控制系统在污水处理中的应用

介绍了污水控制系统的工艺流程、系统配置和软件设计，并对由PLC和上位机组成的自动控制系统的主要功能进行了说明。上位机通过组态软件设计承担监控和管理任务，下位机通过编程软件实现实时数据采集和自动控制功能。     

啤酒废水处理站的工程设计

本项目以哈尔滨啤酒(沈阳)有限公司啤酒厂为设计对象,其啤酒废水处理规模为1500m3/d,进水CODCr2000~2800mg/L。采用预处理-预酸化-IC反应器-活性污泥法-过滤为主体工艺,出水达到《辽宁省污水与废气排放标准》(DB21-60-89中一级标准)。为啤酒行业废水综合治理提供了较好的工艺途径。     

Pyrolysis technologies for municipal solid waste: A review

Pyrolysis has been examined as an attractive alternative to incineration for municipal solid waste (MSW) disposal that allows energy and resource recovery; however, it has seldom been applied independently with the output of pyrolysis products as end products. This review addresses the state-of-the-art of MSW pyrolysis in regards to its technologies and reactors, products and environmental impacts. In this review, first, the influence of important operating parameters such as final temperature, heating rate (HR) and residence time in the reaction zone on the pyrolysis behaviours and products is reviewed; then the pyrolysis technologies and reactors adopted in literatures and scale-up plants are evaluated. Third, the yields and main properties of the pyrolytic products from individual MSW components, refuse-derived fuel (RDF) made from MSW, and MSW are summarised. In the fourth section, in addition to emissions from pyrolysis processes, such as HCl, SO₂ and NH₃, contaminants in the products, including PCDD/F and heavy metals, are also reviewed, and available measures for improving the environmental impacts of pyrolysis are surveyed. It can be concluded that the single pyrolysis process is an effective waste-to-energy convertor but is not a guaranteed clean solution for MSW disposal. Based on this information, the prospects of applying pyrolysis technologies to dealing with MSW are evaluated and suggested.     

SBR法处理低C/N污水的工程应用——以某基地污水处理站改造工程为例

低C/N污水的生化处理过程中,由于碳源不足,不能满足硝化和反硝化的要求,造成出水NH3-N超标。采用SBR工艺对某基地污水处理站厌氧处理后的低C/N污水进行改造,处理后出水COD去除率达到97%以上,NH3-N去除率达到93%以上。     

Comparison of criteria for prediction of runaway reactions in the sulphuric acid catalyzed esterification of acetic anhydride and methanol

Loss of temperature control is one of the major reasons that can lead to runaway reaction. This occurrence is commonly named thermal runway. The aim of this paper is the application of thermal runaway criteria in order to predict the onset of runaway phenomena and define the range of stability related to operating conditions in the reactor, with specific reference to the esterification of acetic anhydride and methanol catalysed by sulphuric acid tested in isoperibolic conditions. The isoperibolic calorimeter has also been used to obtain thermodynamic, kinetic and physical chemistry data necessary to develop a model for the reaction. Some runaway criteria applied in this work require a model for the process, so a model for the analyzed system been developed.Because of the modest reaction enthalpy and low activation energy this reacting system provide a severe test to the runaway criteria.In this work, various runaway criteria have been applied to the experimental and simulated data and the results obtained have been compared.     

膜曝气生物膜反应器生物膜影响因素分析

膜曝气生物膜反应器（MABR）是一种利用透气膜进行曝气，可以实现同步硝化反硝化的污水生物处理新工艺。本文阐述了膜曝气生物反应器生物膜的原理和特点，总结了国内外在该领域的研究成果，重点介绍了C／N、氧气压力、流速、生物膜厚度、温度和pH对生物膜性能的影响。     

Cesium isotope ratios as indicators of nuclear power plant operations

There are multiple paths by which radioactive cesium can reach the effluent from reactor operations. The radioactive ¹³⁵Cs/¹³⁷Cs ratios are controlled by these paths. In an effort to better understand the origin of this radiation, these ¹³⁵Cs/¹³⁷Cs ratios in effluents from three power reactor sites have been measured in offsite samples. These ratios are different from global fallout by up to six fold and as such cannot have a significant component from this source. A cesium ratio for a sample collected outside of the plant boundary provides integration over the operating life of the reactor. A sample collected inside the plant at any given time can be much different from this lifetime ratio. The measured cesium ratios vary significantly for the three reactors and indicate that the multiple paths have widely varying levels of contributions. There are too many ways these isotopes can fractionate to be useful for quantitative evaluations of operating parameters in an offsite sample, although it may be possible to obtain limited qualitative information for an onsite sample.     

SBR处理铁路洗涤废水试验研究

铁路洗涤废水中含有的主要污染物直链烷基苯磺酸钠(LAS)是我国环境标准中第2类污染物质.目前,铁路洗涤废水的处理以物理和化学法为主,存在效果不稳定、成本较高和工艺复杂等问题,急需寻求一种适合铁路洗涤废水特点的处理工艺.用SBR小试装置进行铁路洗涤废水处理实验研究,并且投加LAS降解菌于SBR中,进行了工艺参数的确定,处理效果考察和投菌前后对比等方面的初步研究.     

Ion exchange membrane-assisted electro-activation of aqueous solutions: Effect of the operating parameters on solutions properties and system electric resistance

The properties of electro-activated (EA) aqueous solutions as well as the dynamics of their changes were considered in the current study using aqueous solutions of NaCl and NaHCO₃. The concentrations of the salt solutions were 0.5, 0.25, 0.125 and 0.05 M. The tests were performed at the DC current densities of 25, 37.5, and 50 Å/m². The electro-activation reactor consisted of three individual cells assembled together and separated by anion-exchange (AEM) and cation-exchange (CEM) membranes. During the experiments, four configurations of the membrane placements and solutions concentrations were studied. The obtained results showed the dynamics of the electro-activation process that allows obtaining electro-activated solutions with targeted properties such as pH and oxydo-reduction potential (ORP). It was possible to obtain electro-activated solutions at the anodic side (acid anolyte) with pH of 3.0, 3.5, and 4.0 and ORP of +1100 ± 15 mV when NaCl solution was used as electrolyte. Furthermore, several types of electro-activated solutions with high redox potential (ORP = +921 ± 12 mV) and neutral pH (6.48 ± 0.05) were obtained on the anode side when sodium carbonate was used. At the same time, two types of solutions, one with acid pH (2.14 ± 0.14) and the other one with alkaline pH (10.46 ± 0.03) with ORP = +689 ± 10 and 110 ± 21 mV, respectively, were obtained in the central compartment which considered as electro-activated solutions obtained by means of noncontact electro-activation.     

乙醛废水处理工程实例

某化工厂以酒精氧化法制得乙醛,该厂原有一套污水处理设施,但系统出水难以达标。经改造后,该废水经过冷却到35～39℃、加碱中和至pH值为7左右,进入内循环厌氧反应器(MIC)处理,在厌氧进水为ρ(CODCr)约3200mg·L-1,HRT为24h时,CODCr去除率为94%,出水进入推流式好氧池,采用微孔曝气器曝气,HRT为36h,好氧出水ρ(CODCr)<100mg·L-1。