Determination of depleted uranium in environmental samples by gamma-spectroscopic techniques

The military use of depleted uranium initiated the need for an efficient and reliable method to detect and quantify DU contamination in environmental samples. This paper presents such a method, based on the gamma spectroscopic determination of 238U and 235U. The main advantage of this method is that it allows for a direct determination of the U isotope ratio, while requiring little sample preparation and being significantly less labor intensive than methods requiring radiochemical treatment. Furthermore, the fact that the sample preparation is not destructive greatly simplifies control of the quality of measurements. Low energy photons are utilized, using Ge detectors efficient in the low energy region and applying appropriate corrections for self-absorption. Uranium-235 in particular is determined directly from its 185.72 keV photons, after analyzing the 235U-226Ra multiplet. The method presented is applied to soil samples originating from two different target sites, in Southern Yugoslavia and Montenegro. The analysis results are discussed in relation to the natural radioactivity content of the soil at the sampling sites. A mapping algorithm is applied to examine the spatial variability of the DU contamination.     

Simulation of wind-driven dispersion of fire pollutants in a street canyon using FDS

Air quality in urban areas attracts great attention due to increasing pollutant emissions and their negative effects on human health and environment. Numerous studies, such as those by Mouilleau and Champassith (J Loss Prevent Proc 22(3): 316–323, 2009), Xie et al. (J Hydrodyn 21(1): 108–117, 2009), and Yassin (Environ Sci Pollut Res 20(6): 3975–3988, 2013) focus on the air pollutant dispersion with no buoyancy effect or weak buoyancy effect. A few studies, such as those by Hu et al. (J Hazard Mater 166(1): 394–406, 2009; J Hazard Mater 192(3): 940–948, 2011; J Civ Eng Manag (2013)) focus on the fire-induced dispersion of pollutants with heat buoyancy release rate in the range from 0.5 to 20 MW. However, the air pollution source might very often be concentrated and intensive, as a consequence of the hazardous materials fire. Namely, transportation of fuel through urban areas occurs regularly, because it is often impossible to find alternative supply routes. It is accompanied with the risk of fire accident occurrences. Accident prevention strategies require analysis of the worst scenarios in which fire products jeopardize the exposed population and environment. The aim of this article is to analyze the impact of wind flow on air pollution and human vulnerability to fire products in a street canyon. For simulation of the gasoline tanker truck fire as a result of a multivehicle accident, computational fluid dynamics large eddy simulation method has been used. Numerical results show that the fire products flow vertically upward, without touching the walls of the buildings in the absence of wind. However, when the wind velocity reaches the critical value, the products touch the walls of the buildings on both sides of the street canyon. The concentrations of carbon monoxide and soot decrease, whereas carbon dioxide concentration increases with the rise of height above the street canyon ground level. The longitudinal concentration of the pollutants inside the street increases with the rise of the wind velocity at the roof level of the street canyon.     

Radiological characteristics and investigation of the radioactive equilibrium in the ashes produced in lignite-fired power plants

Coal- and lignite-fired power plants produce significant amounts of ashes, which are quite often being used as additives in cement and other building materials. In many cases, coal and lignite present high concentrations of naturally occurring radionuclides, such as 238U, 226Ra, 210Pb, 232Th and 40K. During the combustion process, the produced ashes are enriched in the above radionuclides. The different enrichment of the various radionuclides within a radioactive series, such as that of 238U, results in the disturbance of radioactive secular equilibrium. An extensive research project for the determination of the natural radioactivity of lignite and ashes from Greek lignite-fired power plants is in progress in the Nuclear Engineering Department of the National Technical University of Athens (NED-NTUA) since 1983. This paper presents detailed results for the natural radioactivity, the secular radioactive equilibrium disturbance and the radon exhalation rate of the fly-ash collected at the different stages along the emission control system of a lignite-fired power plant as well as of the bottom-ash. From the results obtained so far, it may be concluded that 226Ra radioactivity of fly-ash in some cases exceeds 1 kBq kg(-1), which is much higher than the mean 226Ra radioactivity of surface soils in Greece (25 Bq kg(-1)). Furthermore, the radioactivity of 210Pb in fly-ash may reach 4 kBq kg(-1). These results are interpreted in relation to the physical properties of the investigated nuclides, the temperature in the flue-gas pathway, as well as the fly-ash grain size distribution. It is concluded that towards the coldest parts of the emission control system of the power plant, the radioactivity of some natural nuclides is gradually enhanced, secular radioactive equilibrium is significantly disturbed and the radon exhalation rate tends to increase.