Review: recent advances in biogas purifying technologies

Biomethane production through biogas upgrading is a promising renewable energy for some industries which could be part of the equilibrium needed with fossil fuels consumption to achieve a sustainable society. This paper presents a comprehensive list of biogas upgrading technologies focused on carbon dioxide removal as well as recent advances reported by researcher with wide expertise in this topic. Additionally, an extensive costs–performance comparison among the technologies studied is discussed. Among the different alternatives, chemical scrubbing stood out to achieve high biomethane purities while cryogenic technologies proved to be effective against methane losses. Regarding the different costs, water scrubbing and membrane separation seem to be the most affordable techniques.     

可张孔曝气器曝气能耗试验研究

通过试验研究，总结出可张孔曝气阻力损失的影响因素，以优化产品的结构设计参数，降低产品在工程应用中的能耗，获取更好的经济效益。     

臭氧耦合陶瓷膜过滤对膜性能及出水消毒副产物的影响

利用臭氧（O₃）-陶瓷膜过滤（CMF）处理常规工艺出水,研究了不同O₃-CMF耦合方式对膜性能和消毒副产物（DBPs）的影响.结果表明,与单独CMF相比,异位O₃-CMF和原位O₃-CMF均可以有效缓解膜污染,原位O₃-CMF控制效果最佳.异位O₃-CMF对进水（常规工艺出水） DOC去除率（26.25%）略高于原位O₃-CMF（22.31%）,但是其SUVA去除率（83.91%）明显低于原位O₃-CMF（93.10%）.羟基自由基（·OH）生成特征表明原位O₃-CMF可促进O₃产生更多的·OH.在O₃、·OH氧化和陶瓷膜截留协同作用下,异位O₃-CMF和原位O₃-CMF出水中总荧光响应强度和相对分子质量大于0.3×10³,有机物含量降低,进而使得出水中含碳消毒副产物（C-DBPs）生成量分别降低了21.86%和32.35%,含氮消毒副产物（N-DBPs）生成量分别降低了16.16%和19.13%.但O₃和·OH氧化后生成的小分子有机物因难以被CM截留导致其在出水中含量增加,进而增加了卤代酮（HKs）、水合氯醛（CH）和三卤硝基甲烷（THNMs）的产生.本研究对于不同O₃-CMF方式下O₃与CM的协同机制的探讨,改善膜性能和提升DBPs前体物的去除具有一定指导意义.     

离子液体吸收废印刷线路板热拆解过程中挥发性有机物——基于COSMO-RS模型

模拟废印刷线路板（WPCB）的热拆解过程,分析热拆解过程中的挥发性有机物（VOCs）组分;利用真实溶剂似导体屏蔽（COSMO-RS）模型对浓度较高的污染物进行量子力学模拟,研究离子液体（ILs）组成单元对目标污染物溶解度的影响差异,分析溶解过程中主导分子间作用力类型,确定优选吸收剂;测定不同溶剂进行溶解性,验证模型适用性.结果表明：①乙酸乙酯和环戊酮是浓度较高的VOCs组分,在240和250℃时浓度分别为43.1,153mg/m³和105,252mg/m³,质量百分比总和分别为76.3%和67.3%.②高表面屏蔽电荷密度分布峰、长烷基链阴阳离子和亲电基团的存在可提高乙酸乙酯和环戊酮在ILs中的溶解度.双三氟甲磺酰基亚胺盐（NTf₂^-）类ILs是一类优良吸收剂.静电力和范德华力对溶解过程起主导作用.③COSMO-RS模型可定性和半定量用于预测乙酸乙酯和环戊酮的溶解度.     

裂解温度和离子强度对不同来源生物炭胶体释放行为的影响

近年来环境中生物炭胶体形成受到广泛关注,它是生物炭在环境中物理分解作用的重要过程,对污染物迁移有着重要影响.然而,目前对生物炭胶体释放过程和影响因素的研究甚少,人们对生物炭胶体释放机理的认识还很有限.本研究以小麦秸秆和花生壳为生物质来源,系统地探讨了生物炭的裂解温度（300~700 ℃）和溶液离子强度（0.1~10 mmol·L^-1）对生物炭胶体产率的影响.结果表明,随着裂解温度的升高,生物炭的耐磨性增强,且在较高的裂解温度下（≥500 ℃）花生壳生物炭的耐磨性显著强于小麦秸秆生物炭.生物炭的胶体产率受到生物质来源和裂解温度的显著影响,花生壳生物炭的胶体产率低于小麦秸秆生物炭,高温裂解（≥600 ℃）生物炭的胶体产率显著低于中低温裂解生物炭.在相同溶液离子强度下,生物炭胶体产率与其亚微米级碎片率呈显著正相关（p<0.05）,即生物炭中亚微米级碎片率越高,生物炭胶体产率越高.当溶液离子强度从1 mmol·L^-1增加到10 mmol·L^-1时,两种来源生物炭的胶体产率均显著降低,其降低的程度因生物炭裂解温度而异,其中低温裂解（300 ℃）生物炭的胶体产率降低了11.1%~11.2%,中高温裂解（≥ 500 ℃）生物炭的胶体产率降低了60.0%~97.2%.     

鄂东鸭儿湖地区大气中有机氯农药特征及土-气交换

采用聚氨酯泡沫-被动采样法（PUF-PAS）采集鸭儿湖地区大气样,研究典型污染源地区大气中有机氯农药（OCPs）组成、来源及土-气交换现状。鸭儿湖地区大气中OCPs主要组成为艾氏剂（Aldrin）、滴滴涕（DDTs）、六六六（HCHs）、六氯苯（HCB）、甲氧滴滴涕（Methoxychlor）和a-硫丹（α-Endosulfan）,约占OCPs总量的84%。较高浓度Aldrin（平均浓度为161.25 pg/m³）广泛存在应引起高度重视。HCHs（平均浓度为89.64 pg/m³）和DDTs（平均浓度为92.29 pg/m³）普遍存在且含量高,污染程度比较明显。HCHs异构体中β-HCH高于α-HCH,远远高于γ-HCH和δ-HCH,说明HCHs经过长期降解已逐渐稳定下来;来源分析推测存在工业HCHs的使用或者受大气长距离传输影响。DDTs在各点位分布明显不同于HCHs,且各点位DDTs的六种组成均存在很大差别,可能由于点位地理位置以及农药使用情况导致;来源分析推测大气中DDTs主要来自历史残留。鸭儿湖地区OCPs土气交换研究表明,HCHs主要表现为从大气向土壤中沉降;DDTs在大多数点位源于土壤中历史残留的挥发,部分点位受到大气长距离传输影响。     

Determination of organophosphorus pesticides and related compounds in water samples by membrane extraction and gas chromatography

A membrane extraction-gas chromatography method was developed fordetermination of organophosphorus pesticides and related compounds including methamidophos, DDVP, dimethoate, methyl parathion, parathion, thiophosphoric acid trimethyl ester, and thiophosphoramidic acid dimethyl ester in water samples. In thismethod, surface-modified acetic cellulose membranes were used to extract the target analytes in water samples, the extracted analytes were back-extracted into a small amount of methanol, andgas chromatography with pulsed flame photometric detector (GC-PFPD) was used to determine the concentrations of targetanalytes in the extracts. The recoveries obtained for thetarget analytes spiked into the water samples ranged from 66to 94%. The method detection limit for each target analyte was 0.05 g L^-1. The method developed in this study had shown the advantages of being cheap, simple, fast, and reliable. It had been used successfully to determine the concentrations of target analytes in river water samples.     

Large pore size polyacrylonitrile membrane for ultrafiltration

ＩｎｔｒｏｄｕｃｔｉｏｎＩｎｒｅｃｅｎｔｙｅａｒｓ,ｔｈｅｔｅｃｈｎｉｑｕｅｆｏｒｕｌｔｒａｆｉｌｔｒａｔｉｏｎｈａｓｇａｉｎｅｄｒａｐｉｄｄｅｖｅｌｏｐｍｅｎｔ.Ｍｏｒｅａｎｄｍｏｒｅｋｉｎｄｓｏｆｍｅｍｂｒａｎｅｓａｒｅｓｔｕｄｉｅｄａｎｄｍａｎｕｆａｃｔｕｒｅｄ ,ａｎｄａｌａｒｇｅ ｓｃａｌｅｉｎｄｕｓｔｒｉａｌａｐｐｌｉｃａｔｉｏｎｈａｓｂｅｅｎｇｒｏｗｎ .ＰＡＮｐｏｌｙｍｅｒｉｓｅｘｔｅｎｓｉｖｅｌｙｕｓｅｄｔｏｐｒｅｐａｒｅＵＦｍｅｍｂｒａｎｅｓ(Ｓｔｏｉｋｏ,1 991 ) .Ｉｔｓｈｙｄｒｏｐ…     

BOD微生物膜的再利用研究初探

对失去大部分活性的微生物膜进行再培养,以研究膜再利用的可能性。试验结果初部表明:在1/2MS培养基中加入一定量的植物激素,不仅可以使膜的电位值(I0)显著升高,且活性强,稳定性好,可使膜重复利用。     

Improvement of the antifouling characteristics in a bioreactor of polypropylene microporous membrane by the adsorption of Tween 20

Surface modification by physical adsorption of Tween 20 was accomplished on polypropylene microporous membranes (PPMMs). Attenuated total reflection-Fourier transform infrared spectroscopy (ATR/FT-IR) and scanning electron microscope (SEM) were used to characterize the chemical and morphological changes on the membrane surfaces. Water contact angles and relative pure water fluxes were measured. The data showed that the hydrophilic performance for the modified membranes increased with the increase in the adsorption amount of Tween 20 onto the surface or into the pores of polypropylene microporous membranes. To test the antifouling property of the membranes by the adsorption of Tween 20 in a membrane bioreactor (MBR), filtration for active sludge was performed using synthetic wastewater. With the help of the data of water fluxes and the FE-SEM photos of the modified PPMMs before or after operating in a MBR for about 12 d, the PPMMs with monolayer adsorption of Tween 20 showed higher remained flux and stronger antifouling ability than unmodified membrane and other modification membranes studied.