Isotope tracing of submarine groundwater discharge offshore Ubatuba, Brazil: results of the IAEA–UNESCO SGD project

Results of groundwater and seawater analyses for radioactive (³H, ²²²Rn, ²²³Ra, ²²⁴Ra, ²²⁶Ra, and ²²⁸Ra) and stable (D and ¹⁸O) isotopes are presented together with in situ spatial mapping and time series ²²²Rn measurements in seawater, direct seepage measurements using manual and automated seepage meters, pore water investigations using different tracers and piezometric techniques, and geoelectric surveys probing the coast. This study represents first time that such a new complex arsenal of radioactive and non-radioactive tracer techniques and geophysical methods have been used for simultaneous submarine groundwater discharge (SGD) investigations. Large fluctuations of SGD fluxes were observed at sites situated only a few meters apart (from 0 cm d⁻¹ to 360 cm d⁻¹; the unit represents cm³/cm²/day), as well as during a few hours (from 0 cm d⁻¹ to 110 cm d⁻¹), strongly depending on the tidal fluctuations. The average SGD flux estimated from continuous ²²²Rn measurements is 17 ± 10 cm d⁻¹. Integrated coastal SGD flux estimated for the Ubatuba coast using radium isotopes is about 7 × 10³ m³ d⁻¹ per km of the coast. The isotopic composition (δD and δ¹⁸O) of submarine waters was characterised by significant variability and heavy isotope enrichment, indicating that the contribution of groundwater in submarine waters varied from a small percentage to 20%. However, this contribution with increasing offshore distance became negligible. Automated seepage meters and time series measurements of ²²²Rn activity concentration showed a negative correlation between the SGD rates and tidal stage. This is likely caused by sea level changes as tidal effects induce variations of hydraulic gradients. The geoelectric probing and piezometric measurements contributed to better understanding of the spatial distribution of different water masses present along the coast. The radium isotope data showed scattered distributions with offshore distance, which imply that seawater in a complex coast with many small bays and islands was influenced by local currents and groundwater/seawater mixing. This has also been confirmed by a relatively short residence time of 1–2 weeks for water within 25 km offshore, as obtained by short-lived radium isotopes. The irregular distribution of SGD seen at Ubatuba is a characteristic of fractured rock aquifers, fed by coastal groundwater and recirculated seawater with small admixtures of groundwater, which is of potential environmental concern and has implications on the management of freshwater resources in the region.     

活性炭法测量室内空气中氡浓度的影响因素研究

探讨了各种因素对活性炭法测量室内空气中氡浓度的影响,并提出既能保证检测质量,又能符合工程检测需要、提高检测效率的检测条件范围。     

室内氡污染的控制方法

介绍了消除氡源、控制氡源、通风和空气净化等现有房屋室内氡污染的防治方法,以及控制未来房屋内氡污染的方法。     

抽水蓄能电站建设中注意防止氡污染

针对某抽水蓄能电站地下勘探平洞检测氡气浓度超标问题,分析氡污染危害,提出防止氡污染的措施。     

土氡测量在地质灾害勘测中的干扰实验研究

对土氡勘测中来自测量过程、勘测场地条件、气象因素方面的常见干扰进行了实验研究，探讨了干扰机理，指出了定性及部分定量排除干扰的方法。     

Inverse modeling of Asian Rn flux using surface air Rn concentration

When used with an atmospheric transport model, the ²²²Rn flux distribution estimated in our previous study using soil transport theory caused underestimation of atmospheric ²²²Rn concentrations as compared with measurements in East Asia. In this study, we applied a Bayesian synthesis inverse method to produce revised estimates of the annual ²²²Rn flux density in Asia by using atmospheric ²²²Rn concentrations measured at seven sites in East Asia. The Bayesian synthesis inverse method requires a prior estimate of the flux distribution and its uncertainties. The atmospheric transport model MM5/HIRAT and our previous estimate of the ²²²Rn flux distribution as the prior value were used to generate new flux estimates for the eastern half of the Eurasian continent dividing into 10 regions.The ²²²Rn flux densities estimated using the Bayesian inversion technique were generally higher than the prior flux densities. The area-weighted average ²²²Rn flux density for Asia was estimated to be 33.0 mBq m⁻² s⁻¹, which is substantially higher than the prior value (16.7 mBq m⁻² s⁻¹). The estimated ²²²Rn flux densities decrease with increasing latitude as follows: Southeast Asia (36.7 mBq m⁻² s⁻¹); East Asia (28.6 mBq m⁻² s⁻¹) including China, Korean Peninsula and Japan; and Siberia (14.1 mBq m⁻² s⁻¹). Increase of the newly estimated fluxes in Southeast Asia, China, Japan, and the southern part of Eastern Siberia from the prior ones contributed most significantly to improved agreement of the model-calculated concentrations with the atmospheric measurements. The sensitivity analysis of prior flux errors and effects of locally exhaled ²²²Rn showed that the estimated fluxes in Northern and Central China, Korea, Japan, and the southern part of Eastern Siberia were robust, but that in Central Asia had a large uncertainty.     

Inhalation dose assessment of indoor radon progeny using biokinetic and dosimetric modeling and its application to Jordanian population

High indoor radon concentrations in Jordan result in internal exposures of the residents due to the inhalation of radon and its short-lived progeny. It is therefore important to quantify the annual effective dose and further the radiation risk to the radon exposure. This study describes the methodology and the biokinetic and dosimetric models used for calculation of the inhalation doses exposed to radon progeny. The regional depositions of aerosol particles in the human respiratory tract were firstly calculated. For the attached progeny, the activity median aerodynamic diameters of 50 nm, 230 nm and 2500 nm were chosen to represent the nucleation, accumulation and coarse modes of the aerosol particles, respectively. For the unattached progeny, the activity median thermodynamic diameter of 1 nm was chosen to represent the free progeny nuclide in the room air. The biokinetic models developed by the International Commission on Radiological Protection (ICRP) were used to calculate the nuclear transformations of radon progeny in the human body, and then the dosimetric model was applied to estimate the organ equivalent doses and the effective doses with the specific effective energies derived from the mathematical anthropomorphic phantoms. The dose conversion coefficient estimated in this study was 15 mSv WLM⁻¹ which was in the range of the values of 6-20 mSv WLM⁻¹ reported by other investigators. Implementing the average indoor radon concentration in Jordan, the annual effective doses were calculated to be 4.1 mSv y⁻¹ and 0.08 mSv y⁻¹ due to the inhalation of radon progeny and radon gas, respectively. The total annual effective dose estimated for Jordanian population was 4.2 mSv y⁻¹. This high annual effective dose calculated by the dosimetric approach using ICRP biokinetic and dosimetric models resulted in an increase of a factor of two in comparison to the value by epidemiological study. This phenomenon was presented by the ICRP in its new published statement on radon.     

Lorenz Curve and Gini Coefficient: Novel tools for analysing seasonal variation of environmental radon gas

Using a methodology derived from Economics, the Lorenz Curve and Gini Coefficient are introduced as tools for investigating and quantifying seasonal variability in environmental radon gas concentration. While the Lorenz Curve presents a graphical view of the cumulative exposure during the course of the time-frame of interest, typically one year, the Gini Coefficient distils this data still further, to provide a single-parameter measure of temporal clustering. Using the assumption that domestic indoor radon concentrations show annual cyclic behaviour, generally higher in the winter months than in summer, published data on seasonal variability of domestic radon concentration levels, in various areas of the UK, Europe, Asia and North America, are analysed. The results demonstrate significantly different annual variation profiles between domestic radon concentrations in different countries and between regions within a country, highlighting the need for caution in ascribing seasonal correction factors to extended geographical areas. The underlying geography, geology and meteorology of a region have defining influences on the seasonal variability of domestic radon concentration, and some examples of potential associations between the Gini Coefficient and regional geological and geographical characteristics are proposed. Similar differences in annual variation profiles are found for soil-gas radon measured as a function of depth at a common site, and among the activity levels of certain radon progeny species, specifically ²¹⁴Bi deposited preferentially in human body-fat by decay of inhaled radon gas. Conclusions on the association between these observed measures of variation and potential underlying defining parameters are presented.     

Inferring coastal processes from regional-scale mapping of Radon and salinity: examples from the Great Barrier Reef, Australia

The radon isotope ²²²Rn and salinity in coastal surface water were mapped on regional scales, to improve the understanding of coastal processes and their spatial variability. Radon was measured with a surface-towed, continuously recording multi-detector setup on a moving vessel. Numerous processes and locations of land-ocean interaction along the Central Great Barrier Reef coastline were identified and interpreted based on the data collected. These included riverine fluxes, terrestrially-derived fresh submarine groundwater discharge (SGD) and the tidal pumping of seawater through mangrove forests. Based on variations in the relationship of the tracers radon and salinity, some aspects of regional freshwater inputs to the coastal zone and to estuaries could be assessed. Concurrent mapping of radon and salinity allowed an efficient qualitative assessment of land-ocean interaction on various spatial and temporal scales, indicating that such surveys on coastal scales can be a useful tool to obtain an overview of SGD locations and processes.     

A Monte Carlo study of radon detection in cylindrical diffusion chambers

The functioning of radon diffusion chambers was studied using the Monte Carlo code RAMMX developed here. The alpha particles from radon are assumed randomly produced in the volume of the cylinder, and those from the progeny are assumed to originate randomly at the cylindrical surface. The energy spectrum, the distribution of incident angles, and the distribution of path lengths of the alpha particles on the detector were obtained. These quantities vary depending on input parameters such as initial alpha particle energy, radius and depth of the diffusion chamber, detector size and atmospheric pressure. The calculated energy spectrum for both ²²²Rn and ²²⁰Rn was compared with experiment, permitting the identification of each peak and its origin, and a better understanding of radon monitoring. Three aspects not considered in previous calculations are progeny alphas coming from surfaces of the monitor, taking into account the atmospheric pressure, and including the isotope ²²⁰Rn.