SMBBR-AF-SMBBR组合工艺处理高氨氮农药废水

采用特异性移动床生物膜反应器(SMBBR)和厌氧生物滤池(AF)组合工艺处理高氨氮农药废水。考察了HRT、pH和DO等工艺条件对SMBBR-AF-SMBBR组合工艺运行稳定期COD和氨氮去除率的影响。试验结果表明,在进水COD为2 408~7 440 mg/L、ρ(NH_4~+-N)为160.21~433.84 mg/L、TN为208.27~537.65 mg/L、HRT为8d、pH为8.0、DO为4 mg/L的条件下,处理后出水平均COD为342 mg/L,COD去除率达92.3%;ρ(NH_4~+-N)小于4.0mg/L,氨氮平均去除率为89.2%;TN小于50 mg/L,平均TN去除达83.0%。出水各指标均优于原A2O工艺出水。     

煤制乙二醇废水预处理装置的工业化调试

针对煤制乙二醇废水含高浓度硝酸盐氮的特点,设计了缺氧膨胀床(AEB)反应器预处理装置,并进行了工业化启动和调试运行,考察了其在反硝化连续流运行条件下的处理效果及工艺参数变化。结果表明,AEB反应器启动后,填料层生物膜挂膜快速且生长稳定。反应器在工业化调试阶段运行稳定,COD和TN的去除率和去除负荷较为稳定。在受到来水冲击后,AEB反应器处理效果稳定,出水可在短期内恢复正常。该技术的系统操控参数范围较广,易于工业化操控运行,在煤制乙二醇废水和其他含高浓度硝酸盐氮废水的处理中具有较大的推广价值。     

内螺纹变截面铜管拉伸工艺的研究

此文提出了内螺纹变截面铜管分段拉仲一次成形新工艺,并就工艺因素对该管拉伸成形的影响进行了试验研究,从而为合理制订成形工艺提供了依据。     

玻璃纤维-铝合金层合板氙灯老化性能研究

目的研究氙灯环境对玻璃纤维-铝合金层合板性能的影响。方法通过研究玻璃纤维-铝合金层合板在氙灯老化后的力学性能、基体红外光谱、铝合金表面形貌及元素变化,分析层合板的氙灯老化机理。结果随氙灯老化时间的延长,树脂基体老化降解程度越高,树脂与纤维、铝合金的界面强度下降,使材料拉伸及弯曲性能降低,拉伸强度受老化影响最为显著的是正交结构层合板,老化84 d后强度降低13.7%,正交结构0°方向层合板的弯曲强度受氙灯老化影响降低4.6%,其他试样的弯曲强度降幅均低于5%,氙灯老化后的铝合金层表面的微凹坑数量及尺寸无明显变化,但凹坑氧元素随老化周期延长略微增加。结论氙灯环境主要影响玻璃纤维-铝合金层合板中的复合材料层及各界面,树脂基体的降解导致力学性能的衰退,而对于铝合金的影响并不明显。     

高灵敏XRF测定废水中痕量砷

本文提出了在硫酸介质中，以锌粒还原产生氢化物，溴化铜溶液吸收，微孔滤膜过滤制成薄样，Ｘ射线荧光测定水中痕量砷的分析方法。     

石墨管连续涂覆结合基体改进测定地表水中的铅

尝试了使用5%钼酸铵-5%磷酸二氢铵溶液组成石墨管连续涂覆结合基体改进剂的方法,应用于地表水Pb的测量中。实验表明,本法具有提高石墨管在使用过程中的稳定性,消除基体效应的作用。     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

开口圆管非对称弯曲的一种方法

开口圆管非对称弯曲时,在尺寸、形状均有较高精度要求的情况下弯曲有一定的难度。此文介绍了一种成功的开口圆管非对称弯曲冷态成形方法。     

Detecting neural tube defects by amniocentesis between 11 and 15 weeks' gestation

Forty-two open neural tube defects (NTDs) were identified in our series of 7440 amniocenteses tested between 11 and 15 weeks of gestation. Using a cut-off of ≥2.0 MOM, the detection rate for open NTDs was 95 per cent; 100 per cent each for anencephaly and spina bifida; and 78 per cent for encephalocele. Two encephaloceles had AFP levels less than 2.0 MOM and negative AChEs. Thirty-four (81 per cent) of these NTDs were tested between 13 and 15 weeks and 8 (19 per cent) before 13 weeks. There were 0.6 per cent false positives by AFP (excluding serious abnormalities and fetal death) and 0.1 per cent after AChE. The likelihood of an open NTD after an elevated AFP (≥2.0 MOM) was 24 and 77 per cent for any serious abnormality. These results, when combined with an earlier study, indicate that amniotic fluid AFP appears to be as sensitive a test for open NTDs between 13 and 15 weeks as between 16 and 20 weeks. Additional experience is necessary to determine this before 13 weeks.     

福州CRT产业集群废物产生特征及管理模式研究

根据对福州开发区阴离子射线管(CRT)产业集群进行调查、访谈和统计分析,实证研究了该产业集群的废物产生特征和管理模式.结果发现,福州CRT产业集群在不断发展壮大的同时,随着主导产品生产规模的扩大以及配套企业的进入,废物的产生总量不断增加,单位主导产品的废物产生强度持续上升,废物种类也逐渐丰富,给区域环境带来的压力不断增大;但同时,产业集群借助其规模和集聚效应,不仅为废物交换和工业共生体系的构建提供了基础平台,而且为专营性废物回收组织和处理处置设施的良好运转营造了外部环境.