Safety assessment of the film boiling chemical vapor infiltration (FB-CVI) process through a system-theoretic accident model and process (STAMP)

Film boiling chemical vapor infiltration (FB-CVI) is considered as one of the fastest process methodologies for manufacturing carbon-carbon (C–C) composite products and possesses various advantages compared to conventional methodologies. However, there are safety concerns associated with this process for large-scale manufacturing, mainly owing to the intrinsic nature of the precursor and the process conditions. Considering the multifunctional interactions of the various systems during the process, a system-theoretic process analysis (STPA)/system theoretic accident model and process (STAMP) model is used to perform a safety analysis of the hazardous states of the FB-CVI process at the system level. As a case study, the FB-CVI process equipment employed for the manufacturing of C–C composites is considered. The safety constraints present in the system are assessed for adequacy through a hazard analysis by STPA/STAMP. The analysis through STPA/STAMP demonstrated the capability to create proactive strategies for the design and realization of process equipment that can be employed to manufacture C–C composite products through the FB-CVI process.     

感光胶片废水的水解酸化—好氧处理工艺试验

对感光胶片有机生产废水处理工艺进行了方法采用水解酸化－好氧串联工艺和传统活性污泥法两种方法并进行对照。结果经水解酸化处理，废水的ＢＯＤ５／ＣＯＤｃｒ可提高至０．５４－０．５６，平均增加了１７％左右，证实了水解酸化菌在该工艺条件下具有搞高效片废水可生化性的功能。     

水解酸化-好氧工艺处理感光材料有机废水研究

感光材料有机生产废水含有多种合成有机物，其BOD5／CODer比值为0．46～0．48，可生化性良好，经水解酸化处理后该废水的BOD5／CODcr的比值可提高至0．54～056，平均增加了17％左右。水解酸化－好氧串联工艺对该废水总的处理效果表明：在废水CODer进水浓度2000～2500mg／L范围内，CODer总去除率可达95％左右，BOD5总去除率可达97％左右；水解酸化后好氧生化系统的动力学半速度常数Ks＝103mg／L，最大比降解速度K＝5．0／日。     

膜分离技术用于非电解质除杂

介绍电渗析装置工艺及基本原理，提出使用离子选择性透过膜的依据及极限电流的确定方法．论述了不同方法对冷冻液与ＮａＳＣＮ分离效果影响，指出采用电渗析法分离冷冻液中的ＮａＳＣＮ，使除杂率可达９５％以上。本工艺为腈纶冷冻液除杂及防治污染提供了新途径。     

PTFE/TiO_2复合膜光催化降解水中罗丹明B研究

以P25 TiO_2为催化剂、聚四氟乙烯乳液(PTFE)为粘结剂,采用辊压法制备了PTFE/TiO_2复合膜催化剂,并对其进行了SEM和XRD表征。结果表明:TiO_2与PTFE乳液的质量比为4:1时其表面最为平整且分布着均匀的空隙。此外,PTFE的引入并没有改变TiO_2的晶相结构与衍射峰强度。另外,随着光照时间的延长,PTFE/TiO_2复合膜催化表面·OH自由基产生量呈线性增加,且Rh B分子在553 nm处特征吸收峰强度逐渐降低。经过150 min光照后,Rh B的光催化降解率达到87%。连续重复使用14次之后,PTFE/TiO_2复合催化膜的光催化效率仅下降2%左右,这表明其可能在废水深度处理领域得到实用化应用。     

Considering the Prospects of Immediate Resistance in Food Politics: Reflections on The Garden

In this essay, I offer reflections inspired by The Garden, a compelling film documenting the failed struggle of the South Central Farmers to maintain a lush 14-acre farm within an industrial, impoverished neighborhood of Los Angeles. I concentrate on diverse representations of resistance featured in the film, which range from the traditionally mediated to more immediate or material-rhetorical acts. Taking the lead of the South Central Farmers, I conclude that we (as scholars, teachers, and ethical people) may combat the corporate food system with a multifarious approach to social change.     

Migration of saline solutions in variably saturated porous media

Migration of concentrated NaNO3 solutions in homogeneous packs of pre-wetted silica sands was investigated using a light transmission system. Solutions of 5 molal NaNO3 were found to migrate downward 24-62% faster than pure water, in an unstable, fingered manner. This behavior was attributed primarily to a surface tension induced, non-zero apparent contact angle between the imbibing and the resident fluids. For saline solutions of similar surface tension to that of pure water (achieved by the addition of 2% methanol), the migration rates and plume shapes were comparable to that of water, demonstrating that density was not the primary source of the observed differences in migration patterns. At depths where resident saturation increased above residual, the migration process appeared to occur via film flow with slight changes in saturation (<4%), rather than in a series of abrupt jumps, as observed at shallower depths. A method for contact angle scaling was used to illustrate the effects of non-zero contact angles on capillary pressure-saturation curves.     

Contamination Characteristics and Degradation Behavior of Low-Density Polyethylene Film Residues in Typical Farmland Soils of China

Low-density polyethylene (LDPE) film residues left in farmlands due to agricultural activities were extensively investigated to evaluate the present pollution situation by selecting the typical areas with LDPE film application, including Harbin, Baoding, and Handan of China. The survey results demonstrated that the film residues were ubiquitous within the investigaed areas and the amount reached 2400–8200 g ha^?1. Breakage rates of the film residues were almost at the same level in the studied fields. There were relatively small amounts of film residues remaining in neighboring farmland fields without application of LDPE film. The studies showed that the sheets of LDPE residues had the same oxidative deterioration, which was probably due to photodegradation instead of biodegradation. The higher molecular weight components of the LDPE film gradually decreased, which were reflected by the appearance of some small flakes detached from the film bodies. LDPE films in the investigated fields gradually deteriorated and the decomposing levels developed with their left time increasing. The degradation behaviors of LDPE films were confirmed by using Fourier transform infrared (FTIR), scanning electron microscopic (SEM), and gel permeation chromatography analyses.     

水解酸化对感光胶片废水生化反应动力学系数的影响

采用水解酸化工艺可有效地提高工业废水中难生物降解有机物的可生化性,为后续好氧生化处理创造有利条件。本试验在对感光胶片废水采用水解酸化－活性污泥法工艺和常规活性污泥法进行平行对照试验的基础上,从生化反应动力学系数的角度研究水解酸化过程对好氧生化反应的影响。研究结果表明：经水解酸化处理后,在该废水的ＢＯＤ５／ＣＯＤＣｒ比值从０４６－０４８提高至０５４－０５６的同时,后续活性污泥系统的动力学半速度数Ｋｓ从常规活性污泥法的４５９毫克／升下降至１０３毫克／升,最大比降解速度Ｋ从３０／日上升至５０／日,可用于表征该工业废水可生化性和后续好氧化物处理效果改善和提高的程度。