive model was then applied to simulations of 43 non-congeneric industrial chemicals. The chemical concentrations in organs/tissues after single oral administration were simulated, and their maximum concentrations (Cmax's) and area tinder the concentration-time curves (AUC's) were calculated.Fast Inverse Laplace Transform was newly applied for the purpose of simulation of 28-day repeated dose toxicity.Simulated concentrations of 28 days repeated dose were, however, found to be the same as those of simple repetitions of a single administration per day because of the short half-lives of non-congeneric industrial chemicals.A comparison of subacute toxicity data with Cmax's and AUC's in a single dose scenario suggested that the organs/tissues with relatively high concentrations of tested chemical substances were the most sensitive targets within a chemical.Chemical concentrations in liver, for instance, were correlated with the severity of hepatotoxicity among the chemicals. It was also suggested that to improve and widen the present approach, data of metabolite and reactivity of non-congeneric industrial chemicals to organs/tissues, receptors, etc. should be incorporated into the model.     

Japan’s experience of energy saving and business model for low-carbon economy

The purpose of this paper is to clarify the questions concerning stimulation of the innovation and the diffusion of energy saving or low-carbon.To do so,this paper explains using two cases of Japan-energy saving innovation after the Oil Shock and the eco points system.For the case after the oil shock,we explain the energy saving trend after the Oil Shock and the factors statistically.Then we put forward the business model for the low-carbon economy.Furthermore,we analyze the case of the eco points system from 2009-2011 in Japan and explain the significance of the business model for diffusion of the low-carbon products.